Z10 blackBerry how Z10 battery is 100% charged.

Similar Questions

• BlackBerry Z10 how to check that the battery is 100% charged for Blackberry Z10

  Hi, how do I know how much percentage does the battery get charged for BB Z10 mobile.

  Your battery gauge is usually a pretty good indication of what your battery level currently is.  If you want to see expressed as a number instead, drag down and follow the settings > on.  Make sure that the category is set to hardware and look for.  You can also get a lot of apps free battery in BlackBerry World, which shows the level of your battery.

  I hope that helps you.

• BlackBerry Z10 battery from 100% to 0% in less than 10 minutes.

  Hello

  My battery goes from 100% to 0% at least even 5 minutes of the removal from the wall outlet, when it shows 100%.

  What could be the problem? The drums that has bad shot? I had the phone since August 2014.

  Thanks in advance.

  It's just a matter of battery meter indication. Remove the battery for 90 minutes will usually reset the battery meter. Also helps sometimes to plug the charger before you reinsert the battery after 90 minutes.

• BlackBerry Z10 battery not charging to 100%, is stuck at 78%.

  Hello everyone, its my first post so if this is in the wrong section, or this problem has already been resolved, kindly link me to the correct message.

  I have my blackberry z10 not too long, probably 2 months, and as a first step, the battery was not serious. A full charge is 100%. There was 1 opportunity where I used it until the battery was completely hard and off the unit its own.

  He warned me 10% left and stops immediately after that. Now I'll have the problem of it not charging up to 100%. He shows me the icon of "lightning" up to about 75% where it stops and shows me the '=' sign as in fully charged or not charging.

  I tried to restart the device and even turned off while loading see that fixes the problem or not, but nothing helped.

  Someone here has the same experience? Any help or advice would be greatly appreciated

  Hello! I think that's it:

  http://supportforums.BlackBerry.com/T5/BlackBerry-Z10/Z10-battery-life-is-not-accurate/m-p/2447449#M...

• BlackBerry completely exhausted Z10 battery does not load when 10 BlackBerry smartphone is connected to the charger or usb

  Hello

  I have a BB Z10, two days ago, while the travel battery got completely exhausted and the phone got turned off. later, I connected to the BB charger and the phone does not charge, I tried to connect it to the USB, but it does still not load... just a constant red light nod. I tried to remove the battery for 2 hours and back and not luck it is plugged. Like I need my phone works, I tried to go to a service center but not able to locate one on the BB site, I bought a new
  BB Z10 battery and it worked fine. I went back to my place and it took about an hour for me and yet once again, the battery discharged and I am with the same problem now. Now, when I connect my Z10 to the computer (windows 8.1) I get a red + green slow light flashing and after say 20 minutes, it connects to the computer and the phone turns... and when I see the phone it says Exiting battery saving mode"" immediately followed by "turning off the appliance" and it loops constantly. "

  Help, please!

  It's weird, but not the first time I heard of this.

  See this: http://www.blackberry.com/btsc/KB36747

• BlackBerry Z10 battery charger Bundle

  I bought a package of the Q10, but then 'abandoned' battery charger device for the Z10. Can I charge/use the bundle to load the Z10 and/or use it if the Z10 is low the power in use by plugging the charger Q10 in the Z10? I understand that the battery may not be inserted into the Z10 but I was wondering if I can use the "bundle" as described. Thanks in advance.

  Welcome to the forums, yes you can do it.

• BlackBerry Z10 battery automatically

  My Z10 was drained battery Automaticaly now not Possible load (load not entered to Mobile)

  Hi @PVAjith
  How are you?
  Welcome to the official BlackBerry Support Community Forums

  use the official charger?
  the battery... charges but no showing indicators %?

• BlackBerry 10 Z10 battery drains 2 times faster after OS upgraded to 10.2.1.3062 10 Nov/14 software version

  Z10 battery drains 2 times faster after OS upgraded to 10.2.1.3062 10 Nov/14 software version (OS version is now at 3442). I use to charge my phone once every 4 days, but now I need to load every 2 days.

  I use no Bluetooth, no WIFI, have no applications running, no text and no phone call. Emails only 2 or 3 per day. Display says battery system 22% use, standby 7%, PIM 3%, home of screen display of 2%, 1%, and the rest are less then. 1%. I need to know what service or feature that turned on the update of the software so that I can turn it off.

  I ran a few tests and one of them was to turn on my WiFi. This reduces the rate of use of battery significantly drain (I would have thought would have increased with WiFi on battery drain). After the execution of WiFi for a day I shut it off and my battery usage seems to be back to what I had before the upgrade of the OS. I rebooted on Sunday afternoon, it's now Tuesday night and I'm only up to 63% and the unit figures monitor I have 2 more days still to go. Yes, problem solved by running WiFi for a day. Go figure.

• The release of blackBerry Z10 Z10 battery when the phone is turned off

  If I fully charge the battery and leave it on the phone, after a few days the battery shows 100% when I insert and turn it on. If I load completely and let in the phone with the phone turned off, the battery will discharge all night. Battery draining is 100% to 5% in 4-5 hours during the day. Nothing unusual in the monitor of the device.

  I reset the phone to factory settings, the same thing is happening. I pulled the battery then connected etc etc, no change. I tried with radio and wireless off.

  The sound quality is "tinny" when a call with volume turned up, could there be a hardware failure inside causing the discharge? The proximity of the enclosure of the power button would indicate a problem with the on/off switch button also the speaker?

  Thank you in advance.

  Dave

  The most common problem causing drain the battery of all equipment electronic is a capacitor shorted short, suggests that you send it for repair.

• Found blackBerry Z30 games to 100% charged battery

  Hello guys,.

  I ve bought a Z30 recently and I try to keep my battery protected to stop because as its not removable.

  My question is now, which is the thirsty?

  1. play games with the charger plugged in to 100%

  or

  2. to play games (not connected) and load all night.

  The second way is maybe bad as this shortens the circles of support right?

  Follow-up to question is:

  When loaded to 100% and always connected while playing, are the necessary tension levied on the battery or on the outled? As: draining 5% and load back to 100% or takes the z30 the energy behind the charger?

  > Sorry for my English, I'm German

  spyRIC wrote:

  When plugged with 100% charge: fact battery drain?

  Well it depends if you are draining more power than your processor is using. I expect to see the bounce charge 2-3% percentage points. As 100 98 > > 99 98 > 100, etc..

  spyRIC wrote:

  Y at - it all manuals that I can read?

  Not that I know of, on this precise topic.

  You're perfectly fine playing games and using the unit while it loads.

• BlackBerry Smartphones new Curve 8330 and charge the battery/question already?

  Hi all

  I just got a new Curve 8330 last week.  I noticed that it takes ages to completely charge the phone when the battery only about 40%.  The other day it took about 5 hours to get to 100%, I use the power supply provided and also tried the USB cable with the software already installed.

  Tonight, it's about 60 percent, and I decided to load it.  After 3 hours or more, he went up to 45, then 40% and I was not still use it.  Battery icon is there (the icon of the card) then he recognizes it is connected.  I did the battery pull and wait another hour, another 40%.  Then another battery pull and still 40% after an hour.

  I came on this forum and saw the mention of the app QuickPull.  Downloaded it, ran it, and after it restarted, it had fallen to 5%!  Now, it says "low battery" and I do not really understand why.

  Until I started typing this post, I made an another battery pull and abandoned the USB plug.  It is now back up to 15%.  I am really hesitant to reach a store because the last time I brought my LG phone on a known battery problem (getting bulgy where you can spin) and they winded in my entire phone replacement

  Please let me know what I'd do here.  Is this a battery problem, phone licensing, etc.?  What my expectations are on acquire it quickly back to 100%?  I do not drain the battery that much.  It took two days so he can go down to 60%, but I do not understand why it takes so long to load and then it seems to perform when I plug.

  Thanks for your time.  I know this is a long post.  My battery is now 20%?  So he went from 5 to 20% in less than half an hour so confused.

  If you had access to another battery and/or charger, I suggest that you try to change one and if it does not, another permutation. You will have to perhaps just take the phone back, but if I were you, I would make them give me a new battery and charger, just to be safe, because it looks like one or the other may be bad.

• Cannot charge the battery to 100% on X 1 carbon (A 20, 7) after the upgrade to Windows 10

  I apologize if it's buried somewhere on the forum. I searched for hours, really, but did not find anything about exactly that.

  After months of 'Upgrading to Windows 10' pop ups I finally did. On Windows 7, I was able to change my battery to 100% capacity before leaving for a business trip, then change it to the time where I went home. Now I can't find where to do and it won't load no more than 46%. I tried to download the Lenovo power manager that offered a job, but it doesn't have the menu item separate ' Power' as the instructions on the screen. I tried to uninstall the control method battery compatible ACPI Microsoft suggests another position, but that did not help either.

  I have that option after having upgraded my Yoga 2 to 10 Windows Ultrabook. Enegery Manager is still responsible. I just want the same control on my battery on my X 1 as I have on my Yoga. Can someone help me?

  Thanking you in advance,

  Clare

  I'll just throw this out there, no guarantee that your system has the exact configuration than mine or that I completely understand your problem: I have an application of parameters of Lenovo in my Windows menu. in this application of settings, there is a section of the battery, at the end of this section is a battery meter reset. I would start there get your battery threshold.

  I hope this helps.

• How the battery power can be adjusted to connect and charge

  Original title: battery

  How the battery power may be adjusted to trendy and supported? Power management does not allow chraging battery to mobile.

  Hello Examplaire,

  Thanks for posting in the Microsoft Answers forum! If you could provide the information requested by Thahaseena M, we can better help solve your problem. In the meantime, you can find help from the link below:

  http://Windows.Microsoft.com/en-us/Windows-Vista/power-plans-frequently-asked-questions

  Hope this helps J

  Adam
  Microsoft Answers Support Engineer
  Visit our Microsoft answers feedback Forum and let us know what you think

• Satellite Pro L500: amber flashing indicator - battery won't charge

  When power charge light blinks yellow.
  Battery does not charge and if the battery has been removed the laptop stops.

  When this problem does not occur.

  In addition, when the power cord is removed, battery charge for a few moments then yellow flashing lights and load stops. When the stop, the battery charges normal and 100% charged battery gives almost 4 hours of time.

  Can you please guide on the problem. Is the power supply problem? or the battery? or the card mother/material?

  How to check the problem?

  It seems that you already posted a similar topic topic with your laptop a few years ago.
  http://forums.computers.Toshiba-Europe.com/forums/thread.jspa?threadID=63225

  In the first case, it seems that your battery was the troublemaker.

  You are talking about charging light. I m not very well what LED it should be.
  There are 5 LEDs - from left: DC IN / power / battery / HDD, ODD / Bridge Media Slot

  The first DC IN indicator lights green when power is form adapter correctly provided HQ. However, if the output voltage of the AC adapter is abnormal or if power outages computers, this LED will turn off.

  The second left power led lights green when the laptop is turned on. If turn you the phone mode standby, this indicator flashes orange.

  The third battery indicator show the conditions of the accusation of pulp. Green indicates that the battery is fully charged, orange indicates the battery is charging and orange blinking indicates a low battery level.

  Question:
  Are you able to turn on the unit without the battery, but using only an adapter connected?
  Usually, this should be possible even if the battery isn't inserted.

• My laptop is plugged in, but the battery won't charge

  Hello

  In the last two months, capability of my laptop to charge its battery has degraded.
  She went to a battery completely (100%), not being able to load beyond 98% and then 66% and 30%, and now finally, it says "0% availability (plugged in, charge)", but it never increases support.

  Thus, the laptop works when plugged into the charger, but does not illuminate when it is attached only on the battery.

  I rebooted the computer several times - first to stop the machine, then unplug it, remove the battery, press and hold the Start button for a minute, then put the battery back, plug the charger in and rebooting the machine.

  I installed updates for "Stacks" (IE. Microsoft AC adapter, compatible ACPI Microsoft control method battery and battery Composite Microsoft) in Device Manager.
  I also uninstalled the Microsoft ACPI complaint method stack and shutdown and restarted the laptop several times.

  Earlier I called Toshiba support and update the BIOS of 1.50 to 1.70, then restarted the computer, but yet again, the battery won't charge.

  I bought a new battery, which showed that it was fully charged when when I have attached to my laptop, but when exhausted 0% load, I got the same message as for the other battery: "0% availability (plugged in, load).

  I am really puzzled. If not, how can I try to increase the capacity of my laptop battery?

  In my opinion, old battery was certainly defective.
  Is your new original battery, Toshiba battery or any part of third-party product?

  When you start Notepad without battery and put in place when Windows is loaded does the problem persist?