Clean the paper path

Similar Questions

• HP envy 100 D410a cannot replace the paper path door in the printer!

  Has received a 'false' paper jam message and followed the instructions to remove door paper to address 'paper jam' path (it wasn't any paper stuck).  Now, it is impossible to replace the paper path door.  Help!  Thanks, Brooklynllp

  This door can be difficult to get back up sometimes. The video below will show you how to replace the door on. Hope that helps.

  http://goo.GL/40uv3

• The paper feed of my printer Photosmart C4680 does not work

  Hello

  I tried to reset my printer, but the paper source always pulls the paper on an angle and then crashes.  This seems to have started all of a sudden.

  Hi JeaniT,

  If you have the paper guides, set against the paper and that you have cleaned the feed tires there is a good chance that there is a small piece of paper stuck in the paper path causing the paper be introduced an angle. You may need to lift the printer to look at the paper path.

  http://support.HP.com/us-en/document/c01673676

• ENVY 5530 need new lid paper path

  I have a 5530 LIKE, nine. After several frustrating to print attempts, causing any paper stuck, I found that the cover of the way had only 2 rolls instead of 4. Where can I get an another lid paper path?

  Hello, welcome to the Forums! I hope you enjoy your experience

  I saw your post on the search for an another lid the paper path. For some this question, I would say call HP to see if they have an option for you with your new printer.

  Here is their contact information:

  If you call in North America, the number is 1-800-474-6836 and for all other regions: click here.

  I hope that my post was information.

  Thanks for posting!

  Enjoy the rest of your day.

• My Epson NX125 printer goes through the paper without printing anything

  "What is required of ' Print Preview ' or 'Print' for my printer through the paper without printing anything.  Last few times he has done this, ink levels were low and I have renewed their but now they are all full and it will not print even though she goes through all the motions.

  See the printer manual or here

  http://files.support.Epson.com/PDF/nx125_/nx125_qr.PDF

  on cleaning the ink in the print head nozzles. In your case, the purp [ose of the exercise is to reload the path of ink and the printhead with ink.

  Tom Ferguson

• Satellite A30 cannot start after cleaning the heatsink

  I have a problem with my sat a30. It lights for 5 seconds then goes automatically off and on again for 5 times, before finally shutting down completely. all this began after I cleaned the heatsink. can you give me some advice for what to do with this problem?

  Hello

  This path is not easy to say what is the problem, because, who know what did you exactly and how. As you know do something like that on your own is always risky.

  Are there signs of life of the cooling fan? AFAIK the CPU becomes very hot in just seconds after the start, and I presume that CPU is not cooled properly and because of this unit turns off.

• HP 6700: Problem printing labels - try to change the paper type - thought that of why they're smuggling?

  Can not find the path to printer to change the paper type?  Any help is appreciated. Thank you

  @GWCampbell

  In the printing preferences, use the closest 'brochure' or 'thick' or other media type cardstock that you will find in the list of available paper types.

  Example:

  Control Panel > display icon > devices and printers > right click on your printer >

  Printing preferences > tab paper / quality > media
  

  Reference and examples:

  Printing options

  Help printing of the label:

  Print Labels_Business-Cards_Cards

  When you see a post that will help you,

  Who inspires you, gives a cool idea,

  Or you learn something new.

  Click the 'Thumbs Up' on this post.

  My answer-click accept as Solution to help others find answers.

• B210e Inksystem failure, Tower works to solve after cleaning the heads. Does not help

  Currently usinga B210e printer, had a paper jam and removed the jam.  Now I have an error message saying: ink system failure

  Complete guide to troubleshooting by HP, clean same head, back and have always system failure message ink at the same time to activate and deactivate the message that has no effect after hours of frustration.  Have carefully inspected printer and cleaned the printer head prepares and then says turn of and on.  Removed wall taken elctrical and still nothing.  Will you please help if you can because I'm about to throw the printer in an eighteen wheels.

  Thank you

  Bill

  [Personal information]

  Hi Wilcodd,

  I understand that your printer has an alphanumeric error message.  An alphanumeric error message means that your printer has a hardware problem.  If the steps in the document below are not able to resolve your problem, then you need to think to replace your printer.

  Alphanumeric error

  Let me know how it goes.

• All-in-one HP Photosmart C309a "Alignment failed" error message even after cleaning the print heads, etc.

  About 3 weeks ago before making the error msg above, a large black ink blob appeared on my printed piece of paper.  This product for several sheets later, but kept decreasing in amount.  I continued to print & finally all traces of ink have disappeared.  2 days ago I got a msg of error on "load plain white paper. ", but the paper tray was plain white paper in it.  I have removed the paper, straightened and her successor. As a result, the msg "Alignment failed" appeared.  I went through all the steps HP online information on the treatment of the "alignment failed", including the cleaning of the printheads (the right amount of ink was on it), check the vents of cartridge, etc.  My question is: if I have 4 out of colored inks and a new black ink installed, the alignment is being affected by the old cartridges?  A msg on this appeared on the Control Panel, giving the opportunity to proceed with the old cartridges or install new ones, but be careful that it "cannot allow completion of...» "If 'old' were replaced not.  I need to replace these color cartridges or is it probably another problem, which is print head damaged?

  Checked the evacuation & there is no problem, so I tried the informal solution to put the printhead in hot water.  A ran 1 cleaning via / configuration on the printer and finally aligned with success tools.  I waited a while to respond because I wanted to see if the printer should continue to work, and there!

  Thank you very much.  I'm happy that I can keep this printer!

• My Canon Pixma 250 pull the paper into the machine for printing

  My printer will not pull the paper into the machine for printing. I tried to clean the roller, it won't even. Any suggestions to fix this?

  Hello

  I suggest you to contact Canon support for assistance.

  http://USA.Canon.com/Cusa/support

• LexmarkX1270 of acts that it was printing but the paper comes out blank.

  Since the installation of a new black cartridge in the printer, it works as it was printing but the paper comes out blank.  I tried to reinstall the drivers of cleaning cartridge.

  Let us know what happens after you try with another cartridge.

• Cradle of HP ink cartridge 8250 photosmart printer is stuck. Please clean the jam and press OK

  I have an HP photosmart 8250 printer. I had a paper jam, I opened two doors paper jam, paper jam had corrected itself, but the message said then, "the print cartridge cradle is stuck. Please clean the jam and press OK. "Can't get this sign goes.

  OLMS

  Hello

  The print cartridge cradle is stuck is a carriage jam error message. Please make sure that there are no obstacles, and transport must move freely.

  Follow the steps mentioned in the document:

  Link to document

  Although I am an employee of HP, I speak for myself and not for HP.
  Click on the star of CONGRATULATIONS on the left to say 'thank you '.
  Please check one response to "ACCEPTED solution" if it has solved your problem, while others may find it.

• OfficeJet pro 8509: printer stuck in cleaning the print heads

  Printer stuck on the envelope and has been removed with the exception of the corner (2.5 × 2). Turned on the printer to see if it would come out a up... now by initial start-up, he is stuck in cleaning the print heads, but not leaning print head. Help... Thank you.

  Hi @rodman2,

  My apologies for the incorrect link. Here are the links for the jams paper and transport for the HP Officejet Pro 8500 A909g, it will display appropriarte steps to clear the jam.

  A Message appears 'Transport Jam' for HP Officejet Pro 8500 first (A909n) and 8500 wireless (A909g) all-in-One Series

  A message "Paper jam" for the all-in-one HP Officejet Pro 8500 first (A909n) and 8500 wireless (A909g)

  If you still experience the problem you after trying the steps in the link above, I recommend you contact HP for assistance.

  Contact HP:
  Step 1. Open the link: http://h22207.www2.hp.com/us-en/contact-hp/
  Step 2. Enter the product number or select Auto detection
  Step 3. Scroll up to "still need help? Fill out the form to select your contact options.
  Step 4. Scroll down and click on: contact HP options - click Get phone number
  File number and phone number appear

  If it helps, will testify of my answer by pressing the 'thumbs up' below, or click on the button "Accept as Solution" if I helped you reach a solution.

  I hope this helps. Have a great day.

• Rollers which collects the paper in my Photosmart C5280 printer make any movement.

  I have cleaned the rollers, checked the settings, changed the paper, dusted off the printer, but rolls that are supposed for the paper do not move, and the printer gives me a message 'Out of Paper' and do not print.  Any suggestions?  He is an all-in one Photosmart C5280, running on Windows XP, directly connected to the computer.

  If the entry of paper rolls do not move, then it is possible there is something stuck in it or the sensors that control are having a problem.

  * I start by remove all paper from the paper tray and check at the front and the back of the printer to make sure nothing is caught in the rollers

  * Hard Reset the printer by unplugging the unit while it is turned on, wait 30 seconds and plug it back to.

  Thus, there is a document provided by HP with the steps to resolve when a printer does not have paper in the unit.  The document can be accessed here.

  I hope this helps.

• I have an old deskjet Office 1220C - the led flashes to keep and it will not grab the paper - help

  I'm trying to set up an old HP Deskjet 1220C and LEDS are flashing, saying: there is a paper jam, but there is no paper jam.  I made sure that the back cover is locked, cleaned all rollers, etc., but it still keeps flashing.  Any helpful suggestions would be appreciated.  Thank you!

  The page here can help with the paper feeding problems.  Also, open the cover with the power on and make sure that the carriage moves to the position "smiley face", look at the icons on the upper back portion of the printer as shown here.