Hardware diagnostics

Similar Questions

• Sprout of HP: HP PC Hardware Diagnostics UEFI install faulty

  5 times the HP Support Assistant attempted to update the "HP PC Hardware Diagnostics UEFI". Whenever he fails. After each attempt, I made a stop and then tried again.

  After two attempts to install from HP software web page I got it to install correctly. Then I got the HP Support Assistant to do another scan and all is good.

• HP Pavilion 030ea-b: Hardware Diagnostics failure error

  Hello

  I ran HP PC Hardware Diagnostics UEFI. Details [disk 1]:

  Smart Check: spent

  Long DST: failure

  Failure ID: 0LG55D-000837-X87T1A - 618P 03

  Please could someone tell me what is failure and how do I correct?

  Thank you very much

  Hi @23 - B030ea,.
  
  Welcome to the Forums of HP Support!  I understand that tests your cam drive upward with an error when you run the UEFI. I'm happy to give you a helping hand with this.

  I checked the ID failed you posted and it gave me the error code SMART Drive from 305. Now if your hard drive still works for you, I highly recommend to make a backup of all the data that is important to you as soon as possible. A SMART test drive is usually a predictor of drive failure. It could happen today or in a few months, but rather than to risk of losing everything, it is best to take precautions.

  See also this paper: HP laptops - Hard Drive failure errors: failure Imminent, Smart, BIOHD, HD535, etc.

  Once your data is safely backed up, you should probably look at a replacement hard drive.

  Please let me know if it works for you and if it does not solve your problem, please mark this message as a solution. Bravo would be appreciated as well.

• Pavillion dv6 notebook PC: P PC Hardware Diagnostics UEFI - test failure

  HP PC Hardware Diagnostics UEFI - Wide system Test

  Failure ID: 6FH3UT-5AF85H-XD002K-60W103
  
  Product ID: LG266PA #ABG

  The hard drive gave error failure - ATA, model type is serial ST9500325AS [personal information]

  WHAT should happen?

  Also battery check: primary - calibration required (21) - How to calibrate?

  And I don't understand why they provide HP PC Hardware Diagnostics UEFI - if their information so that it does not exist.

  The hard drive has failed and needs to be replaced. If you are still in warranty HP will send a replacement. If this is not the case, a laptop SATA hard detail can be used. Just be sure to get one of at least equal quality of the original in order to use recovery media to install the drivers/software/Windows on the new hard drive. It may be big, but not small ability more. For example if you have a 500 GB hard drive you can use a 750 GB hard drive, but not a 320 GB hard drive.

  Calibration of the battery:

  http://support.HP.com/us-en/product/HP-Pavilion-DV6-3200-entertainment-notebook-PC-series/4308480/model/5051632/document/c00821536#AbT3

• Uninstalling hp pc hardware diagnostics uefi

  Hi, I have HP pavilion n010ek, I installed the pc hardware diagnostics uefi since section hp drivers in this site, everything worked, and a score is made as in the picture (HP_TOOLS f), unless I want to uninstall it but I couldn't find in the Control Panel, how can I uninstall the hp pc hardware diagnostics uefi?

  Hello

  You can delete the HP_TOOLS partition as follows.

  Hold down the Windows key and press R.  Type diskmgmt.msc and press ENTER.

  In the lower pane (chart) showing the partitions, right-click the HP_TOOLS partition and select delete the Volume.

  Once completed, this leaves an entry for "unallocated space".

  You can then right-click on the C partition and select Extend Volume to add to the C partition unallocated space.

  Kind regards

  DP - K

• Report of hardware diagnostics that enabled a single core in core 2 machine

  HP P6370t desktop

  Windows 7 64 bit

  Processor Intel core I3 530 CPU @2.93 Ghz

  performance of HP 6.0.5297.34 diagnostic tools

  The system ran diagnostics of material for a "monthly" race

  He noted "there are 2 hearts in the processor and only 1 core is enabled.

  Several questions (at least):

  Are there conditions reported error of 'false' with HP hardware diagnostics on this issue?

  How would I go about correcting this problem?

  Thank you

  Welcome to the jimbauerv forums,

  I did some research for you, and I came across a thread the guy had exactly the same problem, but he had 4 cores (3 of which somereason were not active).

  He showed that by removing the CMOS battery and put back in after 2-5 minutes. And the computer showed he had all 4 Active cores...

  Another user who has sent by clicking Start--> Run--> type MSCONFIG--> Boot--> Advanced Options

  If it is checked, uncheck 'Number of processors'. If not check it out and in the drop down list select 4 (according to the number of cores you have) and you're done.

  I hope this helps

• HP pc hardware diagnostics uefi

  I currently own a HP 700-074 model computer HP PC Diagnostics UEFI version 5.2.4.0 (rev.1). I check the support site HP monthly for driver and hardware updates and noticed an update for this program.

  This may seem like I'm a little picky, but nobody knows what kind of corrections are available in the hardware of PC HP update the Diagnostics UEFI 5.3.4.0 (Rev. 1) published on 20/12/2013? What is a patch security, minor features/corrections or something else? I guess my question is what is a mandatory update or a recommended update? This program comes with a scoring change that documents what is updated? I'm pretty tired of updating my main hard drive (I don't want to screw up the UEFI boot sector and having to reinstall Windows 8) or Flash the BIOS, especially if its only for the minor bug fixes I can tolerate. All answers are appreciated. Thank you all for your time.

  Hi boinc127, I don't have the log of changes from the last update, but if you have no special numbers its better to not be affected in the present case because it has a prittey complicated procedure to get this installed update, Adi.

• Boots only to the Startup Repair. Hardware diagnostics found bad blocks on the hard disk. is it possible to move data outside of Windows?

  Original title: Hi, I have a Dell Inspiron 1545 laptop.  Recently, he stopped working and would go only to the screen that asks if you want to run the Startup Repair tool.

  Of course whenever I launch it, it goes back to this screen.  Check the diagnostics through the F12 boot, I had three error codes: 0F00:1344, 0244 and 1 A 44.  These were all on the same three blocks.  The message was impossible to read, replace the drive.  I'm really the most responsible for recover my photos, documents, etc. and have an external hard drive.  Is it possible to do so, even if Windows (Vista in this case) will not start?

  Hello

  You can try these methods

  Data recovery

  1. remove the hard drive and it slave in another computer

  2 buy or borrow a USB disk drive hard put in yout case then plug it into another computer and read the hard drive like this

  3. try Knoppix

  http://www.Knopper.NET/Knoppix/index-en.html

  BUT this method depends on your hardware in the computer that failed

  If this does not work, you may need to contact the data recovery specialists

• Hardware diagnostics: "SMART short Self Test - failed" and "targeted read Test Failed.

  Original title: "SMART short Self Test - failed" and "targeted read Test Failed", all the patches?

  When using PC checkup of Dell I get the following errors; during the analysis of the material. "SMART short self-test - failed" and "targeted read Test Failed", all the patches?

  Hello Duane,

  Teke section of the Web site that speaks of similar problem.

  http://forums.techguy.org/hardware/906455-smart-short-self-test-fail.html

  The problem is with the hardware and you can get in touch with Dell computers.

• Pavilion 17-f010us: Hardware Diagnostics

  I have a Pavilion 17-f010us running Windows 10. I want to run a diagnostic equipment on it, but can't seem to figure out how. On older models running Windows 7 and below, I used to be asked to press a specail over powering (ESC or F10, etc.) who could take me to a boot menu where I could enter the BIOS or run a diag utility. Can someone tell me how I would do it on this one? Thank you in advance.

  Hello

  Stop of the laptop.

  Tap away at the esc you key start Notepad to open the Start Menu.  From there you should be able to select the Menu of diagnosis ( f2 ).

  Kind regards

  DP - K

• After the automatic running Hardware Diagnostics, I lost my sound. That happened 3 years ago, but can not remember what to activate the sound.

  After an automatic run "Material of Tests of diagnosis" and at the output of the program, I lost the sound on the computer. This happened to me 3 years ago when I had just bought computer and I took it to the Greek Squad. It was just something that was muted and I don't remember how to get to the appropriate window to correct.

  I fixed it myself and I don't know how. Thank you for allowing me to post here. Best wishes.

• WiFi is not connecting

  I have a mini end of 2014. When I went to use it yesterday for the first time in a few days, the wifi was not connected. When I tried to connect, it says it can't connect to my router and you want to run diagnostics, she did, but went to the writing of the file when finished. I deleted the network in the network settings. In the wifi connect icon he registered the network with a signal strong. Asked the password when I tried to connect, then he said he could not connect and you want to run diagnostics. Other devices use the same router wired and wireless, so I doubt that it is the router. The signal is fine, the computer is in a loft with router down under and it is no problem to this place for years. I restarted with hardware diagnostics and he couldn't find anything. Any ideas? I can do almost anything with the generated report? I don't see anything in Apple help to know what to do with it.

  You can turn off and on the router?

  Yo there an error like incorrect password?

• 10.11.5 crashes completely after you disable wifi on old Macbook Pro

  My Macbook Pro 17 "(fin 2007) installed 10.11.5 without problems." Ran smooth and fast, and then frozen after turning off wifi. System tried to reboot itself. Could not restart, crashes when starting upwards. Had to do a clean install. Unfortunately I turned off wifi once more after re-install-same problem. Another gel, the system does not restart, no matter what I tried. No keyboard shortcut works, only cmd R gives an option to re - install the entire system. Does anyone else have this problem after turning off wifi?

  I would either reinstall El Capitan report to the current system or erase the drive altogether and install a new copy of the El Capitan. Implies that it is not a hardware problem. You did check works hardware - run a hardware test or check the system information to determine if the Wi - Fi card work.

  1. upekkha-AppleHardwareTest · GitHub
  2. Apple Hardware Test - iMac (mid 2007) and later models
  3. Processor Intel Macs - using Apple Hardware Test

  How to run Apple Hardware Test on Mac Intel

  To check your hardware, use hardware diagnostics.  Start the OS X Installer disk that originally shipped with your computer.  After the ring, press in and hold the "D" button until it appears the diagnostic screen.  Run extended diagnostics several times during an hour or so to allow possible errors to be detected.  If you receive error messages note them down.  You will need this information if you take the computer home.

  Reinstall El Capitan without erasing the drive

  Please make sure that you back up.

  1. Restart the computer. Immediately after that the chime hold down the command and R until the Utility Menu appears.
  2. Select disk utility, then click on the continue button.
  3. Select the withdrawal (usually Macintosh HD) entry of the volume of the list to one side.
  4. Click first aid icon in the toolbar. Wait until the button is active, then click it.
  5. Quit disk utility and re-enter the Utility Menu.
  6. Select Reinstall OS X and click on the continue button.

  Also, see this tip for user: basic steps for the OS X upgrade.

  Install Yosemite or El Capitan, from scratch

  Backup if possible before proceeding.

  1. Restart the computer. Immediately after the chime hold down the command and R buttons until the Apple logo appears. When the Utility Menu appears:
  2. Select utility disc in the Menu Utility, then click the continue button.
  3. When loading disk utility, select the volume (entered into withdrawal, usually Macintosh HD) from the list of devices.
  4. Click Delete in the main window of disk utility. A panel will fall.
  5. Define the type of Format Mac OS extended (journaled).
  6. Click on the apply button, then wait for the done button to activate and click on it.
  7. Quit disk utility and re-enter the Utility Menu.
  8. Select reinstall OS X and click on the continue button.

  [Permission to use any part of the foregoing has been granted by khati, exclusively, to theratter.]

• Pavilion g602305tx: portable optical drive failure

  When I insert a disc windows says pls insert the disc and then automatically eject the tray.

  -DVD burner gets power, but not reads any disk.hp g6 2305tx-like pavilion, I need to replace the drive or it's a motherboard problem?

  where can I buy original hp spare parts in bangladesh?

  Use uefi HP PC Hardware Diagnostics utility to test the optical drive. My HP Omen 15 product ready to version 5.7.2.0 installed. You should maybe download and update your version of HP PC Hardware Diagnostics to get one that will test the optical drive. www.hp.com/go/techcenter/PCDiags

  Press the power button and then press the ESC key to access the boot menu. Now, press the F2 key to enter the diagnosis. Click the tests of components and then click on the optical drive. If the test shows the drive as failure you know it's time to replace it.

  Do a web search on Google or Bing with "hp pavilion g6-2305tx optical drive replacement"as key words to find a seller online.

• Spectrum of HP 13-3004tu Ultrabook: video playback choppy after you install the latest video drivers

  I upgraded my video drivers (Intel high definition (HD) Graphics Driver 10.18.15.4248 place) for my Ultrabook 13-3004tu of the spectrum and after reading so online video (YouTube, videos on the sites of integrated information ect) play jerky and the sound is distorted. He was going well until I downloaded the new driver.

  Hello @kiwifruit28,

  Welcome to the HP Forums!

  I have read your message and understand that after updating the graphics driver, your spectrum HP 13 - 3004tu Ultrabook there are problems with the video playback. Here is a document to help solve this problem. Here is a link to HP hardware Diagnostics where you can test your hardware for portable computers. Alternatively, you can do a System Restore to a point before the end of the update of the graphics driver.

  Thank you.

  If this post helped you, feel free to click on the thumbs up!