Lock shift continues to Flash

Similar Questions

• SPA-2100 continues to Flash.

  Hi all

  After receiving the SPA-2100, I have a problem with it. SPA-2100 more return as ATA.

  He seems to be in this stadium and never comes out:

  Slow flashing (0.5 sec ON, continues to 0.5 s OFF)
  

  • Initialization of the system; only occurs at the start of the SPA-maximum, time could be as long as 10 seconds (hardware reboot) to two seconds (warm start).
  • Firmware for download.
  • Looking for a DHCP.

  Other symptoms are:

  (1) the yellow and green lights (lights status, line1, line2, Wan and Wan) anti-terrorism Act keeps blinking once power is connected (with no other cable is connected). I tried to unplug and "the rest" of the anti-terrorism Act and then reconnect the power supply but the yellow and green status lights never "stabilizes" and will continue to Flash intermittently.
  (2) for the ATA WAN is connected directly to my router Lan port and ATA PC port connected to my laptop it reports that the cycles there after disconnected and network connection for limited available ("connection to the LAN - a network cable is unplugged") on the same cycle as the yellow of the ATA and the green light of connectivity LAN of the modem and the status indicators indicate.
  (4) listen to the connected analog phone you can't hear any sound feedback through the earpiece. Also no command doesn't seem to work. (*, etc.)

  I hope that this device is still noticeable feasible.

  Thank you

  Matt,

  I hate to say this man, but it seems (after view it) as if this device is toast. Where do you have, how long have you had, did you contact the HWC (866-606-1866) to support this topic, and when did this start happening? If you obtained it from a VoIP provider, then you must contact them for a new unit. If the unit was purchased by you, you can provide the serial number for the center of assistance to small businesses for a possible rma. If you have had more time that the hardware warranty is, then you will need to buy another camera. The link on each ethernet port lights should not be on unless there is an active connection at the other end. It seems that the unit is locked in its ' cycle (POST) start and won't boot. Good luck.

  Bill

• Stor.E USB HDD PX1399E - 2 20 - light continues to flash red / blue

  Stor E usb hdd, no access that passes light continues to flash red/blue, which means?
  (constant alternating red/blue 2 x / sec., and not not not flashing as read/write)

  * RESOLVED: * already tried several cables, also with dual usb (Y-cable).
  the solution was a cable with an interferencefilter close to the HARD drive.

  Post edited by: borel

  > RESOLVED: already tried several cables, also with dual usb (Y-cable).
  > solution was a cable with an interferencefilter close to the HARD drive.

  Thanks for your comments!

• Satellite C660 - keyboard does not work but the Num and caps lock shift are on

  I have a Satellite C660 which was working fine this morning. When I came home from work and he turned, the keyboard does not work and therefore can not enter my login information.
  The Num and caps lock shift are turned on.

  Any ideas on how to solve this problem?

  Hello

  You are able to disable the CapsLock and NumLock?
  You can access the BIOS by pressing F2 by turning on the device?

  If this does not work, I would recommend checking an external USB keyboard.
  If the USB keyboard would be functions, then this means that the internal keyboard is defective and must be replaced.

• Where is the setting to change to show when you lock shift or stopped

  Original title: caps lock display

  where is the setting to change to show when you lock shift or stopped

  Hello wgkg,

  It should be in the keyboard properties.

  1. open the control panel

  2. click on the keyboard icon

  3. in the keyboard properties, click on settings in the key

  4. scroll to the option of caps lock and highlight it.

  5. click on the button Configure (below the list of available keys options menu)

  6. in the caps lock set up a window, place a nect check mark (tick) for the "show state lock shift on the screen..." and then press the Finish button.

  You will see only the option above, if you have installed the relevant keyboard/mouse drivers. If you don't see these options, that is, the options key parameters, check with the manufacturer of your keyboard, see that you have the correct drivers and 'no' the standard Microsoft drivers generic like the one provided with windows.

  If her you've seen before a prompt on the screen for you say that the cover lock is enabled or disabled, but you don't see it now you probably disabled the option at some point in the past.

  This forum post is my own opinion and does not necessarily reflect the opinion or the opinion of Microsoft, its employees or other MVPS.

  John Barnett MVP: Windows XP Expert associated with: Windows Expert - consumer: www.winuser.co.uk | vistasupport.mvps.org | xphelpandsupport.mvps.org | www.silversurfer-Guide.com

• HP Probook 6555 b: Caps lock and num is flashing 5 times, no start

  Hello

  My referenced above laptop - HP Probook 6555 b - which worked fine until yesterday stopped all of a sudden start.

  When turned on, all lights are on except for the Caps lock and Num that flashes 5 times.

  The fan starts to spin for a few seconds, then stops, there are two short attempts to boot the DVD player.

  I saw a lot of 'solutions' by Googling, none of them worked.

  If you have experienced these problems or if you have the expertise, I would appreciate your hand.

  Thank you

  Ginger

  Hello

  Follow the steps listed in the link below

  http://h20565.www2.HP.com/hpsc/doc/public/display?sp4ts.Oid=4174258&docid=emr_na-c03515402&docLocale=en_US#N101A7

  http://h20565.www2.HP.com/hpsc/doc/public/display?docLocale=en_US&docid=emr_na-c01732674&sp4ts.Oid=4174258

• To cancel light continues to Flash for the last 2 days on my HP 6500 all on the printer.

  Light to cancel on my HP Office jet 6500 all-in-One Printer E709 help a series continues to Flash for the past 2 days, I changed the thinking of the ink that was the problem, but he did not. I unplugged all caps for about two minutes, then the replugged and nothing helped.  I was doing a copy 2 days ago and the paper stuck, I was able to recover all of the sheet, but since then I'm unable to use the printer.  I can't make copies; I can not print nor can I fax this printer.  What can I do?

  Bob_Headrick thanks for the info but I got intouch with the HP company directly, it seems to be a hardware problem.  They no longer support this printer, but gave a good discounted price for a newer version, I'm happy with.

• Lock shift.

  I can access Num Lock to caps lock shift. I can then switch between upper and lower case and the tone changes... for 5 minutes only. 5 minutes, I can switch between upper and lower case, but the tone disappears. The sound of the music remains. I can reactivate the tone as before without stopping.

  I can access Num Lock to caps lock shift.

  You need to explain what it means.

• Questions Microsoft sculpt an ergonomic keyboard - cannot press Caps Lock shift-space-E at the same time. The E key does not work.

  Hello

  Just like the title says, when I try to press a combination of: caps lock shift + space + E, E key is not broadcast.

  Pressing any other key (Q, W, R, T, Y, U) works very well.

  I noticed this only happens with the space bar on the left side, the right one to work properly.

  Any idea what goes wrong? and why the two spacebars feature is not the same thing?

  Thank you.

  Hello

  Thank you for your response.

  Because Israel is not listed in the list of countries for the hardware support, please contact the establishment from which you obtained your Microsoft product.

  Hope this information helps. Please do not hesitate to contact us if you have problems with Windows in the future.

• Is it possible to disable the caps lock shift key on a laptop?

  Is it possible to disable the caps lock shift key on a laptop?  I am running Windows 7 64 bit on a Lenovo laptop
  Thank you

  I understand that you have found some suggestions on editing the registry - they aren't so bad. If you don't want to download all of the files that allow you to disable the LOCKING of the capital LETTERS, you can create it by yourself:

  1. Press the Windows key + R > type notepad , and then press enter
  2. Paste to Notepad:
     

     Windows Registry Editor Version 5.00

     [HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\Control\Keyboard Layout]
     "Scancode Map" = hex: 00, 00, 00, 00, 00, 00, 00, 00, 02, 00, 00, 00, 00, 00, 3A, 00, 00, 00, 00, 00

  3. File > record under...
     • Select to Save as: all files
     • Enter the file name : disable_caps_lock.reg
     • Click Save
  4. Right-click on the created file > merge
  5. Restart your system

  In case you want to turn CAPS LOCK on again, you must remove this registry entry, so you must do the following:

  1. Press the Windows key + R > type regedit and press enter
  2. Go to HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\Control\Keyboard Layout
  3. Right click on the Card of Scancode > delete
  4. Restart your system

  I guess that it is perhaps the only way to turn off the CAPS LOCK.

  In case you still don't want to do this, Windows 7 offers something different to disable the LOCKING of the upper CASE. You can turn the ToggleKeys, then you will hear a beep when you press CAPS LOCK. To do this follow these steps:

  1. Press Start > Control Panel > access >easy access Center > make the keyboard easier to use
  2. Check the box to enable the ToggleKeys

• HP pavilion dv6-1245dx won't boot screen logo, grid screen, caps lock, shift and numluck work

  * little background, my laptop works well before it happened, I stopped and then tried to power it using after a minute I Gilles down, it starts and then when I try to use internet, the display suddenly blacked out, thought it was the power so I tried to power it again I get is bright with no logo so I turn it on and turn it on again then it became lines graph form tried to check if keyboard works numlock and capslock not working when I press it, ang wireless volume does not work

  HP pavilion dv6-1245dx won't boot screen logo, grid screen, caps lock, shift, and numluck work.

  I tried to remove the battery and press hold power button almost 60 sec to reset the bios always the same, I tried the reinstallation of the memory 2 still the same please help

  problem solved... saw something on the forum about pressing f10 or f11 I randomly pressed start magically work

• Cable connector HP Elite 8000 USDT network continues to Flash

  My small Elite 8000 Ultra computer has a glitch.

  The connector of the network cable continues to Flash, even when the computer is shut down.

  Any cure?

  Hans

  Definitely.

  Just unplug the CAT5 cable.

  This can be done if the PC is on or off.

  The flashing led immediately stop and turns off.

• HP Pavilion x 360 has the white screen and LOCK SHIFT key flashes

  I recently got a new laptop from 13-inch HP Pavilion x 360 a week ago. It worked well and I loved. six days after that I started to use it the screen goes black while I watch a youtube video and the mahcine started his strange. I use the power button to turn off the laptop, and then restart it. Laptop works very well and I continue to use it on another fifteen minutes until I close and start loading. 40 minutes later, I opened the laptop to find that the screen does not light and the CAPS Lock key blinks once in a repeating sequence. I didn't do anything the screen lights up. After some research, I think it's a potential CPU issue. What are the reasons as to why it happened to my brand new laptop?

  mijamo21 wrote:

  Yes, I have a warranty and I contacted HP support to send my laptop in for repair. Thank you!

  Your welcome, best thing to do while he is still covered.

• Lock shift out of synchronization with the 2008 Server RDP session

  Hello

  A few of our users have problems with their caps lock being out of sync with their RDP session, that is to say if their keyboard displays light as being off, they type and get capital letters when they press the SHIFT key on their keyboard to stop the caps lock lights up and they then type in lowercase.  I can't find any resolution on the web about what is happening in a 2008 R2 server environment.

  Can anyone help?

  Thanks in advance.

  The gurus server hangs in the TechNet forums, here, we are dealing with consumers having problems with Windows or system performance.

  http://social.technet.Microsoft.com/forums/en-us/categories

• Why is there a delay when I press Caps Lock shift before I can type

  Problem in typing and replacing letters without ceiling... the computer takes too long.

  When I type, and then press the f lock key my computer takes a few seconds before it works.  I tappe has about 90 OMP and it's very frustrating when I want to make a word CAPE all and I have to really stop and wait before I can continue typing.  I have an icon in the lower right corner with a picture of a lock, and when I press the button to unlock the icon change in the image of a padlock with the universal, no symbol (a circle crossed out).  All of the suggestions.  JSSmsn

  See these:

  http://forums.MacRumors.com/archive/index.php/t-897584.html

  http://www.computing.NET/answers/Windows-95/caps-lock-takes-a-while-huh/163377.html