Error "Writeback" Equium CD/DVD

I have a strange problem with my laptop that I discovered when creating backups of the system.

If you have a couple of commercial programs "partition of Eve", which appeared on the CD magazine and they work very well, even when that means writing several DVD. However, the partition of all of the backup system isn't ideal!

If I try to use the standard (for the designated etc. Folders Backup) backup program, everything goes OK until a few hundred MB have been recorded, and then the process fails with an error "writeback". I tried seveal programs, all with the same result.

I looked for references of this error - but they all seem to refer to hard disks. Has anyone encountered this writing on CD or DVD?

The system uses a carpet * a UJ-820 s by car.

Thanks in advance,

Phil

Hi Phil,

I have experienced this error so that my system backup on an external hard drive USB connected. The error is the same, I use Norton Ghost or Acronis True Image.

I finally took it down to a bad USB connection on my external caddy causing intermittent contact when the external hard drive was running (vibrations, I think).

The fact that you tried different applications with the same result would indicate a physical problem rather than a software problem.

I presume that your carpet * a car is equipped internally in which case I suggest to check that it is securely installed, and then check that it is trying to write data at high speed for the media type you are using.

If you have Nero installed, you can also try to set the write speed for your DVD player to a setting below using Nero Divespeed.

Kind regards

Tags: Toshiba

Similar Questions

  • Windows media player error c00d1163 cannot read dvd

    error cood1163 cannot read dvd, says problem with copy protection with video from the dvd player and decoder card. recent problem was working before

    Please create a new thread for assistance. Don't forget to provide the exact problem in as much detail as possible, as well as all the error messages in their entirety and any other information that may be useful.

  • Error ""A required CD/DVD device driver is missing. " If you have a flash drive driver floppy disk, CD, DVD, or USB, please insert it now.

    OriginalTitle:lack drivers

    I change my ubuntu to Windows 7, but "A required CD/DVD device driver is missing. If you have a driver on floppy disk, CD, DVD, or USB flash drive, please insert it now. Note. If the windows installation media is in the drive, you can remove it for this step. "what I can do about it?

    Hello

    Are you able to boot to the Windows Vista operating system?

    Read the following article and see if that helps:

    Error: A required CD/DVD device driver is missing - when you boot Windows 7 or Windows Vista installation disk:

    http://support.Microsoft.com/kb/952951

  • receiving error code 39 for dvd, driver will not load.

    replace corrupt cdrom.sys

    small management business of vista 32 bit.  receive error code 39 for dvd.  driver will not load.  I tried to uninstall.  same question on re - start.

    I tried regedit suggestions.  UpperFilter deleted, no lower filter exists.

    In addition to the above on the excellent advice, cdrom.sys is not corrupt.

  • Year Error Occurred While ejecting DVD/CD-RW drive

    My dvd/cd-RW drive is recognized in windows 7 and said that the work, but when I go to open it, I get "an error occurred eject disc dvd/cd-rw" and nothing happens. Two days before that I had burned a recovery of AVG disk barely shoot a problem on another computer and everything's fine. The next time I went to use the error message appeared. I reinstalled the drivers and delete the upper and lower filters in regedit as recommended by Microsoft, with no result. Any help will be appreciated,

    I replaced e DVD/CD player and everything works fine now. The problem was the original CD/DVD drive has failed.

  • How can you correct - an error occurred in ejecting ' DVD RW drive (e) "."

    I was wondering what is happening. Works perfectly an hour ago now, it does not respond when I press the button to eject the trey. When I try right click then eject it comes with, an error occurred while ejecting ' DVD RW drive (e) "." What is happening to her?

    Hi Scorpion1138,

    Please use the forum.

    Quick question, have you tried to reboot your PC and eject the DVD until windows loads? It might just not be well wedged into the slot.

    Give that a try and let us know if it worked for you.

    JohnD
    Microsoft Answers Support Engineer
    Visit our Microsoft answers feedback Forum and let us know what you think.

  • I get an 0XC0AA0301 error code when burning DVDs...

    I get an 0XC0AA0301 error code when burning DVDs...

    Hi mohamed,.

    Thank you for visiting the community Microsoft Windows 7.  This message provides troubleshooting steps about the error you received when you try to burn DVDs.

    Please let us know if this helped.

    Dena
    Microsoft Answers Support Engineer
    Visit our Microsoft answers feedback Forum and let us know what you think.

  • I get this error message with my DVD player: "Windows cannot start this hardware device because its configuration (in the registry) information are incomplete."

    I get this error message with my DVD player: "Windows cannot start this hardware device because its configuration (in the registry) information are incomplete." I tried to reinstall the driver when the computer prompted me to do it, but there was an error with this as well. My computer will not all read the disks.

    Original title: Matshita DVD-R UJ 890

    Hi AJordanMiller,

    Try these methods.

    Method 1

    Run the fix - it from the link below.

    Hardware devices not detected or does not
    http://support.Microsoft.com/GP/hardware_device_problems

    Method 2

    See the help article:

    Your CD or DVD drive is missing or is not recognized by Windows or other programs
    http://support.Microsoft.com/kb/314060

    Registry warning: Important This section, method, or task contains steps that tell you how to modify the registry. However, serious problems can occur if you modify the registry incorrectly. Therefore, make sure that you proceed with caution. For added protection, back up the registry before you edit it. Then you can restore the registry if a problem occurs. For more information about how to back up and restore the registry, click on the number below to view the article in the Microsoft Knowledge Base:

    How to back up and restore the registry in Windows 7

    http://Windows.Microsoft.com/en-us/Windows7/back-up-the-registry

    It will be useful.

  • Re: Equium A60: DVD drive is not recognized - error code 39

    Hello

    My Equium A60 works very well for 4 years now.
    Lately the DVD ramis playing about and finally today there disappear form the drive list altogether.
    I uninstall the drive and install it again, but there is no difference.

    Windows gives me this message:
    + Windows cannot load the driver for this hardware device. The driver may be corrupted or missing. (Code 39) +.

    could someone help me please!

    Thank you

    This issue has been described a lot of time here in the forum:
    Please check these discussions:
    http://forums.computers.Toshiba-Europe.com/forums/thread.jspa?MessageID=129807&

    http://forums.computers.Toshiba-Europe.com/forums/thread.jspa?MessageID=106314𙽊

    http://forums.computers.Toshiba-Europe.com/forums/thread.jspa?MessageID=107214𚋎

  • Equium L40 DVD Multi drive - do not burn files to DVD

    Hello

    Whenever I try to burn files to DVD discs using my dvd/rw drive, it holds in check the same point and comes with the invalid 'MS-DOS function' error. CDs write very well that it's just the DVD.

    Please could someone help with this problem?

    Equium L40 series
    Vista operating system
    My * a DVD-RAM UJ-850 s

    Hello

    What burning software did you use?

    I use Nero, and I've never had any problems!

  • I/o device error series Equium

    I have a satellite phone and when I put the DVD in the drive I get:

    d: / is not accessible
    and
    This request could not be performed because of an I / O DEVICE ERROR.

    Please someone can help, I had a lot of problems with this laptop and wondered whether or not I take repairs... yet again!

    Hello

    This error is displayed because the drive is not able to read DVD media.
    It would be interesting to know if this happens with all DVDs

    In any case, I think you should try it first;

    Access to the registry, and then remove the Upperfilters and Lowerfilters completely from the following registry key values:
    HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\Contro l\Class\ {4D36E965-E325-11CE-BFC1-08002BE10318}

    After this short intervention, restart the laptop.

    If this doesn't help then the chances are that the player could malfunction
    In this case, you should ask the technician to phone for help!

    Good luck

  • Re: Error Message with Recovery DVD creator

    A few days ago, I bought a new laptop Toshiba L650 12Z. I wanted to make the recovery dvd.

    I throw the creator of DVD recovery and after awhile, it gives the error "the file cannot be read. (E:/sources / boot.wim Error Code: 020150-20-00000000) ' and the process will stop. I tried several times, with the necessary waste of DVD.

    No one knows what to do in this situation.

    Thank you

    I recommend you try a media of high quality like Verbatim or Tdk dvd. You see, creator DVD doesn't accept poor quality, media

  • Equium L350D - DVD/CD drive is not recognized

    Hello

    Having a real problem with the internal DVD/CD player in my satellite.

    Any DVD software I try to use my DVD drive is not recognized. I tried to use the following: Toshiba installed, Windows Media Player, iTunes.

    This is the error message:
    The specific drive is not found. Check the setting by going to settings-> actions-> Source settings, or otherwise verify that the disc has been correctly connect to the PC.

    I hope someone can help!

    Optical disc drive is correctly listed in the Device Manager and Windows Explorer?

  • EQUIUM A60: dvd multi writer

    I just got this laptop DVD says it's a dvd multi burner, but apparently not read the DVD.
    the guidelines mention 2 packs of software but these are not included with the machine the drive appears as a rug * a dvd - ram uj 820 s it will be with the correct software recording dvd - r and dvd + r and RW of what software I need and save data and digital photos

    Hi mad,

    Can you please write your serial number complete model (e.g. satellite a60 - xxx).

    In any case if you have new laptop it must be almost all preinstallation and your DVD Multi driver should work fine. As far as I know on your laptop is preinstalled burn program called SONIC RECORD NOW.
    You can also use another burning software. In this case, my suggestion is to uninstall the Sonic Software. It is possible that there are some conflicts if there are two applications.

    If you want to backup your data on DVD - RAM you don t need any software. Record does not now support writing DVD-RAM discs. DVD - RAM is like HARD drive. Put Virgin DVD-RAM in your drive, wait a second and copy your data on it. To record data on a DVD-RAM, open Explorer. Do not use of cut-and - paste. If there is some clerical error, the data will be lost.

    If you want to remove your data go to START > programs > DVD-RAM and there is utility that allows you to remove all data from DVD - RAM.

    Lots of useful information, you can find in the user s manual. It must be installed on your machine.

  • Equium replacement DVD drive

    I have a Toshiba Equium L20-264 with a Pioneer DVR-K16S dvd player that needs to replace.

    I would be grateful if someone could let me know which drive it would fit? What size/interface is this player?

    Thank you

    Open document in manuals s user and pages 5-11.
    You will find a list of all compatible optical drive for your Equium L20 readers.

Maybe you are looking for