Is it safe to plug/unplug power while race by Satellite A100-451

Similar Questions

• Cursor duplicate in Word while scrolling on Satellite A100-159

  I have a satellite A100-159. I have the following problem: in Word the cursor happens sometimes while scrolling. This means that during the scrolling I see two sliders that is 'left behind' and a real cursor (when I use PG. prev or PAGE down or box that disappears the cursor "left behind"). I already reinstalled Word and in other applications it doesn't seem to be a problem (but I have to say that I use the Word most, with large documents).

  Any ideas to solve the problem?

  Best regards, Eddy

  I think that happens because of fast scrolling of large, long word documents.
  Unfortunately, I think it's a matter of Word and there is nothing to do.
  But you suggested that happens sometimes, and only in Word so I think that it s a big problem.

• PartNumber need to power supply of the Satellite A100

  I have an Equium A100-338, PSAAQE 006008AV model number. Power supply is PA3469E-1AC3. On Toshiba website element is not found. What is the correct/replacement/charger to power?

  Hello

  What do you want exactly? The you´ve of modelnumber displayed is correct both what the problem? If you want to buy a new one, you can check this site for example:

  http://www.freefixit.NET/ukstore/index.php?CATID=31517

  Otherwise, you can also try the PA3378E 3AC3 modelnumber.

  Welcome them

• Memory problem while improving my Satellite A100-181

  Hi all

  I want to upgrade RAM on my Satellite A100-181, 512 MB is a bit limited...
  I ordered a 1 GB dimm noname a month before, put in it, with the 512dimm. As a result, we have only 1 GB recognized, and the laptop does not start if the 512 module is not mounted.

  I thought it was a bad memory module and ordered a kit 2 GB of crucial memory modules, which come paired and guaranteed by Crucial to be compatible with the toshiba A100-181.
  Result is the same: with 2 DIMMS inserted, the PC does not start: just turn on and off and still... With only 1 dimm, it does not start unless the 512 original module is attached to it... And once again, only 1 GB is recognized (915456Ko in the bios, but I guess that video reserved memory is not counted here)

  Is that what anyone has ever heard a problem / solution to this issue?

  Thank you very much.

  It is typical behavior when you use incompatible modules.
  Your laptop can handle with 2 GB max and compatible with 1 GB of Ram is DDR2 400/533 1 GB (PA3411U-1M1G). Use this part number to order compatible module.

  You can also buy the Kingston/Order module. Kingston offers high quality products and using them you won't have these problems.

  The Modules of RAM 'Value' use many chips cheap using several banks/channels, which can cause problems of compatibility with some Chipsets/CPUS.

• BSOD crash to the device USB unplug - Satellite A100

  Hello world

  On my new Toshiba Satellite A100 laptop right out of the box (pre-installed Windows XP MCE), I installed a USB device (a Line 6 POD XT live guitar amp modeling unit). I used the latest drivers available. The instrument is duly recognized and properly installed. I can use it properly.

  Only when I unplug it, or simply turn off... bang! blue screen crash. There is no icon 'Remove hardware safely' available, since it is not a unit of storage memory. Also, it used to work just fine (plug/unplug) on my previous laptop satellite I just replaced.
  Something with media center edition?

  Thanks in advance for your messages.
  Please help me!

  Hello

  Don t think that it s something wrong with MCE, but you know; nothing is impossible.
  The blue screen of death appears mainly due to hardware failure or serious software compatibility issues.

  Try to update the BIOS. Maybe that changes anything.
  Alternatively, you can try to disable the function of the USB ports to save energy. You can do this in the properties of the USB port

  Additional I would recommend contacting the manufacturing of USB device support.
  Maybe these disorders are known for guys

• Satellite A100 - battery all night while the power is off

  Hello world

  I have a new Satellite A100 and I noticed that when I fully charge it and then turn the power off and remove the plug from the socket, the next day when I stick it back in the socket of the control light yellow says that he is in charge.

  So, I turned on the computer laptop and checked is full battery and it says 94%. I let it finish loading at 100% then it off again and came out of the plug. The same thing happened the next day! He held again!

  I don't know that I did not in Hibernate mode because I checked all the settings and choose Turn Off to turn off the laptop.

  I read on the battery recall, so I searched on the toshiba site and downloaded the program from battery test. The result came out that my battery is not between the serial numbers involved. I even manually checked the number on their list but mine is not supposed to be affected.

  Is anyone having the same problems, or is it normal that the battery itself?

  Please let me know... Thanks :)

  Hello

  It is normal and you should not worry about this. The same thing happen on my Tecra. Please check this Toshiba document on this http://support.toshiba-tro.de/kb0/FAQ6301EP000ER01.htm

  Good bye

• Notebook15-r110na Energy Saver: my laptop screen has suddenly started to go black when I need to plug the power adapter

  Laptop screen has just started to go black when I need to plug the power adapter to recharge, if I get screen back to normal.  I have not downloaded anything new recently.  I have download the free 10 Windows but that was months ago.  Any help would be appreciated, but please not too technical as I'm not an expert on computers.

  Maybe the powerplan battery is changed or not properly configured. You can see the current powerplan thanks the battery status bar icon.
  Please check if the powerplan options are correct.
  More specific:
  Brightness updates when it is plugged into the charger OK?
  
  Also: If the screen goes black, can still use you the shortcut keyboard keys to adjust the brightness?

• Satellite A100 does not power up - LED orange flashing but nothing else

  My Satellite A100 laptop fell on the couch and now wont power up,

  I get a flashing orange LED but nothing else.
  This only happens with the AC adapter is plugged and not with the battery.

  What can I do to solve this problem and what should I watch?

  Hello

  Try to remove the battery and unplug the AC adapter.
  Wait a while (> 2 hours) and then reconnect the two parts.
  If the laptop still not, will fuel even using a good power adapter and the battery in good condition, the problem could be related to the problem RAM or the motherboard.

  You should also try to delete one (or two modules if you have some spare parts) module of RAM and should try to turn on the laptop.

  Good luck

• Power supply broken by Satellite L10

  Whenever I plug the power connector, the power LED doesn't light up.
  Only when I move the power cord, it happens.
  I googled around and this seems to be the connection of the power jack on the motherboard broke.
  Many alternative power are available on ebay, the only problem is that my type of laptop is not listed.
  It's a L10-103.
  Can someone tell me the type of DC powerjack can I use?
  TIA

  Hello

  I have goggled around and, unfortunately, I wasn't able to find the right part.
  But you worry about don t; You can purchase these parts from the Toshiba authorised service provider in your country.
  I think that guys will order the CC of lacrosse head of Toshiba.

  Good luck

• Satellite A100 - 02 M: cannot open the local area network to share files and printer - LAN Unplugged

  I have an office of another manufacturer which was connected by a wireless network via a Belkin router for a laptop another manufacturers - both running XP.

  I have now replaced the other laptop with a laptop Toshiba Satellite A100 - 02 M under Vista Home Premium. While I can still access the Internet from both machines, I can't open the LAN to share files and printers. The laptop shows 'LAN Unplugged' all the time. Any ideas would be accepted with gratitude.

  Ray Freeman

  Hello

  I have no general solution, but I'll try to give some advice solution;
  If you want to connect laptop with LAN cable both please make sure that you use a crossover ethernet cable.
  In addition, check if the network card is properly recognized in Device Manager.

  You could try updating the LAN driver and remove the NIC in Device Manager to update the installed driver.
  After restarting again the operating system should recognize the new (Lan) device and should install it automatically.

  I also studied a bit in this forum and found a similar thread:
  http://forums.computers.Toshiba-Europe.com/forums/thread.jspa?threadID=14852&MessageID=54037

  Check the proposals contained in this message.

  By the way; Microsoft provides a very useful page on Vista and how to configure the network, the file and printer sharing and troubleshooting
  http://windowshelp.Microsoft.com/Windows/en-us/networking.mspx

• Satellite A100 does not supply power to the top

  I have a client who has the Satellite A100 (PSAA2C-LE100E) and its not turn on the power. He bought a new AC adapter and tried the battery in and out and still not solve.

  Should there be a light at the front of the laptop when it is plugged in and turned off?

  Is it hard by exchanging the DC IN 19V on the phone jack?

  Thanks :)

  Is this a Toshiba adapter? If the tension or the polarity is wrong, it can damage the motherboard.

  DC IN (power cable icon) light should illuminate when the AC adapter is plugged in, if the adapter does not work. You can use a multimeter to check the volts and amps of the adapter.

  If not, then a new Mainboard.

• Satellite A100-225: battery power light flash orange

  Last night, plugged my AGES of NINE DAYS by Satellite A100-225, the lights were on, it was working fine.

  This morning, woke up, lights were turned off, tried to turn it on, the battery power button flashed light Orange.

  Tried to play with the cable by plugging it into other outlets that I knew worked, nothing helps.

  Have tried to start without the battery in it, without success.

  Unless there is a function that can prevent from starting somewhere, I don't know what to say. This computer is nine days old, and I do not understand how something can just wrong all night.

  Adding info if necessary - computer was on when I went to sleep, and was running Mozilla Firefox and WinAMP.

  Hello

  Perhaps the unit automatically goes in standby mode or hibernation?
  On this device, the automatic system standby/hibernation has been reinstalled. This function automatically stops the system when there is no input or material of access for a specified time. You can specify the time and select System standby or hibernation in the base of the Toshiba power saver settings tab.

  In addition, if the battery LED is flashing it means that the battery charge is low. The adapter must be connected to the battery.
  If it of not possible to charge the battery, so there are several possibilities: the battery could be dead, the AC adapter doesn't work or there is something wrong with the hardware of the laptop.

  Try disconnecting the battery several times and then connect.

  But according to your ad you tried a procedure and it doesn t work. So I think you should ask the ASP in your country to help.

• Satellite A100 - screen power button stays black!

  Hi all

  I have a Satellite A100 (PSAANA-04E005) than just doesn t power up. The power button lights up, but the screen remains black, and you can hear things from fan.

  I tried to remove the battery and running only one AC, tried the recovery disk and everything I could find on troubleshooting, but it s just not work.
  More disappointing is I JUST realized out of warranty - timing is far from perfect...

  Can someone please help with some info so I can get my system back up and running?
  Not too concerned about what was on the hard drive - just that it works again!

  Any help would be greatly appreciated...

  See you soon,.
  L

  Hello

  I put t know if this will help, but in my case it worked in the past.
  -Remove the battery and unplug the AC adapter
  -wait for about 30-40 min, also try a longer period
  -then reconnect the two parts to the laptop and try to turn on the machine

  If it helps then you are already lucky, if not well: (.) You will need to contact the ASP guy in your country for assistance

  Good luck

• Strange on my Satellite A100 power supply problem

  Hi I hope it's just me in Sun.

  I plugged my power on my laptop today and found that no power is getting to the laptop. I checked all the obvious things like the fuse and have even tested the output of the power supply with a multimeter and I get what looks like the correct voltage.

  However, when the power supply is plugged into my laptop blue "alternating current" does not and windows wants to say I'm running out of battery.

  Someone else had this problem? It is a work of repair and return? (I hope really not).

  Thank you

  Doug

  > Is this a work of repair and return
  I'm afraid, m Yes :(

  But the question is; malfunction of what part?  :|
  Maybe that your inquiry is good and everything is ok with the AC adapter / CC.
  This means that there could be something wrong with the laptop itself.

  Maybe it's only one loses the connection between the plug and the motherboard or most serious problem as a malfunction electronics power?  :|

  Who knows. It of very difficult to say what's wrong without any diagnostic tests
  I recommend you contact a technician in your country. He could check the laptop and found much faster fault as a user simply ordinary like you and me.

  Good luck

• Satellite A100 PSAA8C - cannot install Power Saver

  Hello

  I reformatted my laptop toshiba Satellite A100 PSAA8C SK800C today and I was expecting to download all the drivers and install them.

  However, when I download the 'power saver' among the official website of toshiba, I was not able to install.
  Not only that I can not install it, nothing pop out when I click on the zip file CONFIGURATION icon.

  I have already installed all drivers for the laptop computer.

  Can someone help me?

  Thank you
  ~.~

  Hi mate

  You said:
  > However, when I download the 'power saver' among the official website of toshiba, I was not able to install.

  First of all this laptop seems to belong to the Canadian series of Toshiba and if you want to use any tools Toshiba, then you will have to download it from the page of the Canadian driver Toshiba!

  In addition, you can choose the drivers and tools exactly for the PSAA8C series.
  In many cases, you will not be able to use the tools that are designed for other series!
  We must therefore be sure that power saver downloaded has been released for the series PSAA8C.

  Welcome them