Pavilion p6706f front USB ports

Similar Questions

• HP Pavilion P7 - 1037c: my HP Pavilion desktop computer has been moved and I can't find the front USB ports. How can I find them?

  My computer has been moved to my new apartment and set up my movers for me.  I used to see some front USB ports at the bottom of the front panel, but now I can't.  Is there something I need to do?  I really need those!

  Slide the cover down. Look at this picture.

  

  Good day!

• HP Pavilion p7 - 1447c: replacement of HP Pavilion p7 - 1447c USB Port before

  My front USB ports have collapsed.  First of all a =, then the other.  Blue 'key' fell first and without these pins are bent too far to align correctly.  I would like replacement unit part number  I think install should be simple enough.

  Here is the list of partsurfer of part numbers.   Remove the front cover Assembly as shown on Pg 3 and look at the module.  Is this it?   The part number is shown on this page.  HP7-1400 uses the same module, Ebay $ 30

• Pavilion p7 - 1380t: USB ports not working not

  The two front USB ports do work not today. Worked fine yesterday. Everything I plug is not coming. Using ports in the back, they work very well.

  Someone at - it ideas about the problem and a fix?

  Thank you

  Hello @xploded16,

  Welcome to the HP Forums, I hope you enjoy your experience! To help you get the most out of the Forums of HP, I would like to draw your attention to the Guide of the Forums HP first time here? Learn how to publish and more.

  I read your post on how the front USB ports on your desktop computer do not work, and I'd be happy to help you in this case!

  To enable your system to recognize the USB ports before once again, I recommend that you follow the steps described in this document on Troubleshooting connections USB (Windows 7).

  Please re-post with the results of your troubleshooting, and I look forward to your response!
  
  Concerning

• HP a6554f: Front USB Ports not working for a6554f

  Hi, I cleaned the dust from my computer yesterday for the first time because the computer kept crashing. I removed the motherboard, so I unplugged everything that was clinging to her and I also removed the hard drive then plugged everything once I had finished, (do not know if I just plugged in as it was, even if I took a video of it, but the wasen can't good quality so I had to guess a little). I also added thermal compound to the cpu.

  Anyway, everyhting seems to work except the 2 usb ports front of the case. It was working fine until I opened the case (this is why I do not open the computers, but the dust was just too). The audio ports and microphone located in the front work correctly. And the rear USB ports are working properly.

  What I've done so far is running pilot Booster and also I went to Device Manager > USB Bus controllers, then I turned off everything on the list, then allowed them again. And nothing has worked.

  I don't know much about computers so I don't want to go to the hassle of opening the case cause once again I was scared lol but could I maybe hooked up a cable in the port of fake?

  Also, is there a diagram to show where each cable goes to the a6554f model?

  As you pointed out the audio before and MIC ports are working, then it might be just the plug for the ports before USB is not properly or is in the wrong place.  Here is a page that relates to the motherboard. In the lower right corner of the image or the page layout scheme, there are two blocks header before normally taken into USB ports.  Says F_USB1 and F_USB2.  Either we must work to the front ports.  Check to make sure that the wiring box beam (which has the wires going to the front USB ports) is connected on one of them.

• I have a Photosmart 3210 - Can I use the front USB port instead of port back? (back is broken).

  Hello!  Trying to help a friend.  Rear USB port no longer his plug slips outside, no electrical connection.  Tearing in the unit for her brief submeter (out of warranty, nothing to lose).  Can I use an adapter with a standard USB plug on each end to connect to a PC for printing?  The user manual is too vague on this - looks like front USB is just for PictBridge stuff.  Any suggestions/ideas will be greatly appreciated.

  Thank you

  kott2ke

  Hello kott2ke,

  Front USB port: print photos directly from your camera or storage only.

  Rear USB port provides connectivity for printer and USB.

  Kind regards
  Jabzi

  Help the community by marking this post.
  Your question has been answered? Mark it as a accepted Solution!
  See a great post? Give it a Bravo!
  I work for HP

• HPE 500f broken Front USB Ports. Need hardware

  I broke all my front USB ports. Does anyone know where to find replacemnts? I can't find parts in the manual or on the website of HP.

  Thank you.

  HPPartSurfer lists the USB port double room like 517181-001. See here.  Used for sale

• front usb ports are unable to detect the large capacity external hard drive (250 GB)

  Hello
  I have 250 GB external hard drive, whenever I connect to my front usb ports it detected, but pen drives, are to detect flash drives, one of my friends said that you need to update my bios & I here is the motherboard.

  motherboard: Mercury 945gcm

  It is possible that the USB 1.1 and not 2.0 ports that can explain the problem.  In addition, sometimes USB ports out enough power to run an external device that is not powered separatelly.  I don't know if updating the BIOS will help, but if there is an update available for your system (and it MUST be for your system - big bad can occur if you install the wrong BIOS so get with the computer manufacturer, and speak to a representative to confirm that they are appropriate for your system AND your version of Vista) then by all means install it and see if that solves the problem.  You can also get the updated drivers for the motherboard manufacturer, at the same time and see if that helps as well.

  I hope this helps.

  Good luck!

  Lorien - MCSA/MCSE/network + / has + - if this post solves your problem, please click the 'Mark as answer' or 'Useful' button at the top of this message. Marking a post as answer, or relatively useful, you help others find the answer more quickly.

• p6610f front usb ports not working not

  I just noticed that my 2 front usb ports do not work. I had recently opened it to add RAM and swap the optical drive. Could I have hit a loose cable or something?

  TIA!

  Hey vkh3203,

  I'm sorry that you run on this issue with your USB ports.

  Check the connections on the ports indicated in the image below. It would be best to go and resettlement.

  

  Taken from this link

• What is the difference between the rear USB ports and front USB ports?

  Why some USB equipment only works with the USB on a computer BACK and not the FRONT USB port?

  USB ports on the rear panel carry more voltage (voltage not exceeding) the USB headers on the front...

• Front USB Ports suddenly inoperative

  I installed an SSD as drive 0 and moved the former player to Player 1. In doing so, I can have disconnected something because now my front USB ports are dead.

  Can someone tell me what controls the front USB ports or where I can get a diagram of the motherboard for the 8700-1262 XPS?

  Thank you.

  It is located in the owner's manual on the link below, download it and go to page 13 0f the PDF document

  www.Dell.com/.../manuals

• Pavilion S5-1204: USB Ports does not: Windows 7 HP Pavilion Slimline

  Hi all

  Yesterday all of a sudden the USB ports are not read.  I have cameras and use a data transfer cable or a card reader to transfer to the office.  Now they do not read.  Tried the front and back of the usb ports.   However, the optical mouse that uses a usb device works.   I don't understand how the mouse works and the purse strings of data transfer and the readers aren't.

  Win 7 64 bit

  HP Pavilion Slimline desktop computer

  Help!

  Update: I did troubleshoot a HP check and update driver.  The screen messages

  USB root hub: this device does not work correctly.

  The current tab:

  Generic USB Hub (6)

  1 port available

  Power required: 0mA

  Solved.

  I've narrowed the problem to the camera. Very strange. The camera will take pictures and display them on the screen. But something is happening internally where the image will not transmit or transfer it via a usb device.

  I have another device with a transfer device and it works. So it seems I have to buy a new digital camera. BTW, it is a Nikon S2800 - not recommended.

• OfficeJet Pro 8620: HP Officejet pro 8620 Front USB Port

  Can I use the USB port on the front to connect to a computer?

  Or is it just for flash drives?

  Thank you

  Dean

  Hello
  
  Thank you for using the HP forum.

  The façade is for USB.  Use the rear USB port to connect to the computer.

  Hope that helps.

• Pavilion 17-g192dx: USB Ports not recognized

  Hello

  I have a HP Pavilion 17-g192dx that's installed with Windows 10 factory. I decided to give the new operating system a go, but was overall very satisfied with his overall performance and updates of buggy. Not wanting to give up the new machine, I decided to bring it back and oldie but a goodie - Windows 7. I got a copy of Windows 7 Home Premium lying around so I gave a go and installed the operating system. I got the internet running successfully and in no time most of my drivers have been installed. The problem that I face now is that the old BONES will not work with my USB ports. I do not use a hub and have almost exauhsted the drivers for this Web site section. If someone wants to kindly point out how I could go about fixing this issue, any help would be much appreciated.

  I'm not as interested to get back to Windows 10. It is too slow for daily use (ma) and buggy.

  Thanks in advance!

  Hello:

  Download, unzip and run the file setup.exe from the link below...

  https://Downloadcenter.Intel.com/download/22824/USB-3-0-driver-Intel-USB-3-0-Extensible-host-controller-driver-for-Intel-8-9-100-series-and-Intel-C220-C610-chipset-family?product=65855

• Example: Pavl'ln Slimline s5-1: Front USB Ports NOT working

  Really need help from the experts here - model desktop HP Pavilion Slimline s5-1: H2M46AA (a Joshua motherboard with H61 Intel Chipset) crashed hard drive and have no original driver. Clean install of Win7 Home Premium SP1. Everything is OK except other devices, Universal Serial Bus (USB) bus controller. Driver is not found. After installing Win7, installed an ethernet driver and the original files Chipset installed HP Web site. All drivers OK except the foregoing who apparently controls USB ports before 2 which did not. Then, installed all updates provided by Windows Update. USB ports before always inoperative. They worked before the new Win7. After much research, unusable before USB ports seems to be a common problem, but none of the planned solutions help (check that the cables, turn off completely, Intel Driver Update Utility, etc.). On my system, the first of the 4 ID material for this device shows as: PCI\VEN_104C & DEV_8241 & SUBSYS_2ADA103C & REV_02. According to pcidatabase.com, this is identified as: "Texas Instruments USB 3.0 XHCI Host Controller" and therefore a possible problem. The ports are, I believe, USB 2.0 and not 3.0 according to Joshua documentation (http://www.foxconnchannel.com/ProductDetail.aspx?T=motherboard&U=en-us0000525 see also "\windows\inf\setupapi.dev.log" shows there is no files on the drive associated with the ID of the above material because they are not found during the installation of the driver.) So the question: How can I get these ports USB works - have installed to each HP update recommended for this system. I'm puzzled!

  You're right, it's just an update of the driver, but I think that this is specified, you can see the technique of reference:

  FTP://FTP.HP.com/pub/SoftPaq/sp70501-71000/sp70786.html

  TITLE: Texas Instruments USB Controller Driver Update
  
  VERSION: 1.12.25.0 REV: A PASS: 2
  DESCRIPTION:
  This package provides the driver for the Texas Instruments XHCI update
  Solutions of controller in the supported models that are running a service supported
  System.
  
  PURPOSE: Routine
  SOFTPAQ FILE NAME: SP70786.exe
  SOFTPAQ MD5: 9bd312c3c424161a6c3357d260dcf939
  REPLACES: SP59644
  ENTRY INTO force: 6 March 2015
  CATEGORY: Driver-Chipset
  SSM supported: No.
  
  PRODUCT TYPE (S):
  Desktop computers
  
  MODEL OF PRODUCT MATERIAL (S):
  HP Pavilion HPE h8-1xxx PC
  Desktop computer HP Pavilion p6-XXXX (Joshua)
  Desktop HP Pavilion p7-XXXX
  HP Pavilion Slimline s5-XXXX
  HP Pavilion p6 PC
  HP Pavilion HPE h9-1xxx Phoenix PC
  HP Pavilion Slimline s5-1xxx PC