Pages Web for phones must be Apps?

Similar Questions

• Page Web for TomTom starts automatically when windows start.

  When I start my computer the webpage for Tom Tom charge automatically and a pop-up box shows asking me to connect my Tom Tom GPS.  After I close the web page and the pop up my computer works normally.  This problem is very annoying because it really slows down to the top of my boot time.  I use the original version of the 64-bit Windows 7.  Any ideas?

  
  OT: Network programs network networking Internet site Internet Site Web URL of the Web Site
  Thank you
  John

  Hello

  Thank you for the question to Microsoft Community. I'll give my best to help you.

  Method 1
  I suggest you try the steps suggested by kathleencollins dated on June 20, 2012 from the following link:
  http://answers.Microsoft.com/en-us/Windows/Forum/Windows_7-desktop/how-can-i-prevent-my-TomTom-navigation-screen-from/5f478553-fd79-4FE3-9785-d1f80cb3b3e7

  Method 2
  I suggest you try the steps from the following link:

  Run a program automatically when Windows starts
  http://Windows.Microsoft.com/en-us/Windows7/run-a-program-automatically-when-Windows-starts

  Method 3
  I suggest you try the steps from the following link:

  How to remove a computer virus?
  http://Windows.Microsoft.com/en-us/Windows7/how-do-I-remove-a-computer-virus

  Note: When you perform an anti-virus online, you will lose data that are affected by the virus. Microsoft is not responsible for the loss of this data.
  Note: this section, method, or task contains steps that tell you how to modify the registry. However, serious problems can occur if you modify the registry incorrectly. Therefore, make sure that you proceed with caution. For added protection, back up the registry before you edit it. Then you can restore the registry if a problem occurs. For more information about how to back up and restore the registry, click the following article: http://windows.microsoft.com/en-US/windows7/Back-up-the-registry

• Feature Request: Double page layouts for phone / Tablet collections

  This is a feature suggestion, especially where you have sensitive items in the collections that extend across the phone and Tablet top level NAV.

  IE: same collection includes two provisions applied - one for Tablet, one for the phone.

  Dream scenario would be a presentation for iOS phones, tablets, Android phones, tablets.

  Not too much to ask, is it?

  D

  I had posted this same request a few days ago. Neil has indicated that this is a feature they want to deploy Q1 2016!

• When I type in a search on the web for anything whether it's IE, eBay or Facebook my PC just redirects research and opens another page, how can I rectify this

  Original title: redirection

  When I type in a search on the web for anything whether it's IE, eBay or Facebook my PC just redirects research and opens another page, how can I rectify this

  Hi Mark,
  Your computer is probably infected by a virus. Try following the steps in this virus/malware removal guide: http://www.selectrealsecurity.com/malware-removal-guide
  It contains instructions which will remove most malware infections. If you have any questions, just ask me. I hope this helps you.
  Brian

• Why Internet Explorer 9 to open up to 4 web pages made for my homepage to my pc startup?

  Why Internet Explorer 9 to open up to 4 web pages made for my homepage to my pc startup?

  Because you somehow put on your Home Page to have several tabs, all pointed at the same address.  Click on the homepage "wedge" and select «Add or change home page...» "to remove external links.

• is it possible to make a lot of layout for phone Adobe Muse in the mobile web browser like safari?

  is it possible to make a lot of layout for phone Adobe Muse in the mobile web browser like safari?

  or hind the search and address bar.

  I can't wait to meet you! Thank you

  [Moved from the Lounge Forum for a specific forum - Mod]

  Why not?

• I am trying to create a button that opens a pop-up window with a video player, sensible size. Also, I would like for the page Web of the background go darker when that happens. Is there a way top make in Muse?

  I am trying to create a button that opens a pop-up window with a video player, sensible size. Also, I would like for the page Web of the background go darker when that happens. Is there a way top make in Muse?

  Hello

  I created a video for you in Muse. Here is the link:- lightboxvideo.mp4 - Google Drive

  I hope that it would give you an idea on how to do just.

  Kind regards

  Rohit Nair

• How to set the page template for a page in app

  I've been looking for a way to re - assign a specific page to a different page template, and I must be blind. I did it with the regions and reports, but never a whole page. The closest I can find is how to set the default page for an application model template. What I have is a printable form that they want in a specific format. I was able to code the whole thing into a region of PL/SQL, but I was hoping that I could take an existing page template and modify the model to different regions in the areas I would like to.
  
  Can someone help me find this? I have already created a copy of the page template I want to twist.

  If you are in the tree view, double-click the entry of title of page (top); If you are in the component view, simply click the edit button in the page area. Either way will take you to the screen of the Page change. in the display attributes section, you will see a Page Model drop-down list.

  -David

• How to create a page "administrator" for the management of web site with muse?

  Hi people from adobe, I am writing because I have a problem and hope you can help me!

  I created a website with muse, but now I have need a page "administrator" for download rapid photos in the Gallery of the site (like CMS) section, can I create with adobe muse or will I achieve a personal PHP page?

  PS I'm sorry for my terrible English and thank you for the help.

  Francesco M.

  You cannot create any dynamic stuff with just muse. You really need to use PHP (or other server languages) and one database.

  Mylenium

• Pop - annoying up on my pages web site

  Recently I was an annoying pop up on all the pages of my web site
  www.cornubused.com. it's a site commercial marketing our business education
  products. At first I thought it was something on my computer that was originally
  This, but now I get comments from other people who have access to my web site. This
  occurs only on the pages of my web site. I would like to know how to get rid of
  This pop-up. A message is the following:

  "Do you want to allow this web page access your clipboard?" If you allow
  This, the web page can access the Clipboard and to read information you have
  cut or copied recently. "Here are two buttones click on this"Allow message
  Access "and do not allow."

  I'd appreciate it if someone can tell me how to get rid of this pop up
  What is annoying users of my website.

  Quote:

  .. .the behavior occurs when you visit a Web site or a Web page that tries to access the information stored in the Clipboard? s memory... and, as Clipboard? s memory data stored may be sensitive and private for reasons of security, IE7 pops up an alert warning message as below: Do you want to allow this page Web access your Clipboard? If you allow it, the Web page can access the Clipboard and read the information you have? ve cut or copied recently.

  So, knowing that if you turn off this feature, the Web site are given free access to your data stored on the Clipboard, you are ready to share this information with them? If Yes, open the "Internet Options"--> security settings--> custom level...--> programmatic access to the Clipboard... check the 'Activé' option and then click on 'OK '. You need to apply and OK you way out again. At this point, you must restart to successfully post the changes on the hard disk. Be aware, however, that you deleted one of the security settings by default which is to protect your computer and your private data. If you think it's a good idea, the option is there for you to make this choice. Be careful!

• Cisco Wireless-N bridge for phone adapters firmware update problem

  Hello

  I have a bridge for phone adapters N of Cisco wireless. I decided to update the firmware on the device. I downloaded it from the official website of Cisco download page. So I've just connected to the device and started the update procedure. I waited for the right amount of time allowing the aircraft to install a new firmware.

  Now the wireless bridge will not start. Once powered up system LED will blink green for 15 seconds. Then it will become orange and flashes with a frequency higher than forever.

  I tried factory reset, but it does not work: same behavior remains.

  As a note - I have updated exactly same device with exactly same firmware just before I did this and it went good - firmware is not a reason for this behavior.

  Can anyone advice me on what I can do to give life to this device?

  Hi Nikolai,

  If the unit is still under warranty I suggest you to contact Small Business Support Center and open the ticket as most likely the replacement is necessary:

  http://www.Cisco.com/c/en/us/support/Web/TSD-Cisco-small-business-suppor...

  Kind regards

  Aleksandra

• BlackBerry Smartphones (App) not available for download from Blackberry App World

  I use a Blackberry Bold 9000 (personal use) on Bell Mobility.  The operating system is v5.0.0.681 (1137 Bundle, platform 5.2.0.64) and I'm in v2.0.1.12 App World.

  My App World worked well until I have asked me to set up my Blackberry ID.  Since then, App World is basically useless.  My main questions are:

  1. Whenever I try to connect on App World, I am taken to the additive screen of Blackberry App World membership.  I accept the conditions each time, but nothing is recorded, and I have to go through the same process the next time I log on.
  2. When I try to download updates to existing applications, I get the dreaded "...". not available for download on Blackberry App World. »
  3. When I try to download new applications (IE TSN Mobile), I get the same "... not available for download from Blackberry App World."

  After a very long session with Bell Mobility and RIM Technical Support staff, I was able to solve the problem I was experiencing.

  I initially created my Blackberry ID using my mobile device (9000 "BOLD").  Apparently, the program installation but unfinished and recorded properly and that was the root cause of all problems.  When I logged in Blackberry ID of my laptop, I was able to complete the installation in three steps process.  It was to download a plug-in on the Blackberry site, connect the phone to the laptop and then completing the installation program (including seizure of Paypal information, if you wish) on the laptop.

  After completing this process, I could connect the Blackberry ID on my mobile without having to go through the Blackberry App World membership additive and all my downloads have worked without error.

  IMPORTANT: the completion of recording Blackberry ID process must be carried out using Internet Explorer.  I had actually tried to do this a few days ago, but I've been using Google Chrome.  As a result, the global need App Plug In did not download properly on my laptop and I couldn't finish the rest of the installation procedure.

  I hope this helps other people who have faced this problem.

• Change the mailto: link Outlook Desktop for Windows 8 Mail app

  After you have installed Office 365 in Windows 8, the desktop version of Outlook took the "mailto:" links from other applications and Web sites. I want to continue to use the Windows 8 Mail application. Is it possible to change this setting?

  1. move your pointer to the bottom left of the screen, right-click and then select Control Panel then select default programs.

  2. Select set your default program settings.

  3. Select the mail on the left.

  4. Select set this program as default.

  5. click on OK.

  For the Mail app this only associates the mailto: Protocol. It does not send an email page/link for the e-mail application.

• I should have more than one breakpoint in a responsive design for phones?

  I cannot too not exposing things for web browsers, and tablets, but when I get down to sizes of phone, it is difficult to get the page layout to look good.  I decided to try 2 breakpoints for phones: 380 pixels for smaller phones and 480 for larger facilities.  The real world results are disappointing.  A Samsung Galaxy S5 resembles what I see in Muse, but is shifted to the left or overscans on my iPhone 6 s.  It is difficult, what breakpoint is applied.  Is there an advantage to using more of a breakpoint in the class of size phone?

  See 'Why a sensitive site does the white blocks on the right and at the bottom of a page view on an iPad, but work fine on other devices?' in Adobe Muse FAQ

  See also resources for the use of breakpoints listed below the article mentioned above.

• Photoshop Touch universal application for the Continuum for phones on Windows 10

  A few days ago I bought a new 950 Lumia from Microsoft with Windows Mobile 10 which have the peculiarity of 'Continuum for phones' very useful which allow you to use Universal Windows App on a big screen and see them with the same interface they have when they are running on the desktop environment, but the app is still running on your phone.

  With Microsoft display Dock (or others of another manufactuer), you can even plug in you USB mass storage devices.

  For my work I only need Word, a file browser, a Web browser and an app with levels just like Photoshop Touch of Sophie photo editing.

  I already have all the universal App I need, but I'm still missing something like Photoshop Touch and it is not PhotoshopTouch as a universal application on Windows Store (at least with levels).

  If Adobe decides to make Photoshop Touch (or something similar) as a universal Windows application, I use only my phone to do anything and it connects on a large screen, mouse and keyboard when I arrive in my office, without need to bring the laptop with me and with the utility to continue my work on the road on my phone because everything is already there with the Continuum without need for multiple devices and a cloud platform to synchronize files on multiple devices.

  Y at - there someone here who want a Photoshop Touch Universal App for Windows 10 just like me?

  Well, I'd like to get a Surface Pro 4, then I could use Photoshop CC with it.

  Photoshop Touch itself was abandoned, but there are already some applications that allow to fill some of the gaps he left behind (like Photoshop Fix and Photoshop Mix). The problem here, is that they are Android and iOS only for now. (I think not that patch has been released for Android yet.)