MacBook pro won't turn on if plugged into the charger

Similar Questions

• Smartphones blackBerry white screen and light flashing when plugged into the charger

  phone was low load and I let it run out, but when I plugged in the charger all that I get is a blank screen and flashing light.  How he goes again please.

  Hi Pattisalt59

  Have you tried to remove and reinsert the battery while your device is connected to a charger? If not try and see if it blinks.

• MacBook Pro won't feed - need to disconnect/reconnect the battery.

  I have a 'early 2011' MacBook Pro 17 "which does not illuminate when the power switch is pressed.    He worked normally in the last time it was used.

  I'm a PC I / specialist t so I did some fault finding.  Here are the results and measures, I tried:

  1. Power button and no indication button has been pressed.
  2. Button on the side and he said fully charged battery.
  3. Adapter a/c and LED power connector attached LED lights up in green as it is supported.
  4. You press the power button - still no indication of any attempt to power on.
  5. Let Reset SMC pressing SHIFT, control, Option, and power switch.  All released.   You press the power button - still no indication of any attempt to power on.
  6. Power button which is held down for 15 seconds, released, then no hurry once - no change.
  7. Disconnected a/c power.
  8. Removed the back cover.
  9. Battery disconnected from the system board connector.
  10. Connected a/c adapter and power button pressed - no change.
  11. Disconnected the a/c adapter.
  12. Back in the connected battery system board connector.
  13. Joint a/c adapter and the system performed a reset, then IPL upward and ran normally.
  14. System "Shut down" and then press the power button - would not be back.
  15. Removed the a/c adapter and pressed the power button - still wouldn't back off.
  16. Disconnected a/c adapter, disconnected the battery, battery reconnected to the system board.  Power button - will not turn on.
  17. Repeat the procedure which worked previously - a/c offline, disconnected battery system board, connected a/c, press button power (no signs of activity), disconnected a/c, battery reconnected to the governing body of the system, reconnected a/c and it reset and power!
  18. Let system and then "reset" (instead of closing) - it restarts correctly.
  19. Shut down the system and then I tried to power - will not turn on.
  20. Bottom line: it seems that the procedure which will get the system starts, after it is closed: disconnected a/c, disconnecting the battery system board, connected a/c, press power button (no signs of activity), disconnected a/c, reconnected battery to the system board, reconnected a/c and it resets and starts.

  OK, so you MacBook Pro experts out there... what seems to be the problem and what measures would you recommend I take?

  THX,

  Jeff

  Hi Jeffrey,.

  Welcome to Apple Support communities.

  Looks like you did some troubleshooting while trying to solve the problem with your MacBook Pro turns is not on. The article below provides some additional troubleshooting steps that should help you further isolate and resolve service installation or question.

  If your Mac will not turn on - Apple Support

  See you soon.

• Acer Aspire V5 552 slow game performance low when it is plugged into the charger (HELP!)

  So, I recently noticed that my Acer laptop has a problem when it comes to games. The speed of the CPU is really low when you start a game, I did not notice this until a few hours before... I was playing Borderlands 2 and I am disconnected from my laptop to move it to my office and I noticed that my FPS has increased almost double what they were before, I plugged my laptop for the charger and I started to look at the the CPU cores, each carrot got preatty fluctuating between speed and low speed. I've tested this with all my games and all had the same results, for example a Borderlands 2 area when it is plugged in the exercise was about 18-22 FPS, but when disconnected from the charger the FPS increased from 34-48 or more. I tried to read a lot of things on the web and can not find a solution to this...

  Another test I did was with Dolphin Gamecube emulator, the FPS when playing the legend of Zelda The Wind Waker varies between 22-26 or lower on the places of strong thickness, when unplugging my laptop charger I have 30 fps constant in these heavy areas.

  Also with Counter Strike Global Offensive, the game normally ran about 50-60 FPS in all the cards and then tested without the charger plugged in and got 70-120 FPS on all cards

  https://www.YouTube.com/watch?v=xc6Hwgedqmo

  This video shows exactly what happens for me, unless I have an AMD GPU and CPU.

  My Acer Aspire V5 552 Specs are.
  Windows 7 X 64
  8 GB RAM
  AMD A8 - 5557M @2. 1 GHz to 2.8 GHz Turbo
  AMD 8550G GPU
  I have all the latest drivers and updates installed.

  The charger is not damaged, it is original one supplied with the notebook.

  Got a nice deal on a MSI gaming laptop. At first I thought that the Aspire V5 has been an excellent laptop for budget games, but then turned that has a performance problem that ruined the processors to give power maxi while only plugged in, but when unplugged the other way around. Still a nice cell phone with potential wasted with this particular problem.

  No solution to this problem, tecs don't even bother looking at BIOS like other manufacturers of laptop to solve this same problem.

• VAIO 13 Pro won't turn on without plug

  Since I started to install the new updates, which never completely installed through vaio updates. They would fail to install.

  Since then, my laptop lights not connected.
  Don't load increased from 77 per cent and if I unplug the power, the laptop automatically shuts.

  I tried to get to before the updates, nothing has worked.

  Any help guys?

  Oh also, if I highlight the battery in the taskbar, it looks like 2 battery is not attached... I don't have a two battery? If this refers to a sheet of battery, I have no one.

• My MacBook Pro with El Capitan 10.6.11 close the menu drop down. I have to turn off the power

  The closing down and options no longer work in El Capitan 10.6.11 restart on my MacBook Pro mid-2012. I have to press the power button to turn off.  When shutting down or restarting are selected, the Ribbon at the top of the screen disappears and Finder is no longer available but other aps on the bench of the accused are still available. When I restart after turning off the power, the system is back to normal until I need to close again.

  Hello

  Just in case, run disk utility.

  Open utility disk located in Applications/Utilities

  Then select the disk to boot on the left and then select the first aid tab and then click run.

  If disk utility indicates that the disc seems to be OK, you are finished. Otherwise, you must repair the disk.

• Hello my MacBook Pro model (MacBook Pro (15 inch, early 2011 am Dubai bought the Sryalsh C02FD2CPDF8 number and I am in Iran that MacBook Pro not enter the device screen when I turned on the pink vertical lines can be seen, the problem is restless))

  Hello my MacBook Pro model (MacBook Pro (15 inch, early 2011 am Dubai bought the Sryalsh C02FD2CPDF8 number and I am in Iran that MacBook Pro not enter the device screen when I turned on the pink vertical lines can be seen, the problem is agitated and it is not difficult to work with him because I like and what I should I do?))

  Serial number C02FD2CPDF8V

• In early 2011, MacBook Pro won't start

  In early 2011, MacBook Pro won't start

  Is-ti connected? Fully charged?

  Give us some facts!

• I have a Macbook pro (2011 model). It gets stuck on the start screen on to half way through commissioning. This happens whenever the mac turns on. The problem is solved when I reinstall Yosemite to boot to Recovery Mode disk utility.

  I have a Macbook pro (2011 model). It gets stuck on the start screen on to half way through commissioning. This happens whenever the mac turns on. The problem is solved when I reinstall Yosemite to boot to Recovery Mode disk utility. However, the next time you start, the startup process is blocked to halfway to new (on the screen with the toolbar and the status of apple). I want a more permanent solution to reinstall the operating system every time. Would appreciate someone's suggestions and thanks in advance.

  Replace your hard drive.

  You have a backup of trust? If not, buy a disc of exterrnal for that as well.

  The progress bar from the left end at the beginning of the commissioning indicates that your drive has been so damaged, it could not be mounted. Five minutes of progress bar is shown as it does the equivalent of disk utility (ERD [Directory]). If you have reinstalled several times and the problem is not fixed, your drive is in solid form.

• My iPod stop now, it won't turn even after be plugged into the power supply for more than an hour

  IiPod touch than 64 GB itself now cut an hour plug into the current af it starts

  Press the sleep/wake and home buttons and keep them for at least 10 seconds.

  If this is not enough, take a look at these articles Support from Apple:

  If your iPhone, iPad or iPod touch does not respond or does not turn on - Apple Support

  Use iTunes to restore the iPhone, iPad or iPod to factory settings - Apple Support.

  As a final step, try recovery mode. Turn off your unit, then plug it to your computer with the hold home button. Hold down Home button until you see the logo on the screen of your iPhone iTunes. After that on your computer, you should see the iTunes window saying that your iPhone needs to be restored to factory settings. Click Restore.

  More info here:https://support.apple.com/en-us/HT201263

  If these steps do not work, contact Apple and ask for help.

  https://www.Apple.com/support/iPhone/contact/

• Why my Macbook Pro boot used place in any mode but the comments?

  My Macbook Pro almost 5 years, worked very well, then the beech ball began to come a lot and programs would take forever to load. I tried to stop him to restart in diagnostic mode, but it would not closed and just hung up for about an hour.  I hit the power button to force a power down and when I went to turn it on again, it does not start in safe mode or diagnosis.  He goes to the login screen and gives me the choice of my log in or invited, but starts if I select my journal going through the motions leading to the top of the load bar, but before he gets to the end, she stops.  I can start in guest mode and access the internet, but I can't do anything from there.  If I click on the Apple, it gives me the opportunity to go to the startup disk, and when I click it, it asks which drive I use, (only one option, HARD drive), but when I select it, there is nothing there.

  I can't really afford a new Macbook for now, and until the last few days it works very well, so I prefer to get it fixed to the top if I can, so any help is appreciated.

  See you soon,.

  Troy

  Hey there,

  I see your message that you are unable to connect to your user account, even in safe mode.  I would like that you try to start your computer in OS X Recovery and then try to repair your hard drive.  If the problem persists after that, you can reinstall OS X.

  To start your computer from recovery, restart your Mac and press the command and R keys at startup.

  

  Hold these buttons until the Apple logo appears. After your computer has finished starting upward, you should see a desk with an OS X menu bar and window OS X Utilities with the above options. If you see a login window or your own office instead of the utility window, it is possible that you do not press command + R early enough. Restart your computer and try again.

  Choose the option you want to use from the utility window or in the Utilities menu.

  OS X: on OS X Recovery

  Take care.

• Time machine automatically upwards a WD passport when its plugged into the machine of time rather than the macbook?

  Hello

  I have a Macbook Pro with a WD passport for mac that I keep all my photos on.  I know that time machine will back up there if I plug it into the mac and select it to be excluded from the United Nations through the time machine preferences, which I did, but I generally keep the Passport plugged into the time machine itself and use wireless.

  However, I don't really know if time machine is it backs up this way, or if it's just a wireless router that allows me to access the Passport.

  How will I know if it is saved?  And if not, how can I save it while it is plugged into the time machine?

  Unfortunately, it seems as if you are confused about the terms of Time Machine and Time Capsule.

  Time Machine is a software on your Mac, which is used to back up your Mac hard disk... like a Time Capsule

  A Time Capsule is material... more precisely a wireless router with a built-in hard drive that can be used to store backups Time Machine .

  With this information in mind, can clarify you what it is you want to do?

• Failure of Adobe Camera Raw 9.3 dmg for Sony RX1RII with MacBook Pro OSX El Capitan 10.11.5 [using the CS6]

  While Adobe says his record the FIRST 9.3 update plug-in for Adobe Photoshop CS6 (Extended) strives to convert directly from the RXRII of Sony camera RAW files, is not. Maybe my MacBook Pro OSX El Capitan 10.11.5 exceeds the 10.11 noticed on the Adobe Camera Raw graph?

  Please notify.

  CS6 can only be updated up to a maximum of ACR 9.1.1 to install cab 9.3 in CS6, attempts fail.  You can check which version you have by any plug-in / Camera Raw (I think on a Mac).

  You can register CC (LR+PS@$120/yr=$10/mo is the least expensive) or use the DNG Converter to DNG for raw files and the DNG, but not the native raws, open in your older software.

  The DNGC is here: http://www.adobe.com/downloads/updates/

• When I power on my iPhone and plug in the charger it turns on, is this normal?

  When I power on my iPhone and plug in the charger it turns on, is this normal?

  Yes, it's normal.

  If the battery power goes off and you recharge it will reboot the phone for you when it reached a stable level so that you can get phones without hovering above the device to see if it is ready.

• I've upgraded to the new operating system and now my MacBook Pro is in trouble.  Should I uninstall the new system and if so how?

  I have upgraded to the new operating system, El Capitan 10.11.4, and now my MacBook Pro is in trouble.  Should I uninstall the new system and if so how?

  Restore the backup that you did when you replaced the old system