Storage of mass and Keybord Hotkeys m70-165 contorller

Similar Questions

• Updating BIOS for Satellite M70-165 with Windows7

  Hello!

  I recently got properly installed Windows 7 on my M70-165 with all the drivers!
  I ve installed a SSD hard drive too and now the phone works really well.

  But now I would update as bios version. I ve searched on this site and I find the updated 5.30 - WINNER, but it seems that it is only valid for Windows Vista...

  My questio is:
  Can I install this version on my laptop?

  I want to be very secure before installing this because I don't want to mess up now...

  Can someone help me?

  Thank you

  First of all thank you for your report on installing Win7 on this old Satellite notebook. I had it a long time ago and I was very happy with it using Windows XP Home edition.
  Up to now, on this forum, no one has mentioned on the M70 and Win7 so there is not much info on this subject.
  Fact is that this old piece of hardware is not supported for Win7 and if you have installed and configured successfully don't change anything. Leave it as it is.

  Update the BIOS is not important and does not help improve your laptop as it is. You change any BIOS.

• Satellite M70-165 PSM70E - battery charging problem

  Hello
  My laptop is a Satellite M70-165 PSM70E. I use Windows XP Home Edition. I recently bought a new battery and it is impossible to charge more than 50%. I have updated the BIOS to 1.70 (for non Windows Vista users) and I still have the problems mentioned above. I tried to dischage completely and charge it again, several times, with no luck.

  Is there a solution?

  Another question. There is no 'EC' in the BIOS version, only "BIOS version 1.70". I hope there will be some calibration of the battery or the power management after the BIOS update, but there is no menu "Power Management" in the BIOS.

  Is this correct?

  Thanks in advance.

  > recently bought a new battery and it is impossible to charge more than 50%

  In my opinion the new battery is not OK.
  You must consult an another new battery maybe you bought a battery already used?

  > Another question. There is no 'EC' in the BIOS version, only "BIOS version 1.70".
  On the page of the Toshiba UE driver you can find a BIOS update.
  I guess that this update contains the EC update too.

• Re: Toshiba M70-165 (PSM70E) - question about keyboard

  On an old Toshiba laptop Satellite M70-165 (PSM70E), I installed Linux 13. But this laptop seems to have a strange keyboard. I think it's Spanish, since there is a right to the letter, and there is a on the letter as well. But every single Spanish keyboard, I checked on the internet is different from this 86-key keyboard that I have.

  So I'm rather perplexed and I hope you can help me... Thanks in advance!

  And what kind of help do you expect now?
  You want to buy a new keyboard for another language or change some keyboard with good?
  Can you please post exact model part number?

  Is your keyboard layout identical with this one I found in s manuals Toshiba?

• Re: My Satellite M70-165 is unknown in the Toshiba site

  I need support (drivers and instruction) for reinialize my laptop, but it is unclear in the toshiba Web site. Why is that?

  Toshiba PcDiag report:
  Data-2012/01/03 08:06

  [Information sul PC]
  Model Satellite M70
  Number parte PSM70E-01100JIT
  Number of series Z5265264K
  Version operating system Microsoft Windows XP Home Edition 5.1.2600 Service Pack 2
  Version BIOS V1.10
  Processor CPU Intel (r) Pentium (r) M 1.73GHz
  Memoria fisica 2048MB RAM
  Ability disco rigído 80,031,974,400 [bytes] 74.536 [GB]
  Ability spazio libero su disco rigido11, 920, 052, 224 [bytes] 11.101 [GB]
  Video Mobile Intel (r) 915GM/GMS, 910GML Express Chipset Family version is 6.14.10.4363
  Risoluzione screen 1280 x 800 pixels
  Color True Color (32 bit)
  Audio Realtek AC97 Audio version = 5.10.0.5870
  Rete Realtek RTL8139/810 x Family Fast Ethernet NIC version = 5.621.304.2005 address MAC = 00:0F:B0:A7:7E:DF
  Intel (r) PRO/Wireless 2200BG Network Connection = 9.0.2.25 address MAC version = 00:01:02:03:04:05
  Modem software Modem TOSHIBA version = 2.1.51.0
  Device IDE 1 MAST * A DVD-RAM UJ - 841 S version firmware = 1.50
  Device IDE 2 (nobody)
  Device IDE 3 HTS541080G9SA00
  Device IDE 4 (nobody)
  Device IDE 5 (nobody)
  Device ELBY CLONEDRIVE 1.4 6 IDE
  Internet Explorer 7.0.5730.11

  EC/KBC Version «»
  PS-MICOM Version «»

  > I need support (drivers and instruction) for reinialize my laptop, but it is unclear in the toshiba Web site. Why is that?
  It is not possible. Do you know why?
  You cannot search for laptop using the M70-165 model name. On the Toshiba download page, it is listed by model number. Your Satellite M70-165 a PSM70E part number so please use it for identification of laptop on the download page - http://eu.computers.toshiba-europe.com/innovation/download_drivers_bios.jsp

  Older models are listed in the option ARCHIVE.

  Please check again.

• Satellite M70-165: unit of CD/DVD can't read data DVDs - "not possible access to D:.

  Hello world

  I have a Satellite M70-165 equipped of a DVD unit MAST * a DVD-RAM UJ - 841S (5.1.2535.0 driver version).
  After years of 1 and a half with no problems, a few days ago, I restore the operating system (Windows XP Home) through the Toshiba restart DVD.

  Since then, the CD/DVD unit can read DVD audio, CD, or movies, but when I open a DVD (DVD software) data it is said that "it is not possible to access to the D:\." and something like "does not correct" (I use an Italian version of Win XP so I have to
  translate the messages in English).

  All drivrs are regularly installed and there should, in theory, work very well.

  I am a user of entry level, and I don't really know what to do. I attended every single forum on the issue for the past few days, but nobody does
  could help me.

  I would be extremely grateful if someone could help.

  Thanks in advance!

  Hello

  This error message has been documented on the site of Microsoft Knowledge:

  [Error message when you access the CD or DVD drive after upgrade you to Windows XP: 'Incorrect function' | http://support.microsoft.com/default.aspx?scid=kb;] EN-US; 315350]

  The documentation says that this problem can occur if the registration of CD from Roxio Easy CD Creator program is installed on the computer, and if the version of the CD burning program is not compatible with Windows XP.

  Please take a look at this Forum thread too:
  http://forums.computers.Toshiba-Europe.com/forums/thread.jspa?threadID=24203&MessageID=88868

  A user has solved this suppression of some video capture software that had a DVD DIY option.
  These programs may change the whole registry values and causes these annoying problems.

  Please check if you have installed these programs

• Problem with Mat * a DVD - RAM UJ - 841S Satellite M70-165

  Hello

  I have a Satellite M70-165 equipped of a DVD unit MAST * a DVD-RAM UJ - 841S (5.1.2535.0 driver version).
  After years of 1 and a half with no problems, a few days ago, I restore the operating system (Windows XP Home) through the Toshiba restart DVD.

  Then the CD/DVD unit can read the DVD-audio, CD, or movie, but when I open a DVD (DVD software) data it is said that "it is not possible to access the D:\". ». and some time "poblem whith I/O device. and the same problem that I have with some new cd (which were not burn)
  I have'nt try every thing. I come here to ask the question.

  Sorry for my bad English

  THX

  You can do the following: go to download drivers of Toshiba Europe site and check if there is an update of firmware for this specific player. If so, I strongly recommend you apply and check if it works.

  If the didn t of the firmware update worked later you assumed that the reader is defective and must be replaced.

  Welcome them

• I bought storage additional iCloud and even if my credit card was charged no extra storage has been made available.

  I bought storage additional iCloud and even if my credit card was charged no extra storage has been made available. Anyone with similar problems? Please notify.

  < re-titled by host >

  Hi cyspider,

  I understand that you have purchased storage additional iCloud and your credit card has been charged, but you do not see that the storage has been added.  Have you received an email from Apple regarding this purchase?

  The first thing I would say is to restart your iPhone.  Then tap general > storage & use of iCloud.  In the iCloud section, the amount of 'Storage' has changed?

  If the Total storage has not been updated, the link below will put you in touch with the assistance of the iTunes store team.  They will review your account with you and take measures to solve the problem.

  Get help with an item purchased from the iTunes Store or App Store, Mac App Store and iBooks Store

  Downgrades and upgrades storage iCloud

  Take care

• I get an error message of complete storage - please backup and remove your something online (can not see the full error message) when converting PDF reader to point rower inacrobat DC. Help, please

  I get an error message of complete storage - please backup and remove your something online (can not see the full error message) when converting PDF reader to point rower inacrobat DC. Help, please

  Hi debg25514049,

  You will not be able to export your PDF to PPT using the service Adobe export in PDF format.

  You'll need subscription to pack Adobe PDF or the Acrobat application to convert PDF to PPT.

  Kind regards
  Nicos

• Can someone provide me with a script powercli to clone a vm under tension of mass and customize them.

  Can someone provide me with a Powercli script to clone a vm under tension of mass and customize them.

  And where is the script will fetch this information?

• USB HDD as a data store and storage of VMS and new virtual machines

  I have a server Esxi 4.1 with 1 TB RAID 5 storage and 3 virtual machines. The storage is full and no space for another HARD disk, so my question is: would it be possible to use a USB HDD as a data store and could be included as a storage for new virtual machines or the VM? If so, could someone let me know how to do it because I'm not able to detect the HARD disk on the host itself.

  No, it is not possible to use a USB drive as a data store.

  Linjo

• Establish connectivity between storage ESX3.5 and windows Server 2003

  Hello

  I installed the server on HP Blade BL 460c ESX3.5 evaluation copy which has 60 GB of space. I have HP AIO 600 box with 1 TB of capacity and running win2k3 server OS storage. I want to use partion on HP AIO 600 box for all my vitual servers.

  How can I configure NFS partion on the storage win2k3 server and add on ESX3.5 server so that I can even use all virtual servers?

  Do not know the server storage, but I guess that NFS is what you would use

  Check

  http://www.RTFM-ed.co.UK/?p=228

  http://VMblog.com/archive/2007/01/23/using-Windows-based-NFS-in-VI3.aspx

• whenever I have stop storage usb mass, all the removable drivers disapered

  ho I fix

  Hi jeanalonso,

  1 when was the last time it was working fine?

  2. did you of recent changes on the computer?

  3. how to stop mass storage devices?

  If you use material to stop the mass storage device, then make sure that you stop the device required by double clicking on mass storage and more by selecting the required device to stop withdraw.

  If the problem persists after you follow the above then check out the link below and run them the troubleshooter available, check if it works.

  Tips for solving problems of USB devices

  http://Windows.Microsoft.com/en-us/Windows-Vista/tips-for-solving-problems-with-USB-devices

  I hope this helps!

  Halima S - Microsoft technical support.

  Visit our Microsoft answers feedback Forum and let us know what you think.

• Device drivers missing for storage of mass cont, sm bus cont, broadcom ush

  In the Manager of devices for my laptop, I have a yellow exclamation point indicating device drivers missing for Mass Storage Controller, controller SM Bus and Broadcom USH. I was not able to find a source or a solution.

  I use Win 7 on a Dell Latitude t6420 with Google Chrome installed.

  In the Manager of devices for my laptop, I have a yellow exclamation point indicating device drivers missing for Mass Storage Controller, controller SM Bus and Broadcom USH. I was not able to find a source or a solution.

  I use Win 7 on a Dell Latitude t6420 with Google Chrome installed.

  Have you TRIED same Dell?  They made your computer, they support the drivers for the hardware / equipment.

  Visit Support from Dell: drivers and downloads website and enter the serial number of your Dell Latitude E6420 and change the operating system to the correct (including the architecture 32-bit or 64-bit) and download appropriate drivers.

  You should get what you need under Windows 7.  Just be sure to install the card mother/mother/chipset drivers, network, communication, etc.  You should have a list of stuff you configured this system with.

• Storage utilization &amp; iCloud &gt; storage management &gt; Photos and camera

  I'm trying to free up storage on my iPhone 6 more running iOS 9.3.1. Photos is empty. Recently deleted photos is empty. Photos is disabled in settings > icloud > photos. The rockers are disabled in the settings > photos and camera. But its still appearing as using 440 MB of storage in the photo library and 30.6 MB in shared photo streams.

  

  How to explain and free this storage? Are there ghosts stored photos? All other discussions on this topic as the change of date and time has not worked for me.

  Is this storage room # or iCloud?

  If you connect to iCloud.com, see you there in Photos?