Portege Z830-10F no display - power light flashes
Hello
I have a problem, when Toshiba Portege Z830-10F of loading, the screen is off, flashes of light of energy Green two times two times yellow and repeated, the screen will not turn on.
What it means?
(PC was left alone in the night on table)
I try to disconnect the battery and load without it, it did not help.
Indicator DC IN (first on the left):
Flashing orange indicates a problem with the power supply, initially, you should try plugging the adapter into a different power outlet. If she does still not work, please contact Toshiba support in your country.
((Deuxieme power light to the left):
Flashing orange indicates that the computer is in mode 'sleep' and that there is enough available power (mains or battery adapter) to maintain this State. In sleep mode indicator lights for a second and off for two seconds.
Also try this.
Remove the battery, disconnect the adapter, press and hold the power button / stop along 30 sec.
Now connect the battery and AC adapter and turn on the device.
Tags: Toshiba
Similar Questions
-
Portege M100 does not start - power light flashes orange
Hi all
I have a Portege M100.
Since ysterday, the computer does not boot. When I push the power button, I hear the noise of the fan starts working, but nothing else happens. The power light continues to blink in orange.
I removed the battery and tried to turn on the computer with the AC adapter is plugged in, but nothing changes.Any ideas on what could be the problem? I would appreciate help,
Thanks in advanceYalin
Hi mate,
could possibly be the RAM, so please check the RAM modules and remove 1 module if you have 2 of them installed.
Otherwise, I check if some another module of RAM is available and install the module of well known work. If this is not sufficient then I strongly recommend you to bring your machine to a service partner chartered for a balance of health/repair of equipment.Please give some information about your situation...
P.S.: you can try to remove the battery and AC and leave the machine without power for about 24 hours. Maybe it helps?
Welcome them
-
Satellite 2805-S201: AC power light flashes orange 8 times
Hello
I worked on a Satellite 2805-S201 and everything was fine until I put a PCMCIA wireless with 3, 3V power.
After that, the AC power light flashes orange 8 times and recycle.It comes with power supply, battery, AC and no battery installed, etc. If I pull out the power plug and the battery and then put both when AC is green and the battery may charge. As soon as I push the power button, I hear a light click on the right side of the device and then it goes into the amber cycling power.
Bulletins of support mentioned that the card could get damaged, but did not mention the unit itself.
No, the PCMCIA card is not always connectedAny thoughts?
CA
Hello
The flashing provides a micro code which refers to the hardware failure.
But please don't ask me what might mean this code because in my opinion, only an authorized service provider can be read and can check in his manuals and documentations.
But it is of course, in most cases, it s a hardware problem of motherboard! ;(Perhaps the external PCMCIA card was not totally compatible and damages of something on the map but it's only my personal suggestion to ensure what s bad hardware fault diagnosis would be necessary.
-
Qosmio F20 won't start - power light flashes orange
My Qosmio F20-149 crashed yesterday and I was not able to get it working again. When I try to turn it on, the power light flashes on and outside (on: 1 sec, off: 1 sec) and the cooler fan operates at full power. When I press a key, there is a genre or a sound error. otherwise no reaction of the laptop; even the CD player does not open.
I did no RAM-implementation to date, and I use the original power supply Toshiba. I tried from the laptop using only the battery, only power and on both. No change in the reaction. I tried all possible combinations (with a free one, both... etc) of my two cards, RAM (512 + 512) and still no use.
I am really puzzled.
If I understand you just your laptop sends a blink code. Copy the following code appears so laptop has detected a problem with the electronic power supply.
In this case, there is nothing that you can do and the laptop must be sent to the service provider allowed the closest.They have manuals containing instructions and the exact description of the code how do I solve this problem.
Sorry, buddy, but I do not think that anyone here can offer an accurate diagnosis for that matter. -
Portege Z830-10F - WLAN stops working when USB3.0 port is in use
Hello
On my Portege Z830-10F wireless stops working when I plug in a device on the USB 3 port. The wireless connection back upwards as soon as I remove the device.
The problem occurs with any device I plug. I tested with disks external usb (usb 2 and usb 3), USB, a receiver wireless mouse and a printer/scanner.
This problem only occurs when something is connected to the USB 3 port. The USB 2 ports on the rear do not have the problem.
Port USB 3 itself works very well.
Running windows 8 pro:
* Wireless lan adapter: Qualcomm Atheros AR9200WB-1NG (version 10.0.0.75 driver)
* USB port 3: Renesas USB 3.0 eXtensible Host Controller - 0096 (version 6.2.9200.16420 driver)I see that I ve got the latest drivers installed on the wireless LAN card and the usb host controller 3.
The problem arises as well on windows 7 and windows 8 pro. I used the wizard to upgrade Toshiba upgrade of windows 7 to windows 8.
This problem is present since I got this laptop. I ve already done a reinstall / recovery back to the original with windows configuration 7 but this doesn´t solve the problem.
Does anyone else have this problem?
Is there a way to fix this?
Thank you!
Hello
To be honest, it's the first time I read on this issue.
I have no idea how a device attached to the USB 3.0 port could affect the Wlan functionality.I assume its hardware fault and cela must be verified by a certified maker Toshiba.
-
Calibration Portege Z830-10F and battery
I have a problem with the Portege Z830-10F battey.
With no alert, closing down and when to start the load at the level start at 51%.
In an hour, the charge is complete.
There is a method to calibrate the battery?
Best regards.
Nicola> There is a method to calibrate the battery?
The battery can be calibrated to unload the battery until it is completely empty and then until the battery indicator would turn to green (in some cases blue). This indicates that the battery has been recharged.
This procedure should be repeated several times in the line.But be careful: even if you would calibrate the battery, it might be possible that the battery would not provide the same performance due to the age of the battery.
Sooner or later each battery began to lose the performance load and in such a case, it s just a matter of time, when the battery needs to be replaced.
-
Portege Z830-10F - Wi - Fi adapter is very low
Hello
I have Toshiba NB305 Netbook and Pavilion dv6 too and inside wireless adapter works fine Intel. But in the Portege Z830-10F adapter WiFi Atheros AR9002WB-1NG sees only two of the ten wi - fi networks... and often disconnects.
Can you recommend the latest drivers for this card?
See the portal Toshiba WLAN and last version here - http://aps2.toshiba-tro.de/wlan/
-
I have a wn3050rp extension
its power LED flashes all the time
I installed by mistake inside wn3000rp firmware
and since then, its power light flashes
Help, please
http://KB.NETGEAR.com/app/answers/detail/A_ID/22688
see this
It will help you
-
Lenovo B590 Orange laptop power light flashing
Hello
Recently, I noticed that my B590 Lenovo laptop indicator light was flashing orange. I tried to restart the notebook and by ensuring that all the plugs are secure, but nothing is indeed it. That means the power light flashes average orange?
~ Laila
Hello
Just wanted to give an update on this issue, in case someone else runs into a similar situation. As I said, I'm under market entirely adapter. I found that the old ground had not been eradicated because if you go out without replacing, it leaves a gaping hole in your laptop!
I solved the problem of blinky light orange by disconnecting the battery, but leaving so much, with little electrical tape, to hold it in place that it will protect the pins bit inside battery - thanks for the link to the manual, it is also useful.
Mahalo,
~ Laila
-
KDL-46XBR9 shuts off and the power light flashes red
KDL-46XBR9 shuts off and the power light flashes red
It flashes ten times, then rehearsals.
-
Under Vista, my fan starts and stops, makes a loud sound and the power light flashes
My fan starts and stops, resembles a car reving his engine. The power led also flashes. Gateway gt
* original title - my fan starts and stops, resembles a car reving his engine. The power light flashes too *.
Hello
If you have nothing on the screen, including a splash with logo screeen, etc, contact gateway if under warranty
If it is under warranty, contact a local reputable computer repair workshop
-
HP dv7-3085dx power light flashes, but the laptop does not work.
Hello! I have a HP Pavilion dv7-3085dx. It has a hard drive Bay 2.
Recently, I bought the caddy + cable kit and an Intel SSD. The thing is, when I plug the sata cable to the motherboard for the laptop, and the SSD to it, the laptop does not light. When I press the power button, it flashes once (the power LED flashes once), but the laptop does not light. When I press again, nothing happens.
I tried to remove the power supply plug, battery and plug it all again, but the power light flashes once (when you press the power button) and no reaction.
Maybe it's the sata cable: when I remove the new cable and connect the SSD with the sata cable on the 1 hard drive Bay (the cable supplied with the notebook), it works fine. The laptop starts. And when I connect the former sata cable, with the SSD on the second hard drive Bay, it also works.
I just want to now what is the flashing light means light? Why it does not work with the new cable?
Thanks in advance! Sorry for my bad English...
Emilio.
It is possible that this is a problem with the kit. I would recommend to download and install the latest BIOS update for your laptop, using the download at the following link: http://goo.gl/rbHkg
If it still doesn't work after that, I would recommend to suppress the kit for a replacement or to try another.
-
Portege M750 starts no-power light flashes
I have an orange flash on my power light error code (1 long flash 3 short 1 long 2 short 1 long 1 short)...
I have to take the power connector on battery and start battery to operate...
I use image windows 7 Toshiba with all Microsoft updates (now I NEED many to verying reasons so don't grill me again... for example DON 'T SUPPORT MICROSOFT UPDATES blah blah blah)
What does this code mean and y at - it a Bios Beta above version 3 for these things...
Any helpful comments would be greatly appreciated...
Hello
In short, 0, long ways 1.
In your case, the binary code is 1000 1001
Now, we must reverse the binary code because the most significant bit.
This means that the code is; 1001 0001
The HEXADECIMAL code means; 91 hError code is 91 h but I n t know what that 91 h means and what role might be affected exactly!
Eventually it s something wrong with electronic power supply on the motherboard, but only the ASP technician could provide more details
However, in most cases, the motherboard is affected and needs to be replaced.Welcome them
-
I have a late 2009 Mac Pro, that will not start and the power LED flashes continuously. I tried all the different buttons start without success. Any suggestions?
This error code means that there is not enough RAM to work.
When yo get that open the side cover and search lights lit by strips of RAM
-
32D1334B LCD TV - not light power light flashes red &; Green
I have a Toshiba 32D1334B LCD TV, it used to work perfectly well and then all of a sudden, it will not activate.
When I plug in the TV, the power automatically light flashes red and green permanently. There is no way to turn on the TV; the screen remains black.I had to take off the back, watched and deleted all the parts, but can not see the obvious problems. I also a multimeter and power to the various sections of the TV is, but that's as far as my electrical knowledge goes!
I don't really know what else to try, but I am very reluctant to throw away the TV that I know it's probably a unique piece that needs to be replaced to fix it. I searched online and others have reported the same problem exactly, but it had not resolved there always. Unfortunately, TV is more under warranty... If anyone has any suggestions or can provide any help, then it would be greatly appreciated!
Thanks in advance.
If you find out how to fix it please let me know because my tv is the same.chris
Maybe you are looking for
-
His record game - I hear any noise from the computer all of ym,
I checked the Device Manager and system main volume installed a package of Codecs. I get the message "this device is working properly" when I check the properties of an audio device... But I have no sound. everything seems to work normally,Play file
-
Duplication of important file?
My recovery Point climbed only need 2 DVD need 7 without obvious reason. On the audit of large files/folders, my most important files are: C:\ 45.5 GB C:\Users\ 16.7 GB 16.4 GB C:\WINDOWS\ C:\Users\IAN 14.9 GB C:WINDOWS\winsxs 8.48 G
-
Pavilion tx2000: Pleeeaaasse help, or an idea to fix my laptop :(
My Pavilion tx2000 does not open when I turn it on. And when I try to system recovery options, it says that my password is incorrect and that it has been disbled. Help, please...Or any idea how to solve this problem, I don't mind removing evrything i
-
RTL8188EE 802.11bgn computer adapter laptop Pavilion 17 "AMD not finding oe 5 G 11n mode
The map depending on the device, the Manager is RTL8188EE 802.11bgn adapter in I have a Pavilion laptop 17 "AMD not finding oe 5 G 11n mode. In properties, in the mode list, there is no mode 11n. How to get the correct driver for the 11n mode.
-
Where can I find the cj7600win7en64.exe file? (Printer Lexmark problems)
I'm at my wits end after trying to find and download cj7600win7en64.exe for allowing me to use my X 6650 printer with lexmark studio productivity using Windows 7. I visited countless times lexmark support site and that you still can't find link to do