error 303_will will not boot from the optical drive W / re disc

Similar Questions

• Z575 will not boot from the hard drive or restore DVD

  Need help on a laptop Z575 age of 2 years that immediately after an automatic update of windows, will not start either from the hard disk or restore DVDs (blue screen). Does not start in safe mode, not booting from a rescue of third party DVD. Attempt to start, it will show you the ability to start the Startup Repair tool. Repair shows that it is unable to fix with the detail following problem error messages:
  Signature of the problem 1: 6.1.7600.16385
  Signature of problem 2: 6.1.7600.16385
  Signature of the problem 3: unknown
  Signature of the 4:21200196 problem
  Signature problem 5: auto failover
  Signature of the problem 6:7
  Signature of the 7 problem: bad driver
  OS version: 6.1.7601.2.1.0.256.1

  Normally think that the hard drive has failed or that windows update caused a software problem, but the inability to boot from any restore disk that makes me think that there is another serious problem with the hardware of the laptop.

  Any help would be appreciated. THX

  Additional note: when you try to boot from a restore disc, blue screen, error message:
  Stop: 0x0000007B (0xF78DA640, 0xC0000034, 0x00000000, 0x00000000)
  It is a hardware failure that cannot be restarted soft.

  I also removed the hard drive and RAM, reinstalled and rebooted, no change.

  Additional note: I was able to access the hard drive with a recovery of old program, focused on the (SpaceFM) ram charged through the DVD player. Hard drive data appears intact. Still does not start from the hard disk or a DVD of windows system.

  Thank you. Rather than buying a 4 GB or more large key USB comes from put this into hard drive replacement. Installed correctly, boots very well now. No other error of the optical drive... and no explanation I can see, but that's it.

  Unless something else pops up we'll just call cela a HARD drive failed after 2 years of common use. Thanks again.

• Reinstall vista again HARD drive now PC don't can not boot from the DVD drive I can copy vista external hard disk drive, and then install on the laptop

  Duplicate info wire - running kill disk, vista disappeared and my laptop does not see my dvd/cd drive and I can't reinstall vista OS because of this problem

  Have to reinstall vista on a new HARD drive now PC can not boot from the DVD drive I can copy vista external hard disk drive, and then install on the laptop?

  The DVD player worked before HARD drive went bad now, it won't work.

  And I just replaced the HARD drive, but now cannot load an operating system that he...

  Help, please...

  Hi dynamitenews

   

  1. are you able to boot to the desktop?
  2. what happens when you try to start the computer?

   

  You must have the DVD drive to start the computer using the disk, you cannot use the external hard drive to do the same thing.

  Also I suggest you to make sure you have defined the start as CD/DVD-Rom as the first choice option in the BIOS. See below the help link-
  http://Windows.Microsoft.com/en-us/Windows7/BIOS-frequently-asked-questions

  If nothing is done, then you can contact the manufacturer support for assistance on setting up the correct boot sequence and check.
  
  BIOS WARNING-
  Change (CMOS) BIOS/complementary metal oxide semiconductor settings can cause serious problems that may prevent your computer from starting properly. Microsoft cannot guarantee that problems resulting from the configuration of the BIOS/CMOS settings can be solved. Changes to settings are at your own risk.

   

  I hope this helps.

• NB100 will not boot from the XP CD in the external USB CD/DVD drive

  I try to install XP Home in my NB100
  The netbook still refuses to boot from the XP CD. It's just not more
  Returns the current operating system (Ubuntu) or give the error "Could not find NTLDR" dreaded.
  And yet - it will boot from an Ubuntu Live CD disk perfectly fine, AND
  If I connect this external hard drive on my computer Windows 7, (another Toshiba
  Portable satellite) that the machine starts quite successfully since the XP CD
  in the same external drive!

  Can anyone throw any light on what is happening on Earth on?

  Hello

  There are various reasons why this error message:
  In most cases this error because the laptop is trying to boot from a HARD drive or flash drive that is not configured correctly. Maybe the drive is not bootable or not compatible.

  It would also be possible that some sectors on the HARD disk, HARD drive failures are corrupt or BIOS is damaged. NTLDR error messages may also appear if the master boot record is damaged.

  In your case I recommend that you format the first HARD drive before booting from the hard drive CD7DVD external using Win XP CD.

  By the way: you must add SATA driver to CD Win XP using nLite.
  The SATA driver is placed on the European driver Toshiba page in the Intel Storage Manager

  The SATA driver is needed to recognize the HDD by Win XP!

• Boot from the optical drive on a Lenovo H430

  I try to start on a DVD of Win7, but I am unable to set the boot priority to any type of optical drive in the BIOS. The BIOS boot devices menu is the same. I know that I can use the USB tool, but also, it does not work. Y at - it a patch of Lenovo BIOS that I can ask, or another solution to be able to boot to the optical drive?

  In fact, I realized myself. There was an option in the output menu that allowed for it. Thank you for your help.

• Windows 7 for Lenovo G50-70 - the computer will not boot from the CD

  Hello world

  I hope that someone here will be able to help

  I bought a new laptop with Windows 8.1. I want to install Windows 7 on that I know well because I can't use the new windows. I changed the settings in the BIOS to get the machine to boot from the CD, but it won't be fair. I also tried to restore the system to boot from the CD, but it installs just the Windows pre-installed, new instead. Also, I can't access the CD from the drive while all my other computers are capable of (what is strange)

  Can someone help, please?

  See you soon

  PS. : I can turn on the computer through the small "boot botton" on the side and select the DVD drive to boot from. But this is not followed by the message "Press any key to boot from CD" and the computer starts just W8 yet;

  I contacted customer service and followed your advice. They refused to help him on the ground that there nothing wrong with the machine in their opinion, and since I wanted to change operating system. All preinstalled spyprogrammes Lenovo has been erased with this downgrade. So far, I've owned a laptop computer brand new and expensive for a year I used only to waste my time, trying to make it work, that was not why I bought it in the first place. What a RIP-OFF!

• HP Pavilion p7-1414 will not boot from the CD

  Hello

  I recently bought your desktop HP Pavilion p7 1414, I am trying to boot from a CD to reinstall Windows 8 - I put the CD to start first in the BIOS, but when I restart the computer and I have the CD, "press any key to boot from the CD" is not displayed.  It starts just directly to the computer HARD disk in Windows to connect.

  I have 64-bit Windows 8. 6 GB of RAM and a terabyte of HARD drive space.  I'm looking to reinstall Windows 8 for a new start.  Any ideas why it won't boot from the CD?

  Very happy!

  Hello:

  You must go into the BIOS and enable the legacy Mode and disable secure boot.

• Tecra M3 PTM30A will not boot from the cd to reinstall windows

  Hi all

  Totally new here and I have a question. I replaced the hard drive in the laptop, the old man died.
  I set the bios to boot from the cd. He reads the Windows XP cd for a minute then jump to trying to boot on the network adapter.

  Do I need to have the cd of recovery or must it be able to boot from a plain old XP cd?
  If it can boot from a normal cd is the stuffed ROM or am I missing something?

  Thanks in advance to anyone who can help you.

  Hello

  > I replaced the hard drive in the laptop, the old man died

  Your new hard drive is recognized by the Bios?

  > Do I need to have the cd of recovery or must it be able to boot from a plain old XP cd?

  You can use a recovery (if available) disk or Windows disk copy. In the Bios, you must set the Cd/DVD-ROM as 1st boot device and press F10 save and exit. Turn it back on. Thus, your computer you should start the installation of the Cd drive.

• M91p will not boot from the CD

  I try to install a new SSD in my M91p, but when I press Enter for the splash screen, change the boot order have only Boot from CD rom, then reboot, I get a "error 1962: OS not found" message.

  I checked the DVD rom is functional by returning to the old HARD drive and use it.

  What Miss me?

  
  

• Stops on his own computer and will not boot from the CD

  someone entered cmd and did something to my computer, now, the computer shuts itself, what can I do I tried to reinstall windows and the computer does not start from cd?

  * original title - someone entered cmd and did something to my computer, now, the computer shuts itself, what can I do I tried to reinstall windows and the computer does not start from cd? *

  At the startup/power on you should see at the bottom of the screen either F2 or DELETE, go to Setup/Bios or F12 for the Boot Menu

  Go to your Bios/Setup, or the Boot Menu at startup and change the Boot order to make the DVD/CD drive 1st in the boot order, then reboot with the disk in the drive.

  See you soon.

  Mick Murphy - Microsoft partner

• Re: satellite A300 screen turns off after the toshiba logo, will not boot from the CD/DVD

  Hello, I have this problem with Toshiba satellite A300.

  I deleted several files and folders of my drives C and E. To restart the computer, it only shows the Toshiba logo then a slightly gray white screen on a thorough inspection. Whenever I press CRL + ALT + DELETE, the computer restarts and behaves in the same way.

  I tried to use an external monitor, but there is no difference. The tent to start using a CD/DVD, same behaviour occurs, it does not start and screen remains blank after the Toshiba logo, I tried even to change g the order of boot, but in vain.

  What could happen?
  Thanks in advance.

  Hello

  It seems that you deleted system files and Windows no longer starts. Have you tried to restore the disk image factory settings or hard drive recovery? Or do copy the Windows installation... It is easier to reinstall rather fix the problem.

• R3000 Presario will not boot from the cd after installation of windows 7

  Hello

  I have an old Presario R3000, someone updated to windows 7, has a few problems, including the cd player read don't not bootable disc, because I would like to install Vista instead, any suggestions on how to solve this problem, thanks in advance.

  chefey aka David

  Hi Futoji

  Portable office, dismissed plugged DVD and voila, it worked. I have an installation disc Windows 7 Starter and installed as I thought it would be better for! GB of memory, was not bothered with it runs, so Vista, installed fine. Some drivers are missing, sound and player card, as it's XP, so no drivers HP, I have a fixed front sound, means add files in a folder of the directory, will have to google search it again once, thank you very much for your advice, which fixed the problem, I am not too bad for a surfer of money. I know the numbers of the missing drivers, it's just a case of locaing, some of the download sites are very confused. Once agai thanks.

  David

• Windows 8 HP laptop Pavilion will not boot from the cd?

  Hi all

  I have a Windows 8 HP Pavilion laptop. I forgot the password of my account, but I wasn't worried because I had a recovery disc. However, even with the cd in the laptop, I directed to the login page every time. I want the cd to run the place and recover my account! I have enabled the legacy in BIOS and disable secure startup, and I even changed my boot order to put the boot first CD. None of this works well. Can someone help me? I really want to access my laptop soon.

  Thank you

  Alice

  Immediately after switching on the laptop, press the ESC key to get a menu. Then press F9 boot options. Use the arrow key to move down and select/highlight the CD/DVD drive, and then press the Enter key.

• can not boot from the hard drive

  On an iMac 21.5 ", OS 10.10.5 Yosemite:

  Deleted and a 500 GB external hard drive well prepared for use as a bootable hard drive. Installed OS 10.10.4 Download Yosemite on the Apple Store. When you select it as the drive hard start, it only offers itself as a restore for Time Machine option. Cannot start it up like a normal hard drive for other purposes. You want to use as a test drive for the software.

  During the installation of Yosemite, the installation by a loop repeatedly to infinity in 24 minutes each iteration to complete. I finally chose to leave the Setup process.

  What is going on?

  Have you created a USB Installer to install Yosemite? Or, have you tried to install after it finished downloading?

  Create an installer for OS X - Apple support bootable

• Satellite L300-1AS - error PXE - boot error - will not boot from USB

  Startup error - error PXE-L300 1AS - will not boot from USB

  I recently bought a new HD to replace the original that my laptop takes an hour to load.

  I put the new drive hard at in the BIOS setting, I chose to boot from USB... USB is recognized as it appears on the screen of the BIOS. I disabled the LAN option as it gives me PXE error... I think that the USB files are not read. as I handed the old HD and attached to boot from USB but it just goes to the start screen.

  I thought that perhaps I bought the wrong HD, but a new appeared on the BIOS setting... I'm a bit confused and would appreciate it if someone could point me in the right direction...

  Any help or advice will be appreciated.

  Thanks in advance.
  Abul

  New HARD drive has nothing to do with it. Problem must be your USB key.
  In your ad you didn t wrote what is on it, and we don t know if USB can operate as boot device or not.

  I put t know what OS you want to install right now but original recovery DVDs or use Microsoft installation disc and install Win7 32 bit. I ve installed on friends L300 and it works perfectly.