No sound from the tv with hdmi w3 connection

Similar Questions

• No sound from the computer with connected generic speakers VISTA SP2. Symbol pregnant shows active with the Digital Audio device.

  I have vista SP2, I connected to generic stereo speakers using the green light at the back of the computer. Vista does not recognize the speakers. The speaker symbol at the bottom right shows "digital (HDMI) 2 high definition output audio device." It shows active. I had this problem before, and VISTA should pick up 'speakers' something to that effect. I have no sound until it captures "speakers". I can't get VISTA to recognize this. It keeps starting with the digital audio device. Don't know what to do, checked all the forums. It should just pick up these simple generic markets good speakers. Before SP2, I lose sound when VISTA is in standby mode. He would then turn off the stereo speaker and replace the digital output device driver... However since SP2 I can't get VISTA to recognize that I have just connected speakers and not a digital output device.

  Yes, when I uninstalled the driver, THEN shut down the computer and then restarted, he picked up the device high definition audio "speakers" good pilot is NOT the

  "digital (HDMI) 2 high definition audio output device that he used to pick up."

  I now have sound!

  I hope that it stores the right driver now as in the past, when VISTA went into sleep mode, it will disable the speakers, and you have to restart every time.

  Thanks for your help.

  You can add instructions to boumediene, the fact that you must RESTART your computer to search for new drivers, once you uninstall.

• No sound from the Clip when it is connected to the car charger and car s in the

  I just got a car charger for my 8 GB Clip. I have the Clip connected to the connector of the car aux in, and it plays beautifully this way.

  However, when I connect the car charger, which is a fact by Motorola for a mobile phone, the sound of the Clip completely stops.  There is no sound at all.

  Even if I barely touch the metal of the car charger USB plug to the USB port of the clamp, the sound cuts.

  A ground loop isolator would correct this problem? The comments that I have read of these say all that they helped with motor and alternator noise, but I don't have that.  I have no sound at all, even if the Clip is loaded and he continues to play according to the display of the item.

  I checked the car charger works well because I have a box of jump with a record of 12 VDC (just like in the car).  The cool Clip and plays with a helmet with the Motorola car charger in this configuration very well.

  Any ideas what is wrong and how to fix it?

  Thanks in advance.

  Just for this follow-up, the ground loop isolator completely fixed the problem I had with the sound cutting on my video in the car.

  The one I chose was the PAC SNI-1/3.5 RCA noise filter.  He goes online with 3.5 mm cable to the and has a socket on one end and a plug on the other.  It would have been cool if he had just had two male connectors, because then I could have plugged one side in the Clip and the other in the input of the car Jack.

  There is no significant deterioration in the sound, and now I can load the Clip while listening.

• I have my Dell XPS HDMI cable to my Sony Bravia TV / I get the image on the TV but the sound from the laptop

  I have my Dell XPS HDMI cable to my Sony Bravia TV / I get the image on the TV but the sound from the laptop

  Thank you.  I had to go to the sounds and have speakers/headphones to HDMI it didn't work at first but founmd you need to have the TV and the computer.

• HP Wireless TV doesn't Connect - no sound from the TV

  HP G60 - 235DX notebook PC with Windows Vista.

  HP Wireless TV Connect WY555AA #ABC model

  Connected to the HDMI port - 2 on a Samsung HD 52 '' TV

  The video is great, but no sound from the TV speakers. Sound plays on the mobile speakeres.

  I checked the Device Manager on the laptop and the drivers are up to date and there are no conflicts.

  Help, please.

  Thank you

  Hello Larry,.

  Please take a look at this document, which provides troubleshooting steps that should help you resolve your problem of 'no sound', connecting your laptop to your Samsung TV via an HDMI cable.

  Please let me know if it helps to solve your problem.

  Good luck!

• iOS 10 no sound from the speaker of the ear or EarPods

  After update of iOS 10 (in 6 s iPhone and 5s) I have a problem then to make or receive calls. Most of the time it is no sound from the speaker of the ear or EarPods and I have to press the speaker during calls to listening. To get back what I have my iPhone and open it again. This seems to happen after that I used once the EarPods.

  Be aware that I have consume EarPods in 90% of my calls and iOS 9 I had no problem at all.

  Hello Billy78GR,

  Thank you for using communities of Apple Support. It is my understanding that you met the receiver and headphone audio problems after update to iOS 10. I know that it is extremely important to be able to hear others during calls. I'm happy to help you to get this resolved with you.

  First of all, I recommend you restart. This can solve many unexpected behaviours. Follow the steps below to restart.

  1. Press and hold the sleep/wake button until the Red slider appears.
  2. Drag the slider to turn off your device completely off.
  3. Once the device turns off, press and hold the sleep/wake button again until you see the Apple logo.

  Restart your iPhone, iPad or iPod touch

  As you use the headphones on most of your calls, I recommend checking and removal of dust or debris from the helmet. If the problem persists, please refer to the additional steps in the link below.
  If you do not hear a person, a call or a voice message or if the sound is not clear on your iPhone

  Have a great day!

• New iPhone SE no sound from the speaker of the brand

  I just bought a new iPhone SE and I'm getting no sound from the speaker. Does anyone have any ideas on a possible resolution?

  I restored from an iPhone 5 to the top, both phones are on the latest version of iOS.

  Once the synchronization is complete, I ejected the phone correctly. But there is no sound coming from the speaker:

  • Key "secret" in both positions, no sound from the speaker
  • The top volume, using the volume buttons and the sound, no sound from the speaker settings
  • Headset plugged in, sound comes from the helmet, remove them, the iPhone recognizes, but still no sound
  • I tried the music app, ringtone from another phone, videos, podcast app, no sound from the speaker
  • Past the phone power off & on again, no sound speaker
  • Reset iPhone (hold both buttons down for 10 seconds), no speaker sound
  • Reset iPhone settings, no speaker sound

  I begin to suspect it is a hardware problem, but as I am not near the Apple Store, I would try as much as I can before you go this route.

  Thank you

  Hello Andy,

  Thank you for using communities of Apple Support.

  I understand that you have restored your iPhone backup iPhone a precedent, and now there is no sound from the speaker.  Given the troubleshooting you have already done your next step is to restore the factory settings to see if the problem persists:

  Use iTunes on your Mac or PC to restore your iPhone, iPad or iPod to factory settings

  If the problem persists, then please make an appointment with the Apple Store is close.

  http://www.Apple.com/retail/Geniusbar/

  Take care.

• No sound from the right speaker / can not configure the speakers

  Hi all

  I have a new computer Sony laptop and just tried plugging in my speakers 2.1 computer inside.  Sound only comes out of the left satellite and a subwoofer.  When I try to set them up in the sound control panel, the installation of the single speaker on the speaker Assistant is stereo and only the first test tone (left) plays from the satellite on the left, then silence (no dial tone test on the right).

  Everything works fine on the built-in Laptop speakers, but they are for computer speakers, so I wish I could use my old speakers when I'm at my desk.

  Sony Vaio and Windows Update Update did not recommend all new drivers for the audio controller.  I downloaded and installed the latest driver on the site from Realtek but that didn't work at all so I rolled it back to the version provided with the system.

  Work fine with my laptop speakers older and my cell phone, so the fault is not with the right satellite is.

  Thank you
  Drew

  Hi Drew,

  Thanks for posting your query in the Microsoft Community. There is no sound from the right speaker in accordance with the description of the problem.

  ·         Did you do changes on the laptop before the show?

  I suggest you follow the steps in the article.

  Tips for solving common audio problems

  You can see these articles for more information:

  Sound cards: frequently asked questions

  No sound in Windows

  I hope this helps. Let us know if you need more assistance.

• How to block the site from the db with Mozilla?

  How to block the site from the db with Mozilla?
  I noticed this file is blocked by some customers of Mozilla. Is this possible to Mozilla software and security settings?

  On another machine it works but the other cannot be connected to the database. This puts inside Mozilla technical possible?

  See:

  • http://KB.mozillazine.org/Parental_controls

• How to use the adapter from the wall with my Mac Pro laptop?

  How to use the adapter from the wall with my Mac Pro laptop?

  The AC wall connector is not compatible with the outlet on the MBP?  As the MBP charger will work from 100v to 240v, a transformer is necessary.  You need a converter that connects to the power outlet home and is compatible with your MBP.  You can buy the Apple travel kit:

  http://www.Apple.com/shop/product/MD837AM/A/Apple-world-travel-adapter-Kit

  Or you can use a single specific converter for the geographical area:

  http://www.Amazon.com/orei-grounded-universal-adapter-Singapore/DP/B004SCSV2U/re f = sr_1_4? ie = UTF8 & qid = 1460735377 & sr = 8-4 & keywords = us + in + uk + power + adapter

  (it is a UK USA example)

  Or you can get the converter that adapts the charger directly:

  http://www.Amazon.com/HIOTECH%C2%AE-extension-charger-connecting-specification/d p/B00MA48JZW/ref = sr_1_3? ie = UTF8 & qid = 1460735486 & sr = 8-3 & keywords = us + in + uk + power + ad aptor + apple + charger + cord

  (again, this is for a UK plug.)

  Ciao.

• I have no sound from the external speaker

  I connected this morning my iPod in my car, as always. But today I got the only sound from the internal speaker and no sound from the external speaker in the car. So far I have never had problems.

  How did the car system connected to the car?

• Save the selected value from the ListBox with its respective values control tab dropdown selected in another list box

  Hi all

  I'm doing a vi where I save the selected value from the ListBox with values respective tab control dropdown selected in another list box. Whenever I select Item1 can change of course and the respective tab will be open for this element. But now I want to just save the selection and put it into another ListBox.SO I can't renmove or add my wishes. Please help me.

  It will work.

  Probably not the greatest solution well.

• My speakers on my Dell Latitude D820 suddenly emit only a low sound. I adjusted all the volume controls in the menu sounds from the Control Panel, and there is no change in volume.

  Low sound volume

  My speakers on my Dell Latitude D820 suddenly emit only a low sound. I adjusted all the volume controls in the menu sounds from the Control Panel, and there is no change in volume. It's real power radio on the internet and play music from a CD inserted into my machine. The sound icon does not appear in the toolbar.  I tried the fixit of automatic Wndows and it ran and said low volume has been set. Not the case.

  Hello

  1. what operating system do you use?

  2 did you change on your computer?

  Method 1:

  I suggest you follow the link and check.

  No sound in Windows

  http://Windows.Microsoft.com/en-us/Windows/help/no-sound-in-Windows?T1=tab02

  Method 2:

  I suggest to follow the link and search for the volume in the taskbar.

  (a) right click on an empty area of the taskbar and then click Properties.

  (b) in the Notification area, click Customize.

  (c) select the volume see the icons and taskbar notifications check box, and then click OK.

  I also suggest you to follow the link and check.

  Change icons appear in the notification area

  http://Windows.Microsoft.com/en-us/Windows7/change-how-icons-appear-in-the-notification-area

• I'm not all the sounds from the speakers. The volume is up

  I'm not all the sounds from the speakers.  The volume is up

  The following links may be worth a visit:

  No sound in Windows
  http://Windows.Microsoft.com/en-us/Windows/help/no-sound-in-Windows
  (Win XP / Vista / 7)

  (307918) how to troubleshoot sound problems in Windows XP
  http://support.Microsoft.com/kb/307918/en-GB

• No sound from the microphone in Windows 7.

  Original title: Add a microphone to windows 7

  Hello I am trying to add a microphone to windows 7.  I put in the pink jack point on the back but no sound. I'm redoing a voice on a software program Pinnacle while the editing of a film that I took.  Thank you very much

  Hi Linda,.

  You are able to get the sound from the speakers?

  You can check if the microphone works on another computer.

  You can also try to run the hardware troubleshooter and check if it helps.

  Convenience hardware store