Satellite P10 and Netgear USB dongle use

Similar Questions

• Acer XC-605. I have a wireless usb device and a usb dongle. Can I replace my w wireless card

  Acer XC-605. I have a wireless usb device and a usb dongle. Can I replace my card without extra wire with usb3 Sockets. If so, should what material I go for? Front Sockets have been botched again and are now worse thn useless. Thank you.

  Thanks Asdfguy86. The map you suggested was not good because it was full of size, but, thanks to your liknk, so I knew what to ask and what seearching I just added "low profile."

  My search came up with this https://www.amazon.co.uk/gp/product/B008N3FPXS/ref=oh_aui_detailpage_o01_s00?ie=UTF8&psc=1

  This has also been enlarged but came with an alternative mounting plate.

  There is a free space above so I was able to move my antenna wi - fi so far and release the slot for pci express to the new card usb3 so I was even able to keep my embedded wireless and bluetooth. What a result!

• Satellite P10-133: I want to use the WLAN

  Hello

  What should I do when I want to use the WLAN with the satellite P10 133?

  Thanx

  Hello

  First that you check if your laptop has been equipped by the wireless network adapter.
  If this isn't the case, then you need to update.
  The easiest way would be a use of the WLan USB key.

  Check your WLan router level. There are different WiFi standards such as 802.11 A, B, G and N
  If your WLan router supports 802.11 B and G, then you should buy and stick that would support both standards too!

  Then configure the WiFi network (especially it s described in the installation instructions provided with WLan stick) and the WLan router.

• Satellite L10-333 PSL10E - USB dongle problem

  HI members, I have a Toshiba satellite L10-333 MODEL No. PSL 10F now I bought a 02 usb wireless dongle.
  now my problem is that whenever I have start my laptop and connect to 02 to get online, the dongle starts to make a loud noise, which is constant and pushes me insane.and it breaks to the top of the internet connection.

  now, I was on the 02 forum, told me it might be the usb port is bad, or maybe I should try re - install the usb drivers, I can not find on the web site of Toshiba, seem to be an error with the results.

  I don't want to spend any more money for this laptop, as it s old for a few years and I have already replaced the screen
  at a cost of £150. can someone help me please.

  I don't have any other Internet, only the dongle... Thank you Paul.

  Jin

  > maybe I should try re - install the usb drivers, I can't find it on the web site of Toshiba, seem to be an error with the results.

  Download chipset utility of [page driver Toshiba | http://eu.computers.toshiba-europe.com/innovation/download_drivers_bios.jsp] and install it

• Satellite P10 and so-DIMM DDR400 problem

  (First, hi to all and sorry for my BAD English: o)

  Given that I have install my new memory DDR400 (Corsair Value Select VS512DS400 x 2) in My P10, problems occur: error in windows, Crc in files compressed, etc... I try with my old DDR333: no problem.

  Give it a try with a friend of mine who have the same P10:
  exactly the same error

  I do some research, and I found a possibility:
  I see in the technical data sheet for DDR400 (and all the DDR400 SO-DIMMs are like that) the required voltage is 2.6 volts.
  And for the DDR333 needs only 2.5 Volts.

  I want to know (or confirm) if DAL00 motherboard which is inserted into the series P10 (I use 1.90v bios) can proceed to 2, 6V?

  It was very strange because I use CPU - Z to determine how fast is used for DDR400, bios seems to determine the correct speed for DDR400 (200 Mhz) and pass the FSB ratio to 1:1, Arf! good for this point! : o).

  The first time I saw the DDR333 memory in the Toshiba
  with a 3.0HT processor (which use bus 800 Mhz Quadpumped)
  I was very surprised! : o).
  Eheh, Toshiba engineers maybe had same problems when
  they used the DDR400 on it?

  Can you help me for this technical problem?

  Best regards, Ray

  Hi Ray

  In your case is problem BIOS don't recognize new RAM module. It's very nice that you are interesting about this problem, but this kind of question can be answered simply by an engineer or expert, and it will not solve your problem.
  Always is it that you need RAM DDR SODIMM (333 MHZ). The best solution for your unit is to buy one of these three modules:

  256 MB (PA3311U - 1 M 25)
  512 MB (PA3312U - 1 M 51)
  1024MB (PA3313U-1M1G).

  Good luck!

• Satellite P10 and the graphics card driver updates

  Hello

  I'm a newbie on this forum, but let's get to the point. I have Toshiba Satellite PSP10E (PIV 2.8HT 800 Mhz, 1 GB of system memory bus speed and UNFORTUNATELY a GF 5600go...).
  My (not only) problem is that Toshiba use engineering video BIOS version and it does not have the latest drivers for the geforce series. The most up-to-date driver that really works is the last of the series 5xxx... so you can see that none of the newer games can be run with a performance on this map... because older drivers don't use really not (available at directx9.0) 2.0 pixel shader. It would not be a problem if Toshiba would give an update not only BIOS system, but also the bios video (new system BIOS contains the same old video bios.

  I really had to settle for playing games that are 2 years old? First of all pay a lot of money for a witch of the computer has enough power to run some new but don't care support Toshiba for this...

  I was the proud owner of a Toshiba laptop, but I'm not! If I had to choose again, I decide to buy computer Toshiba...
  My Question: is that Toshiba will do something with this problem? Someone knows how to help? Thanks for any help (I have not found such a problem in this forum, sorry if it has been the front sign) and sorry for my English (hope that's understandable)
  My video Bios is: v4.31.20.56.A6

  [Edited by: admin]

  Hello

  We know that you can not install the drivers downloaded from the download page of GF because of the restriction of material. It's not only the Toshiba models, but also on other producers of portable and if you visit the download page of graphics cards, it is always recommended to download drivers designed by the manufacturers of portable.

  I think that nobody can explain why it's because I'm sure you know the reason. The performance of the graphics card will always be a topic of discussion and you will always want to have maximum performance for games with laptop, although performance may not be the same as on the desktop where you have the possibility to change the graphics card and install the latest drivers.

  Because of this, I think that it is really unnecessary to some turbulence here. Believe me, you can buy what you want, but after two or three years you will be always satisfied with something.

  In any case, good luck and enjoy life!

• Satellite L500 and WIn7 upgrade - cannot use FN + F9

  Hi everyone, New here so I hope someone can help.

  I recently bought a Satellite L500 with Vista operating system. I've upgraded to Windows 7 with a upgrade Toshiba drive. After the upgrade I could no longer use the FN keys to switch my touchpad back on.
  I had to get a bluetooth mouse to use a pointing device. Can someone help me get the keys FN working again.
  Thanks in advance. Mickbarker57.

  You have problem with FN + F9 only or flash cards do not work?
  Have you tried to check the properties of the mouse and use the enable/disable option here?

• Satellite P10-304 bad USB

  I recently had the above in the hope that I could solve a problem USB.

  The laptop was running XP SP1. I have SP2 installed, reinstalled drivers and updated bios update, but still no luck.

  Now, windows has detected 4 controllers, 1 enhanced controller and 5 poles, all this without obvious conflicts (no! on a yellow background).

  Yet when nothing is connected a known working device (ADSL USB modem) occurs, no device detected, no noise, no nothing.

  However, on the modem the USB flashes red that means it must be power of attraction of the port.

  In addition, there are 5 hanging of IRQ 16 devices, 2 USB controllers, graphics nVidia, cardbus and SD card controller card. Would it be the cause of the problem?

  Help, please!

  Hello

  It may be that you need a USB hub with external power supply as USB ports for laptop does not provide the same power as a desktop!

  Good bye

• Satellite P10 554: what does "removable devices" on average of start menu?

  Hello

  My DVD burner does not work, so I have no chance to install Windows XP from the recovery disks. I tried to boot from external DVD writer, but the device is not recognized. Similarly a bootable USB key.

  That means Toshiba with "removable devices"? Or I made a mistake?

  Thanks for your replies.

  Best regards
  Frank

  As far as I know Satellite P10 and P20 have removable optical drive. You can remove the CD/DVD drive and put it inside the floppy drive and use it as first boot device.

• Can anyone recommend a compatible 3G card for the Satellite P10

  Can anyone recommend a compatible 3G card for the Satellite P10?
  I tried to use a vodafone gprs card that the machine would not work with.

  Thank you

  Hello

  You want to buy a PC WiFi 3 G/GPRS card?
  These cards use the PCMCIA port and should work on most laptops that provide this PCMCIA location.
  I think you'll find many cards if you googel in the internet.

  Check it out and

• Satellite P10 - after installing XP, the SD card reader does not exist

  I formatted my Satellite P10 and complete nine with XP SP1 installed. Since that time the integrated SD card reader no longer exists in the system (when I insert an SD card it doesn't work). Is this a problem with a driver or what can be the problem?

  Before formatting, it's normal. Pleas explain easily. I'm not a professional user.

  Hello

  What drive did you use to reinstall Windows XP? If you use the Toshiba recovery disc are all drivers and pre-installed tools because the disc contains a picture of the factory settings.

  In your case, I would try to install the latest driver for the European driver of Toshiba download page card reader. Maybe it's just a driver problem you s wrote:
  http://EU.computers.Toshiba-Europe.com > support & downloads > download drivers

  I m wondering that you only use the SP1 for XP. SP2 or SP3 new contains a lot of important security updates. I recommend you to update your XP version.

  Welcome them

• Satellite P10 TV OUT button does not

  Can someone help me, I recently rebuilt my laptop Satellite P10 and now noticed the TV OUT button on the side right does not work. The OS is XP PRO

  I can use the F5 key, but who want to get this dedicated button works, someone at - it ideas

  See you soon

  Dave

  Hi David,

  When you have rebuilt your laptop you re-install the operating system and all the utilities Toshiba? I think that the button that you are talking about is controlled by the Toshiba EasyKey utility.

  HTH

• [Urgent] E3276 USB Dongle is unable to connect to RV325

  Dear experts - I need your help. According to the list of dongle, Cisco RV325 is supported USB dongle E3276. However, I can not connect with it properly (you can see the USB1 is connected and seeing USB Dongle appears connected). I'm trying to use this dongle with Windows to access the 4G network properly. Help, please! Please give me some advice!

  Kind regards

  Tommy

  Hi ImkTommy79:

  If you need help for this dongle, please contact the Small Business Support Center (HWC) and ask them to escalate the case to L2 and so the beta code can be assured. The Document should be updated...

  https://supportforums.Cisco.com/document/12316401/dongle-support-rv320-and-rv325

• Need new HDD for Satellite P10-304

  Hi guys.

  Does anyone know where I can buy a hard drive for the laptop above to reinstall complete

  Current hard drive is officially dead!

  Concerning

  Paul

  Hello

  I found some info on the HDD on Satellite P10:

  It can be used a 2.5 ", 9.5 mm hard disk with capacity of 30 GB / 40 GB / 60 GB / 80 GB

  -Master - IDE bus
  -9.5 mm, 2.5 HARD drive carrier
  -Support synchronous Ultra DMA 100

  So for your laptop you can buy IDE HDD up to 80 GB of capacity.

  I think you can buy it everywhere. In PC Magazine, online electronic store, eBay...

• Satellite P10: The drive will not burn DVD

  Hope someone can help me,

  I have a Toshiba Satellite P10 and have just received some photos software, burning
  But my drive will not burn DVD, I try with discs DVD - RW which must work my laptop.
  What is happening is when it comes of the burn on the part of the disk of the process he starts, but it fails.

  I tried to burn it with Nero, but even if I burn OK on any CD discs with this software it will not work on DVD discs. It's really annoying because when the burning process it fails so that it makes the DVD - RW disc seem curupt and then my drive has problems mounting the disc to try a deletion once more.

  I have the Nero log file failed
  Done if it's any help to anyone.

  A big thank you Michael.

  Hello

  What about different DVD media? Have you tested the media DVD-R or DVD + R common?
  Have you tried different brands of DVD?
  I can't give you a properly answer why the drive can't burn your DVD - RW, but to my knowledge not every media is supported by the player.
  So I think you should check different DVDs.