HP 1320n: jam printer

1320n printer started the day with a smear of ink on the left side.  Then it progressed to paper jams at the back door of the printer.  I have replaced the roller on the front of the status bar.  Paper jams so bad that it rips to remove if.

Based on what you say, I suspect you have a defective oven.

The fuser film sleeve can last hundred thousand copies, but once it starts to deteriorate at the edge of it shreds pretty quickly.

Do you have small pieces of plastic in scraps of paper at the back door?

You may also be able to see the film of fusion sleep which is either a grey plastic or brown hollow tube which is around the fuser heating element. If you can see the sleep, you should be able to see if there is a damaged end.

I suspect that if you look online, you'll be able to find a video showing you how to remove fuser it takes some technical skills on this machine.

If my post is solved your problem and click the accepted as button solution under him. In order to thank a technician for a post click the thumbs up button under the post. You can even click on the two buttons.

Tags: HP Printers

Similar Questions

  • no lights after paper jam, printer does not

    no lights after paper jam, printer does not

    John, thank you very much, found that when the paper through the printer offline mode, I put on the line, then reconnected to electricity, and she came back.

  • HP1212nfMFP: Blocking due to previous paper jam printer

    I'm not able to restart my printer after a paper jam.   I made all the corrections and suggestions that I could find on the U-tube and the: various forums of the printer.   As all cleaning rollers, pick up pad, inspecting the inside with a strong light and magnifying glass, inversion and shaking the machine to dislodge any fragment of piece of paper etc.

    I also recycled the machine several times without a power supply off and then the cycle.

    What is happening is that all the above cleaning procedures.  I try to test print a Setup page...  A sheet of paper feeds and jams full length, just as she enters the pickup roller.  The machine hangs and displays a message that says: to remove a paper jam in the paper path area.

    It must be a patch to do this, run completely tear the machine part, which I am tempted to do.  Help!

    Thanks for your help what they call, but he did waste two hours of my time to discover that 1) HP has no interest to my problem unless the printer is under warranty.  Which they say, until you've dug product codes and serial numbers by standing on the head with a flashlight in hand.  Two 2) database of the problem is completely silent on this issue.  It's amazing given the trivialization of jam printer problems.  There must be a way to disable the short code locking of tearing the printer totally collapse.    Overall, I think thqt I'll never buy an HP product, new given the support of shit that does not exist.  Next, lift the printer on the cliff to the rocks

  • All-in-one Officejet 5610: computer said paper jam, printer does not respond

    We had a paper jam, which we is allowed. The printer says there is no jammed paper and printed successfully a self-test.  The table of edge devices and printers said that there is a jam paper and attempts to print just to sit in the queue.  Clicked on the HP Solution Center and it says printer is ready. The printer is okay.  Only the OS seems to have a different opinion.

    Not tried them: (1) open the back door and look for debris. (2) open the Feeder and locate debris.  (3) open front (involves opening door cartridge, unplug the printer and remove the trays) and search for debris.  (4) self test printing.  (5) restart the system.  (6) unplug the printer while and leave unplugged for 60 seconds to force the delivery.  (7) repeat steps 1-4.  No SOAP.

    Have you tried what is obvious.  Turn on the computer and the printer off both.  Now, unplug the printer from the computer.  Turn on the computer and then turn the printer back on.  Now reconnect the printer to the computer.  This assumes that the printer is connected to the computer via usb.  Alternatively, you can try to plug the usb cable into a different port.

  • Photo paper jams printing

    I use a HP Photosmart C5140 all-in-one printer and have had zero problems with it since purchase 6 years, but today I was printing to 4 x 6, three prints photos and then the paper began to jam.  I did all the things normal, firm, re - align, choose photo paper, stack the book perfectly, I think that I did everything possible, but the ongoing book to get stuck at the back as it rolls around the roller printing.  Any thoughts on what could happen?

    Thank you for having responded to my call for help!  I think that the cleaning of the rollers made the difference. Thank you.

  • HP Photosmart 7280 C: Jam printer when printing from InDesign

    I seem to be able to print anything, except when a print to InDesign file. When I try, I get a paper jam?

    Hello

    You use a different type of paper to print with InDesign? The program itself can cause the paper jam, but maybe the settings or the paper you are using are the cause of the problem. I often print on thicker or InDesign photo paper and usually just put a sheet in the printer at a time to help with jams and paper pick up questions.

    Please report parameters and the type of paper you are using to help find a solution. Thank you!

  • Message of paper jam paper on PC but not paper jam printer

    When I go to print, printer status box rpet 'paper jam' and it will not be printed, but there is no jam of Pope.  I have connected the printer to other computers and laptops, I have, and the printer works fine, then, of course, that there NO paper jam.  The printer says it is "ready".

    How can I get rid of this false jam on my netbook status 7 from Microsoft?  I don't know what to do.

    Restart the PC and the printer. mohanad

  • How to clear the jam printer for HP E709N

    How to clear the jam on HP model printer-E709N all-in-one

    HI - go ahead and follow the steps described in this document.  It guides you through the compensation jame paper and check the printer works properly.

    Hope that helps.

  • OfficeJet J5780 'ghost' & paper jams printing.

    My J5780 is probably 2 years or older, always worked very well in all aspects.  Today, he has done several print jobs, from one to three pages, as usual.  After the last (single page printing) print job completed successfully, the printer started out of the blue, a page of paper feed, then fed a second page, (both without printing), and then to half way to the two - third through feeding white page 3, he recorded a paper jam.  There is no paper jam; the before food, rear Wireless, scanning area, high flow access, double all the areas checked with a micro-lumiere.  No scraps, corners, Chad, dust etc.  Printer turned off during 10-20 seconds, to bike, same;  Turn off the printer for 3 minutes, even.  Power dropped once or twice for 1 to 5 minutes, without change.  No pending or in process printing, last print job was successful and completed satisfactory.  None of these events seemed to have any printing tried strictly paper RSS, from 1 to 3 sheets, variably interference on the first, second, or third leaves, up to now. Sometimes with feed several sheets of two to six leaves.

    Message "paper jam: clear jam and press OK." continues.

    Occurrences of holding torque after an action of 'Cancel' when the printer appears to be printed, (no power supply of paper), then Jam review occurs again.

    Been to paper/paper jam feed problems, etc. in several different forums, FAQ, etc.  Solutions?

    Thank you!

    Thank you, Rainbowlady23.  I have clean the rolls early in the process.  So.  Went through your hard reset suggested and as soon as voltage, he started the food cycle like the previous, however, he seemed to be a little bit slower, so I thought I could get through the menu of the printer to default settings selection.  Did it, and the cycle food order.  Tried to do a self test report, but he hung up obviously try to generate the report.  I canceled, did a hard reset of the second, has a different selection of menu/factory by default - and Bingo, it is fixed.

    Really appreciate your comments for me - take care and have a great week.

  • B210 in paper jam printer there is no paper stuck in the printer, but the screen shows paper jam

    Paper jammed paper but screen says paper jam jam preformed the resolution of problems and no resilt

    Hello

    Have you tried the steps outlined in this article. Give them a shot and tell us if it helps.

    Good luck!

  • officepro 8600I have: jam printer

    I can see the pieces of paper under the rollers which are visible through the front door.  However, they are too far back to grasp. I tried with a pair of tweezers to no result and work from the rear as well.

    Hello

    If you have tried all the steps above and you still have problems, you could tray holding a more rigid media piece (like a sheet of photographic media or card stock about the thickness of an index card - do not use the thick cardboard).  And see if you can feed through and clear jams.  If it will not feed exceeded stage stuck bits, you can try to unplug the unit and manually feeding the rigid sheet through the drain plug back.  Often, this will push some of the pieces of paper remaining through.

    I hope this helps.

  • My hp6500a repeat me print paper jam and wont after getting out the paper. How can I fix?

    My hp6500A says paper jam printer, I clean paper restart always says paper jam. I took it completely apart clean rollers, ink ramasseherbe, still no luck. Please help thanks Arty1961

    You are right, I have connected the printer to my laptop and did an update, I guess there's a few missing drivers. Thank you very much it works better than ever. Thanks you are great. Art

  • HP LaserJet P1606dn: Paper feed 1/3 and printer jams

    I got the impression for about 2 years.  Jams printer after paper feeds about 1/3 of rolls.  I inspected all areas of paper jam.  I think that there are papers torn or other debris in.  I cleaned the rollers with compressed gas area.  Attention no longer flashes when I remove the paper stuck, remove the cartridge and reinsert.  Jam if I feed tray or manual tray background.

    Mystery solved.  I was using an "accountant" Linkyo cartridge.  Just for the hell of it, I replaced it with a cartridge Linkyo and the document without problem.    Lesson learned.

  • fake K5400dn printer jam error

    I'm out of HP Officejet Pro K5400 K5400dn on Mac OS X v10.8.5.  I can print from my iMac.  But my MacBook gives me a message of paper jam printer that I can't erase even restart the computer, disconnect and reconnect printer.  I can run this same MacBook computer printer diagnostic checks that fine print and I can print without problem from another computer.  Cannot find out how to clear the error of printer jam that seems frozen in the queue on this printer only.  Any suggestions?

    I was able to solve the problem by removing the printer my printer list HP, eliminating all jobs "pending."  When I added the printer to the list - the error message disappeared and it is printing.

  • HP Laser 3700 jam duplex printing

    Hello

    A local charity uses the printer above but now there is a problem with Paper Jam.

    Sded unique printing works great but causes a Paper Jam print double-sided.

    It says paper jam tray 2.  The paper gets stuck in the upper flap tray 2 and does not seem to move further.

    Help, please. Is - fixable?  What should I check?

    Thank you very much

    Hello

    Thanks for your reply, but I managed to solve this problem.

    He's had some paper stuck somewhere in the duplex feed rollers.

    I managed to erase in mind a plastic card strong manually from the hatch above the tray 2.

    It moved some piece of paper was stuck in the rollers.

    Thank you very much

Maybe you are looking for

  • Qosmio PX30T - Bluetooth mouse has stopped working

    I was able to reactivate Bluetooth on my PX30T after having changed the batteries in my Bluetooth mouse. (Sorry Toshiba, your standard mouse is uncomfortable!). Not sure if the circumstances leading to it as my son noticed the battery do not and then

  • Missing audio beats

    reinstalled windows 7 and beats audio is missing. Product name: HP Pavilion dv6 Notebook PC Product number: A5F76AV Windows 7 Home Premium 64-bit Service Pack 1 pls help

  • Windows 7 Home Premium license transfer

    I bought my son a laptop a year ago Acer Windows 7 Home Premium screen license is destroyed and my mother has an acer laptop with Windows Vista I can some how make windows 7 my son and add it to my mother because my son is no using of my mother is de

  • XML and the data recovery

    Hey,. Not sure if this is the right section on the forum: I was wondering if there was a way to retrieve data from an XML page. For example, I want to create a BBApp that can request a XML page and once it has loaded to extract all of the appropriate

  • GIF Glitch

    I'm putting one on my video for a few seconds but the gif is not playing is a still image.