problems with VOIP on WRP400

Similar Questions

• Firmware update recent Airport 7.6.7 causing problems with VoIP

  Hi all

  Firmware update of recent Airport 7.6.7 causing problems with VoIP.

  Unable to connect voip since update...

  Any help appreciated.

  Thank you

  It might be useful to know what VoIP that you use and what type of problem the update affects your VoIP.

  My MagicJack & NetTalk lines properly.

  Jim

• NEW PAP2T-NA: having problems with call with a VOIP provider, but not another

  What I discovered, that's the problem, if the incoming call is answered, then after the end of the call, she can immediately accept a new call; Otherwise, if the incoming call is not answered, and then after the caller hangs up, the ring on the phone to the ATA will continue for a few seconds, and even after the stop of the ring, dial the number will get a busy signal. This State (gettting busy tone) will last more than a few minutes, before it can accept another call again.

  I tested the same line with another VOIP provider and no problem with this provider.

  Is that mean that the problem is with the first VOIP provider? What could be the cause?

  Thanks in advance.

  Finally confirmed that there is a problem with the VOIP provider. The problem has been solved now. This solution requires some setting side PennyTel (VOIP provider).

• Satellite L500 and problems with the Wi - Fi

  Hello people

  I'll just throw my problem there.
  First of all my details and information that can help me to help you!

  Satellite L500 running windows 7 (note: same problems when installing Vista)
  Latest drivers wireless as well as the latest drivers for everything.
  My wireless router is 1 billion active voip 7000 series sound quite good for when I got it about 2 years ago and works well.

  Basically, the problem is that the wireless on my Satellite L500 keeps dropping out. I m not more than 20 meters at most, right now I m 10 m with 1 wall in the way. I tried to make a website, and he says has fallen to either unable to find host connection.

  However other computers laptops in the same room, same place at the same time has no problem at all. Has ever.
  As soon as I'm in the same room as my router, it works again. Sometimes works if I stand right on the opposite wall.

  So basically I m thinking my card wireless in my laptop is defective or simply not good?
  Can u replace the card with another wireless? Maybe the Toshiba ones are just no good? I read so many problems with these cards Toshibas wireless...

  Anyone have any ideas? I ran out of the info you need? I repost he's again in a day or two with the types of wireless devices in every laptop.

  Hello

  For the moment, I doubt that your wireless network card is broken. Before Exchange you it you must also update your BIOS and not only the WLAN card driver. Two updates you need to download it from the Toshiba site:
  http://EU.computers.Toshiba-Europe.com > support & downloads > download drivers

  I had a similar problem with my Toshiba laptop and WIFI connection. The problem was in the WLAN energy saving mode Windows power management. Here, you can also choose a mode for energy saving wireless network card. Turn it off, and then choose a maximum Performance.

• Problem with router SPA2102 Battlefield 2?

  I have problems with my Battlefield 2 (all versions). I have the SPA2102.

  EDIT: The game freezes when I click to join a server, nothing happens.

  I can play other games online.

  When I try the demo version which im using this router, it does not work.

  But when I try with the same laptop in other places it works completely fine.

  I set up a static IP address and forwarded my ports to help

  http://www.PortForward.com/English/routers/port_forwarding/Linksys/Spa-2102/Battlefield_2.htm

  What else can I do to make it work?

  I am running Vista 32 bit.

  Thank you in advance!

  Basically the SPA2102 is not design to handle the heavy traffic. This unit is designed to route traffic for VOIP devices and not for game features.

• problems with, phone, 6, Bluetooth kit, Nissan, after update, for, Rios, 1.0.2

  After the update to ios 10.0.2 - trying to use bluetooth to call my vehicle, it says: "this article is not in your phone book." How can I solve this problem?

  Greetings, joybelino1!

  Thank you for joining the communities Support from Apple! I can't wait to see that you are having problems with your Bluetooth in your car! The good news is that Apple has a great article that will help you with measures to try to resolve the problem. Read this article to gethelp to connect your iPhone, iPad, or iPod touch with your car radio. Even though he talks about problems with the connection, it also has the steps for other questions you may have once connected.
  
  

  If you use Bluetooth

  1. Consult the user manual of your car stereo to get the procedure to a Bluetooth device.
  2. On your iOS device, drag up to open Control Center, then press ontwice to turn on Bluetooth and turn it back on.
  3. Restart your iOS device.
  4. On your iOS device, Cancel the twinning of your car radio. On the screen of your car désapparier your iOS device and any other device. Restart your car and your iOS device, then pair and connect again.
  5. Update your iOS device.
  6. Install the updates to the firmware of your car radio.
  7. If you still not connect, contact Apple technical support.

  Have a great day!

• Anyone having problems with WiFi connectivity after upgrade to Sierra?

  I was wondering if anyone else knows issues with WiFi connectivity since the upgrade to Sierra 10.12? I have not had any problems with connectivity WiFi previously on El Capitan. Now I have regular randomly loose connectivity. My internet is cable and when it is connected I have a 100% connection. My details of iMac and I have used only 10% of my storage.

  

  No problem with my iphone 6.

  Hello AspDesigns,

  I understand that, since the upgrade to Mac OS Sierra, your Mac seems to have trouble staying connected to Wi - Fi. Fortunately the diagnosis built-in wireless can help identify the source of so much trouble.

  Search for Wi - Fi using your Mac problems

  See you soon!

• Problems with mail after switching to macOS Sierra

  Hey all

  After having recently upgraded to macOS Sierra, I am unable to read my mail.

  I get the following error every time I check on "Get Mail".

  There may be a problem with the mail server or the network. Check the account settings "*" or try again.

  The server returned the error: Mail could not connect to the server 'pop1.tribcsp.com' using SSL on the default ports. Verify that this server supports SSL and that your account settings are correct.

  What does this error message mean and how can I solve this problem.

  Thank you

  Hi Michael,

  I see your message that you get an error in the mail indicating that there is a problem with the mail server or the network.  To help get this problem resolved, I suggest that you follow the steps below:
  

  If mail refers to a problem with the mail server, or the network

  Mail will say that it is impossible to connect due to a problem with the mail server or the network. For example, the message may refer to a connection that has expired, or too many simultaneous connections:

  

  If you are connected to the Internet, but the connection has expired, your email provider might be affected by a discontinuance of service. Contact them or see their status Web page to ensure that their e-mail service is online. Examples of status pages:

  • iCloud mail status
  • Gmail status
  • Status of Yahoo mail
  • Status of the AOL mail
  • Status of Outlook e-mail

  If the message indicates the number of simultaneous connections, too many of your devices is check your e-mail account at the same time. Quit Mail on one or more of your other devices.

  If you are still unable to send or receive e-mails

  1. Make sure that you have installed latest version of the Mac software updates, especially if the problem occurred immediately after the installation of a previous update.
  2. In OS X El Capitan or later version, you can see a status icon and the short error message in the upper right of the Mail window, under the search box. The message may indicate 'Network offline' or 'Connection failed', for example. Click the message to see more details on the issue.
     
  3. Check your connection to the Mail connection doctor. It might be able to say more on the issue.

  If you cannot send or receive e-mail on your Mac.

  Take care.

• iMac 27 "mid-2011 - Intermittent problem with CPU fan running at full speed and sleep mode.

  Hello!

  My iMac 27 "has an intermittent problem with the CPU fan runs at full speed. Sometimes it happens at the time when I start it, sometimes only in my session, and sometimes only after a certain time. So does seem to be a problem of "heating".

  Second issue is with the mode 'sleep'. It may occur also at any time, at the start of the iMac, session, or after a certain time. But once he starts to go in mode 'sleep', when I wake up, it goes right back in mode after a few seconds and that it will continue indefinitely until I restart the computer.

  What could be?

  Please help me!

  4ntoine

  Here is my model of iMac:

  iMac 27 "mid-2011 model 12.2

  Intel Core i7 3.4 GHz

  AMD Radeon HD 6970M 1024 MB

  OS X El Capitan 10.11.6
  SMC 1.72f2

  Boot ROM IM121.0047.B23

  reset the SMC

  Reset the management system (SCM) controller on your Mac - Apple Support

• problem with playing the clash of clans

  I'm having some problems while playing the clash of clans on my 2 mini ipad screen does not seem to meet sometimes as if it was some sort of delay so I have to tap several times in order to use a filter or throw the troops on the battlefield.

  Hi Trinitygr,

  Thanks for posting in the Community Support from Apple! I understand that you are having problems with your iPad screen while playing a game. I like to play games on my iPad and I don't see how this could be a nuisance. I'm happy to offer assistance.

  Are you only had this problem when using the app clash of Clans, or does it happen in all applications? I recommend to start by following the steps described in this article:
  If an application you have installed unexpectedly closes, unresponsive, or does not open

  Take care!

• I'm having problems with an outdated Apple ID

  I have problems with updating Apps etc in my Apple account because he always asked an obsolete in sign.  How can I change this?

  Hello

  Go down to itunes apple ID Delete page homepage all ID and then add it back back.

  See you soon

  Brian

• Anyone having problems with the new iPhone LTE connection 7 on Verizon?

  I am now on my iPhone second 7 with Verizon. I had four phones for me and my family. I have now had issues where I have no signal in the same areas where my signal allows to be strong. I can't solve the problem with the activation/deactivation of the airplane and then mode again in normal mode. My phone will rest with no signal for 5 minutes, then going to LTE with three bars. I also had the problem where I had only 1 x signal, while my son standing right next to me has LTE. And he had the same questions, where I'm on LTE and it gets no signal. I use to have LTE where I live and work all the time, now it's spotty at best. Apple has replaced me and my sons iPhones but not luck. Still do. Any ideas or an any other suffering?

  (1) go to settings/cell phone/cellular data Options/enable LTE and select ONLY the DATA. This seems to solve the problem (as a temporary solution) for most of the people affected by this problem. The bad part is your request might not be as clear (since they cannot use the highest LTE signals) and you can make calls and data at the same time. But it does not solve the issue.

  (2) there are rumors (but you didn't hear that from me that we only are not supposed to discuss beta software program Apple in this forum) that the new version of Apple Beta for iOS (which also includes an update of the software carrier Verizon to 26.0) seems to solve this problem. So, there's a light at the end of the tunnel.

• Problem with some fonts of symbols after the installation of the Sierra

  Hello

  I have recently upgraded the OS on my iMac late 2012 for Sierra, since doing so, I noticed a problem with several fonts.

  All symbolic symbols Apple to Wingdings fonts not correctly displayed in the font book. Apple symbols looks like a standard wheelbase of san, and other symbolic fonts just show as question marks '?' where the images should be.

  In text editing, that I can't even see the symbolic fonts like Zapf Dingbats and Wingdings in the selector. However, they all work well in Adobe Illustrator (CS5) and Microsoft Word 2011. Apple symbols still looks like a standard font.

  I already tried the following:

  1. check the fonts in font book

  2 fix the duplicates in the font book

  3. using the "Restore Standard fonts" option in the font book

  4 deleting a file in the folder Preferences plist Fonts

  5 deleted the cache of police and the database

  I'm out of ideas. Has anyone else had the same problem found a fix?

  Kind regards

  Greville

  I'm just to add that I used the recovery partition to do a clean install of Sierra on a hard drive external and then booted into it to see if it had the same problem.

  And he does. Wingdings and other photo fonts appear as '?' in boxes where the letters must be in the font book.

  So this seems like a problem with the way Sierra displays these fonts, not with the font files themselves.

• ios10 problem with non-users of iphone messaging

  After upgrading my iPhone 6 ios10, I had intermittent problems with the messaging of Android users (basically, the conversations no iMessage). In about 60% of the time it is not just to deliver the message no matter what I do (pressing the 'Try Again' don't work do not). He has no problem with the reception of the texts, but I can't answer to Android users (Interestingly, I can message users of Android if they are in a group with iPhone users text). I tried everything was updated to the last verision until reset of ios everything.

  I can't find anything online about this. I'm the only one who what?

  Group Messaging uses the MMS. Normal text messages using SMS. SMS uses the voice channel to transfer messages and is strictly a basic function. If you are experiencing problems sending SMS, contact your carrier.

• I have problems with ios 9.3.5

  my ipod says it's still Friday, September 23 when it is Monday 26 and is stuck in the 04:00 time when I change the time, the screen turns off a color at random, then restarts then both will and I have to change but rest later if it changes at all used to date will not change anything and it runs still works when it wants to and it doesn't stay connected to WiFi , I have the ipod 5th generation and am not elligible for ios 10 Please if you can solve this problem with ios 9.3.5 I would be very grateful as I use my ipod for almost everything. Thanks - René

  It is a community based on the user. You do not speak to Apple directly. You can contact the Apple Support here: http://www.apple.com/ca/contact/