Comouter to school does not start sometimes beep codes wirh.

Similar Questions

• Satellite L650 does not start sometimes the Power button

  Sometimes when I press the button works / starting the fan of laptop and the laptop does not start.
  However when I press once again lights up.
  This does not depend on how long you keep holding the power button so that it starts.
  Anyone facing this problem.

  Thank you.

  What exactly do you mean by does not start?
  Is this means that the laptop has been closed or has been set to standby or hibernation mode?

  Are you able to see the Toshiba start screen when you switch on the device?
  If fans hang on this means that the laptop has been put under tension, and then you the OS should start to initialize.

  PS: usually it s no matter how long the power button could be pressed. Briefly press (1 sec) should turn on the laptop.
  But if you do not want to power OFF using the Notepad works / stop, then you will need to tap more long time 4 sec long but it is not recommended that this reset should be made only if the OS hang

• XP labors heavily and Will does not start (sometimes even in safe mode.) "And if it starts in the DM, it will freeze when I try to enter to change anything).

  I have a XP computer. During use, the power supply cord unplugged and computer is dead. When I tried to restart it, it will go to the blue screen with an error, go to the screen that asks if I want to start in safe mode. It does not start in normal mode, but it does get my wallpaper and stay there. Sometimes Windows XP screen and stay there. It really starts to make a lot of noise when one of these things happens. Don't know what to do. I have a XP OS disk Dell provided with the computer. Any ideas?

  Repair the Windows XP installation - you should have all your files intact.

  A repair install will replace the system files with the files on the XP CD used to the repair facility. It will leave your applications and settings intact, but Windows updates will have to be reapplied.

  http://michaelstevenstech.com/XPrepairinstall.htm

  Good luck.

• Satellite L500-164 does not start sometimes

  Heyas!

  For most laptop does not start on the first attempt. The Power LED lights up, the cooler and the HARD drive start (it looks that they rotate exactly once) and that's it. After a few seconds the laptop turns off again. There is no screen and the LED on the HARD drive also not would light up. If that happens, I start the laptop again and again. In most cases I need to start 2 - 3 times, but once I had to start 20 times until it worked.

  I also tried to start just with the power supply (I hope that's the right word for it, I'm German = D) and took the battery out of it, but the result was the same.

  But when the laptop finally started, it works without problem.

  Greetings,
  Daniel

  It is not easy to say what the problem is but it certainly is hardware related issue and your laptop must be verified by the authorized service partner Toshiba. With the help of diagnostic tools that they can find out why this happens.

  Here in this virtual world we can only speculate on the possible reasons.

• Tecra M10 - does not start only beeps

  My Tecra won't start. It sounds right. I checked the RAM and battery. I removed the keyboard, but without success.

  What is going on?

  Concerning

  Hello!

  Normally beep code at startup means that it s something wrong with the hardware (hardware malfunction).

  To identify what is the cause, you can search with Google. There are a few websites that shows what the beep code (depending on the BIOS you have).

  It could be the RAM, CPU, graphics card or something on the motherboard.

  But if your laptop is under warranty, you can contact an ASP. The repair should be free. ;)

  Good bye

• I have a Pavilion a6244n desktop computer. It does not, start just beeps long short 2 and 1. Beep codes HP

  identify the video card. He has a card of Nvidia GeForce 8300GS. Because I can not start the computer, can I safely replace the card with a GeForce 520 and will recognize it and start the computer? It is almost 5 years and I have already replaced the power supply. The computer worked very well all these years and think it can last from several others. Any suggestions? And thank you for taking the time to read this.

  I replaced the video card. New card is a GeForce GT 520 Galaxy. Everything is back to normal.

  Thanks for your advice.

• Satellite M40X-119 does not start - 4 beeps only

  Hello..

  I have Satellite M40X-119
  When I press the power button, the blue light comes on and the fan starts and then only 4 beeps
  (Beep - beep - beep - beep) intreval approximately 1 seconds. and then nothing happens!

  I replaced the RAM with a new one... but still the same

  any advise?

  Hello!

  As far as I know the Satellite M40X has a Phoenix BIOS.

  Phoenix BIOS, there is no code 1-1-1-1 (beep-beep-beep-beep).
  I think it is 1-1-2-1 or something else.
  Here is a list of the different beep codes:
  http://bioscentral.com/beepcodes/phoenixbeep.htm

  If you replaced the RAM, I think that there is something wrong with the CPU or the motherboard.

  Good bye

• CD / DVD DRIVE DOES NOT START? SAYS CODE 10

  I tired to uninstall the driver, and then restart the computer. It still does not work. When I go into the Device Manager, it says device will not start up, code.10. Is it possible to fix it? When I put a cd in, it sounds as if it will start, but doesn't.

  Try this.

  Remove the filters, uninstall the driver and then restart the computer and wait a few minutes and try again.

  No disc will eb read until this yellow device driver is first set.

  This method works on xp and vista. Try the link below.

  http://www.pchell.com/hardware/cd_drive_error_code_39.shtml

• After a custom Windows 7 installed on a Toshiba Satellite P105-S6084, my audio device does not start. Error code: this device cannot start. (Code 10)

  I got driver Conexant speakers on my laptop. I tried to find a device driver updates, but have had no luck. After being in Control Panel, hardware and audio, Device Manager, sound, video and game controllers, under that is high definition Audio Device with a yellow triangle and!.

  After a right click and update driver, it says that the driver is up-to-date. In addition, the error code says this device cannot start (Code 10)

  In addition, this seems to be a driver of Microsoft when the original driver was Toshiba/Conexant. I looked on the support Web site of Toshiba for a driver updated for my laptop and Windows 7.

  Any suggestions?

  Umesh P,.

  Thank you for answering my question. I don't know that this forum allows you to stay busy. Thank you for taking the time to answer my question.

  To sum up, I checked the Windows Audio and Windows Audio EndPoint Builder according to your instructions. Both were running as usual and start automatically, so it wasn't the issue.

  I then visited Fix It. On the web page, since I am under Windows 7, the instructions on the provided web page to access the control panel and through system and security, to try to resolve the problem to fix common computer problems.

  This process led me through the same re-setup of the device through Windows 7 driver that failed previously. Also because it has detected Windows 7, the web page would allow me to run the Fix It program.

  When I visited the Support from Toshiba web page you provided, I was unable to find a sound driver for Windows 7. After filtering through my computer on their web page, the nearest driver was for Vista.

  Take a chance, I downloaded it anyway. What has been the worst that could happen? It does not work? Well, I was there already. In any case, the installation worked and I now the audio again.

  Moreover, this is the link for the driver, for anything that might be in a similar situation I've been:

  driver_audio_conexant_25636A.exe

  -or-

  http://cdgenp01.CSD.Toshiba.com/content/support/downloads/driver_audio_conexant_25636A.exe

  Also, Conexant offers no direct audio driver support and ask you to check with the manufacturer, which in my case is Toshiba. Toshiba not currently has an audio driver Windows 7 for my particular Satellite phone. Since this is an older, they can't come out with an updated driver.

  But, since the audio driver Vista download works, it is now a non-issue.

  Thank you!

  Jay

• LR4 does not start 0xc000007b error code

  That's what I get when I try to open LR4. I have scanned for viruses. I went back I could go with restoration. I've deleted and reinstalled LR 2 times. My file backup get the same error code. Please help THANKS

  Based on the user comments and suggestions, we have updated our documentation on this subject with a few new solutions.

  http://helpx.Adobe.com/Lightroom/KB/error-Unable-start-correctly-0xc00007b.html

  We are locking this thread. If you have any other questions or still see the error, please continue the discussion on this thread: http://forums.adobe.com/message/4836005

• Acrobat (CS5) does not start, the error code 213:19

  My HD crashed.  I installed a new SSD and do a fresh install of Win7 Ultimate and all other software.

  Now, all CS5 programs give me error code 213:19

  Solve the 213:xx question and error Acrobat X and XI Acrobat license

• Satellite A80 121 does not start and make a beep after every 15 seconds

  Hello
  I have a Toshiba Satellite A80-121, and it won't work. Yesterday, worked all very well, but now it does not start.
  When I press the button the button normally has a blue color, then the screen stays black, no image at all, then the fan stops. Then I got a beep every 15 seconds.

  Can someone help me what is wrong?

  Thank you very much for your help

  Hello!

  It sounds like a hardware malfunction...
  If you have installed two RAM sticks try it with a single. Check it!

  I m not a technician to laptop but the problem may be with the motherboard, RAM or CPU, but this is my personal opinion.

  Good bye

• Satellite L300D - sometimes it takes forever to start or does not start

  Anyone able to help me?

  Sometimes it takes me an eternity to boot up my laptop and sometimes it does not start at all and I get sent to the start screen repair and which translates a unable to repair press ok to turn off the computer message. Whenever I get to start a laptop program always crashes with some answers takes about an hour.

  I used the recovery disks, I did when I was told to do, first used the labtop about 5 times so far. Whenever I've restored the system it works very well for about 1 hour until that I had to install the Windows updates.

  Anyone able to help me on this problem of mine?

  As already written boarder is not easy to say why this is happening. With own laptop preinstalled, obviously, everything works fine.

  So what you need to do is to disable the automatic update of Windows.
  Chose the option check for updates but let me choose when... and before enable update checking the list of all the available updates.
  Be sure only important updates will be installed. Do not install the updates defined as optional.

• HP Pavilion p6210pt desktop PC: after the installation of the new module of RAM PC does not start and continues to beep.

  Hello

  I am trying to upgrade the RAM on my PC. I don't know I got the correct specifications: 240 pin DDR3 PC3 - 10600 1333 MHz

  And it comes to envy, I bought, Kingston.

  The PC has 6 GB of RAM and a free slot, after I insert the new module on the free location corretly and press power, the PC does not start. It starts just a beep and the screen remains black.

  Don't know how better to explain this.

  If I take the new RAM all works normally. If I take old modules and just start by the new, the same thing happens, computer won't start not and just keeps to the beep. One of the Tweets is longer than the other, and then it repeats.

  Can anyone help please, it's just the motherboard it is too old or something?

  Thank you.

  See you soon.

  JO

  Hello

  Given that your PC works with the old DIMM modules and not the new dimm then you should contact Kingston for a cure.

• Get beeps when the computer starts and does not start

  Original title: Hello I have Mo Intel DG31PR & 2 GB Transcend RAM while the switch on it give beep 4 times and you would be in this case for several attempts does not start and it begins so please help and what is the problem?

  Nothing more to say

  Pravin Dave

  Hello PravinDave,

  If we get the beep codes and the machine will not move past, then we have hardware problems.

  You will need to contact your hardware manufacturer for more information on the beep codes and their meaning.

  Best regards

  Matthew_Ha