15 - ay006nq: return of sleep problem

Similar Questions

• Error ' ' system timer was triggered "and hibernation / sleep problem.

  Original title: Hibernation and sleep problem?

  I bought a new laptop of Toshiba C55 series probably a little a month ago and for a while, it was fine, I had no problem. I had some mistakes with what is called a bad pool header, I've not experienced this once again. My main problem is with the sleep and hibernation. I went and disabled any parameter that would be extended automatically to my computer after a short period of time. It is set at only hibernate after like five hours, I'm never away from him that long. I don't want it to hibernate unless I put it specifically put into hibernation. I heard talking about hibernation is hard on your computer. I am usually only away from him for a couple of hours, so it's easier to have it in sleep so I can come back and get the right to return to work or what I was doing. I put it in mode 'sleep' whenever I need to go away for a few hours, for some time, I had no problem, he would go to the mode standby and stay there until I woke it. My problem is that most of the time when I put it in fashion watches, it goes to the hibernate after only a few minutes. WHY would he do that? And how can I stop it? There are times that I put him to sleep and he done as it should. Most of the time, but it goes to the hibernate after a few minutes. I don't want to make this period. Is there a setting I'm missing, I have conflicting settings on something? What is a small problem with Windows 8, or with my computer itself? The last thing I want to do is to restore it to factory settings and lost all the things that I have saved and have to reinstall my programs again.

  There is also something else showing in my event viewer I've ever seen before. That means when he says "system timer was triggered." And can someone tell me what means the bad pool header error and how to fix it?

  I found a solution, I noticed when I Hibernate the computer at night to go to bed is when it remains not in mode 'sleep'. I stopped it in hibernation at all now and it says in the mode "sleep" very well.

• Portege z830-11J - Windows 8 - resume/sleep problems

  Toshiba, help Windows 8 problems with old laptops and Windows 7 computers.
  The problems seem to be hardware related, but I have to contact microsoft.

  Schould where can I go for Windows 8 curriculum vitae/sleep problems with this laptop.
  contact microsoft support would be useful?

  Thank you

  Jürgen

  Hi Jürgen

  I don t think that Microsoft would be able to help you usually the laptop manufacturers are responsible for own products

  If you have any problems regarding the features of the laptop, you will need to contact the maintainer authorized Toshiba in your additional countries, you can call the hotline of Toshiba.

  You can also ask the here community of users for some advice, assistance, etc.

  This Z830-11J is certainly win 8 supported as you can see here the model number in the Win 8 compatibility matrix: http://eu.computers.toshiba-europe.com/innovation/jsp/checkWindows8Compatible.do?service=EU

• HP Spectre13-3010dx sleep problems, Shutdown

  Hello

  I recently bought this ultrabook and I noticed that the sleep and stop functions do not work as expected. Restart works very well.

  Description of the problem

  • When you try to put the computer to sleep, the screen goes black, but the system stays on (lights on the keyboard, the fan spins again). I'm unable to recover from this State unless I make a difficult stop (hold down the power button / stop) or wait 5 minutes, how the computer off simply. This kind of... defeated the purpose of "sleep". Haha.
  • Same thing happens when I stop the laptop - screen turns off, turns on and the fan turned on and unless I turned off by force, laptop remains in a vegetative state for five minutes and then shuts down its own.
  • In both cases, I am unable to recover from the black screen. No response from the computer, regardless of the key combination (Ctrl + Alt + Delete, etc.)

  I dug around here the support forums and noticed other people had issues similar, but on different computer models (i.e., Pavilion, dv6, etc.), so I tried to take these specific solutions to solve my problem, but there has been no result.

  Steps taken to solve the attempt

  • The laptop came with the version of BIOS Insyde F.09, so I updated the version of BIOS to F.13. Does not solve the problem
  • I went into the BIOS and reset all default settings. Still has not solved the problem.
  • I found another thread that the user had the same problem as me, but on a different model specifications. I tried to use their solution to roll back BIOS. However, it has not yet solve the problem.
    http://h30434.www3.HP.com/T5/notebook-lockups-freezes-hangs/shut-down-sleep-problem-HP-Pavilion-note... ***

  Note: Problem of this other user has emerged due to a BIOS upgrade, while my computer was delivered to me with this already existing problem.

  From this moment any help would be much appreciated.

  Thank you

  Mike

  ______________________________

  "I'm very much in the idea of genius to be beautiful." -Sean Booth

  Hi all

  I am not convinced that it could not help others, but they gave me a day after I posted this, notification to install updates on my laptop and these updates fixes the problem. I do not know what updates took place, but they work.

  For those who still know the problem, my apologies. I'm not really sure what HP update to solve this problem.

• Close / sleep problem - HP Pavilion Notebook PC 15-e055st

  I have a problem with my laptop HP Pavilion 15, model 15-e055st, I bought two months ago with pre-installed Windows 8. I put tax at the operating system level to Windows 8.1 and seemed to work OK.  Then I used the HP Support Assistant to a few important updates, including BIOS and other software.  Following the HP update, that the computer would not Shut Down or sleep, but restart worked OK. When I try to stop or sleep, the screen goes black but the power light and the wifi of the keyboard light stay lit and the fan still works.  The machine will not this situation without me recover everything first do a hard reset by holding the power button down for five seconds.

  I trıed restore the software to the State before the update of HP but the problem still existed.  Two days ago, I updated the computer, which cancelled the operating system of Windows 8.1 for Windows 8.0 but closing down / sleep problem is still there.

  Can someone help me?

  It worked for me also!

  DaveyK, I'm really very grateful to you for the solution to this problem.  Thank you!

  I now get with some serious computing, until the next bug happens!

• Edge 13 sleep problem win7 (intel)

  Hello

  I think I have a sleep problem with my edge. If I close the lid, I can still hear the hard drive by clicking on current time to time and CPU fan. I checked all the power settings and it should go to sleep and nothing should stop going to sleep. Case may be where the cover he never sleeps, but if I choose sleep from the start menu, it will sleep. And I checked all the places it should go sleep by closing the lid.

  Thing worries me a bit, it is that if I run in prompt command "powercfg - a" he reports this computer only supports the S3 (hybrid sleep) and S1 and S2 modes are not supported.

  Mystery solved:

  HW problem!

  A magnet located in the lower right corner of the cover of the computer, under the screen rectangle shaped box is too low!

  I tried one of my magnets "fridge" on the top of my power button and computer went to sleep state and _stayed_ in mode standby.

  * Sigh * I wonder what I should do to fix this problem? Magnetic tape to improve the weak magnet on my computer?

• (Redirected) Upgrade to Windows 10, sleep problems

  I have sleep problems and stop once I've upgraded to Windows 10, the Dell Studio XPS 8100 won't go to sleep. The screen turns off, but the power LED remains lit and fan as well.

  Best of this post in the forum Windows 10 here:

  http://en.community.Dell.com/support-forums/software-OS/f/4997

  Bev.

• my computer recently crashed and when I tried to use photoshop, then I got the message: - message - problem with display driver, temporarily disabled the improvements. Does that mean, they will return when the problem is solved?

  My computer recently crashed. A fixed it but! When I then tried to use photoshop I got the message: - message - problem with display driver, temporarily disabled the improvements. Does that mean, they will return when the problem is solved?

  Update or restore your graphics driver.

• Sleep problem close cover yoga 900

  Support blew me and told me that I should pay for software support so this is my last effort to resolve this problem before I return this thing...

  I have a 900 yoga and you have set power options to make the eve of the laptop when the lid is closed. When I close the lid of the laptop / Tablet think its been tilted in tablet mode and invites you to spend on windows tablet mode. Its as if I hit the screen around the other way. The device does not sleep and he's here eat battery. If anyone else has experienced this?

  Thank you

  Landon.

  
  

• Pixi sleep problem

  We are testing on the Pixi and I noticed a problem of sleep with the device.  Intermittently, when the screen goes to sleep and you press power once button to activate back on nothing happens.  Then if you press and hold the power button on the unit complete again.  The screen does not return until the phone is rebooted.  We have already replaced the unit once on this issue and happens with the second device.

  Any ideas on how to solve this problem would be appreciated.

  Thank you.

  Go to the Sprint store and let them know that you need to put in a spacer.  While you're there, I recommend you have them test the battery to make sure it's working properly.

• Dell U2715H as second monitor sleep problem

  I just bought a Dell U2715H monitor to connect to my iMac 27 "mid-2010.

  Implementation, the system works beautifully. Plug n play, as we are accustomed to the Apple universe.

  But after an automatic start, this morning, the Dell remained black, what I tried.

  A phone call with the helpdesk Dell did not bring a solution; they are willing to trade for a new monitor, but I think not (just a feeling) which will tackle the problem.

  After having a cup of coffee, I came back to my Mac, who had fallen asleep in the meantime.

  Pressing a button all of life, including (surprise) the Dell monitor system.

  After a few experiences, I discovered that after a reboot, the Dell remains black.

  Put the system to sleep (using a hot corner) and pressing a key is not wake up the Dell.

  Bringing the system to sleep and pressing a button after waiting 10-20 seconds, puts the entire system, including the Dell monitor.

  The monitor is connected to a mid 2010 iMac 27 "2.93 GHz Intel Core i7, with a miniDP to DP cable.

  Although I found this 'solution' after hours of frustrating attempts, it feels a bit inadequate.

  Anyone who is familiar with this problem who found a more definitive solution?

  Reset the SMC of the iMac, as in > reset the management system (SCM) controller on your Mac - Apple Support

  and discover > get help with graphics issues on external displays connected to your Mac - Apple Support

• Apple TV 4 is not connect to wifi when return from sleep mode

  When I turn on my Apple TV 4 is not to connect to any wifi NET. If I search for it, it does not appear. However if I take the Apple TV, it is already connected. It's a little bother doing this several times...

  I'm afraid that there are already several discussions on this problem. Search for 'sleep' and 'network' or 'WiFi '. But it doesn't seem to be a solution. It seems to have started with tvOS 9.2, which I assume you have. And it affects all ATV 4, so it's something to do with your ATV settings or the configuration of the network, but I don't know what it is. Please report it to Apple to the https://www.apple.com/feedback/appletv.html . We hope it will be fixed with an update tvOS.

• Satellite L40t-b917 - sleep problem after upgrade to Windows 10

  Name: satellite product L40t-b917

  Operating system: Windows 10 (64-bit)

  Hello

  If I have problems with the mode 'sleep' after that I upgraded to Windows 10. When I try to resume my laptop from sleep mode, Toshiba screen seems then the unit turns off.

  After 2 hours of searching on the internet I found that a solution said that my drivers are too old. So I tried to download but my drivers resembles not yet supported.

  Any solution to this problem?

  Where can I download updates for my device?

  Thank you.

  Hello

  Go to control panel and uninstall the Touchpad, display, wireless and sound drivers/utilities.

  Restart, and then run Windows Update to install the updated Windows 10 compatible drivers.

  Make sure that the BIOS is also the latest version.

• Tecra M5 does not return from sleep mode

  Sometimes my Tecra M5 won't wake up from sleep mode.
  The LCD does not turn, and hard drive works only for a second.
  I have for it to turn by pressing the power button / stop for a long time and then run again without my work that has not been saved.

  Other times I'm having problems with turning it off. Wondows disconnects and the PC is pending for a long time with LCD on - logging off XP screen.

  I have instaled videoprt.sys update and the latest BIOS 1.60

  Thanks for help.

  Hello

  I'm don't know if this will help, but try to install Microsoft Windows XP KB917332. You can find it on http://www.laptopvideo2go.com/drivers/ms_kbs/

  Please report the results!
  Good luck!

• Tablet in the form of progress bar during the return from sleep mode

  When I start my iMac mode 'sleep', it takes forever to load initially. When lights up the screen, this pill in the form of loader/progress bar appears on the display of connection with all inactive until it ends. When it is finished, I am able to connect successfully. I also got the gray screen of death twice now, assuming it's related.

  I wiped the computer and reinstalled the operating system last night and already the problem persists. No matter which other experienceing this issue or know a solution?

  Thank you.

  Mac computers: progress bar appears after waking from sleep - Apple Support