DefaultL2LGroup keeps trying to connect to an old IP address

Hi all

We have a Cisco ASA 5510, who had a VPN tunnel established with the connection of the previous home network administrator.  When he resigned, we have removed the tunnel-group.  I noticed, though, in the newspapers, that can still be seen:

4 December 28, 2014 07:51:26           Group = DefaultL2LGroup, IP = x.x.x.x, FAULT, had decrypt packets, probably due to problems not match pre-shared key. Abandonment

Where the x.x.x.x is the IP the guy. I tried grepping its IP in a show run and all I found were an acl entry.  Is it possible to get DefaultL2LGroup to stop trying to restore this tunnel?

Thank you!

Given that you see

ERROR, had problems decrypting package

I would say that its configuration is still trying to send you encrypted packets.

Tags: Cisco Security

Similar Questions

Maybe you are looking for

  • Does anyone else have a problem with the left speaker is much lower than the right?

    Any source that I use the left speaker is much lower than the left. If I put my finger on the right I can feel the pressure of air pushed but not by the left. Is it an iPhone defective 7?

  • Workstation Z400: EEC VS. Memory non EEC

    I was told I could use the ram non EEC in my system that comes with the UNECE. Is this possible, and are there disadvantages?

  • Satellite A40, running windows xp, webcam problem

    I have a webcam and a fujifilm finepix camera that can be used as a webcam. I can't work on my laptop. When the software is downloaded and it should start working the screen going blue with white writing, I can't read it because the laptop turns off

  • HP ENVY at Quad Win 7 bluetooth adapter

    Hello I have problems to activate BlueTooth on my new HP ENVY 15 t Quad with Win 7 Pro 64 installed OS. The laptop is equipped with a card 802.11b/g/n WLAN [1 x 1], Device Manager indicates this device as a 8188EE Realtek RTL 802.11bgn Wi - Fi adapte

  • Triggers the analogue output with PCI-4461

    Hello I'm trying to generate a signal of analog output triggered with a card PCI-4461. First I tried to use the feature OR DAQmx 'start analog edge' with the way analog input AI0 as the source and the channel analog output AO0 as task. After it gave