Reference Dell 3100cn Laser Printer

Similar Questions

• (Redirected) new Mac trying to get non supported Dell 1250c laser printer for work, Dell does not give me a driver

  Have a new mac book pro 13 "computer laptop. have a dell 1250c laser printer. He used to work with my 17 "pro, but not now. Software  OS X 10.9.3 (13D 65)
  Dell does not provide a new driver for my new mac book pro 13 "
  In addition, it will show 3 pages of device settings - ea time I try to print by pressing the buttons on my Dell, but not the page I want to print.  Help?

  Best of this post in the Forum of devices/printers, here:

  http://en.community.Dell.com/forums/3528.aspx

  Bev.

• Jet Dell 1130 laser printer, the red light keeps blinking

  I have a Dell 1130 laser printer. It prints well and all the time. Problem the red light continues to Flash. What should do?

  According to the manual, a red flashing! slight implementation:

  • A small error and the machine is waiting for the fault to be cleared. When the problem is corrected, the machine picks up.

  • Small amount of toner is left in the cartridge. The estimated life of toner cartridge is close. Prepare a new replacement cartridge. You can temporarily increase the print quality by redistributing the toner.

  If you have a new authentic toner cartridge, try to reset:

  With walking and the cartridge door open, press and hold the Cancel button until all lights flash in sequence. Release the button and close the door.

• Reference Dell 3100cn impression faded and white bands on the right side

  I have a Dell 3100cn that has about 3 years and I started to experience 2 lines of dots down the right side in each of the CMYK about 1 inch from the right margin.  With some additional impressions, points has continued and the right margin collapsed to some.  When he meets it, I inspected the original drum, which had 13 000 impressions color top and found a pattern of noticeable wear on the roll right where the points emerged, which is also in the middle of the faded area.

  Since then, I've replaced all 4 cartridges (no change) and the drum (this removed the points) and the points are gone, but faded on the right side are always present and sometimes introduce a little yellow toner into a stipe as well.  Any ideas what may be the cause - possibly a roller needs to be replaced?

  Here are some pictures of the problem: http://picasaweb.google.com/kerrylandis/Dell3100cn?feat=directlink

  Any help would be most appreciated.  Thank you!

  Kerry

  Did you clean the stuff off the coast of the new drum unit? There SCRATCHES, left on the drum, after that you do? If so, this drum unit is "toast".

  Once again, excellent photos. Nothing seems to be "demonstrably" false except for one thing... I noticed you are using 3rd party toner carts. In this model of printer, which is bad news. I'm sure they are cheaper, but in the long run, you'll end up paying a lot more to get your machine fixed.

  3 toners (in this printer class) do not have the same OEM toner xerographic properties. In your case, it seems as if the black toner from the black developer is agglutination at the drum, preventing all other colors to make an efficient transfer. You will need to replace all the 4 cpl developer and all 4 carts of toner (with original parts) just to be sure. Not cheap.

  By law, manufacturers of printers are prohibited by the "us clay Act and Sherman Act ' and the 'Canada competition law" and other laws of you ask to use their cartridges. That said, this Bill does not mean that OEMs are responsible for repairs when downgraded 3rd party or products are used in their machines. Also, this Act does not require manufacturers to share their toner formulation... usually a trade secret... with their competitors.

  Some manufacturers use special formulas for their toner. All 3xxx/5xxx series Dell COLOR laser printers fall into this category. IF 'other' toner is used in the machine and the machine is damaged, repair of that circumstance is NOT covered by your warranty. In other words, you will have to pay for the repairs until the machine is fixed, then, the machine is back on warranty. I know from personal experience that Dell has this policy.

  I know your warranty not on now... but it will cost you some $$ if you want to restore this machine perfect condition. More than $$ printer is interesting, but it's your decision. (you might think of parting with the machine on eBay)

  Personally, I no longer buy third party carts... NONE of the 3rd party resellers ask if they will guarantee repair of the printer costs if their product causes damage. If they say yes, ask in writing.

  Sorry I don't have better news for you.

• Reference Dell 3100 cn - prints light down left side

  Had problems with my 3100 cn laser printer impression of light on the left side of each page, so I bought a new drum thinking that was the problem, but it did not work. I use Dell toner and toner levels are fine, so I wonder why the print quality is poor? Ideas please!

  Thank you

  Paul

  paulchapman31,

  Try to clean the toner by following the information below.

  A wand of cleaning for cleaning the printer is installed on your printer.
  1. open the front door.

  2. remove the scroll bar that is inside the printer right up to the stop.
  Access window cover slides open.

  3. hold the cleaning rod and push the stem and shoot once to clean the inside of the printer.

  4 move the slide to its original position.
  5. close the front cover

• Windows and Dell 5100cn Laser printer 8

  So I don't see this printer is NOT SUPPORTED on the list for Windows 8. Is there an alternative to maybe install the driver in compatibility mode. I've seen it suggested for other printers, however the Dell 5100cn is not an EXE installation.

  If I can't use this printer, I do have a weight of 65 books office paper.

  RW

  Reference Dell 5100cn, 2013 Office 64 bit on Windows 8.

  Had the same problem, each office application has crashed during the selection of 5100cn and other applications has worked well.

  I have installed the 5130cdn PCL6 driver in Windows 8, works like a charm with office.

• Reference Dell aio 962 printer suddenly stops and flashes "left cartridge incorrect".

  While the printer is working correctly, all of a sudden for no reason apparent stops and flashes "LEFT CARTRIDGE INCORRECTE. All attempts to address this problem have failed. Use the cartridge Dell XL Black series 5. Another cartridge change has no effect.

  Please advise as soon as POSSIBLE.

  Contact Dell, as the printer indicates a kind of hardware failure, it will not be a Windows fix for it.  Go to Dell web and some pilots and support, enter your printer model number and go from there.

• Reference Dell V310 W printer malfunction

  My Dell V310 series printer prints 1 document "job" perfectly, regardless of the number of pages. But it will not print the next job. The document will be displayed in the queue with a status of "impression". When I try to delete the document, it reports "deletion", but the document remains in the print queue. If I restart the computer the document is no longer in the queue and if I select the document again it will print. But I cannot print another document, unless I restart the computer. Putting off the printer and has no effect. My computer is a Dell Studio XPS 9100 running Windows 7 and is connected to the printer via wireless LAN. I tried this on Dell laptop my wife also running Windows 7 with the same results. The printer reports that has the current drivers and firmware. I spent a lot of time today reload the printer and connect to the local network without success. The fact that it prints the first "work" perfectly and the printer sounds like its going to print the next job but 'hold' is above my pay grade to fix. Appreciate any help. WEarp

  WEarp,

  In the batch of December of Windows updates, Microsoft has installed Internet Explorer 11. IE11 caused printer problems.

  Open Internet Explorer, click on help, then click about words of Internet Explorer. It should show the version here. If you IE11, then go to control panel, Windows Update, updates installed, look for Internet Explorer 11. Click Internet Explorer 11, uninstall.

  Restart the computer when you are prompted. Then see if your printer works.

  Rick

• Reference Dell V313w to printer all in one. Scanning documents record a new GB Flash Drive.

  Notice: part missing... directed to OCR on the printer CD, found the part. Must be an administrator to install, restarted in Administrator Mode. Try to install ask password for Windows, gave the password, it was wrong. Brain storm to change password, can't do that, need to change to new password old password. Where can I find the old password?  Another question: at the moment all the analyses and printer made a partial closing down. The power light does not turn off, but nothing works.  How to fix this?  I uninstalled and reinstalled and the printer is set as default, as said to do.

  Thank you for your help.

  AHarris343,

  Not knowing the brand and model of your computer and the operating system is not very useful.

  You can try...

  First run, delete print jobs to eliminate any print job stuck in the queue.

  Unplug the printer.

  Uninstall the printer, start, Control Panel, programs and features (Add/Remove Programs) Dell V313 printer, uninstall.

  Restart your computer.

  With online computer, insert the floppy disk to the printer and install the printer. Because the printer is already installed, you can select additional computer, and follow the instructions. This should install it the printer and OCR program.

  Rick

• Reference Dell Photo A10 printer 692 cannot communiate with professional Dell XP computer

  The printer works fine when it is attached to another computer...  He... "serve - to"... work very well on XP...  Last week, I tried to print I clicked on file... click on print... Printing box appears... I implemented what I want print, full dockument, how many copies, ect... click on 'Print' nothing...  As I said at the beginning, the printer prints and communities with the computer when I'm clinging to my other XP... I don't understand why I get an error communation with other... Everything is hooked up the same I checked to make sure that several timer... "RATS"...

  Greetings distinguished

  Mr. Rose

  E-mail address is removed from the privacy *.

  Mr. Rose,

  Dell does not have a printer A10/692. Go to information on Dells inkjet, all-in-one printers
  go to the printer model you have and the installation instructions are here.

  Rick

• Dell 1320c Laser printer prints something red to orange

  My dell 1320c printer has recently started to print all the Red objects in a document in orange, all ink cartridges are full. Someone knows how to fix this?

  As the link above for www.nos-computers.com, was on an inactive site I put detailed information on similar questions on this page

  en.Community.Dell.com/.../20872557

  I hope that this help anyone with similar problems.

• (Redirected) Reference Dell 1815n-photocopier/printer/fax(Error file format not supported trying to print from a USB flash drive stick)

  So I saved for different types of documents on a flashdrive (PDF, Word, Excel) and after having placed the flash stick drive in port on my Dell 1815n, an error pops up that States format not supported for files. I have formatted the USB stick, but cannot get anything to print. I tried 2 different flash drives to ensure that either has not been corrupted? Any help?

  Best of this post in the Forum of devices/printers, here:

  http://en.community.Dell.com/forums/3528.aspx

  Bev.

• Reference Dell V715w stops printing after 1 post

  Hi I have a Dell v715w which stops printing after printing 1 job.  I mean it prints 1 whole work and then 5 minutes later if you are going to print anything else nothing happens.

  I have to remove all the dle *. * process, stop the spooler service, and then restart the spooler service for and then restart the print job.

  Any ideas?  Help?

  This becomes quite painful when you want to print more than one thing at a time.

  Thank you

  SkrOfInfo,

  Happy that you guessed it work! Thanks for posting back.

  Take care

  Rick

• Dell 2230 Laser Printer sometimes I get this message: host driver printer for 32 bit applications has stopped working.

  Recently, I started using a new computer - a Dell Precision M6700 with Windows 7. Previously, I used a Dell with Windows XP and had no problems with my printer. Now, I have intermittent problems with get this printer to work. Sometimes it works fine, but sometimes, I get this message:

  Host driver printer for 32 bit applications has stopped working. I clicked so he could find a solution online, and it is never able to find one. I just get another message that says:

  An unknown error occurred while printing.

  Problem event name: APPCRASH
  Application name: splwow64.exe
  Application version: 6.1.760.1.17777

  Do you recognize this problem and is there a solution?

  Hello

  I suggest to go through the steps from the link provided and check.

  Printer in Windows problems

  http://Windows.Microsoft.com/en-us/Windows/help/printer-problems-in-Windows

  Method 2:

  If the problem persists, you can also run a full scan using the Microsoft Safety Scanner and check.

  http://www.Microsoft.com/security/scanner/en-us/default.aspx

  Note: there is a risk of data loss if all the files are infected and which can be removed in the cleaning process.

  You can also contact Dell to:

  Product support

  http://www.Dell.com/support/troubleshooting/us/en/04/troubleshooting/ProductSelector

  Hope this helps and keep us posted.

• Reference Dell V715W is printing very slow

  I recently installed the Dell V715W printer it installed ok and print ok, unless you want to print anything that has all the graphics on it... He takes seriously until 5 minutes to print one or two pages.  If you want to print just a word with text document, it prints quickly.  Any ideas on why printing is so slow?  I am running Windows 7 64 bit

  A few thoughts more...
  -would be good if you could test it with another wireless router in exclude
  -with certain printers, there is an option to basically 'print as image' (makes a huge difference when we had a similar problem with PDF - totally different Scenario however).