Pavilion 15 laptop: Start button / stop does not turn off

Similar Questions

• Venue Pro 8 - button / stop does not turn off the screen

  I just got a coming 8 Pro (32g).  The user manual says that I should be able to press the power button and turn off the screen.  However, when I press the power button, nothing happens.  I can for 4 seconds and the PC will ask to stop, but pressing on this button does not put the tablet in standby or turn off the screen at all.  I have to go to settings-> Power-> sleep just to turn off the screen.

  Yes, I checked the setting of the button / stop under control panel, and it is set to "Sleep" for all cases, battery and plugged in.

  Is there another setting somewhere to turn on the power button to turn off the screen?

  (Oops, deduplication)

• Start button / stop does not work

  Here's the thing:

  I bought the OfficeJet pro 8600 last year.

  Everything was ok until this month one (September 2014) after 13 months of use.

  All of a sudden the power button no longer works, I mean, I can no longer turn the printer unless I unplug him the decision-making.

  I followed all the instructions on this thread (http://h30434.www3.hp.com/t5/Printer-All-in-One-Install-Setup/officejet-pro-8600-plus-won-t-shut-off... and have my unresolved problem.)

  Its firmware version is CKP1CN1435AR. The latest version on the HP site is CLP1CN1322CR. I downloaded it but I could not install because it presented the status does not apply.

  I would like a concrete solution from HP support. If it is a firmware issue, please tell me where I can download a functional.

  If it's a hardware problem, please tell me we can I acquire spare parts, after the warranty period has expired, can I fix it myself (I'm an electronic engineer). If you know that it's a hardware problem, you must know which component is defective and will save a lot of my work if you tell me where can I buy a new one, instead of telling me to take my printer to an HP support.

  Thank you in advance,
  Stanley

  To the right.

  Finally, I managed to find the cause of a malfunction of the power button on the printer.

  It is not necessary to connect the printer directly to the output. It is not necessary to reset. It is not necessary to update its firmware.

  When you use the printer, I noticed that when I raise the front panel by pressing the button located to the right and pulling the Panel upwards, the light on the power button is off.

  When lowered the Panel, the light on again.

  So obviously, I concluded that the operation of the power button was based on mechanical moving parts work perfectly.

  I pressed the power button and the printer still does not close. So, I pressed the front against the printer and to the left. I heard a sound like a click.

  I pressed the power button and the printer turns off again.

  I repeated the process several times with the same result.

  Then I realized that simply lower the Panel was not enough for the power button work.

  After having lowered the Panel, press it against the printer and a little to the left until it almost imperceptible click.

  In doing so, the power button works perfectly.

  I hope this can help owners of this printer, once HP has not helped.

• START BUTTON / STOP DOES NOT ILLUMINATE

  I have a hpe-500y that a few weeks and the power button which is normally blue when on or yellow in sleep mode does not work, is there a way to reset this or is it a warranty issue? computer turns on normally and works very well just know light.

  Hello

  It's almost certainly a hardware failure of the LED charge to illuminate the power button.  I highly recommend that you have this repaired under warranty - depending on the time you got the PC, you may still be able to get the retailer to replace so it may be interesting to contact them about this.

  If you need to contact HP for repair under warranty, you can do here.

  Kind regards

  DP - K

• Start button / stop does not call stop after the upgrade of loll

  My motorcycle g has not put an end to calls after the upgrade of the KitKat Soother. Either I allows calls from the end of the setting.

  Help, please.

  using a magnetic flipcover?

• Mute button external does not turn off

  Pavilion dv4 - 1120us - not her although all retired as correct and functional - but mute button external stays on

  Hello

  OK, let's try another driver and a slightly different method.  Download the following Installer and save it on your desktop.

  IDT Audio Installer

  Once download completed, right click on the installer and select "Run as Administrator" to launch the installation - ignore any warnings that you have already installed a driver later, just continue to install it.  When finished, restart the computer and check the status of the IDT audio device in Device Manager and let me know.

  Kind regards

  DP - K

• Start button / stop flashing light turns off

  Original title: Power up

  When I turn on my Dell Demension E510, the power button flashes amber in color. I can't turn on my desk until there is a clicking sound or reset and the flashing light goes off.

  Hi HOWARD R Ruscin,.

  This seems to be a hardware related issue. Your best bet of contact would be the manufacturer to resolve the problem.

  Visit the following link to contact:

  http://en.community.Dell.com/

• T400: Start button / stop does nothing in Vista

  Hello, I start button / stop set to "turn off computer" in the Power Manager settings, but when I press the Vista power button nothing happens. I use Vista 32 bit SP2. The power button turns the computer very well and of course now that it performs a closed hard but he executes any action when you press right on it.

  Holding for 1.5 seconds will shut down normally (assuming that you have defined at the stop) and now it for about 5 seconds or more will make a stop 'hard' who just turns off everything without a load.

• printer do not wake off mode 'sleep' and does not turn off when the Start button / stop pressed or pushed.

  HP printer all-in-one B210a win 7 64 bit.

  no error message just don't wake up from power saving mode and does not turn off when the power button is pressed. must be disconnected and then turned back on. works fine until the power saving mode he did go to sleep then not answer the test print command or Toolbox controls.  power saving mode is turned off, but still goes to sleep.

  First, you will need to make sure that the printer is under warranty.  You can do it here.  So, if you are in warranty, you must contact HP at 1-800-474-6836 and the United States in computer science, international users click here.

• HP Pavilion 15 p150nh: laptop does not turn off completely

  Hello!

  I have a laptop HP Pavilion p150nh 15. It does not turn off. If I want to close it will turn off completely. I have black screen but the vens are still on and the buttons start led is also single beds. I've tried everything. Updates, hard reset I was looking for BIOS but nothing.
  Help me please!

  Hello

  On some machines, the pilot for 11 series IMEI has been known to cause that kind of question of the judgment, so it may be worth trying an earlier version.

  You can use the following method to install an earlier version of the driver IMEI.

  Download driver IMEI on the link below and save it in your downloads folder.

  http://ftp.HP.com/pub/SoftPaq/sp66001-66500/sp66228.exe

  Disable your wireless card (should be f12 ).

  Open your download folder and run the installer - it warns you that it is an earlier version, but simply continue.

  When finished, restart the laptop.

  If the computer shuts down correctly, turn on your wireless adapter and use the utility on the following link to prevent Windows 10 to update automatically the driver IMEI again.

  https://support.Microsoft.com/en-GB/KB/3073930

  Kind regards

  DP - K

• Hi all, I bought apple phone I 5s recently is the power button / stop does not. Bought in the United States, but I was shifted to the India, the works of will to guarantee in India please help

  Hi all, I bought apple phone I 5s recently is the power button / stop does not. Bought in the United States, but I was shifted to the India, the works of will to guarantee in India please help

  Ask an authorized service provider regarding iPhones, a guarantee of a country may or may not be honored in another function where you take the device.

  (143868)

• WiFi HP Pavilion g6 2304TX button does not turn off (WINDOWS 8.1)

  after update to 8.1 windows WiFi button does not turn off even if the plane and pilot mode works well becomes but led still shines in white if it is off or on (WINDOWS 8.1)

  Uninstall the bluetooth driver. The problem is due to the old version of the bluetooth driver.
  If you use the Ralink Bluetooth driver. then download the latest driver from

  http://download-software-notebook.blogspot.in/2013/10/RALink-IVT-Bluetooth-stack-drivers.html

  Hope the problem is solved

• Pavilion 15-e020tx: does not turn off pc portable hp pavilion 15-e020tx

  Hello.
  I have a pc hp laptop pavilion 15-e020tx. It does not turn off and does not wake up mode 'sleep'...

  I tried to restore my laptop to factory setting, updated everything I can, but it still does not work
  Could someone help me please

  Update the BIOS to the current version. A F.24. The direct link to the download is below.

  http://ftp.HP.com/pub/SoftPaq/sp69501-70000/sp69897.exe

• My Apple Watch does not turn off.  When I go to turn off the slider isn't in the article to stop, I can restart but the cursor still does not appear

  My Apple Watch does not turn off.  When I go to turn off the slider isn't in the article to stop, I can restart but the cursor still does not appear

  Hello

  It is not possible to disable Apple Watch when its on the charger and connected to the power supply - this is normal.

• Satellite PRO U300 does not turn off

  Hello

  I am facing a problem for the last few days on my Satellite PRO U - 300 (31st PSU)...

  The machine does not turn off and the power light stays on (blue LED) even after you have disabled. In fact, happened 3 - 4 times when I start the computer normally by pressing the power button / stop, it does not start and I noticed that the indicator was not extinguished even after + shut down +. Like any it is blocked! I have to finally, remove and reinsert the battery to start the laptop.

  Some details of my pc are as under:

  Version of the OS Microsoft® Windows Vista Business 6.0.6001 Service Pack 1
  BIOS Version V2.00
  Processor Intel (r) Core (TM) 2 Duo CPU T7100 @ 1.80 GHz

  Can someone help me solve this problem. Is it possible that during the uninstallation of programs, any perticular driver file is also deleted?
  Thank you

  JITENDRA

  Hello

  I don't know that you understand the indicator of power, but to me it sounds like AC Power LED and this LED is always on when the laptop is connected to the power supply.

  Power on / off LED is probably what you mean (the other starting on the left).
  Anyway, you turn off your laptop using a standard on the Start button?
  Are you sure you want to use the Hibernate mode.

  Believe me, the entire description here is pretty confusing to me. It may be that the laptop is turned OFF but power light is still on.

  Have you installed something 4 days ago? Or deleted some important application?
  Sorry, but it is not easy to say with certainty what the problem is here.