How to remove the front rear of the Tecra S1 PT831A to check cable and power?

Hello

I need to "check the cables and power," following the Seatools for test back and start-up message 'failure to support, check cable PXE - E61'. I also have a message for the CHKDSK using the XP Pro CD, saying after 26% that "the volumn appears to contain one or more unrecoverable problems".

Remove all screws B6 or what else - to remove the back cover for "check cable"?

Startup by default, without failure, then to BSOD Mode screen whatever the choice is taken, the BSOD is too short a period to read the message, and there is no option in the choice of Safe Mode to disable "Restart in case of failure".

I removed and reinserted the RAM and HARD drive without change to issue.

Hope this makes sense and someone can give advice.

Concerning

Wagga

Hello

Each laptop has in the list of all bootable devices BIOS. If none of them can be used the last of them, LAN port, is checked, and then you'll see this message PXE - E61.
If the problem may be your HARD drive.

First check HARD drive. Enter the BIOS and set it to default settings. Restart the laptop and check if the HARD drive is recognized and registered properly in the BIOS settings. If so he has no problem with connectors.

I recommend get you the new HARD drive for testing purposes. Put the new HARD drive and try to install the OS by using the original Toshiba recovery disc.
Please post comments.

Tags: Toshiba

Similar Questions

  • Please tell me how to remove the microsoft Narrator, it drives me crazy and I can't find an icon or the program to remove it.

    Microsoft Narrator

    Hello

    How to activate the Narrator or disable in Vista
    http://www.Vistax64.com/tutorials/124575-Narrator-turn-off.html

    I hope this helps.
    Rob - bicycle - Mark Twain said it is good.

  • I run xp coffeehouse get an icon remove the device safely. I check it and it is for a card broadcom netlink gigabit ethernet which can not be deleted

    I run xp family on a computer laptop hp compaq 6510 b.  The broadcom netlink gigabit ethernet adapter is part of my motherboard.  Why do it and can I get rid of him?

    Hello

    1 have had any changes made to the computer before the show?

    Restore the system to the date and time when the computer was working fine.

    http://support.Microsoft.com/kb/306084

    If this message has always been to present its likely that the Ethernet card that is built into the computer is connected to the motherboard using a USB connection (this is common in laptops). If this is the case, there is nothing that can be done to remove the message that the deactivation of the Ethernet card, but this will prevent you from being able to use wired Internet/network connections.

  • How to remove the fake xp pro on disk 0 and use xp real House on disc 1

    %windir%\System32 shows H:WINDOWS that I want to remove or uninstall.

    The default OS: [boot loader]
    Timeout = 1
    default = multi (0) disk (0) rdisk (0) partition (1) \WINDOWS
    [operating systems]
    "multi (0) disk (0) rdisk (0) partition (1) \WINDOWS="Microsoft Windows XP Professional "/ noexecute = optin/fastdetect

    Has a genuine version of XP Home on my C:. Also. I have the product key.

    My guess would be to spend %windir%, shift + delete old OS, I don't know really and clearly needing instructions on how, if it's the solution.

    Oh, it would be appropriate to make known this computer was a gift and I was told just to put my old hard drive in the new...

    Also, if I change the 'Time' to display the list of 1 second longer operating systems could I just decide what operating system to use?

    Hi ioyg,
     
     
    You may want to format the partition containing the counterfeit copy of Windows XP.
     
    See this link for more information to do the same thing:
     
  • How to remove the old pieces of previously uninstalled McAfee and Norton?

    I have a model office gateway 5310 (x 86) Windows XP Home Edition with Service Pack 3. I have all the Windows updates and you are using Internet Explorer version 8 as browser. Norton and McAfee are preinstalled on the machine (in 2007). They have been uninstalled via the control panel years. I read recently that they leave traces behind which may adversely affect performance (which I am trying to improve). I don't have Revo Uninstaller and CCleaner (but not for registry problems - I use regedit). Any suggestions on really get this (and other) junk out of the system would be great. Thank you

    Norton

    https://www-secure.Symantec.com/Norton-support/JSP/help-solutions.jsp?LG=English&CT=United+States&product=home&version=current&PVID=f-home&docid=kb20080710133834EN_EndUserProfile_en_us

    McAfee

    http://service.McAfee.com/FAQDocument.aspx?ID=TS101331

    UTC/GMT is 02:11 Sunday, October 14, 2012

  • How to remove the internal contacts of Web site reports and remittances form?

    Hello

    There used to be an article about it previously under the support of old, but I can't find them more

    I would therefore delete the activities of people internally at my company of all Web site traffic reports and also to form presentations as it makes it difficult to work on the actual performance.

    For the test, we can use our gmail accounts personal, which will further enhance the figuration, but should be much less that is currently happening.

    Has anyone done this before?

    Thank you

    Richard

    Actually found something I could test for web traffic...

    Eloqua 9 is in the 'Setup' > 'Management' > then under the "System Management" tab > in the left menu, expand "IP filters" and select "visitors to be filtered from analytical."

  • How to remove the rear work plan in photoshop CS6

    Hello

    I'm trying to find how to remove the rear work plan in photoshop CS6?

    I always looking for the "preference", but I can't find the solution.

    I really prefer to have no background as the CS5 because I always work with "drag & drop" and now, it is impossible to see my office.

    Capture d’écran 2012-03-28 à 11.15.15.png

    Thank you

    Concerning

    You could ask on the cs6 forum, but I think thre an option under window or view to remove the frame of the application.

    http://forums.Adobe.com/community/Labs/photoshopcs6?view=discussions&start=0

    I have a question if you don't mind. What resolution is your screen?

  • How to remove the download button located next to my home button? I continue to by clicking on it when I want the House and it's annoying.

    How to remove the download button located next to my home button?

    You can use customization feature to move it to a less irritating location. I suggest the bar the module if you keep this poster.

    Start customizing with one of these, and then drag the arrow to a new location, or in the dialog box to remove all the bars:

    • Right click on a zone empty of the tab bar > customize
    • Press the Alt key > menu view > toolbars > customize

    You will notice that some combined controls separate in the view to customize. If you put something between them, they will not be able to recombine. (For example, if you separate stop and reload or put something between front/rear and area URL.)

  • Satellite A30 - how to remove the hard drive

    Hi, new here...

    Can someone tell me how to remove the hard drive in my Tosh A30...

    Thank you
    captainp

    Hi Tim,.

    The hard drive on your SA30 is in the optical drive, but slide the optical drive out of its housing (undo the F5 marked screws on the bottom of the laptop).

    The hard drive will be visible fixed with four Phillips head screws that need to be removed (two on each side of the hard drive. With the removed screws, gently slide the hard drive toward the front of the laptop to disconnect its connector and carefully pull it out of its Bay.

    HTH

  • How to remove the keyboard on Satellite L850?

    Nobody here knows how to remove the keyboard on a L850 or can point me in the direction of the repair?
    Older models had a band at the top that does this is very simple, but this model seems to be sealed in.

    Hello

    Fix locks around the keyboard. So to remove it, you will need to insert your finger into the left hold of lid and push keyboard corner, so let corner keyboard appears.
    As far as I know there are 14 latches on the lid of the keyboard:
    -6 down,
    -1 lock on the right and 1 bolt left side
    -6 latches in front.

  • How to remove the laptop battery?

    Hello!

    My question seems a little odd, isn't it? I bought a HP Pavilion dv7-1285DX two months ago. I don't know how to remove the battery from the laptop! Sounds crazy, I use HP laptop for 5 years, but I could not understand how the hell should I take the battery from this new guy! Could someone please tell me what to do. If you know how to do it please show it with a photo or something, or set up a website or video or something.
    Thank you and all comments are appreciated.

    Siar

    Message edited by Siar on 13/10/2009 02:26

    Hello

    Follow these steps: -.

    BE VERY CAREFUL!

    Before you begin any Setup or uninstall procedure:

    1 shut down the computer. If you do not know if the

    computer is turned off or in hibernation, turn on the computer.

    and then stop it through the operating system.

    2. disconnect all the external devices connected to the computer.

    3. disconnect the power cord.

    4. remove the battery by following these steps:

    a. turn the computer upside down with the front

    towards you.

    b. drag and hold the 1 battery release latch to the left.

    (Disengage the front edge of the battery of)

    the computer).

    c. lift the front edge of the battery 2 and bring her back.

    d. remove the battery.

     

    Reverse the above procedure to install the battery.

  • How to remove the DV6-7029WM flange to replace the LCD

    For the life of me I can't understand how to remove the front panel. I got the top removed, but the lower part will not move around the hinges. It seems to be not overlooked, but at this point I'am not sure. I removed the front screens and I didn't have any problems, but it baffled me.

    Thanks for any help.

    Hello

    It is the last link:

    http://h10032.www1.HP.com/CTG/manual/c03582006.PDF

    I hope this helps.

  • How to remove the lid of the scanner on the Photosmart 5520?

    Manual to insist that the lid of the scanner of the Photosmart 5520 (model #CX042A) can be removed.

    When I try however, it does seem it Peel, as if a force is applied over it feels like it will break.

    I contacted HP technical support per session chat, and after about half an hour the technician finally dropped and referred me to the store where I bought it.  I went to Office Max, where I bought and asked them.  They were also puzzled with a right to the camera in front of us, they could not figure out how to remove the cover.  They were also afraid to break if they tried to remove it.

    Are there instructions indicating how to remove it so that the lid or the hinge is not destroyed in the process?

    The manual is not wrong.  You can remove the cover on a 5110.  I was just trying to do the right way the first time.  This post told me how to do it.  As far as I know, the only things that have changed since the 5510-5520 are the firmware and internal control.  The shell of the printer must be roughly the same.

  • How to remove the box empty?

    Hello! How are you all? Can someone tell me how to remove the empty area in a picture? For example I circle. If I save it in jpeg/png format and then will display a white space that is infact empty area if the background is set to transparent. I can choose this circle with the magic wand tool and by doing the opposite, I can select area located in front of it. is anyway to remove this empty transparent space so that any image size is the single circle?

    JPG doesn't support transparency, so when a zone is empty it fills the background color.

    PNG save transparency but then you must make sure that you are save in this format.

    Using the magic wand to target and remove the unwanted area works perfectly, but you still need once, be sure to save it as a PNG image.

  • Studio XPS 8100 - how to remove the cover of the modular Bay?

    I would remove the plastic cover of the modular Bay on the front of my venerable Studio XPS 8100 so I can install a USB 3.0 3.5 inch hub instead. However, I can't find instructions for it. In fact, I can't find any description of how to use the modular Bay.

    To start: how to remove the cover plastic modular Bay?

    Also: If someone has found the instructions on how to insert a player or another device in the modular Bay, I would be glad to know where I can find them.

    Hello rdunnil

    I took off the glasses and I saw how the metal plate is attached. Applying light pressure with a screwdriver flat head will do the job. Exchange on USB 2.0 ports would also work: I found directions for the removed from their metal case. Whatever it is, I'm all set. Thank you for pushing me in the right direction. It is much more valuable than the useless, generic link you gave me.

Maybe you are looking for

  • should I be connected to the internet

    desktop computer is not connected to the internet

  • Change of hard disk

    I have a Pavilion Eite E-570f and you want to replace the hard drive with a faster I have not done that before, but am computer enough to know to check before I shoot things out LOL I intend to remove the old drive and connect the new drive exactly a

  • How to referee a "delta t" chart.

    Hello Sorry, but my English is not good. I'm data acquisition serial port, but my data has just the amplitude (y axis). I know that the delta t is 2 milliseconds. How to officiate from delta t to a graphic? Can someone help me?

  • HP Compaq 8100 Elite CMT: Need power supply 400w replacement.

    I ordered a refurbished HP Compaq 8100 Elite CMT Quad Core i7-860 2.80 GHz 8 GB RAM 1 TB HARD drive And I ordered a gtx geforce 650 need a 400w power supply. I don't know on what power I need command that will fit in this. Can someone help me?

  • How can I use the same e-mail for PC and laptop program?

    Hi, I recently bought a laptop and would be able to open, read, send and store my emails, exactly as I do on my PC. We use windows mail. I can do currently using webmail, but I want to be able to do in exactly in the same way as on the PC. Any ideas