OfficeJet 6500 has
What is the 6500 has regular wireless
Officejet 6500 a models are all wireless.
Tags: HP Printers
Similar Questions
-
Impossible Telec... OfficeJet 6500 has
I have problems with the passage of my printer fax. I have a HP Officejet 6500 has everything in Copier, scan, fax and printer. I created everything correctly according to the instructions. I ran a test 'fax', and he said that my phone line was not active. I use as my ISP Comcast. I called them to test my phone line, in fact, they said that everything is working properly and that the line is active. I use the telephone cord two wires supplied with the printer. Called HP support, no help. They said that the phone cord is defective and I have to buy a new one. Well, I've been all over creation trying to find one and nobody does not sell, only the four sons. Now, I'm really frustrated! I would like to start using my Fax. Help, please!
Hi @kimberfo ,
Thank you for using the HP Forum. If your problem has been resolved, please select the button accept the solution.
Kind regards
George -
Why my hp officejet 6500 has more printer take ten minutes to four pages of fax?
HP Officejet 6500 a Pus E710n-z series
Windows 7
Why my hp officejet 6500 has more printer take ten minutes to four pages of fax? No change has been made and no error message. This seems to be an extremely long time for only four pages!
Firmware has been day t0 then did a hard reset and tested a fax. seems to be faster, but was not a very detailed page. will be able to say when I have more pages to send. If this is no better at this moment, will post back.
-
How to print from my ipad to the officejet 6500 has more?
I read that there may be something else than necessary. I want to print directly to the Officejet 6500 has more. Apple said ths is an Air Print printer able to do this. I don't take this monster out of the box until I know he will do what I want without a lot of trouble. Thank you.
OK, so you were talking about requiring the update. It is difficult to say that all depends on if it came with the new firmware or not. It is not really relevant, however, because it will be updated as soon as Web Services. This process takes a few minutes. There is no computer necessary for the update of the firmware as long as the printer has internet access (which is directly connected to a router via ethernet or wireless). Yes, a connection ad hoc, you will be able to print from the iPad, but you can use its 3 G connection instead of through your router. It can only support a single WiFi also. Go ahead and set up the printer and keep me posted on what happens.
BTW - what is the problem with your PC that it cannot access the internet?
-
Windows 8 does not support HP Officejet 6500 has more
Dear all,
My operating system is Windows 8, however, when I install the HP Officejet 6500 has more, I'm unable to install the printer driver. The error message "the operating system is not supported".
I would also ask HP to meet this emergency request.
Thank you
George Tay
Hello
Where do you find the printer driver? From the CD? I believe that the CD is released before Windows 8. This can help:
Kind regards.
-
OfficeJet 6500 has more - black print cartridge will not print - other colors will be printed
OfficeJet 6500 has more the black cartridge will not print. I put in a new cartridge, so it is there
ink. The printer works, because the other colors of printing. It worked very well and when
printing, black has slowed and now does not work.
I called technical support. Megan has been very helpful to me through the steps to
clean the print head. Unfortunately, the black cartridge still does not print. I have
has ordered a new printer, the 6700. I appreciate the help of Megan and will be happy to
have a new printer.
-
OfficeJet 6500 has more - copy
How can I copy from an original two-sided and a double-sided copy?
Hello
The Officejet 6500 has more provide the duplexing only.
The duplexer to this model provides no ADF Suplexing options.
You can find the specifications below:
SS, maybe you'll see, impressions recto only are provided.
Kind regards.
Shlomi
-
OfficeJet 6500 has more printing problems
My Officejet 6500 has more (model CN557A) is connected through the USB port. My operating system is XP. I can scan my computer, I can copy and print from the printer control panel, but I can't send anything to print from my computer. This problem just started about 3 days ago. I tried troubleshooting but I have not received the case. I did not add new programs, and I have 194 GB free on my hard drive.
Can anyone help?
N ° however, I accidentally discovered the problem. I had a card reader connected to my computer to download pictures. Apparently it disrupted the cycle of printing for my printer. I removed the card reader and the printer works fine now. Thank you for your response.
-
How to set default COPY for HP Officejet 6500 has more quality DRAFT?
How can I set default COPY quality to the PROJECT for HP Officejet 6500 has more?
Hello
Press on copy on the front panel of the printer, then press the settings button.
Quality faucet and quick selection / project.
Press on set as the new default settings, and then click Yes to confirm the changes.
Later draft quality will be used for the copy unless any other quality is selected.
Kind regards
Shlomi
-
Message ' load paper ' wrong on Officejet 6500 has more
I get a message ' load paper ' on my Officejet 6500 has more. When I first got the printer and installed with my office, it does the same thing, but he stopped after a download from HP. Today I installed it on my laptop, and now it gives several times the same message despite that I have loaded and reloaded varying amounts of paper.
Windows 7 64 bit
Hello
This article should cover the problem you are experiencing. Give the steps described a shot and tell us if it helps.
Good luck!
-
HP Officejet 6500 has stopped printing, paper white just came out.
My Officejet 6500 has just stopped printing. I use a USB connection and my operating system is Windows XP Home Edition. At first, it was just the text that Wouln't print but the colors would come by, even on test prints. On a print document the little box comes up showing the data transferred to printer, printer starts but doesn't work with a blank page. I have uninstalled/reinstalled program, has gone through the full program of the HP Solutions guided, checked all connections, installed the new driver, and yet do not print anything. Have never had any previous problems since I bought. I have not recently installed new programs. Would appreciate any other suggestions.
After everything I lived, I finally solved the problem. Although the ink levels showed ink cartridges, I put a new black in one and it works!
-
HP officejet 6500 has more: press the button doesn't work is not on the right side
Hi I tried to turn on my printer and it is stuck on maintenance mode and will not work my right from the touch pad is there a replacement for the touchpad or a way around the mainenance mode?
Hello @jgrier1,
Welcome to the forums of HP.
I understand that your printer is stuck on maintenance mode and the touchpad is not responding.
I would like to help.
I'm sorry, but the display on the Officejet 6500 has more, is not a replaceable part by the user.
Try to go through the document next to the touch screen.
It also can you go beyond the question of maintenance mode.
-
HP Officejet 6500 has more poster "original jam. Clear the jam, and then press 'OK' to continue. "There is no paper jam and the printer will print as long you don't try to use the automatic charger. However, the error message continues interfering with scanning and other print jobs. Any ideas on how to clear the error message? I tried to reset, nothing helps.
Thank you.
Hello HPAllinOneSande,
Perhaps there is a jam that is located somewhere on the printer. See if you can follow these steps to clean the error and the jam.
' Original jam: clear jam and press OK "Message displays on the all-in-one
-
HP Officejet 6500 has more by using a different IP address than before
I have a HP Officejet 6500 has more. Until yesterday, the printer worked wirelessly with my Mac OS 10.6.8 using the same IP address in IPv4 as the computer. I ran the HP Network Config page and it shows an IP address different today that it did. Is the message that I get when I send a document to print wireless: network host 192.168.1.101 is busy try again in 10 seconds.
I checked the IP address of the printer and it is 192.168.1.100 (not 101). Therefore, they do not speak with each other. I treated all the solutions that I can find on the HP network to see if I can get the two survey periods to match and nothing seems to work. I turned off, turn off router, off modem, printer is off, turned off computer and lit them all back. No help.
Any suggestions? Can I print using USB, but it's embarrassing.
Something doesn't look good - maybe that I misunderstood... You say above, your computer and your printer had the same IPaddress and, when this is the case, you were able to print. Now, the printer and the computer have different IP addresses and now, you are not able to print. If this summary is correct, that then it seems to me that it should be exactly the reverse.
If the IP addresses were the same, there is a conflict between devices, a bit like a mailman trying to deliver mail to two different locations which have the same addresses... What place receives the mail? It is normal for all network devices have their own unique IP address - how each device gets its own mail... or data packets.
From the sounds of things, your printer is 100 but the MAC OS think its 101. Therefore, the print job is sent to 101 and never happens at the printer. You have two options... tell the OS that the printer is located at 192.168.1.100 or that, to avoid this problem in the future, on the IP address of the printer a static address, just guessing anything below 100, as 192.168.1.50 and then specify the operating system that the printer is located to 192.168.1.50.
To make the choice of the latter, you must use your internet browser (Safari) and navigate to the 192.168.1.100 address. There is a web interface for your printer. Look for the network settings, then you can change the way that the IP address is obtained from dynamic (DHCP) static. And, after that, you need to find the IP of 192.168.1.50. It is also important to complete the subnet mask that will be 255.255.255.0. Finally, if your printer includes "web applications", you should also check the DNS addresses. You can use: 8.8.8.8 and 8.8.4.4 (Google's DNS servers) or 208.67.222.222 and 208.67.220.220 (OpenDNS servers)
Note that when you save / apply the changes, you will lose your connection to the webinterface of the printer as the printer will have a new address. To return to the printer web interface, access the new static IP address.
As far as to say where actually the MAC OS printer, the simplest option, as appropriate, is to use the HP tool to add a network printer or a device. To do this, AFTER you change the IP address. The HP software will scan the network printer and it should give you a result that shows the printer to the new static IP address. Installing and if possible, the name of the printer with a few references of "static HP or the"HPat192.168.1.50"set as default printer and remove the old definition of HP printer.
The other option to speak the printer MAC must use Add a printer via system preferences > printer/Fax. I'm fairly certain that the MAC tools can analyze the LAN... in any case, it will be a more complicated procedure. Better for a user MAC more warned give assistance if you go this route.
Hope this helps
-
OfficeJet 6500 has more fax keyboard disabled
Hello experts,
I have a printer officejet 6500 has more, and I have questions sometimes when you send a fax.
In some cases, after dialing the phone number of receiver, automatic voice ask redirect the fax to a number given (eg. "dial 26 Fax").
Anyway, the keypad of the printer is disabled after dialing the phone number and I can not send the fax. How can I activate the keyboard when calling the digit numbers requested by automatic voice?
Hi there ofblack, welcome to the forums
I saw your post on the fax concern you have. First of all, I suggest you to check on the Page. 48 of the User Guide , which is to monitor dial to see if this information will help you. As long as you enter the numbers fast enough, the fax needs to work with the numbering screen, otherwise, you will need to use the phone to enter all the guests under send a fax manually from a phone.
This guide is the standard troubleshooting for fax so that might help: I can't send or receive faxes
Have a great Thursday
-
OfficeJet 6500 a: how to adapt a HP Officejet 6500 has so we can print on both sides
Hello dear hp team
I have a HP Officejet 6500 has more that color print on both sides.
Now, I have only a 6500 a which initially can print one side.
I changed the room in the back (I put the piece of the 6500 has more printer) so that mechanically, he has the ability to print also the two sides.
Now how do I program the printer so that it detects that he now has the ability to print on both sides?
Thank you for your reply and sorry for my English mistakes.
A student of the Swiss school.
Hello
As suggested in the post above, only available for the printer manual duplex printing.
The accessory of the duplexer is designed only for he 6500 more than model a, it is not intended and cannot be used with the model 6500 a, as you can find below:
Suitable only for HP Officejet 6500A Plus e-All-in-One Printer - E710n
Shlomi
Maybe you are looking for
-
Satellite 2430-S402 freezing after wake up
Hello If I let my 2430-S402 (about 2 years) go into 'hibernation' and wake him up and then save by pressing the power button, sometime later (between 2 and 5 minutes) comes it will freeze. Then I have to press the power button to turn off and restart
-
Where can I get 4 8 GB simms to upgrade my memory low 16 GB
I can't find Ram for my 13 pro on the Apple? I can't find my end of 2013) End price of mac. Thank you Glenn *. .com
-
HP Photosmart C4700 all-in - One series Printer will not reinstall
Hello. I have a HP C4700 all-in - One Printer. I don't have literal no computer knowledge. We have installed a new router that came with a password so I had to change all the devices. The printer is offline. I tried to fix it as said. No option
-
I tried enabling to TIS using nodes of property for the appropriate channel and by disabling the TIS for strings, I don't want to use. When I do that, I get the following error: niScope read Cluster.vi:1internal software error has occurred in the ext
-
I bought the Windows Anytime Upgrade, but the software will not be installed.
Help... I bought the Windows Anytime Upgrade on Microsoft Office software to my Vista laptop, but the software will not be installed. Operation message is not supported on this platform. How to get around the facility? I have the product key number,