does not start the last bars of microsoft, PAGE_FAULT_IN_NONPAGED_AREA windows vista system

Please help send the laptop to repair costs more than the laptop... can I now an expensive paperweight? I remember well, here are the details:

-bsod STOP: 0 x 00000050 (0xE967206E, 0 x 0, 00000002 00000000, 0X836A8510)

-tried to restart, all options on F8 does not.

-No installation disc available as it was only an upgrade to vista (tried the upgrade disc, didn't work)

-recovery disk proven system of point of sale without success.

-every time we it reboot go to the black screen with the bar where the green bars run on the side but always goes back to bsod.

-System is an ACER EX4630-4126

-BSOD popped up all while surfing internet

-is the new software installed spybot s & d

-can not run memtest because it does not start up vista

-tried running the memory diagnostic tool but it shut down on me before completing the diagnosis

Any help would be greatly appreciated. I'm not much of a person of the laymens terms computer wouldn't greatly appreciated. Thank you.

Ainjel Hello,

This occurs generally early in the boot process. For example, the problem may occur shortly after the splash screen appears, and you will see a black screen with a moving progress bar. Specifically, this problem occurs generally when the system tries to load the i8042prt.sys driver. The problem only occurs in certain hardware configurations.

You need the installation disk so that you can try to perform a system restore which is the WinRE recovery environment and then once you are able to start, you can try to install the fix below:

Error message when you start a Windows Vista-based computer: "STOP: 0 x 00000050 PAGE_FAULT_IN_NONPAGED_AREA".

http://support.Microsoft.com/kb/939720

Do a restore from WinRE system:

http://Windows.Microsoft.com/en-us/Windows-Vista/what-are-the-system-recovery-options-in-Windows-Vista

Kind regards

Savan Microsoft technical support.

Tags: Windows

Similar Questions

  • Try to install and give the message that it does not support the BONES - and it says unsupported windows vista and we have windows 7

    Try to install and give the message that it does not support the BONES - and it says unsupported windows vista and we have windows 7

    Try to force the lightroom Installer to run in Windows 7 mode:

    Right-click on the Setup file and select Properties option.

    Then click on the Compatibility tab.

    The value of the Windows 7 operating system and check.

  • My acer aspire one does not start. the scrolling windows screen, then screen turns off. logon appears and resets, sys

    My acer aspire one does not start. the scrolling windows screen, then screen turns off. but after a long time (45mins) the login screen appears and d sysytem restarts. I have a multi boot with 2 installations of xp, and this happens with both bones. not able to access my sys to bak - up also. all f8 options were considered, but no use.

    I have some bad sectors on d: (have total 3 drive partitions c:, d:, e: with xp on c: and e :))
    the sys wud show a blue screen and reboot when certain file wud b accessible on d:... now the sys cannot start all... pls help...

    Hi Srimotu,

    ·         You get an error message or an error code?

    ·         Have you made changes on the computer before this problem?

    Follow these methods.

    Method 1: Try starting it in last known good configuration.

    http://support.Microsoft.com/kb/307852

    Method 2: Try to start in safe mode.

    http://support.Microsoft.com/kb/315222

    If you are able to boot into safe mode, try a clean boot.

    http://support.Microsoft.com/kb/310353

    Note: After the clean boot for troubleshooting, return the computer to a Normal startupmode.

    Method 3: Disconnect external devices such as printer, scanner, etc. and try to start.

    Also disable automatic restart in the event of system failure

    http://support.Microsoft.com/kb/307973

  • Firefox Pei does not start the Profile Manager. Firefox version: 50.0

    Firefox Pei does not start the Profile Manager. Firefox version: 50.0

    Have you tried; Type of topic: profiles in the address bar.

  • Mozilla, your last update does not include the last cert of intermediaries of extended validation from Verisign, Symantec class 3 EV SSL CA - G2, please fix ASAP

    Your last update of firefox, Mozilla does not include the last cert of intermediaries of extended validation from Verisign, Symantec class 3 EV SSL CA - G2, please fix ASAP

    Firefox never includes the intermediate certificates.
    It is the responsibility of a server to include all the intermediate certificate required to make it possible to build a certificate chain that ends with a trusted root certificate embedded.

    Note that Firefox automatically records the intermediate certificates that servers send in certificates for future use Manager (they appear labelled as 'Software security device' in the References tab).
    If a server does not send a complete certificate chain then you get an untrusted error when Firefox has stored missing intermediate certificates to visit a server in the past that a send it, but you get an untrusted error if this intermediate certificate is not yet registered.

  • Equium A100-338 does not start the OS Vista - update Bios?

    Hi guys,.

    My laptop (a few months) decided to die and was told by tech support that it might be because of the BIOS. The problem is that the computer does not start the operating system (Vista) and the update of the BIOS available only is the version of windows. Are there any other mirror to get the traditional update or even a way to convert a the update the BIOS from Windows startup disk?

    Thank you

    Hello

    If you can see that one version of BIOS on Toshiba page then only one version exists and is available!

    > The problem is that the computer does not start the Vista operating system
    I don t think that BIOS could be responsible for this problem.

    You must first provide more info on this problem!
    The laptop goes to home Toshiba screen? Have you tried to recover the laptop with the Toshiba Recovery CD?

    Please provide details!

  • I updated windows 10-level, he wiped my photoshop. downloaded 11 elements, it does not start the installation

    Hello

    I need help! I use photoshop a lot. I started at level 10 windows and it wiped my photoshop. I downloaded again, it does not start the installation. I tried redownloadeding and it says it can not extract it because all the parts aren't there. Would love to be happy again with photoshop.

    Hi Mark,

    You can download Photoshop elements by using the following link: Download Photoshop Elements | 14, 13, 12, 11, 10

    Be sure to download the two files available for download.

    Kind regards
    Rahul

  • I installed the new version of LIghtroom (2015) compared to the creative clouds.  Creative cloud said that I installed the new version.  However, the shortcut icon that has been installed does not start the new version.  Also, I went to the link propertie

    I installed the new version of LIghtroom (2015) compared to the creative clouds.  Creative cloud said that I installed the new version.  However, the shortcut icon that has been installed does not start the new version.  I also went on the link properties itself, but without success in starting.  How to launch the new version?

    Thank you, toinimj59.  I did this part and the installation is complete (there is apparently not earlier--included an acceptance of the general terms and conditions...)

    Solution 1: Disconnect from the desktop creative cloud app and reconnect

    1. Disconnect from and to, the app Office creative Cloud click here for instructions to return in
    2. Launch of Lightroom.
  • When the Active Server is shut down normally, the passive server does not start the service

    Hi friends,

    I have a question for the vCenter heartbeat,

    When the Active Server is shut down normally, the passive server does not start the service.

    Is this normal?

    Thank you.

    He starts the services on the passive server because the correct judgment still leaves the server active as being the "main".

    Stop all services of it properly. And after it comes back online replication starts as before, so that no service must be started on both servers. (in this case that you will have questions)

    Please note that on a server computer, you have 2 possibilities to "stopping down": the BONE and the option of status and control of the server Vcenter Heartbeat

    See you soon!

  • CS6 does not start, the trial version will open instead of the real version

    After reinstalling my system of time machine cs6 does not start, the trial opens instead. Serial number is not accepted. What should do?

    Hi MFGTG,

    I checked the serial number and found that there is a problem with the serial number.

    I advise you to please call our 800-443-8158 support or start the conversation by clicking the below link

    http://helpx.Adobe.com/contact.html

    Thank you

    Kapil

  • My computer does not start, the alarm tone the aa from the hard drive, then back to the top and is very slow...

    My Pc does not start at times, especially first time in the morning, an alarm tone sounds, then it tries to start, Frost pattern on the screen... or black at all. then after pressing the new button could start up of normal, it will be very slow. Help, please

    Hi WolfgangKlinger,

    ·         Did you do changes on the computer before the show?

    ·         You're able to boot in safe mode?

    ·         You get the error message?

    Follow these methods.

    Method 1: Disconnect all external devices except the keyboard and mouse.

    Method 2: Start your computer in last known good configurations.

    How to start your computer by using last good known Windows XP Configuration

    http://support.Microsoft.com/kb/307852

    Applies to:

    • Microsoft Windows XP Home Edition
    • Microsoft Windows XP Professional

    Method 3: Follow these steps:

    Step 1: Start the computer in safe mode and check if the problem persists.

    A description of the options to start in Windows XP Mode

    http://support.Microsoft.com/kb/315222

    Step 2: If the problem does not still in safe mode, perform a clean boot to see if there is no conflict of software like clean boot helps you eliminate software conflicts.

    How to configure Windows XP to start in a "clean boot" State

    http://support.Microsoft.com/kb/310353

    Note: After completing the steps in the clean boot troubleshooting, follow the section How to configure Windows to use a Normal startup state of the link to return the computer to a Normal startupmode.

    After the clean boot used to resolve the problem, you can follow these steps to configure Windows XP to start normally.

    (a) click Start, run.

    (b) type msconfigand click OK.

    (c) the System Configuration Utility dialog box appears.

    (d) click the general tab, click Normal startup - load all services and device drivers and then click OK.

    (e) when you are prompted, click on restart to restart the computer.

    Method 4: Follow the steps in the article.

    Advanced Troubleshooting for General startup problems in Windows XP

    http://support.Microsoft.com/kb/308041

    For reference:

    How to make a computer faster: 6 ways to speed up your PC

    http://www.Microsoft.com/atwork/maintenance/speed.aspx

  • Satellite L450D - 13 X does not start the system - PXE - E61: Media test failure

    Hello

    I turned on my laptop after only a day and it will not load
    As a first step, he said start the system restart or start normally,

    I chose startup repair, but it does not complete the repair.
    It now comes with a repetitive screen with PXE - E63: media test failure, check cable of
    PXE - MOF: exit ROM PXE

    I tried Googling the answer and go into the BIOS menu and to the section boot but I can't seem to change anything at work.

    There are, and exclamation mark in front of what I think is my hard drive on the screen

    ! HDD1/SSD1 TOSHIBA MK2555GSX-(S2)
    CD/DVD HL - DT - ST DVDRAM GT20N-(S4)
    FLOPPY DRIVE
    LAN

    I have nothing in the disk drive and I don't have a recovery disk.

    Any help would be appreciated

    Thanx

    Leon

    Hello

    For me, it looks like a malfunction of the HARD drive and so the BIOS can not find a bootable device and goes to the last possible bootable option which is LAN.

    The exclamation mark in front of the HARD drive indicates that there is a problem with the HARD drive so I think you need to replace the HARD drive and you need to reinstall the system.

    PS: What laptop do you have exactly?

  • Tecra M2 does not start - the power light AC blinking orange

    Someone at - it a list of codes for the Tecra M2 flash.
    My friend has a laptop that does not start at the top. the AC power LED flashes orange. a long, short, long, short, long, short, long, short.

    I checked the battery and reinstall the RAM.
    Any IDE?

    Hello

    I agree with go.
    The ASP would be able to tell what means error.

    Usually means short and 1 long: 0
    So the error must be: 1010 1010
    Due to the last significant bit (LSB), to be read by behind:
    So it now means: * 0101 0101 binary *-> it must be converted to hexadecimal-> * 55 Hex *.

    Then, you will get a hex code.
    But unfortunately, I m not very well which could mean this code

    So ask ASP for help!

  • Firefox does not start, the Profile Manager is not available

    Firefox worked, then update it does not start. I tried all the fixes; However, the Profile Manager is not accessible or even present in the execution file. I unintalled and reinstalled several times, but I still can't get it to work. There is no Windows or Norton firewall block so I do not understand. What can I do? I want to use Firefox because it's the best browser; but now I'm forced to use Oscar. It's not terrible, but I prefer the features I've had with Firefox

    I had upgraded to the latest version; but the thought of demotion to the version which worked perfectly. In the end, I had to defrag, do a registry clean and optimization of performance of PC, but for the upgrade launched. So, I'm happy to say that I reply to this post with my Firefox browser. Thank you very much for your help. If all goes well, I won't have problems.
    DoubleD52

  • The app on the market does not start, the page is white with some Blue Cross top left.

    The market does not start even on the internet.

    Hey Karin!

    I'm sorry you had to go through the frustration that you presented this nuisance. I am very pleased to hear that these steps solved your problem. =)

    Enjoy new applications you find on the market of Firefox. Here are a few suggestions that I find very useful, to help you get started:

    Have a wonderful day and please feel free to post new threads in the SUMO forums, if you have other questions about your Firefox OS device.

    Thank you

    -Ralph

Maybe you are looking for