handheld is stuck, only power button works

Similar Questions

• I bought my palm tx 3 years ago... problem: the power button work anymore; appear it only in a white light scanning when I press on the back 'home '.

  I've had my palm tx for 3 years now and I have had some problems with it. (because I bought it on the web, there was the guarantee) the first problem is the "power" does not work anymore? and the second, the scan goes blank (white) when I press one funds 4 (calendar or at home...). What could be the case of this defect?

  I bought my palm tx 3 years ago... problem: the power button work anymore; appear it only in a white light scanning when I press on the back 'home '.

  The warranty on a TX is only 1 year from the date of purchase.  Yours is way past the period covered.

  The switch was a small part of the TX.  Pressing any other button will turn on the unit, and it will turn off let it expire.

  There is a wire on the switch repair yourself, if you're a DO-IT-YOURSELF person here type:

  http://Forum.Brighthand.com/showthread.php?t=255871

  Have you tried a Soft Reset?  A warm reboot?  A Hard Reset?    Resets are explained here:

  http://KB.Palm.com and enter 887 'ID of Solution '.

  WyreNut

  Message relates to: Centro (AT & T)

• Compaq 6710 b: my HP Compaq power on only when I plug in power. Don't turn on with the power button / stop!

  I have a laptop HP Compaq 6710 b... Its more than 6 years...

  The problem is really annoying... The laptop powers on only when I force taken into the spindle of the charger and the laptop works very well after that...
  But the laptop never turns on when I try to power by pressing the power button!
  I did not understand the reason why...

  Any thoughts on this problem?  Help!

  There are no settings in the BIOS that affect the use of the power button.

  The power button works at the level of the material (firmware).

  By pressing the button translates the action of the Commission of the conditions of the logic system.  There must be voltage at specific points in the power circuit. If the voltages are not present, then the power button does not work. This can be caused by a failure resistance, mlcc capacitor or a bad solder joint, if the power button has been tested and shown to work normally. Fluff even could cause this to happen. This can help out-performed by Visual inspection and using a multimeter.

• macOS Sierra - press and hold the power button to enter the mode 'sleep'

  I recently updated my MacBook Air (13 inch, early 2015) model of El Capitan macOS Sierra 10.12. Before the update, hold down the power button / stop for 2-3 seconds, put the machine in standby mode. It does not properly after the update. Release the power button to switch to sleep mode works only once after each time you start the machine.

  I know he has an option to set the mode of sleep using Ctrl + button / stop and by selecting one of three options to restart, sleep and Shutdown, but who needs 3 more click click and is not fast. Also, independently of any application that is open, pressing the button walk / stop worked fine before the update, but now I need to be on the desktop even do Ctrl + Power button work.

  All patches available for it? Miss me the old way of put my Mac to sleep I do not remember if I did some tweak in my Mac, or was it a default feature...

  Greetings jainam2209,

  Thank you for using communities of Apple Support. It seems you want to put the Mac to sleep, but it does not always work.
  I would recommend read you these articles, the first article explains the ways that macOS Sierra is supposed to go to sleep.
  The second article can help if the computer won't sleep when you're trying to sleep.
  

  macOS Sierra: put your Mac to sleep

  macOS Sierra: If your Mac won't go or stay asleep

  Take care.

• Help! My ideapad s110 turns on if I press the power button

  My lenovo ideapad s110 lights when I press the power button. But when I press the Quick Start button on it powers. And it only happens when I have not plugged into the battery adapter. When plugged in the power button works. What could be the problem here?

  Hello

  Please contact the slot support to have the machine checked in the service center

  

  Thank you

  Alaa

• My computer is stuck on the Welcome screen and the power button does not work. How can I activate it finish (and on)?

  My computer is a Windows XP laptop. It actually worked fine this morning, but now my power button does not work and the computer does not start correctly.

  Hello

  Its best to contact the manufacturer of the computer as it might be a hardware problem.

• My Mac Pro 2009 gives me only a power button blinks when I try to turn it on.

  My Mac Pro 2009 gives me only a power button blinks when I try to turn it on. External drives turns on but not the computer or monitor. I tried holding down the power button to restart but I still get only a power button blinking and no departures. It is running IOS 10.8.5 and I use it mainly for recording and mixing of music. I use Digital Performer and, sometimes, ProTools. Nothing new has been installed recently.

  fans on, power button flashing says "not enough RAM that works correctly for starting up".

• my ipod 5 does not light, I am of the view the home and power button down for 10 to 30 seconds, but my home button is stuck or at least does not, what should I do?

  so I have my button home broken for some time, not only does not respond as broken in the iPod so I couldn't press it or anything. It is only today that my iPod will not turn back. I normally would just hold the home button and the power button for some and things would turn out right away but now I can't use my home button so I'm stuck without options. I left that he plugged for a while but still nothing. I tried to clean the home button. So what should I? get a new home button or just get an upgrade anyway.

  You could bring to the Apple store and let them to evaluate it. If an upgrade is financially feasible, I would recommend that you're not just fixing the home button will help. Also note that if you do any repairs on the iPod it will void your warranty (if you have one.)

• Lenovo Y40: Must only press the power button two times to turn on

  Hello

  A few months ago, I bought my Lenovo Y40 on the Lenovo Web site and recently, to turn on, I have to press the power button twice. When I press that once, the Lenovo logo is displayed on the screen, but after 2 seconds it turns off. On the second attempt, finally the laptop turns on and the windows is started.

  In addition, rarely the phone stucks on the lenovo logo screen, is necessary to contain the power to reset.

  Someone had some problems like these describe above?

  Thank you.
  Pedro Lopes.

  Hello

  I contacted Lenovo's Support and they recommended to perform a full recovery of the system. Apparently, it worked because I did not suffer these problems since I got windows. Probably, there was a problem with the partition that has been responsible for the initialization of the system.

  Thank you, Pedro h. Lopes.

• Started at Mo and not charging with the charger connected. Charger works. Keyboard not workin except power button / stop. Restarted using ex in car without success. SW

  Started MacBook and not charging with the charger connected. Charger works. Keyboard does not not except the power button / stop. Restarted ex drive no available help hoping that it was a matter of SW. SW and the operating system works very well. Read some info online. Tried to reset the SMC. Now, the MacBook does not start. Can U help me please. Thanks in advance.

  MacBook, 2010, Mac OS X 10.6.8

  Hi Veronica Steward,.

  I understand that you have turned into a series of questions about your MacBook and want help getting the computer to turn on. Here is an article that can help you through the steps to fix this problem:
  

  If your Mac will not turn on - Apple Support

  Let us know how it goes and thanks for coming to Apple Support communities.

  See you soon.

• Hi all, I bought apple phone I 5s recently is the power button / stop does not. Bought in the United States, but I was shifted to the India, the works of will to guarantee in India please help

  Hi all, I bought apple phone I 5s recently is the power button / stop does not. Bought in the United States, but I was shifted to the India, the works of will to guarantee in India please help

  Ask an authorized service provider regarding iPhones, a guarantee of a country may or may not be honored in another function where you take the device.

  (143868)

• 27 "2013 mac only shut down using the power button / stop, is this a problem or a part of the new system

  After my upgrade that Mac is not closed by using the drop-down menu option, it also seems to crash the finder.  Finder raises with force quit.  I can only shut it down using the power button.  Is this a bug/problem of a part of the El Capitan?

  Wacom tablet software is known to cause this problem. Options:

  Uninstalling the Wacom software

  Completely and remove items from connection

  The Wacom driver update

• the power button is not impossible to turn work so I pad

  My I pad will not turn off you press and hold the power button down until the tour of her, but she died not just goes to sleep. In addition, it is not to connect to the internet, even though it says it's connected to the internet. anyone has any ideas. I can't also the connect to the computer to sync, because it does not recognize. ,

  Hello

  You should be able to use Assistive Touch because it has a digital power button. It works essentially the same. Turn on Touch Assistive

  For the internet problem, first try to reboot it now, then try to reset the network settings in settings > general > reset.

• Mute function button works only on Satelite A660

  Hello

  I couldn't do the button mute to work. The flight of the up/down button, the toshiba buletin Board, play/pause, wifi and eco button works. I couldn't find the software that controls the function keys. Does anyone know how to configure it? Previously on my old Satelite M50, there was a software toshiba utility that allows users to configure each button.

  I found that the Toshiba software utilities help button, but not the Mute button. I found the TBSsoundMute file in the Progrm files/Toshiba/SCT/and clicking on the file makes the mute sound. How can I associate the button mute for the file? The only thing that happens when I press the button mute is the buttons all light which I think is related to the Dimmer.exe software.

  I managed to work the button replace the Dimmer function with the software of mute, now mute button, but the dim buttons not now. I don't know if it is the default settings. Is there a way to mute and dim at the same time? So people will know it mutes and dims.

  Post edited by: mystvearn

  Post edited by: mystvearn

  > When I managed to work the button replace the Dimmer function with the software of mute, now mute button, but the dim buttons not now. I don't know if it is the default settings. Is there a way to mute and dim at the same time?

  You can set the key Mute or Dim.
  The two of them at the same time is not possible!

  So I think the thread is answered.

• iMac G3 stuck power button / stop

  So, I bought a G3 iMac on eBay. It's a PowerMac 2.2 If you need this information.  A few months later, the power button is stuck in. So I have to keep hitting the power button to get it to turn on. And if I shake the computer, you can turn off. All solutions on how to get this button to be able to take off. The computer was probably not the best handle I see a few pieces chipped through the case and the door for the RAM has tape on it since there is nothing to hold the bottom.

  The initially supplied with your iMac keyboard has a power button.  If you use this keyboard, can you use this button to power instead?