HP5510 all-in-one ink jet: administrator

Similar Questions

• Inkjet 3630: HELP WITH the ALL IN ONE ink JET PRINTER 3630

  MY INKJET 3630 don't WILL NOT MOVE CARRIAGE ON PRINTER to ENABLE ME to CHANGE of INK CARTRIDGES so OBVIOUSLY WILL NOT PRINT or SCAN A DOCUMENT can NOT SEE or FIND ANY OBSTRUCTIONS AFFECTING the PRINTER - CAN someone please HELP me I AM at a LOSS WHAT to DO

  Hi @She1,

  Thank you for joining the HP Forums!

  I noticed your post that your printer HP 3630 will not move to the transport of ink. I'm happy to help you!

  Please try the steps in this jam of transport guide, a "E3" display of the error (jam carriage)and let me know what happens!

  If this, or one of the posts on this thread, helped you to solve the problem, please click on accept as Solution on the message. To show you 'like', or that they are grateful for my post, please click the thumbs upwards below. If there is anything else I can do to help, please don't forget to let me know!

  Hope this guide helps!

• REPLACEMENT OF THE CARTRIDGE TO A DESKJET 3050 ALL IN ONE INK JET

  When the replacement cartridges are needed, do I have to replace the two black and color at the same time even if the color has been used least?

  Hi clibay,

  No, you can replace just the cartridge that is empty.

• Scan button disabled HP5510 all-in - one Win7

  HP5510 All-in-One
  Win7
  
  Please give me a link to the thing that I have to get the Scan key on the Control Panel before work? I tried just about everything I could find here and I must be missing something, I don't know what. Impossible to install from the CD original, says I need administrator rights (even if I'm using setup.exe as an administrator) and I don't have the right OS for the disc.  Cannot find the complete software recommended here. Tried printing HP and doctor Scan with no joy (says I need all the stuff that is on the CD!). Tried to install the framework of Solutions HP too. No joy. He always asks the Solutions Center on the CD.
  
  I need this scan button. My camera is not right next to my PC and have to go back from the PC to the scanner is ridiculous.
  
  If there is no way to get the scan button for more work, why not put to work (other than what is obvious and that is to make us buy another device)?

  I found my solution.  I installed the device on an old PC I had in stock, who always had WINXP top.

• OfficeJet 6500 E709n: Failure of 6500 all in one ink system

  Recently inherited a 6500 all in one and installed this AM.

  Everything was going fine until I had to print a test page.

  Error: Ink system failure.

  The manual says disconnect power and reconnect after 10 seconds.  This did not help.

  When I ask to print, it says printing the error message and then it makes a grinding noise - in that order.

  Then an error message appears on my pc computer screen.

  This printer has been moved from one House to the other - it would have something to do with the message or the squeaking noise?

  Any suggestions?

  Thank you for your suggestions.

  I had 2 problems: ink system failure and grinding.

  The solution you provided workd partially - that is to say, I can print now but...

  First of all, concerning the failure of the system of ink - the operating manual supplied with the machine to stop the machine, unplug from wall, waiit 10 sec and reconnect.

  I tried and it doesn't work.

  The ground ' n you provided (from HP for the SAME model as my machine) gave another way to reset the machine - turning machine on, unplug the machine, unplug the unit from wall, wait 15 sec, wall plug, machine to reconnect.  In that order.

  Similar, yet very different and IT WORKED.

  So thanks for that.

  But the machine still makes a grinding noise that lasts about 3 seconds.

  I press print, paper flow, paper comes out of the printer, and then there's grinding hard.

  Back then a series of sounds as if something has been reset.

  All very very different from my previous 960C that is turned on when I printed and do not grind or reset of sounds.

  Clues?

• HP deskjet 3520 all-in-one: ink HP 564 Setup

  I plug a new printer on 22/04/2016, HP deskjet 3520 all-in - one. but this printer is not equipped with ink of installation, which is used to initiate the printer.

  I returned it to the store, but the seller said it's a product of view shown on the plate, doesn't come only not with ink of the installation. because it is sold in promotion, he refused to give me the refund.

  I tried to ask for assistance from the centre to support hp several times, but they do not meet me.

  Very funny.

  So, how can I solve this problem? where to buy configuration HP 564 ink?

  I buy a new printer, but I can't use it.

  Hi @.

  Sorry to hear about your experience as well at the store, then with the help of HP.

  I will send you a private message (check the blue envelope right)

  Cheers, Ciara

• 3636 Deskjet all-in-One: ink cartridge is Deskjet 3636 configuration necessary?

  The black cartridge for installation provided with my printer all-in-one Deskjet 3636 recently bought is defective. My printer does not recognize the cartridge. I followed all the troubleshooting steps, including turning on/off the printer and the cleaning cartridge, however, nothing works. What the configuration required to install cartridge? The color cartridge is recognized and the printer is connected wireless. The only issue I'm having is the black cartridge. Could I buy a regular black ink cartridge and use it for the first impression?

  Yes, you must use cartridges for initial Setup configuration and operation of the printer. The best way to solve this problem is to put the printer in return for Exchange.

• HP PSC 1510 all-in-one: ink cartridge for HP PSC 1510 all-in-ONE - no dealers found

  Hello

  I am looking for black HP 92 (C9362W), but your body just says there are no resellers found. Is - this saying that I can not find this cartridge can? If Yes, what ink cartridge can use HP PSC 1510 all-in-one model?

  Thank you

  Erika

  Hello

  Please try (Canada):

  http://www.shopbot.ca/pp-HP-C9362WC-compatible-price-133571.html

  http://www.shopbot.ca/pp-HP-C9362WC-HP-price-35399.html

  http://www.myprintershop.ca/HP-c9362w-92-ink-inkjet-cartridge-black.html

  Kind regards.

• HP Photosmart C309 - a printer feeds all in one ink

  I had printers HP all-in-one for years and have been very happy with them so far. I don't do a lot of printing, and my last printer, the HP Deskjet 2510 would keep ink for 6 months. He was a shot-color cartridge and a black cartridge. My current printer, the C309-a, feeding ink. It has 4 individual color cartridges and a black photo cartridge. I haven't printed 50 sheets with black ink and the cartridge is almost empty. On 2 February, I changed all the cartridges and with the small amount of printing I did I think that all cartridges must be more than half full.

  I read that this type printer goes through a process to prepare for printing using ink so I only turn the printer on when I need to print, rather than let on and he prepares to print every day when I turn on my laptop.

  What can be done to save the ink, which is very expensive? If this issue cannot be solved, I'll have to look at printers other than HP, when I buy my next.

  Thank you for your help.

  I suggest to leave the printer, it will enter a low power state automatically.  Make sure that you always have the printer plugged in to an outlet.  If you use an external switch (e.g. a Director or switch the power jack) out of ink will be used each time you start.

  The printer will give an early warning that the ink becomes low, the cartridges do not need to be replaced until print quality begins to suffer.  Ink warning is intended to give notice if you have the time to have a replacement in hand.

  Some other suggestions:

  • Do not run unnecessary cleaning cycles.  Cleaning cycles are rarely necessary and use ink.
    
  • Use draft mode printing of common materials.  Draft mode uses about half Normal or best mode ink.
  • If printing on plain paper using "Plain paper" parameters in the selection of paper.
  • Not your case, but if you did a lot of printing XL cartridges have a better cost per page value.

• C 3175 all in one ink levels

  I have an all in one printer which worked well on an old top desktop (windows XP). My new Lap top is windows 7. driver installed fine, but I cannot get the ink levels more! Be glad of any help?

  Hi bazandmaz,

  I understand that you now the printer installed and running on a Windows 7 computer, but you cannot check ink levels. I can't help but wonder if you use the base rather than the full features software driver and the driver.

  This download includes the HP Photosmart Software Suite and driver

  Name of the file:
  AIO_CDA_NonNet_Full_Win_WW_130_140.exe [1/1, 290.27 M]

  If you have already the full feature software and driver, you should be able to find the HP Solution Center and check ink levels it.

  If this does not resolve the problem, please use the HP print and Scan doctor. HP printing and doctor Scan is a free utility (tool) that allows to quickly solve common printing, scanning and connectivity problems. HP recommends that you run the tool every time that you need to solve a problem.

  Printing and scanning doctor diagnoses and resolves common printing, scanning and connectivity problems, including:

• HP Photosmart Plus all-in-One: ink cartridge problems

  I have a model B209.  Last week, I decided that I would take the four staples of cartridgesto used, because they have a recycling program.  I wanted to only buy black ink, so I bought 2 separate packages of the 564 Black.  Has opened a package and installed as usual.  All I keep seeing is problem Catrridge of ink: the following ink cartridges seems to be missing or damaged.  see status screen on your computer for more details.  The question is # 1 status display has not yet shown on my computer. #2 I can't even to other options on the Touchscrren of the printer.  I have read and watched videos of people who give directions and instructions on cleaning the print heads.  I tried to remove the printhead, soaking in the water, leaving back dry and enforcement.  I did these things repeatedly.  When I soak the print head in the water, the water changes color.  I hope that I have accidentally hit the wrong part of print head when I removed it from the printer.  Please help, because it's my only other option when I can't access wifi to my portable device used for the printing of tickets, Groupons, etc..  Thank you!

  Your printer requres all 4 cartridges to be present, that is why the printer tells you that the cartridges are missing can may not last.

  Some newer model printers, which use the cartridges with integrated print heads, can operate with only the black cartridge only.

  But the B209, separated print head and ink cartridges, if not all the cartridges are installed, the print head does not work.

• E-all-in-one S: Jet Office Office Jet 6800 6800 series; What and where is a print head; How should I do?

  Office Jet series 6800 printhead problem watch what and where is a print head. How to fix it.

  The print head is where the ink comes out, it is connected to the assembly that contains the ink cartridges.  The print head is not usable on series Officejet 6800 user, you will need to contact HP for a replacement as described in the document here.

• want to 4500 all-in-one: ink carrage groaned when he moves to or from home

  It seems that ink carragee groaned when he moves from the starting position to start printing.  When printing there is no unusual noises, but when it's over print and moves to the House he moans again.

  Hi there @BillW1,

  Please come back to me and try the suggested troubleshooting and research throughout the printer for obstructions. As the noise continues, I would recommend next contacting HP directly to ask if you qualify for a replacement unit. I'll leave the details of the HP below.

  Step 1. Open the link: www.hp.com/contacthp/
  Step 2. Enter the product number or select Auto detection
  Step 3. Scroll up to "still need help? Fill out the form to select your contact options.
  Step 4. Scroll down and click on: contact HP options - click Get phone number
   
  File number and phone number are displayed.

  All the best,

• 7310xi all-in-One: ink cartridge leak on bottom of 7310xi printer all in one

  Printing on paper is wavy line down the entire page. A self-test shows lines in black and tricolor bars. I cleaned the contacts on the cartridges as directed. Carts and springs for the cartridges look ok. What does not seem normal is the accumulation of ink on the bottom of the printer directly under the ink cartridges. Of course, I had a cartridge leaking at some point. The pile of ink stand high enough and is probably interfere with something. Sometimes after that it prints a page, I hear a noise like metal on metal grinding. Then the message transport jam error will appear. When I remove the rear door of the printer there nothing wrong apparently. It's ok for me to use metal tongs to remove the pile of ink while the printer is on (since it is the only way you can reach the battery), or is it a good way to electrocute me?

• brand new officejet pro 8600 e - all - in - one, ink system failure msg, msg lack cartridge...

  told to turn off the printer after ink system failure msg, but then gives a cartridge can fail to msg and said that the printer can be damaged if turned off.

  The printer is brand new. I print a dozen test pages fine... haven't touched inks since installed first. When I open the cartridge access door, inks/heads move to the opening, so I can't reinstall the cartridges. Help!

  The document here can help.  You'll need temporarily ignore the message about not to turn off the printer...