HP Photosmart C5180 and Ethernet

Similar Questions

• pump motor stalled error on Photosmart C5180 and C6280

  When I turn on my printer, one is a Photosmart C5180, the second is a Photosmart C6280, I get an error message saying "pump motor stalled." If I switch off and on again, it clears sometimes. No matter who else experienced this on both printers. Both use only Original HP ink cartridges.

  Hi Andrew

  According to the users in this thread:

  http://h30434.www3.HP.com/T5/printer-all-in-one-install-Setup/HP-Photosmart-C7280-pump-motor-STALLED/TD-p/500777

  There is a solution on the first page of joulem, several customers have received the help of

  I hope this helps!

• Problem cartridge HP Photosmart C5180

  Recently, I tried to change the cartridges for a printer HP Photosmart C5180 and bought two new sets, so I got some for the future. The representative of HP in the store told me that 02xl vivera HP inks would work as well as 363 regular cartridges supplied with the printer and that they would be more beneficial that they hold more than 50% ink. They also fit perfectly into the printer.

  When I put in the error message the front of the printer says: "the ink cartridges are not intended for use with this printer. I can't bring back them to the shop as I bought a HP store in Las Vegas and I live in England. Please, please help if you can because I do not know that they would work with change of parameter or something.

  Kind regards

  Andy

  Sorry, the 02 cartrdiges cannot be implemented in the C5180 which is regionalized for England.  There are certain circumstances where HP can change the settings of the regionalization of a printer, but this case does not match this model.

  Kind regards
  Bob Headrick, Microsoft MVP printing and imaging

• SD card in Photosmart C5180,

  When I put an SD card in my Photosmart C5180 and try to 'save the photos on the computer' I get a msg "you must install the software for the device", I have a new CQ2014 of Compaq PC, with Win 7 and 64-bit

  Hello

  Install the full feature software below?

  http://ftp.HP.com/pub/softlib/software11/COL30777/MP-76232-1/AIO_CDA_Net_Full_Win_WW_130_140.exe

  If this isn't the case, be sure to first disconnect the USB port.

  Enter the control panel > devices and printers.

  Right click on the C5100 printer icon, and then select Remove an instrument.

  Restart your PC and follow the installation.

  Kind regards

  Shlomi

• Windows 7 and scanning. All-in-one printer, HP Photosmart C5180

  I had some experience in the past with an upgrade of Windows 2000, XP and a printer/Scanner, I remember more that now, but I managed to get an upgrade for the printer but the scanner never worked despite the many phone calls from HP again. I have a HP Photosmart C5180 all-in-One printer and I'm about to upgrade my XP computer to Windows 7. Y at - it an upgrade that will manage the printer and the Scanner?

  Thank you. New PC comes next week. I will be presenting on the question of whether it works or not

• Can I make my HP Photosmart C5180 wireless?

  I have a linksys wrt54g router, I'm not currently using for internet service. Can I connect to my HP C5180 and make wireless for home printing?

  Hello

  The HP Photosmart C5180 provide coinnectivity USB only.

  It is not equipted with any Ethernet network card or wireless and therefore cannot be connected to a router, but only directly to a computer.

  You can find the specifications below:

  http://support.HP.com/us-en/document/c00701803

  Kind regards

  Shlomi

• HP Photosmart C5180 - Windows 7 64 bit - network - device detected but FAIL to install.

  Hello

  I have a Photosmart C5180, connected with an ethernet (not usb) cable.

  It's great to work with all the computers in the House (vista and xp).

  But my new computer, a 64-bit windows operating system 7, impossible to install the drivers:

  The drivers are now installed, but the step 'add a device' does not work correctly.

  After the analysis of network, the printer is displayed:

  

  Then I click Next, to "network analysis":

  

  OK, next step is "installation." Before the picture, it says 'detected printer"(french).

  

  And a few seconds after it fails:

  

  Grrrr wtf?

  Thanks for the help!

  I had problems to install the HP software. When I installed the full package I get pop ups and error messages. So I did a complete reinstall (I have now if he really had to do I had other issues). After that I just installed the drivers and no extras and it works very well. I'm also hooked using the ethernet connection. A point even before the reinstall if I come you drivers and no additional software. I can still scan using Windows Fax and Scan. I probably will not add extra software until there is another version.

• Wireless laptop cannot connect to Photosmart C5180 printer on network

  I recently got a new computer, which is the main connection to our home network.  We have a laptop and a Photosmart C5180 printer.  I can't get the wireless laptop to connect to the printer, even though I have the shared printer on the pc.  I have the printer connected to the pc via a USB cable.

  I see the printer shared and available on the laptop, but get the error message when you try to print.

  Does anyone know what I'm missing that will allow me to print from wireless laptop?  It worked until I'm the new pc, so I know I'm missing something.  Should the laptop have both installed printer software/drivers?

  Yes, the printer directly connected to a router with an Ethernet cable will be the simplest solution.

  Yes, all computers will be able to access the printer on the network as long as they are connected to the same router (Ethernet or wireless, regardless).

  He shared from the computer and the printer connected to a computer with a USB cable are not a real printer on a network.  This creates what is essentially a print server and the computer with the USB connection manages the interaction of this printer with all the devices on the network.

  A USB connected printer sharing can be done, but it's a lot more work that the printer is connected to the router with an Ethernet cable.

  It's really a lot more work to set up the printer with a printer shared over a network connection USB method true when it comes to do this with Windows 7.

  Windows XP made it incredibly simple, but he was not very secure on a network.  With Windows XP, all you had to do was to share the printer, and then install it on another computer.

  With Windows 7 on both computers, you must configure a homegroup, enable file sharing and printers (disabled by default), share the printer and install the printer on the computer client / remote.  In addition, this method will require the host to be on anytime for remote printing machines.

  The printer is connected to the router with a Ethernet means that the functionality of the printer depends solely on the router being on (most are on 24/7).  Computers will print regardless of the other computer either on or off.  There should be a shorter time in the impression that a computer is responsible for printing rather than two computers.

  Again, I will be more than happy to help you set up with the method USB shared with two Windows 7 computers if that's what you want.  You find that it is much easier to use the Ethernet connected method to be simpler and more efficient to print well.

  If you want, here's a little more information from Microsoft on sharing a printer between two units of Windows 7.

  Setting up a homegroup

  Activate the file & printer sharingand sharing the printer on a Windows 7 computer

  As long as the printer & file sharing is enabled and two Windows 7 computers are in the same group of residential, you should be able to use the USB share method.  Without these two two options being Setup, it simply does not work with two Windows 7 systems.

• 0xc18a0106 on Photosmart c5180 error code

  I followed the recommended procedure, but the problem persists. The printer connected to a network home via the gateway.

  The printer does not work and returns the error code 0xc18a0106 on the front panel of the printer and work is the removal of the (QC) all cartridges have been replaced by nine. Any proposal to resolve this situation?

  Hi demertzy,

  Just had this problem on my HP Photosmart C5180 printer.
  
  That's what I did:

  If you get an error message on your screen of the printer (HP Photosmart C5180) that says "0xc18a0106-ink system has failed", you will need to perform a reset of the printer.

  Something usually causes the error and it is generally a chip failed, an obsolete chip or break when installing a new cartridge, and this must be corrected before continuing. Most of the problems usually come from the last cartridge inserted, so start by replace this cartridge. You will also need all the cartridges with low ink in there or you will need to replace any empty before continuing. After replacing the cartridge problem, keep it as it can be allowed to use at a later date, once the error has been reset.

  To reset the printer:
  1 - Unplug the USB cable from the printer.
  2 - Press the key On / Off turn the printer power off, unplug the power cable from the printer, press and hold the 'OK' button and the 'HELP' button, then plug the power cable, wait a few seconds and release both keys, then press 'On '.
  Your printer will now initialize and you will need to follow the on-screen instructions and selection of the printer. This can take several minutes to complete. Your error code should now be gone, and you will now be able to copy and print.
  3 reconnect the USB cable from the printer.

  He has worked with me... Hope it will work for you.

  Robert

• HP Photosmart C5180 printer range: computer says it is printing, but will not be printed

  My printer was working fine until yesterday. The display shows 'printing', but nothing happens. I tried to turn it works, made sure I've had connections in place and give him a rest from one day to the next, but she still does not print. Thank you for your suggestions you have!

  Welcome to the HP community @fondyia,

  I read on how your Photosmart C5180 is no longer printing from your PC running Windows 10, and I want to help you get this resolved!

  I suggest first trying the steps described in this guide:

  • HP printers - printer 'offline' status message (Windows 10)

  Tip: Make sure that the printer is plugged directly into the wall, avoiding bars power and surge protectors. This ensures that the printer is full on.

  When you are finished, please let me know the result. If there are printing problems that are still visible, try to make a copy of the printer and tell me what's happening! If you see errors, made me know what they say, if you please!

  (Please try to print from more than one program on your PC)

  If one of my suggestions, helped to reach a solution, I ask you to click on the button "Accept as Solution" please and thank you!

  If you want to send me a 'thanks' for my answer to help today, click on the thumb to the top slot

  

• My HP Photosmart C5180 all-in-one will not print text correctly in black, color print very well.

  My HP Photosmart C5180 all-in-One does not print black without be eliminated text or streaks in the text. Will print fine text color.

  Have tried all the "patches" you list and much more. The printer prints fine on my old PC Windows XP and worked fine on my

  new PC using Windows 7 until recently.

  Please don't tell me to... Reinstall, download the new driver, install the new cartridge, clean align the print heads, different paper or go to 'solutions '... Etc... Etc.  I HAVE ALREADY BEEN THERE AND DONE THAT!

  Everything you "patches" end with 'the unit of service... " WHAT IN THE WORLD WHAT THAT MEANS!

  This has been a nice printer for more than 5 years, but is somewhat glitch spoil me when using the BLACK INK?

  Gordon,

  Thanks for the reply, expecting not one, but what you say is all that we need to buy another printer if we did all the "fixes", etc... etc. you know that take a printer to a repair shop will cost more

  then buy a new one.

  It was stupid of saying me to check on the warraty of HP page when I already told you that the unit is 5 years old.

  But don't thank you for the reply... even if it was a joke!

• HP Photosmart C5180 not not recognizing new ink

  My HP Photosmart C5180 is not to recognize the new yellow ink cartridge.  I bought 2 and it does not either.  Does anyone have any suggestions before buying a new?

  Thank you!

  I had the same problem with the black cartridge. But I just reinstall the software and it works perfectly again. I hope it helps someone.

• Vista Photosmart c5180 driver problem

  Can anyone help - when I start Word by clicking a file in Outlook, when I quit Word I get an error meesage and it can:

  Temporary workaround available

  This problem was caused by a known issue with your Hewlett-Packard printer driver, which causes the close unexpectedly when your HP printer is set as the default printer Microsoft Office 2007 programs. Hewlett-Packard is aware of the problem and working on a solution.

  What is a driver?

  Power to Turn-off of your HP Photosmart C5180 all-in-One, uninstall the current HP software and drivers, then download and install the latest drivers from HP:

  http://h10025.www1.HP.com/ewfrf/wc/softwareCategory?product=1153481&LC=en&cc=us&DLC=en&lang=en&cc=us&submit=go%20

• Photosmart C5180 - not possible to uninstall the drivers

  I want to uninstall my Photosmart C5180 of PC software, but it s is not possible. I also tried first to do a new install of the compleate, before uninstalling software - same result.

  Every time when I start the PC, I got an error message that says no connection to "TryApp"?

  How solv this problem?

  Hello

  Thank you for your reply,

  To uninstall the software, click Start and click on run in execution type folder window and click OK. This will open the Temp folder, in the eyes of temporary folder for the folder that starts with open 7Z file 7Z and then open the Utils folder and then open the CCC folder and double click on Uninstall_L4.bat and this will start the uninstallation process. Once this completed, please restart the computer and check.

• Printer HP photosmart C5180 need a CD for XP

  Lost my CD for my printer HP photosmart C5180 OS is XP try to install it, but need a cd please help

  Hello

  Welcome to the HP Forums!

  I understand that you are looking for a CD for your HP Photosmart c5180 for Windows XP, and I'm happy to help you!

  Please visit this Web site, all-in-one printer, HP Photosmart C5180 pilots, to download the driver. As it does not resemble a CD is available for this operating system.

  Hope this helps and have a nice day!