Question on the extension of the memory in a Satellite 1800 204

Similar Questions

• Satellite A60-672: Question on the memory expansion

  Hi, apologies for this new! I would like to increase the memory of my Satellite A60-672, where I can find what I need (including the number) etc.

  Hello

  Your device can handle with max 1280MB. The compatible modules are:

  PC2700 256 MB (PA3311U - 1 M 25)
  PC2700 512 MB (PA3312U - 1 M 51)
  1024MO PC2700 (PA3313U-1M1G)

  Good bye

• Question about the memory of the speeds on Qosmio G30-175

  Hi all

  I have a G30 - 175 and it came with 1gig of memory. and the other day I went to pc world and bought a 2 giga upgrade. The seller asked me what memory speed would I like for my laptop, knowing that the ddr2 at 533 mhz memory, so I asked for it.

  When I came home and replaced the memory, I noticed that the memory supplied with the laptop was actually s pc2-4200 ddr2 533 mhz. the memory that I got from pc world was of the pc2-4300 ddr2 at 533 mhz.

  It would be allowed to go ahead and install this memory, or should I expect pc2-4200?

  Thanks in advance

  Jay

  Hello

  I would recommend using DDR2 533 MHz (PC2-4200) 200 - PIN SODIMM as here on this page:
  http://www.orcalogic.co.UK/ASP/ProdType.asp?ProdType=24718&ft=m&St=3

  Train to my knowledge it s advisable to not to mix modules

• ESXi 4.1 - Question about the memory usage

  Hi all

  I am currently in the process of migrating from ESX 3.5 and ESXi 4.1.0 everything by making the upgrade of my equipment (3 x HP DL380 G7, 24GO RAM, CPU Intel X 5660 2 each).

  The boxes are installed with ESXi 4.1.0 Build 384481 and hpq - esxi4.1uX - bundle-1. 0a, hardware monitoring is done using HP SIM (V6, Windows).

  What bothers me, however, is that the VSphere Client (4.1.0 Build 345043) reports steadlily increases the memory usage in the Summary tab. The increase varies according to the system, ranging from 98MB in 1848 MB in the last 3 days, continues to grow.

  During this time the performance tab reports consumed memory exceeds granted memory.

  Everyone saw this behavior, too? Is this normal or am I facing a memory leak here?

  Thanks in advance.

  Kind regards

  SilentGuy

  good no worries. Here's the jsutification who might come to our rescue.

  the reason to ask to the image is to understand tips on different time and or prabably model.

  officers of 3rd party as HP may be one of the reasons for these behaviours and this pumps memory when they perceive newspapers. I think it's side normal use would normally not go beyong 2000 MB for an esxi normal opertaing without no VM

  I suggest you to watch more than two days and see if it grows even more...

  hope this helps

• How to increase the video memory on my Satellite 1800-254?

  A friend give me a Toshiba satellite 1800 Lalonde - 254 s for use only watch movies for my kids. With graphics memory, it has its impossible to reproduce movies, so I increased the RAM to 512 MB graphics memory is 8 MB. How I increase the graphics memory? Is it possible?

  Thank you very much

  Titanico

  (Excuse my English, I use a translator)

  This old laptop has a graphics card with shared memory. In other words, when you have more RAM inside more memory will be used for graphical operations. According to the specifications of the laptop this old notebook was shipped with 128 MB of RAM, but can be improved up to 512 MB.

  Trying to find internet modules two PC100 256 MB with part number PA3069U - 1. 25 M and update.
  That's all what you can do about it.

• Question on the infrared driver for Satellite Pro U400 - 12 p

  I downloaded the infrared driver for Satellite Pro U400 - 12 p
  When I run the Setup, I get an error that says "the installation of the windows package file is not complete" or something like that.

  Anyway, he said that the Setup file is in ruins. Tried downloading it several times.

  Hope I have posted this question in the right forum.
  Thanks for help.

  When you download the driver to extract it to a folder created on your desktop. From there start the setup.exe file. It should work.
  Have you done the same?

• Beeps satellite 1800-204 - I use the CL3 & CL2 all RAM modules

  I tried to install a 256 MB Samsung M464S3323BN0-L1L in my laptop S1800-204. It did not work very well, I'm afraid :) The power light turns on but nothing happens.

  The original memories were a Toshiba THLY64N11A80 (64 MB) and a Samsung M464S0924BT1-L1H (64 MB). Using one of the old as well as 256 MB modules makes the computer a long beep and one short beep at startup.

  I wonder if the reason is that memory, I got is CL3, while the 'old' are CL2? Maybe the computer only support CL2 memory.

  If I could get a PC100 CL2 memory, it would work or require an organization special line/column too?

  Hello

  Toshiba recommend using these memory modules:
  PC100 256 MB (PA3069U - 1 M 25)
  PC100 128 MB (PA3005U)
  PC100 64 MB (PA3004U)

  The PA3069U - 1 M 25 is a module of Kingston - 256 MB - SO DIMM 144 - polig - SDRAM - 3.3 V ECC memory.
  In my opinion, you must use the memory modules with the same properties.
  In addition it s advisable to use similar modules in both banks.

• How can I increase the video RAM on Satellite 1800?

  I want to increase the ram video shared in (Trident cyberblade Ai1 vga) from 8 MB to 16 or 32 MB. My laptop is Satellite 1800-804. I'm not able to see the configuration of the BIOS for this module.

  Can anyone help?

  Remond

  Hmm, maybe I m wrong but as far as I know this laptop supports only 8 sheared MB memory graphics card. I did not found anything about 32 MB.
  In any case, if the BIOS has no option for memory sheared increasing so be it s is not possible or you should check the properties of the graphics card of the art.
  There, you should check the performance tab.

  But as I said above, it of possible that the graphics card is supported only 8MB

• Update the BIOS on a Satellite 1800-314

  Hello

  I have an old Satellite 1800-314 and I want an update of the BIOS. I did an update of the BIOS on my desk, but never on a laptop. Is there someone who could help me with a manual or something else?

  Hi Antoni,

  I also have a Sat 1800-314 and I could explain how to upgrade a BIOS.

  The first step is to find your current version of the BIOS (in the HWsetup or look you in the BIOS, after turning on the power button, press and hold ESC and you will enter the BIOS), then the next step, go to the Toshiba site http://eu.computers.toshiba-europe.com, then click on support & downloads and go to the support home page and look if there is available as your latest BIOS version and download it.

  If the preparation is done and you have to extract the zip file containing the upgrade of the BIOS on a 1.44 MB formatted floppy. Make sure that the PC is connected to the power adapter. Stop, and then turn on the PC. Press and hold the button depending on the layout of the keyboard is located right between the keys Alt Gr and INS pushed until a beep sounds and the message "ready for the update of the BIOS. Place the BIOS update floppy in the drive and press any key when you are ready to move forward,"will be displayed.

  Place the floppy disk containing the BIOS upgrade in the floppy drive and press a key. FDD access will begin. When you're prompted by the message: "Please push the RESET switch (or turn the AC OFF power off / WE) to restart", remove the disk and turn off the system and turn it on again to restart the PC.

  BEWARE: Info-BIOS-Ce is only for a SATELLITE 1800 314!

  I found this Information on the following site http://eu.computers.toshiba-europe.com when you go to the Support home page and click on the Knowledge Base. You will find a very good FAQ of the BIOS that contains all the various procedures of BIOS for Toshiba laptops.

  Rudi Bye

• Unable to connect to the Internet with my Satellite 1800 712

  Hello

  had to reinstall Windows XP Home on my Satellite 1800-712, unfortunately do not have the recovery disc otherwise it would all be ok.

  Now, I can't get on internet, I downloaded new drivers for LAN, they installed ok, LAN is set to autodetect, USB wireless dongle drivers installed everything is ok.

  In my tray icon (bottom right) shows the networks but with red cross... I get a message saying that wireless networks are within range, click here to see the networks... when I click, Sun protection comes up saying no. networks in range... aarrrgggh.
  What can I do, please?

  Hello

  First you need to check if the wireless network adapter appears in Device Manager (expand network controllers).
  If the local network adapter is listed and there is no yellow exclamation point, this means that the wireless network adapter has been installed correctly.
  Now you have to activate the Wlan switch (somewhere on the side of the laptop) and the FN + F8 key combination.

  Now Wlan is enabled and you should be able to set it up.
  You can use a 3rd Wlan tool part for configuration or specific parameters of Win XP.

  Check it!

• Re: upgrade memory for a Satellite 1800-921 PIII 1.1 GHz...

  I am trying to find the memory upgrade for my Satellite 1800-921 PIII 1.1 GHz... Part number: PS183E-00HTT-EN.
  The vehicle is currently a Nanya 256 MB SDR 133 Mhz - CL3 and I undestand it can be upgraded with an additional 256 MB card.
  The only problem is that I can't find a compatible! Any ideas what's need & where I couldn't leave?

  Hello

  The compatible module is PC100 256 MB with PA3069U - 1 M 25 part number.

• Equium A60-155: a few questions about the memory

  Heya everybody,

  I recently studied an upgrade of memory see Soulseek cause BSOD on my machine because of that I think it's "not enough memory". I have 256 MB ddr (64 of which goes to the graphics card which is a pain) aboard and I know I have 1.2 GB on board senior. My questions are:

  1. how many slots memory are there on the motherboard?

  2 if I wanted to buy a memory chip that is should I choose; 184 pins or 200 pins? I could not know that one is my chip of 256.

  3. I found a few sellers on ebay who sell 1 GB chips (pc2700 200 pins), a chip of the United States won't work on my laptop without any problem of "tension"?

  Thanks in advance

  Mirko

  Hello

  I found the info on your device:

  -upgrade that a location is available
  -l' device can handle with max 1280MB
  -module of memory is PC2100 DDR - RAM
  -module 1 GB compatible is 1024Mo PC2700 (PA3313U-1M1G)

  Good bye

• Question about the memory consumed and active

  I have esx4.1 on three dl585 running. I have about 100 active vm running, and I have a small question.

  My vm is all 2008 r2 datacenter and I gave them 1 cpu and 4 GB of ram. When I recover a single virtual machine and look at the summary page, I see the bones of memory consumed host 4075 mb and the active guest memory 81 MB operating system. My question is can I reduce the host cunsumed memory to 2 GB without noticing a difference within the virtual machine?

  It looks like you can.   To be absolutely sure that you'd need monitor assets long enough to have a good idea of what the average is and what are the tops.

• Equium P200D - question about the memory usage

  Can anyone help?

  I just bought an Equium P200D and noticed it uses 700 MB to 800 MB (minimum 40%) of memory even when not doing anything, there is an AMD x 2 with ATI onboard 62.

  Is that correct under Vista or something wrong: the system seems slow.
  Any help would be great.

  Thanks in advance
  Justin

  Hi Justin

  Don t worry buddy there is nothing wrong!

  Fact is that the Vista operating system eat resources of the laptop! He needs a lot more resources as previous operating system MS

  So relax and enjoy your beautiful machine
  ;)

• Questions about the record HDD Recovery - Satellite L350D

  Hello everyone!

  I have a Satellite L350D with Windows Vista.
  I'm in my mind to reinstall.
  All my data from the two partitions are saved with the exception of a folder on my drive E Data "HDDRecovery" who shouldn't be modyfied or deleted, or whatever.

  I wonder if all the data are removed from the hard disk due to formatting, how does appear that this same folder HDDRecovery remains safe on the hard drive?
  Or is that the hard drive is not really formatted and data on my hard drive are always safe and hidden?

  Thank you for answers!

  Hello

  I'll try to explain how it works.

  Original Toshiba designed for your laptop recovery image is recorded on the second partition in the file called HDDRecovery. This image should be used if you want to install OS and have the original state factory.

  For this installation, you can use this recovery image of the second partition or by using the recovery DVD. It is recommended to everyone to create this recovery DVDs. Have you created?

  If you use recovery DVD the whole HARD disk will be formatted and all data stored thereon will be removed.
  If you start the HARD drive recovery process only C partition is removed. This folder HDDRecovery is important if you only want to use HARD drive recovery facility. When you want to use the DVD only you can remove (I do not recommend you to do).

  I hope I could help a little, but if you have any other questions please let us know.