dv6500 due to flat battery and no ac adapter output power of

Similar Questions

• Equium A100: How to manage the battery and the AC adapter

  Advice please...

  I use my laptop (A100) mainly as a desktop replacement. What should we do. the power supply cord. Leave it permanently, but don't damage the battery and the means of the laptop is permantly on standby, or constantly updated to recharge the battery every two hours, which is not very practical.

  First laptop, so probably stupid question.

  Hello

  There are different meanings to this topic.

  I manage like this:
  I work on the current, and sometimes only with the battery until it is almost empty. Then I charge the battery while he was still working on current alternative.

  After awhile of use, each battery life to shorten.

  Good bye

• Satellite A210 - battery and no boot

  Hello!

  I used my about 4 years by Satellite A210BX as usual two days ago. The next day, I wanted to start the computer, but it does not start. Just brought an error message indicating "dead battery"... So I searched the Toshiba site and found that it might be the RTC battery for the time and date settings. The laptop battery was fully charged during the last night, but it still does not boot to the top. Just a black screen and you can hear the fan running. But nothing else. No BIOS, no letters on the screen, just nothing :-( If the laptop is loaded via a regular power outlet in the front of the case three LEDS are on (the cable, the SDNA circle battery smbolshe). All three symbols are blue, flashing light.

  The advice I can do now? I found an article on the battery to charge for a few hours when the laptop is on RTC.
  I will try that today. AY of other things I can do now.

  Thank you very much
  Florian

  Hey,.

  I doubt that this has something to do with the RTC battery. This battery can be charged if the laptop is connected to an AC adapter for 24 hours, but this should be mentioned in the user manual

  Can you start the laptop with AC/DC adapter only?

  If this is not the case try removing the battery and the AC adapter for an hour and then test it again.

  In the worst case, it s a hardware malfunction and it would need you will need to contact the technicians of laptop for help :(

• Satellite P200 - 17 c PSPB6E - battery and charger delivers

  Hello

  I was wondering if anyone can help.

  I had my laptop Satellite P200 - 17 c PSPB6E for about 2 years. For the last 6 months the battery and the AC adapter have been gradually getting worse.

  The adapter is now very loose and I need to hold it with one hand while using the laptop. The same battery with the AC charger in place does not increase (it shows 0% available plugged in, load). If the AC adapter slips, the laptop is dead and I need to recharge.

  Essentially, it seems the only thing keeping the laptop on, is the adapter (which itself is very loose).

  I need to know whether a battery or a problem with the AC adapter. I had only the laptop for a short period and would not have expected problems early.

  Thank you

  Baker

  Hello

  In my opinion, that your laptop is quite old (2 years) and these things can happen, mate.

  But I think you need new batteries and AC adapter or motherboard. If the battery doesn't charge with adapter connected the case is clear: the battery is faulty because she will not be charged.

  Regarding the connection of the adapter problem AC/DC it's hard to say because theoretically, it could also be a problem with the socket on the motherboard. This is why you should ask a technician for laptop. The technician can tell you what the problem is.

  Welcome them

• Tecra A7: Is it ok to remove the battery and store it outside of the laptop?

  I took out the battery of Tecra A7 my wife so that it does not load and offload unnecessarily (laptop works exclusively on the sector).

  However, I read on the Internet that to take out the battery can sometimes be dangerous to its electronic components: namely, electronics no longer works correctly and the battery is considered to place in Notepad, as 'dead', even if this isn't really so.

  This can happen with my Toshiba battery, too?

  I did the same thing with my older Satellite P20. I put t see any problem here. But it is recommended to charge the battery and run the laptop on battery only from time to time. Charge the battery up and he sometimes empty. It's good for each rechargeable battery.

  I put t know where you found this info but believe me you can remove the battery and laptop can run on power only.

• Life of the battery and laptop computer games

  HP Support Assistant shows that my quality of 1201-tx battery g6 is 86%. My laptop is now 15 months old.
  So is this beneficial? Or I damaged my battery?

  Is it a good idea to play games after getting 100% charged battery and the AC adapter is plugged? It will damage battery?

  After battery get 100% load, what laptop works on CA only or battery discharge and recharge at the same time, i.e. the laptop running on battery power?

  Thank you.

  
  ____________________________
  | Please hit Kudos, if I help you! |
  | |
  | WILL |
  |___________________________|

  Sure!

  Adhering to the recommendations made by the suppliers of battery cells and best practices, the laptop does not charge the battery when the battery is fully charged to 100%. Once the battery is fully charged to 100%, the load little "terminate" is defined, preventing charging the battery. The battery does not erase the cool bit "Cancel" until after the fuel gauge drops below 94%. Once the battery gauge drops below 94% fuel, the 'fresh' bit is set and the battery starts to charge with the AC adapter plugged into the laptop. If the AC adapter is disconnected between levels of 94% to 100%, "little fee" will not be scheduled and the laptop will charge is no longer the battery.

• is it safe to run my compaq presario cq62 without the battery and the power cord attached?

  My laptop told me that my battery should replace... I have to keep my power cord in now all the time coz my battery poer only changed as 5 minutes... is it safe out of my battery and run the laptop the power cord?

  Hello:

  Yes, you can do it.

  Is it a matter of having a lighter weight?

  You can also run the power cord with the battery installed.

  Sometimes the battery is so bad that you have to remove and the laptop will not work with the battery removed and plugged power cord.

• Satellite U 300 - battery and sound problems

  Hi, I was wondering if anyone has had similar problems as me:
  My laptop is only two years, but last year his work only intermittently. I get messages saying that the driver is not installed, until one day he will decide that the driver is installed after all and works very well. Until the next time it stops working. There seems no rhyme or reason for it. I gave up trying to reinstall the driver, because I know that (possibly) the sound will come back without intervention from myself.

  My second problem may be connected - I have problems every now and then close the laptop. I try to put in mode 'sleep', but is not complete the process, and the blue light comes on. When I then open the cover, very often, the screen stays black and I have to turn off the machine and turn it on again the force again.

  Then recently, I noticed a sharp drop in the battery life (less than an hour). He also annoyingly started losing all power and cut until the indicator showed all the usual warnings of low power.

  Anyone know if these problems can be linked, and whether they can be fixed? A new battery will fix it? To be honest, he arrived at a point where I think to buy another laptop do since they are really starting to get frustrating!

  Thank you very much

  Gooday,

  I also own a U300 I bought about 2 years ago now, I had no problem with the sound but didn't have any other problems with my 1-2 months battery life after life - 20-30 min. I just baught a new battery and it is promising, I just did the first load and it lasted long, however the windows said it had 0% remaining, but I pulled out another 30-45 minutes the dough until it went flat. If you look in your event log do you get the message

  ": The embedded controller (EC) has failed in the specified time-out." This may indicate that there is an error in the EC hardware or firmware or BIOS is accessing the EC incorrectly. You should check with the manufacturer of your computer for an updated BIOS. In some cases, this error may cause the computer to function properly. »

  It is listed under ACPI in the event log.

  see you soon

  Lee.

• Lenovo IdeaPad Y560 does not load, battery and charger are OK

  My 3 year old Lenovo Y560 laptop i5 does not load when I turn on with the battery in it everything works normally, but when I plug in charger nothing happens. I checked the charger and it works great, its output is stable 20V. When I remove the battery and try to power the laptop with charger only, LED indicators light up for half a second and nothing happened. With closed laptop battery and charger plugged in, battery light flashes orange, about 3 seconds 10, without the battery even after several hours. I had no problem with jack for charging so far, so I think that is not due to a problem. I tried something with the power for 30 seconds button now and it did not work. Does anyone have the same problem or at least an idea of how to solve this problem?

  It seems that your charger is broken despite the supply voltage. My guess what it cannot deliver sufficient power. Try to find someone with the same charger (voltage, socket and polarity must be the same. There may be several amperes/watt) and try to use it. If you do not know someone who might have a charger as it try stores electronics or services.

• Satellite A200 - battery and a fan failure

  My Satellite A200 is a little more than a year and has not stopped the charge battery.

  While watching over portable saw fan does not no more, although no effect on performance when it is connected to the House.

  Two probs are fan cannot be hardware failure?

  And is it connected to the failure of batt?

  For me, it is not easy to say that the two issues are related somehow. You can check the functionality of fan if the laptop works on AC power only. Remove the battery and check it out.

  Also try changing the profile of power and method to see if it has any influence on the cooling fan feature.
  What about the battery? If the battery has stopped loading it may be due to the battery itself or perhaps electronic power supply on the motherboard, but if you want to have an exact answer to this the laptop must be controlled by authorized service provider?

  The warranty is still valid?

• The battery and power on my Acer Flash!

  Hello!  Battery lights and power of my laptop Acer Aspire One to blink when I insert my charger.  It will load for about a minute, then starts flashing... which does not load, or loads slowly.  I guess it's a battery problem, since I just bought a new charger a few weeks ago, which was working fine until today!  I bought from a friend, so I don't have the appropriate manual or instructions on how to identify and solve the problem.  I suppose I could ask to Google, but I'd rather have my info from a person ;)

  Thank you very much!!
  Mirkwood76

  Hello

  Welcome to the Microsoft Community Forums.

  Looks like the power lights flashes when you connect the charger.

  This problem usually occurs due to damage to the batteries, you can check these steps.

  a. plug the computer into a different outlet, and see

  b. replace the battery

  c. Board of power or in the laptop charger is bad. It is recommended that the laptop be maintained or repaired.

  You can also take out the battery and remove all external devices connected to the laptop. Keep the computer idle for 5-10 minutes and re - insert all the materials.

  Hope this information helps. Get back to us if you have more queries about Windows.

• BlackBerry smartphone how to restart the Blackberry Torch 9810 without remove the battery and reinsert again?

  Hello

  Can anyone help on this issue

  I want to restart the unit without removing the battery and reinsert again.

  Y at - it an option

  Yes.  It's easier with your blowtorch laid flat on a desk (etc.)

  On the QWERTY keyboard, press and hold ALT, and then press right SHIFT and DELETE keys at the same time. Until the red light appears, then release all keys.  This restarts your device and works on all devices with a standard QWERTY keyboard.  There are also applications 3rd party who will accomplish the same thing, but I think it works for me.  I hope this helps. ~ ecm

• Battery and Wifi info not displayed after updating IOS 10

  After upgrading to IOS 10 I have more information at the top of my home screen line. He comes to the line with WiFi, battery, and other info. I see it if I open an application, only some however. This status being lost, it is difficult to look at the life of the battery.

  How do I turn it back on?

  If it cannot be enabled by the user, then Apple needs to bring him back.

  David

  Hello! You can activate the in your settings. Go to battery and select on the percentage. The other options that are displayed on this bar, you can also turn on in general settings. Make sure that the WIFI is enabled in the settings. I had this happen before. After trying your settings, if you still do not see the bar with all the status restart the device. If it still does not work, you can try to recover the device on iTunes. The last resort would be to call the Apple support. I'll try to fix it in the settings that the lines may be busy.

• I just replaced my battery and it says 'battery of Service '? The battery is new. I need to reset something?

  I just replaced my battery and it says 'battery of Service '? The battery is new. I need to reset something?

  Try resetting the SMC http://support.apple.com/kb/ht3964

• How to fix stuck battery and automatic when restart updated ios 9.3.3

  How to fix stuck battery and automatic when restart updated ios 9.3.3

  Lambung writes:

  How to fix stuck battery and automatic when restart updated ios 9.3.3

  What do you mean battery stuck?

  the basic troubleshooting steps are: reboot, reset, restore from a backup or restore as a new.