Printer hp photosmart does not turn!

Similar Questions

• HP 4585 Wireless does not turn off

  I have a HP Photosmart C4585 all - in - one printer and it does not turn off using the power button.

  I have already disconnected the cable, waited more than an hour and it has not solved the problem.

  I also completely uninstalled and reinstalled without success.

  Maybe it isn't a huge problem, because it does not work, I don't think it's good to keep it on all the time and wasting energy.

  Please let me know.

  Wing

  Thank you very much, printer is fixed, I can turn on and off, and even the wireless signal is back.

  Everything that fact

• printer does not turn on

  My Deskjet 6980 printer has stopped working.  It has worked very well so far. Flashing lights said he needs ink. I put in the new ink. Now, it won't turn. The power supply is turned on, the works of output (without surge protector), but the printer does not turn on. In all he has no light on the printer, except light power cord in the back. I tried everything I could find online, but nothing works. My computer was still recording the printer, but since it will not power, says that it is in offline mode. Any suggestions would be helpful.

  The unit may have developed a power failure, but may be also simply in a State of error because of the fresh cartridges.  There are a few steps, I'll try in this case of troubleshooting.

  * If possible, try to remove the cartridges that you recently installed before performing a hard reset of the printer.

  * Hard reset of the printer by unplugging the device, disconnect the other end of the power cord from the wall outlet, separates the power cord of the power supply, wait 30 seconds and plug it back up.

  See also the steps described in the document, found here, to solve a lack of power.  I hope this helps.

• Photosmart Premium Fax c309 Series all in one printer Wireless Radio does not work

  Some time before, the radio on my Photosmart Premium Fax c309 series wireless all in one printer stops working.

  With a wireless network test:

  Wireless is on (but light indication only is not lit)

  wireless network card has failed

  "The wireless radio does not work.  Contact Hp support.

  Any help would be greatly appreciated!

  Thank you

  Smithb2

  Hi smithb2, welcome to the forums there.

  I saw your post on the wireless radio does not not on your model Photosmart C309.

  I did some research and came across this post in the community that seemed to have worked for others with the same problem.

  Re: Without the printer wireless radio does not

  I hope that helps!

  If troubleshooting doesn't help not solve your problem, then I would say call the HP Technical Support to see all the other possibilities for you. If you call in North America, the number is 1-800-474-6836 and for all other regions: click here.

  Have a great Thursday

• My photosmart A710 series does not turn on.

  any ideas of rml

  Your power cord or printer turns off if the printer does not turn on.  Parts for your printer are not made or sold more, so the only option would be to replace the printer.  I'm sorry.

• printer do not wake off mode 'sleep' and does not turn off when the Start button / stop pressed or pushed.

  HP printer all-in-one B210a win 7 64 bit.

  no error message just don't wake up from power saving mode and does not turn off when the power button is pressed. must be disconnected and then turned back on. works fine until the power saving mode he did go to sleep then not answer the test print command or Toolbox controls.  power saving mode is turned off, but still goes to sleep.

  First, you will need to make sure that the printer is under warranty.  You can do it here.  So, if you are in warranty, you must contact HP at 1-800-474-6836 and the United States in computer science, international users click here.

• on a printer shared and I get printer spooler properties does not

  When I try to print from my other pc it say memory and Printer Spooler context does not and when I go to control panal printer and try to right click on anything it says the spooler does not and not connected

  You can print from the computer to which the printer is physically connected (assuming that the printer is physically connected to one of your computers)?

  What version of Windows, including the service pack is on the computer to which the printer is physically connected? (Right click on desktop and select Properties, if you do not know).

  What version of Windows, including the service pack is on the computer that is giving you problems?

  How did the computer which gives you problems connected to your local network?

  Can you access any file on the right computer of the bad computer?

  What is the brand and model of the printer?

  The following applies to the computer that is giving you problems:

  Often, but not always, the symptoms you describe are caused by a corrupt print job stuck in the queue or a damaged printer driver.  However before you clean things up, on general principles, that you can download, install, update and run full scans with each of these two free programs:

  AntiMailware MalwareBytes
  SUPERAntiSpyware

  Do not operate the two scans simultaneously.  Each will take a long time, so start it and then go do something else for a while.

  IMPORTANT: If either of the analysis above turns up malicious software (other than tracking cookies), both from the scans will work on all the other computers connected to your local network.

  Cleaning of printers

  NOTE: If after completing step has the print spooler is not always running after you launched the command "net start spooler", you will not be able to follow all the steps in "First Article".  Instead, go to the other link and download and get and use the utility 'cleanspl' such as described here.

  A. Clean on print jobs pending

  • Open a command prompt window (start > run > cmd > OK)
  • Type the following in the black command prompt window, and then press ENTER after each line

  net stop spooler
  del/q '% windir%\system32\spool\PRINTERS\*.* '.
  net start spooler
  output

  B. clean the old printer drivers and install the latest drivers by using the directions in One Article.  If you have (or had) a Lexmark printer, follow the instructions on the following site before installing the new drivers, as explained in its first Article: http://members.shaw.ca/bsanders/CleanPrinterDrivers.htm

• 2335dn does not turn on and make clicking noise

  I have a 2335dn printer that does not turn on and makes a clicking noise up through the document feeder.  FYI, the scanner lock is not locked either.  The display does not illuminate, nor the printer begins to warm.  It is simply a constant clicking noise.  I don't know if there is an internal power supply or if she has been shot.  Y at - it may be a loose connection where the cable connects the document feeder at the bottom?  Appreciate any comment.

  Thank you

  Chris

  OK, so I opened up the printer and found a bad capacitor on the power supply.  After replacing the capacitor all starts perfectly.

• When I turn my iphone sideway, the video does not turn sideway

  When I watch the video on my iphone, I usually turn my iphone sideway, the video would turn sideways to get the most out of the video. But now it does not turn sideways.  Try to find the adjustment to set the option or the recent updated version this video sideway option removed.

  Swipe up from the bottom of the screen to get to the control center. Press on the icon of a padlock on the right side until it becomes black. If the icon is white, the screen rotation is locked.

• Toshiba Camileo P10 does not turn

  I have a toshiba camileo p10. The problem is that the camera does not turn. I tried to recharge the battery, but the red light blinks for hours.

  I tried without the battery and the charger plugged but nothing happened. I cleaned the contacts.
  All solutions?

  Have you removed the battery AND the AC adapter?
  Try this. The two parties should be removed/disconnected.
  Leave the camcorder for some time (a few hours). Press and hold button power 30 sec long. After this plug in the battery and charger.
  Wait until the battery has been charged and then try to turn on the cam by pressing the power button.

  Good luck buddy.

• Toshiba 46HL900A does not turn on

  My TV turns completely. The Red led will turn from red to green, but the TV does not turn on? Someone knows why? Thank you

  Hardware problem might be serious... to be honest, that you have some many options troubleshooting...
  If its material of serious malfunctions, only an authorized technician would be able to help you.

• Equium M40X: Cannot print - not done. Print Spooler service does not

  My notebook Equium M40X has suddenly decided to stop from allowing me to print, gives me the message "operation was not completed. "print spooler service does not. I get this message even when you try to install the original installed printer drivers.

  To resolve this problem, I went to the services.msc to attempt to start the print spooler, but the command is not here present and seems to be missing. I also tried to launch it by clicking Start and then run and typing "net start spooler", but even once, it does not. Can anyone help with this?

  My laptop is an Equium M40X and the operating system is Windows XP Service Pack 2.

  Hello

  This error occurs because the spooler service has not been started or has stopped working.
  It seems that this error is known to Microsoft and they decided to public an article in the knowledge base that could help solve this problem.

  http://support.Microsoft.com/kb/314876

  As you say that the spooler service must be restarted.
  To start the spooler service, follow these steps:
  1. click on start and then click Control Panel.
  2. double-click Administrative Tools and then click Services.
  3. double-click on the Printer Spooler service and then change the startup type to automatic. This option sets the spooler service starts automatically when you restart the computer.
  4. If you want to start the spooler service immediately, click the Start button under the Service status field

  If you will not be able to restart the spooler service, you can try to restore the Windows operating system to the point initially by using the Windows System Restore tool.

• camera does not turn on

  I tried to load camera after death, it does not at all, but the orange light is on when it is plugged, let it charge all night and still it won't turn. I videos I would like back, please help.

  The charge indicator lights orange when the charging starts. It seems that the battery is charged. Try to turn on the camera while loading and check if it is turn on.

  Note: The charging light turns off, charging is completed.

  If the camera does not turn ON even when the load is in progress, the service is required.

  You can initiate the service from the link below:

  https://eService.Sony.com/

  You can also contact our telephone support or Chat to try additional troubleshooting procedures.

  http://eSupport.Sony.com/us/p/select-System.pl?Director=contact

  Please provide model # exact camera while contacting support, so that they provide accurate information. You can locate model # on the back panel and it will start with the letters MHS.

  If my post answered your question, please mark it as "acceptable Solution".

• Satellite PRO U300 does not turn off

  Hello

  I am facing a problem for the last few days on my Satellite PRO U - 300 (31st PSU)...

  The machine does not turn off and the power light stays on (blue LED) even after you have disabled. In fact, happened 3 - 4 times when I start the computer normally by pressing the power button / stop, it does not start and I noticed that the indicator was not extinguished even after + shut down +. Like any it is blocked! I have to finally, remove and reinsert the battery to start the laptop.

  Some details of my pc are as under:

  Version of the OS Microsoft® Windows Vista Business 6.0.6001 Service Pack 1
  BIOS Version V2.00
  Processor Intel (r) Core (TM) 2 Duo CPU T7100 @ 1.80 GHz

  Can someone help me solve this problem. Is it possible that during the uninstallation of programs, any perticular driver file is also deleted?
  Thank you

  JITENDRA

  Hello

  I don't know that you understand the indicator of power, but to me it sounds like AC Power LED and this LED is always on when the laptop is connected to the power supply.

  Power on / off LED is probably what you mean (the other starting on the left).
  Anyway, you turn off your laptop using a standard on the Start button?
  Are you sure you want to use the Hibernate mode.

  Believe me, the entire description here is pretty confusing to me. It may be that the laptop is turned OFF but power light is still on.

  Have you installed something 4 days ago? Or deleted some important application?
  Sorry, but it is not easy to say with certainty what the problem is here.

• Pavilion 15-e020tx: does not turn off pc portable hp pavilion 15-e020tx

  Hello.
  I have a pc hp laptop pavilion 15-e020tx. It does not turn off and does not wake up mode 'sleep'...

  I tried to restore my laptop to factory setting, updated everything I can, but it still does not work
  Could someone help me please

  Update the BIOS to the current version. A F.24. The direct link to the download is below.

  http://ftp.HP.com/pub/SoftPaq/sp69501-70000/sp69897.exe