HP dv6-2150us touch funtion button volume but still red

Similar Questions

• computer laptop Lenovo, but a red cross that pop up on the volume button and it s saying no audio device is intall

  I have a computer laptop lenovo, but a red cross that pop up on the volume button and it, s say no audio device is intall

  I want to know how can I solve this problem

  The following link might be worth a visit:

  No sound in Windows
  http://Windows.Microsoft.com/en-us/Windows/help/no-sound-in-Windows
  (Win XP / Vista / 7)

• HP dv6-2150us + Windows 7 64 bits + quick launch problem

  I have a new install of WIndows 7 64 bit on my HP dv6-2150us, and now there is a problem with the Quiclaunch buttons. Before my reformatting to get a clean install of windows 7, the quick launch buttons has worked, after the installation of the new, I have a problem. The problem is that pressing the volume buttons or button mute are not any notification on the screen. I can adjust the volume from the keys, but no statement is displayed (I need to check the volume slider in the bar of tasks to see how I increased or decreased it). Mute works also but still no notification.

  I installed all necessary drivers and the problem does not reolved. I wonder if windows 7 is somehow blocking notifications or if it's a problem with the application of buttons?

  Install 3RVX,

• Pavilion dv6-2150us: scanning wireless to the printer on my computer

  computer, Pavilion dv6-2150us, product # WA779UA #ABA, Windows 7 Home Premium

  HP Photosmart B209 more Pinter a - m

  I am able, with a usb connection to scan from the printer to my computer;  I want to scan wireless to the printer on my computer.

  Thank you

  Hello Mocha7 ;

  Welcome to the HP forums!

  I read your post on the analysis of the problems with your HP Photosmart Plus B209 a - m and wanted to help.

  I don't have the same printer model, but I do not have other HP printers, and the process is essentially the same.  When you install the full exercise for the printer software, it installs a shortcut on the desktop that allows you to scan to PC.  I did it with two different HP network printers and it works the same for both.

  So, you need to check that you have installed the complete service for the printer software. The linked page is for Win7 software and the driver for your printer: http://support.hp.com/us-en/drivers/selfservice/HP-Photosmart-Plus-All-in-One-Printer-series---B2/3777155/model/3777156

  IF it shows no Windows 7 when you open it, click the Edit button and select Windows 7 from the pulldowns.

  In addition, this link is to the page for your printer troubleshooting: http://support.hp.com/us-en/product/HP-Photosmart-Plus-All-in-One-Printer-series---B2/3777155/model/3777156/troubleshooting

  Please note that there are two procedures, you should try to use: printing using doctor Scanand a communication or connection error ...  See if they are able to help you solve the problem of scanning.

  Good luck

  I'm a volunteer and I do not work for, or represent, HP.
  ========================================================================
  If you feel that my suggestions helped you, please click on the thumbs-up symbol to say thank you!

  If they helped to solve your problem, please click 'Accept as Solution' to help others find similar information.

• DV6-2150us-> does not supply power to the top.

  Hello

  I have a computer laptop dv6-2150us pavilion which, for some unknown reason, does not. I was working very well. I stopped and would not start in a couple of hours. I kept the power button down as others have suggested, but nothing happens. A laptop is dead.

  How to deal with a computer that won't even turn on.

  One thing I think is to change the battery. Before the power loss, my battery needed replacement. I had to keep the laptop plugged in to work. I couldn't work on the battery.

  I would appreciate any ideas. Thank you

  Kind regards

  Sam

  The first thing, remove the battery and unplug the power adapter and leave it without power for a minute.

  Then plug the AC adapter in (be sure to leave the battery) and see if the laptop. If it doesn't, the next test would be to check the power adapter (reconnect it in community/points of sale). If this still does not work, you will need to try another adapter to see if the laptop turns on.

• is there a fuse for this laptop? is the computer pavilion dv6-2150us laptop

  is there a fuse relpaceable on or near a pavilion dv6-2150us motherboard

  Is the power supply for the pavilion dv6-2150us originally?

  Remove the main battery and connect the AC adapter and try it turn. It is safe to do so.

  If that doesn't work try a hard reset as follows:

  Remove the battery and unplug the DC power adapter.
  Press and hold the power button for more than 15 seconds.
  Plug the DC power adapter (leave the battery for now)
  Press the power button

  Please post your positive or negative results.

• Left click the Satellite C660 Touch Pad/buttons does not work

  Hi guys!
  I own a Toshiba Satellite C660 (of course: P) anyway. Today, I was just doing what I do usually on my laptop,
  when suddenly the left button of the mouse has stopped working. (Bare with me, it's very weird to explain xD!) Also I can not 'left click' on my touch pad. I can still move the cursor with the touchpad and right click with the right button.

  I tried slightly shaking incase of crumbs, or something. Although I never eat around my laptop. It is not difficult to grow as there is something under it, it just doesn't work!

  In summary, I can't left click. But I'm able to move and made a click right, weird!

  For the moment I have my USB mouse plugged in my computer and it works fine, but it is very annoying!

  Sorry if I don't explain it too well!

  Help, please!

  On this virtual path, it is not easy to say what the problem is here. It is not easy to tell if the left touchpad button is faulty or disabled in some way.

  As a first step, you should check all the settings for the touchpad. If your laptop computer has preinstalled software check Synaptics all parameters associated with the touchpad buttons.

• Acer Switch 10 i. put powered w / power cord, power button + volume Up/Down ii. No LED light

  Problem:

  Power does not illuminate. 75% battery charge. A tried
  a. power switch button
  b. power button + volume Up/Down button for 60 seconds (technique of being able to be in hibernation mode)
  c. a/c power cord... light to show load or power not turn on AND the Tablet does not become hot... in other words, Tablet accepts no power coming from being plugged into an electric outlet

  Solutions to be able to put it back on

  1. perhaps central card mother battery died... Well, in the past my LAPTOP would work with single power supply and no battery... but... it is a tablet that works maybe like a mobile phone because if the battery is dead, then unit does not work until the Central battery has sufficient charge

  2. maybe an electrical circuit problem?

  3. may reset a deep sleep mode?   ... but already there is a technique of this situation and I tried it.

  4 perhaps, software power settings but if are unable to start. can't get to the BIOS.

  Thanks much for any help.

  Solution... it was an electrical problem, capacitor w / low-Volt charge had gone below this threshold to function, voltage decay over time.  Replaced.  Laptop as it has done before does not.

• HP dv6-2150us failure of recovery with new drive

  My HP Pavilion dv6-2150us Win 7 64 bit computer portable 320 GB drive has failed.  I want to install a 500 GB drive for a replacement, but get an error message when about 35% through the process recovery disk.  I tried all three options, system reset factory and reduced to a minimum.  All fail.

  The new drive can be partitioned and formatted easily into another computer.

  Any advice?

  The problem seems to be the process of partition/format.  I partitioned and formatted the drive on another PC via a USB/SATA cable and was finally able to do thanks to the installation of recovery factory reset.  Watching the reboot process and installation of things.

• Xbox connected to the HDMI port, the only problem being transmitted through the built-in speakers is extremely strong, o change the volume but not succession

  original title:

  Hi all
  I desperately need help. I recently bought a touchscreen "All-in-one" PC "Packard Bell OneTwo M.
  I plugged my Xbox via HDMI port to the rear and the visuals are great, the only problem I have is volume transmitted through the built-in speakers is very strong, I used the keys function keyboard to try to change the volume but no succession, the remote that I have provided with the PC has also volume buttons but them seems to change the volume of my digital TV which is also integrated in.
  Any help is appreciated
  Concerning

  Hello

  You can adjust the volume on your computer by following the steps in the link below:

  Adjust the sound level on your computer
  http://Windows.Microsoft.com/en-us/Windows7/adjust-the-sound-level-on-your-computer

  It will be useful.

• HP-DV6-2150US has a lot of white stripes on the screen

  Hello

  My computer laptop DV6-2150US, System: Windows 7 64-bit, has a lot of white on the screen when I turn on it, and when I used it, I need help. I've updated the drivers, but the problem persists.

  Thank you.

  You have a hardware problem, I recommend contact support to get a quote on a repair.

  Then, you can compare that against the price of the purchase of a new laptop computer.

  You can also try to connect an external monitor to see if the problem is seen here, it may be a way, but you wouldn't know until you've tried.

  So a few options for you to think,

• Screen for HP Pavilion dv6-2150us witch?

  My 3 year old stepped on my Pavilion this morning. I am looking to buy one to replace it, but I want to confirm that I need.

  Amazon gives me linked below, both of which seem to be for the same unit, but it is of course the right one.

  http://www.Amazon.com/HP-Pavilion-DV6-2150US-substitute-replacement/DP/B003TQ4K08

  http://www.Amazon.com/glossy-laptop-HP-Pavilion-DV6-2150US/DP/B00438BBLW/ref=pd_cp_e_1

  Thanks for any help

  Well according to a photo on Amazon it is on the left side. Looking at the back, with the closest connection to you, but by all means, if you feel more at ease to get one from Amazon, it is the place to go.

  When you were on the PowerBook or you forgot the screw, you have left the battery in place. 

  You are RESTful is probably order it directly from HP!

• I found the show/hide button toolbars, but you should know how to REMOVE toolbars that appear on this list?

  I found the show/hide button toolbars, but you should know how to REMOVE toolbars that appear on this list?

  Is attached a screenshot of my screen with the context menu to show/hide tabs. I want to delete some of them and let others. Please help me to know how. Thank you!

  Hmm, maybe this "one-time" imported into the new preference? Try this:

  (1) in a new tab, type or paste Subject: config in the address bar and press ENTER. Click on the button promising to be careful.

  (2) in the search above the list box, type or paste the cust and make a pause so that the list is filtered

  (3) double-click the preference of browser.uiCustomization.state and the content must be highlighted in a small dialog box.

  (4) copy the whole line and paste it into Notepad and save it as a backup.

  (5) in Firefox, click on the button '3-bar' menu > developer > Notepad. Remove the comment that appears and paste data preferably, that must appear on a long line. Click on the "Pretty Print" button to make it more readable.

  So I hope that you can spot the extra toolbars and change them out, taking care to preserve the commas between the elements.

  I don't have the extra toolbars in mine, but I copied and pasted back this spaced format and Firefox was able to handle it well. I went into customize and moved a button, and when I left, Firefox has rewritten the preference set as a single line. Assuming that yours works fine, then you can get rid of the backup from step (4).

• I woke up this morning and my iPhone 6 does not light. I tried to reboot it by holding down the button market / stop and the button "home" but the apple logo never appeared and I had on the charger for a while and still nothing. Please leave suggestions!

  I woke up this morning and my iPhone 6 does not light. I tried to reboot it by holding down the button market / stop and the button "home" but the apple logo never appeared and I had on the charger for a while and still nothing. Please leave suggestions! Thank you

  You can make an appointment at the Apple Store - Genius Bar store and bring it into service. You can also search an Apple Store - find a store - Apple.

• My ipod touch does not illuminate, but siri works and turn on randomly.

  I was using my ipod and then it froze from nowhere. So, I turn it off using the power button. But, siri was turning, and saying: "I don't have that." Although I do not have suumon him. And now my ipod turns on.

  Try to keep the sleep/wake and home button until the apple logo appears or 15-20 seconds. -AJ