TouchSmart 610: Intermittent display blinks and turns off windows 10

Similar Questions

• Impossible to stop my flashing pointer (hourglass also blinks and turns off constantly)

  Several weeks ago my pointer flashes constantly (unless it's on a hyperlink or another element of the selection). The hourglass flashes also with her. I tried everythink in the Panel, but nothing works.

  Hi and thanks for joining the HP Forums.  There are many different processes which may cause your mouse will Flash in this way.  Here is a good thread where several different people have found what caused their problems and have been able to solve.  Please read the thread for ideas on what you have installed and try the steps provided to see if you can find the process that causes your error:

  http://forums.CNET.com/7723-19411_102-517913/mouse-cursor-flashing-busy/

  Thank you!

• problem with file NV4_disp stuck in a loop and turn off windows XP starts

  When booting I get this error message and the physical memory was erased.  I can then start only to the top through safe mode.  Have you checked the diagnostics and updates of pilot with no result. :(  Thank you

  Maybe your video driver needs to be updated.

• Satellite P300 - 20 H refresh the screen every 10 minutes and turn off during 3 sec

  Hey,.

  Basically, I bought my P300 Sat about a month previously and each time it runs, battery, the same error will occur...
  It will update the screen every 10 minutes or more and turn off for 2-3 seconds.

  This isn't a big problem, but it is annoying that I can not sort.
  I tried to run a check of problem to find a solution, but he says that he can not find a.

  Help, please
  Thank you.

  Hello!

  Can you please explain what you mean with refresh? And what exactly is happening?

  It is not easy to say what the reason is for this, but have tested an external monitor on the laptop? And you can determine if it s a problem with the internal display or not.

  In addition, you must make sure that you have installed the latest display driver and BIOS. The two you can find on the Toshiba site:
  http://EU.computers.Toshiba-Europe.com-online decision-making supported Downloads & => Download drivers

  If you installed a display driver Toshiba not you should remove it. These display drivers can often cause problems and don t have protection against overheating.

  Good bye

• Qosmio F20-154: BSOD and turns off

  Qosmio F20-154 goes to blue screen and turns off if the cd is inserted or if the flash drive is inserted
  Also hotkey error on turn on the computer

  Hello

  This means that you can not read data CD or USB key?
  Is this correct?

  Have you tried to boot from the CD or DVD?
  Have you tried to reinstall the OS?

• Satellite A60-181 heat up and turns off.

  Hope someone out there can help you.
  I was not able to use my A60-181 for awhile without being constantly plugged to electricity.
  And it seems to warm up and turns off.

  I bought a new battery, but I still get the same problem... and it is only 2 years old!
  Someone has an idea of what I need to do?

  In my view, this case is clear. It s a simple overheating. Usually the laptop stops automatically to prevent laptop damage material. Usually, this occurs if the laptop fans twist with speed and maximum performance.

  The reason for this behavior could be a dust and debris inside the laptop. Especially after 2 years of work and aspiration, the dust has a bad influence on the rotation of the fan.

  The module of cooling for computer laptop cleaning could help!
  But if you have no experience of it please contact the technician. It is recommended to clean the fans professionally.

• Equium A60: After BIOS update device will beep several times and turns off

  Hello

  I downloaded the windows BIOS update for my Equium A60 (dated 11/15/05) and ran the executable by following the instructions, after ensuring that the current AC has been connected, etc.. The update has got a little more to halfway when the computer turns off suddenly.

  Now when I try to turn back on it just a few beeps and turns off again. It seems to me that the BIOS is screwed. Is there anything I can do to get my machine to run?

  Thank you
  Phil

  Hi Phil,

  Unfortunately, it seems that if the BIOS of your laptop is corrupted. Unfortunately, he didn't there has no easy way for you to correct yourself and you will need to take the phone to your nearest Toshiba Service agent who has the necessary specialized equipment to reflash your CMOS with a new BIOS chip.

  Kind regards

• Satellite A135-S4666 - cooling fan turns on and turns off every 20 seconds

  Hello

  I'm from the Argentina... I just bought a new Satellite A135-S4666 and I noticed that the cooling fan turns on and turns off every 20 seconds.
  It is a little annoying and it disctracts me of what I'm doing... is there a solution?

  Thank you very much.

  Hi Martin,

  This behavior is perfectly normal and nothing to worry about. If you find the noise irritating cooling fans you are likely to change their behavior by using the utility of Toshiba power where you should be able to set the cooling mode to run more quietly. I think trhe default is to allow the CPU to run at full speed, which will, of course, the fans turn every few seconds, but by reducing the speed of the CPU, the heat produced will be lower and therefore the fans will run less often.

  Kind regards

• After the update to el Capitan my iMac will not be asleep. I put it to sleep and turn off the mouse and keyboard that goes with it, and 5-10 minutes later, he wakes up on his own. Now, I have to stop it after use and each time only. Major pain

  After the update to el Capitan my iMac will not be asleep. I put it to sleep and turn off the mouse and keyboard that goes with it, and 5-10 minutes later, he wakes up on his own. Now, I have to stop it after use and each time only. The Major pain. Any help would be greatly appreciated.

  Please test after taking each of the steps that you have already tried:

  Step 1

  Take all of the measures suggested in this support article, including those under the title "If the previous steps do not work." It is the starting point for a new effort to solve the problem.

  Note that, as stated in the article, the computer will not sleep, if some sharing services are enabled. In the menu bar, select

   ▹ System Preferences... ▹ Sharing

  Disable all sharing services.

  Step 2

  If sharing music iTunes home sharing is enabled, disable it or quit iTunes. Do the same with third-party applications that have a similar feature.

  Step 3

  Select

   ▹ System Preferences... ▹ Accessibility ▹ Speakable Items: Off

  Step 4

  Select

   ▹ System Preferences... ▹ ▹ Advanced Bluetooth...

  and uncheck the two boxes marked

  Open Bluetooth Setup Assistant at startup if...

  Step 5

  Reset the printing system.

  Step 6

  Back up all data.

  Triple-click on the line below on this page to select, then copy the text to the Clipboard by pressing Control-C key combination:

  /var/vm

  In the Finder, select

  Go ▹ go to the folder...

  from the menu bar and paste it into the box that opens by pressing command + V. You won't see what you pasted a newline being included. Press return.

  A folder named 'vm' should open. Inside, there may be a file named 'drag '. Move this file and only this one in the trash, but do not yet empty. You will be asked for your password. Close the folder window.

  Restart the computer and empty the trash.

• Why windows constantly error reports and turn off

  Why windows constantly error reports and turn off. It is THE most reliable service.

  * original title - sucks of windows *.

  Hello williamiscome,

  This error message do you receive?

  The computer shuts down or restarts it?

  Let know us and we will continue to help you.

  Best regards

  Matthew_Ha

• After installing something from windows update my computer start Startup Repair each time and said "a hard disk problem is preventing Windows from start" and turn off.

  Hello

  After installing something from windows update (about 300 MB in size) my computer start Startup Repair each time and said "a hard disk problem is preventing Windows from start" and turns off.
  Then a window pops up saying "Startup Repair cannot repair this computer automatically.
  The details of the problem say;
  Problem event name: StartupRepairV2
  Signature of the problem 01: AutoFailover
  Signature of the problem 02: 6.0.6001.18000.6.0.6001.18000
  Signature of the 04:65537 problem
  Signature of the problem 05: unknown
  Signature of the 06 problem: BadDisk
  Signature of the 09 problem: unknown
  Signature of the 10:1168 problem

  System Restore does nothing, and all the other tools of recovery. :(

  Please help, it will be much apreciated :)
  DOM

  If you are sure that the problems began immediately after installing a Windows Update, use the free support of MS here:
  Visit the Microsoft Solution Center and antivirus security for resources and tools to keep your PC safe and healthy. If you have problems with the installation of the update itself, visit the Microsoft Update Support for resources and tools to keep your PC updated with the latest updates.  MS - MVP - Elephant Boy computers - don't panic!

• I have automatic updates set to download and allow me to install. has stopped working 4 or 5 months ago. Now auto installs updates when I turn off windows. Impossible to control as I used to.

  something changed with my automatic update process.  I have win XP pro, completely up-to-date.  I used the icon, do a right click Select custom, see what updates there and install them when I was ready.  no longer works like that.  Today, as yesterday for is, I see the icon it says XX % downloaded, the icon disappears and then it's as if I never had the update.  When I go to turn off windows he installs the updates received.  very inconvienent.  Any advice.  I checked my settings, always the same "download and draw attention to me..." "Thank you.

  Hi DavidSklover,

  Refer to the procedure described in the link provided to reset the windows update components and check if it helps.

  Reset Windows Update components.

  http://support.Microsoft.com/kb/971058

  Let us know if this solved the problem.

• turns off Windows Defender and windows internet Explorer is always not responding - what goes wrong?

  turns off Windows Defender
  internet Explorer Windows Guard does not and any system runs slowly

  Hello

  Do a comprehensive check for malware, and then do the cleaning below. Remember that no one can detect program
  or remove any malware.

  It can be made repeatedly in Mode safe - F8 tap that you start, however you must also run them
  the Windows when you can.

  Download malwarebytes and scan with it, run MRT and add Prevx to be sure that he is gone. (If Rootkits run UnHackMe)

  Download - SAVE - go to where you put it-right on - click RUN AS ADMIN

  Malwarebytes - free
  http://www.Malwarebytes.org/

  Run the malware removal tool from Microsoft

  Start - type in the search box-> find MRT top - right on - click RUN AS ADMIN.

  You should get this tool and its updates via Windows updates - if necessary, you can download it here.

  Download - SAVE - go to where you put it-right on - click RUN AS ADMIN
  (Then run MRT as shown above.)

  Microsoft Malicious - 32-bit removal tool
  http://www.Microsoft.com/downloads/details.aspx?FamilyId=AD724AE0-E72D-4F54-9AB3-75B8EB148356&displaylang=en

  Microsoft Malicious removal tool - 64 bit
  http://www.Microsoft.com/downloads/details.aspx?FamilyId=585D2BDE-367F-495e-94E7-6349F4EFFC74&displaylang=en

  also install Prevx to be sure that it is all gone.

  Download - SAVE - go to where you put it-right on - click RUN AS ADMIN

  Prevx - Home - free - small, fast, exceptional CLOUD protection, working with other security programs. It comes
  a scan only, VERY EFFICIENT, if it finds something to come back here or use Google to see how to remove.
  http://www.prevx.com/   <-->
  http://info.prevx.com/downloadcsi.asp  <-->

  Choice of PCmag editor - Prevx-
  http://www.PCMag.com/Article2/0, 2817,2346862,00.asp

  --------------------------------------------------------

  If necessary here are some free online scanners to help the

  http://www.eset.com/onlinescan/

  http://OneCare.live.com/site/en-us/default.htm

  http://www.Kaspersky.com/virusscanner

  Other tests free online
  http://www.Google.com/search?hl=en&source=HP&q=antivirus+free+online+scan&AQ=f&OQ=&AQI=G1

  --------------------------------------------------------

  Also do to the General corruption of cleaning and repair/replace damaged/missing system files.

  Run DiskCleanup - start - all programs - Accessories - System Tools - Disk Cleanup

  Start - type this in the search box-> find COMMAND at the top and RIGHT CLICK – RUN AS ADMIN

  Enter this at the command prompt - sfc/scannow

  How to analyze the log file entries that the Microsoft Windows Resource Checker (SFC.exe) program
  generates in Windows Vista cbs.log
  http://support.Microsoft.com/kb/928228

  Run checkdisk - schedule it to run at the next startup, then apply OK then restart your way.

  How to run the check disk at startup in Vista
  http://www.Vistax64.com/tutorials/67612-check-disk-Chkdsk.html

  -----------------------------------------------------------------------

  If we find Rootkits use this thread and other suggestions. (Run UnHackMe)

  http://social.answers.Microsoft.com/forums/en-us/InternetExplorer/thread/a8f665f0-C793-441A-a5b9-54b7e1e7a5a4/

  I hope this helps.

  Rob - bicycle - Mark Twain said it is good.

• Is it possible to set up a computer to turn on and turn off itself every day or on any selected date?

  Is it possible to set up a computer to turn on and turn off itself every day or on any selected date?

  Mine is a HP G72-b27CL running Windows 7 64 bit laptop.

  Yes can schedule a task to start the system using the option shown in the screenshot below:

  

  You can schedule a task to turn the system off by as shown in the link below:

  http://www.thespinningdonut.com/how-to-automatically-shut-down-your-Windows-7-computer/

• Screensaver Windows 7 Pro x 64 and turn off monitor do not work

  On a new install of Windows 7 Pro x 64 (detail), the screen saver and turn off the monitor features do not work.

  I put the simpler (in white) screensaver at 1 minute and turn off the screen in 2 minutes, but are never triggered.

  I don't have a wireless mouse, as I read that may cause problems. All Windows updates have been applied.

  Please notify.

  Try to reinstall/update the chipset drivers and associated power, of your motherboard to the support site, maybe also an update of the Bios and