Green light but no access

Similar Questions

• The airPort Extreme has green light, but nothing can connect to it.

  My 5th generation AirPort Extreme suddenly stopped allowing all devices connect via WiFi or Ethernet. I can't see it in the AirPort Utility, I can not access it via the browser, and I've rebooted several times without success. I'm afraid, it may have just died, but I'll try to revive because while I can buy a new one, I hate the look of the new units. Any suggestions?

  Try powering down of the entire network... all devices... in any order you want

  Wait a minute

  Start the modem and let it run a few minutes

  Start the AirPort Extreme and run a full minute

  Keep a minute out one at a time until the entire network is back of boot devices

  Report on the results

• Satellite C660 - green light comes on but no display

  Hello

  I have 3 laptops Satellite C660 all do the same things.
  The power is turn on and get the green lights but no display on the screen. It happens from time to time.

  Anyone know what I could be the motherboard is going or is it over heating?

  Thank you

  I can't say with certainty what part could be affected, but fact is that if the Toshiba start screen does not appear at the beginning of the startup procedure. This means that the self-test isn t power began and could not be passed correctly. This could be linked to the problem of the motherboard or part connected to the motherboard. That is to say. RAM modules.

  I recommend if possible, check the modules single RAM.

  High internal temperature may affect the functionality of the laptop too. But you can avoid these problems, clean the cooling and cooling grids fans from time to time.

• WiFi on but green light on the airport is not

  I and Airport Extreme. WiFi works, but the green light is not lite. If I unplug or click the reset button, it flashes orange, and then darkens. I ran a diagnosis and everything he says is done, which is to use a unique name, use WPA2, connects automatically, etc.  Why the green light does not illuminate? Is it important because the WiFi is on?

  The Green LED has probably failed. As long as everything works OK, you can ignore the 'question '.

  However, if the airport is 4-5 years, it would be time to start thinking about a replacement... given that the average life of the airport lasts about 4-5 years.

• I am expierencing problems with my isight Camera on my MacBook Pro. Suddenly the video camera does not start (no green light on) FT or Photo Booth. The screen is black, if I restart computer it works but after closing the lid, it stops. V10.11.3

  I have problems with my view i camera on my Mac Book Pro. Suddenly the video camera does not work (no green light on) FT or Photo Booth. The screen is black, if I restart it, it works but after closing the lid it stops and I have to restart the computer.  I use V10.11.3. An idea about what is happening

  Hello mpm068,

  Thank you for using communities of Apple Support.

  Since your iSight webcam works up to the time that your Mac goes to sleep, I would like you to start please help desk trying to replicate this problem then to reboot in safe mode:

  1. Choose the Apple menu > shut down.

  2. After your Mac stops, wait 10 seconds, then press the power button.

  3. As soon as you hear the startup tone, hold down the SHIFT key.

     You must press the SHIFT key as soon as possible once you hear the startup tone, but not before.

  4. Release the SHIFT key when you see the gray Apple logo and progress indicator.

  To exit safe mode, restart your Mac, but no press during the startup.

  OS X El Capitan: start in safe mode

  Take care.

• LaserJet Professional P 1102w printer green light blinking, but will not be printed

  I had my P of professional LaserJet 1102w for a little less than a year.  I use it very rarely and very slightly (I've probably printed total less than 25 pages).  It has always worked well.

  But in the last 2 weeks, it stopped printing.  The Green led comes on, but it will not be printed.

  I went through the troubleshooting diagnostic tests on my computer (HP Pavilion, Windows 7 operating system).  The result shows that my computer detects a problem, but it cannot identify it (for example, no paper jam, no toner, etc..).  I manually checked it for a paper jam too.  I have not seen any problems.  I turned off, unplugged, he turned his back.  She still does not print.  And now the green light blinks, even if I turn it off several hours ago.

  Help, please.  Thank you.

  Update: I realized what it was.  My USB cable was very slightly loose.  I don't see when I checked manually the printer the first time.  But I checked a second time and just pushed him tighter.  Problem solved.

• After several years of functioning, my Time Capsule shows a yellow flashing light instead of solid green light.  He always seems to be working, but watch the blinking light.  An update is necessary?

  Time Capsule.   After six years of good operation, my Time Capsule shows a yellow light flashing instead of green light solid.  It seems to work fine, and I tried l ' switch off and restart, nothing helps.  An update is necessary?

  The Capsule of time... and other Apple routers... flashing orange when they have a message for you. To see what it is...

  Open AirPort Utility on your Mac... (Finder > Applications > utilities > AirPort Utility)

  Click on the image of the Time Capsuleand a small window will appear

  If you see an Update button, then new firmware is available for the Capsule of time if you want to install this package. To do this, click on the Update button

  Otherwise, find the Status parameter and then click on the little orange dot it for more information on why the status light flashes, with a suggestion to fix whatever may be the cause

• My airport express base station works but the yellow light flashes constantly how can I get the green light?

  Yellow light blinking on my airport express and I can not get the green light flashes. Internet still works well.

  When the amber light is flashing, open AirPort Utility

  • Click on the AirPort router
  • Look for the Status parameter in the small window that appears
  • Click on the little orange dot here and another window will open to explain what might be the 'question '.

• Wireless switch on, but the green light is turned OFF so WiFi doesn't work do not

  Hello

  Sony VAIO VGN-FE780G with Windows 8.

  Wireless switch starts giving the problem for the past 1-2 years. The green light is used for down working on laptop, usually as he used to come down as soon as you move the laptop little. I used to move the cursor to the market and push it a little to make it ON. This is usually used to make green and wifi, used to work.

  Last week the green light went off and then even after trying to do ON dragging to MARKET or pushing, sound not to become green.

  My guess is that the switch had bad connection and now it has finally broken from the inside.

  What is the solution? I can open the laptop and fix it?

  Kind regards

  Sachin

  raklow364:

  Although the VGNFE780G initially provided with Windows XP and is not supported for Windows 8, I would say that if you had Windows 8 working on the PC to WiFi before, this seems to indicate a problem of material with the switch.

  Have you tried opening the charm of settings in Windows 8, and clicking on the PC to change settings link, then wireless to see if the WiFi radio has been disabled in the settings?

• Toshiba 40RL953 became unresponsive; green light at the edge of

  Today I have updated the firmware on my TV via the internet. After the update had completed, I browsed some improvements for awhile and watched television.

  An hour or later, I became a game of children on Toshiba places.
  After finishing with the game, I stopped and the TV became unresponsive. green light on the Board but no response to remote or onboard controls.

  After 30 minutes of waiting, I turned off the wall, but when the computer reboots, the same question occurred, TV is completely insensitive with screen black but turned on.

  While I wait for CS to get back to me, anyone have any ideas?
  Can I previous back on firmware flash from a USB Pendrive without access to the menu system, or anything like that?

  > I fixed it, so for those who have TL93x series, this is my email address [email protected], I'll try to help you.

  Could you share your experience and your knowledge here in the forum?

• FaceTime Camera: the green light next to the camera makes a slow blink, and there is no picture

  MacBook (retina, 12 inch, early 2015) El Capitan 10.11.5 now ongoing enforcement.

  Whenever I try to access the camera FaceTime (FaceTime, Photo Booth Apps) the green light next to the camera made a slow blink, and there is no picture.

  The system report > camera > model ID: Apple camera VendorID_0x106B ProductID_0x1570

  The numbers of the vendor and the product are correct?

  The camera worked for 6 months passed and I used FaceTime several times without problem.  Several users are affected.

  None of the recent changes to the system.

  Since the problem began, I have:

  (1) installed Skype to see if one application other than an Apple app had a camera problem. Skype has no camera or.

  (2) improved 10.10.4 to El Capitan Yosemite.  Hoping that the upgrade would reload the application Face Time.   No change in symptoms

  (3) reinstalled the El Capitan using the OS X Internet recovery.  I have not used the time Machine.

  (Note for everyone, it was simple and painless and does not need to reinstall applications.)  I want to reinstall MS OS was too simple)

  (4) several other threads suggested to reset NVRAM and SMC memory, even if they do not seem to be associated with the prob. who - without success here tried either

  Any advice to determine whether it is hardware or software?  Still dig while you wait for a response.

  Note: This problem is not resolved

  Also, over How to troubleshoot the iSight - Apple Support .  Any assistance to the problem.

• Green light is on after saving workout

  I noticed that when I did a workout using Apple training app, the green light remains on. However, using a third party bodybuilding training app, the sensor lights do not remain after the recording of the session as it does with Apple app. During this experience, I also see the green icon of the person currently running on the dial of the watch.

  I was able to get light and the icon turns off by opening a series of other applications on the watch, it usually takes about three other applications to load before the icon and the light turn off. I think that's what ends up completely close the app to drive for some reason any. It's a little awkward to do and if I can't, she empties the battery fairly quickly.

  I thought maybe with last update yesterday (2.2.1), I'd see a fix, but a test this morning revealed that there is a problem.

  I wonder if anyone else can be faced with this or similar or if anyone my knowledge a fix.

  Thank you

  Hello

  Check if an activity is currently suspended in a third-party application fitness on your watch (like the app of bodybuilding or any other application of fitness that you may have installed and already used).

  If there is, put an end to this activity within this app on your watch (not your iPhone).

• Problem of green lights (heart probe)

  Yesterday during the training of the "Promenade of the Interior", I noticed that the green lights (heart sensors) are still on.

  I restarted the watch, but as soon as I open workout app, the lights are on: fiscal year 20 minutes, they turned off some time just for 2-3 seconds.

  Please help me understand what the problem is?

  I exercise almost every day, and this is the first time I see them constantly of lighting.

  Both iPhone and shows are up-to-date with the latest software

  Thank you

  Hello

  This is a normal behavior.

  Follow-up training through the training app, Apple Watch measures your heart rate continuously.

  More information:

  Your heart rate. What it means, and where on Apple Watch you will find. -Apple Support

  Use of the workout on your Apple Watch - Apple Support

• no power and green light on my hp Pavilion flashes

  Hello

  I am trying to understand if the power supply on my hp is bad or not. The green light on the back of the Tower flashes and the computer does not illuminate. I tried all the preliminary things and nothing works, the green light continues to Flash until I disconnect the large plug into the motherboard, then the light remains on and not flashing. Once I unplugged the power cord and the main to the motherboard disconnected thus form, I then tried plugging the power cord disconnected and reconnected then the main to the motherboard plug (kind of try to jump start it up), the fan is trying a (but only for a second, then goes back, so it does not start).

  Does anyone know if this means that the power supply is bad or if something else could be wrong? I wonder if the power would be bad when the computer is clearly trying to start, but not quite making it.

  If the power supply is flashing it must be reset.

  Unplug the power cable from the wall and the power supply.

  move the red switch in the reverse position, in that it is and then bring him back. If you live in the USA 120Vac->-> 120Vac 220Vac see image below.

  

  After having done that, you can plug the power cable into the power supply.  Connect the wall power cable. If the power supply is still usable is no longer flashes.

  Best regards

  ERICO

  Edited to correct the broken image link.

• Photosmart 6520: green light behind the printer

  My printer fell off my table. The green light flashing in the back when I plug in the power cord, but it not light. This means that the printer is damaged or is there something I can do to get the power to work.

  @tljohnson329

  Printer:

  E-all-in-one printer, HP Photosmart 6520 range

  The troubleshooting Section:

  Printer does not turn on

  Suggested article:

  • Internal power supply > step 3: reset the internal power module

  When you see a post that will help you,

  Who inspires you, gives a cool idea,

  Or you learn something new.

  Click the 'Thumbs Up' on this post.

  Fixed / responded? Click this post accept as Solution to help others find answers.