Satelite L775 used high power - orange light blinks 5 times

Similar Questions

• Portege Z930 - 14L - DC orange led blinks 8 times and green ECO light led

  Portege Z930 - 14L. I can't boot from the last power since.
  The domain controller in the orange Led blinks 8 times and eco green light led is lit.

  DC IN flashing ornage indicator indicates a problem with the power supply. Initially, you should try plug the adapter HAVE an another power outlet. If she does still not work, you should contact Toshiba ASP (authorized service provider)

  Electronic supply on the motherboard is probably the problem.

• P1102w: P1102w - orange light blinking - won't initialize

  My printer won't boot and the orange light blinks. I tried to uninstall and reinstall the printer driver and firmware.  It also shows 'it can run out of toner' when I know that it is not. Cannot print page of test or anything else that he does not communicate with the computer. Help!

  Hey @cbloom57,

  Welcome to the Forums of HP Support!

  I understand that you have an orange light flashing on your Laserjet P1102w printer range. I can help you with that.

  To start, make sure that the printer is plugged directly into a wall outlet, not a surge protector. Once it is, while the printer is on, remove the power cable at the back of the printer for one minute. If you still see a flashing light orange, then the printer is more likely to have a recoverable hardware problem. This document explains How to resolve error lights on the printer.

  Please let me know the results after following the above. If you are able to clear the blinking light, click on accept solution. If you appreciate my help, please click on the thumbs up icon. The two icons are below this post.

• Aspire V5 on used to be able to. Power light blinks 5 times.

  Daughter finally used the laptop on battery and ran down id by pulling it completely until the computer turns off. She plugged the power cord and it would not come when you press the power button.  Laptop has been plugged in overnight and this morning same problem - just power light flashes five times when you press the power button. This is the same behavior so plugged in to the power supply or not. I tried holding down the power button. Tried with battery removed and a/c power, but then no light at all.  I tried removing the battery and the power of the a/c, press and hold the power button for 30 seconds, then install the battery and plug in power a/c, but no difference.  I tried another a/c adapter and no difference. Any ideas?

  I had an object hold down the power button on all day.  Now I plugged in the power of a/c, and it began immediately.  Problem solved.

• My KDSR70XBR2 turned off and now only red light blinks six times then pause of 2 seconds followed

  TV off last night and gave a warning of the temperature.  I turn it off, put a fan behind it, but it still blinks six times then 2 second pause followed by six flashes and pause.  I did that for about 18 hours now.

  Help, please.

  The x 6 times standby light flashing indicates that the device has a power problem and may require services. To find an authorized service of Sony to your TV in your area go to:

  https://eService.Sony.com/webrma/Web/index.do

  Nathan_SD

• Trinitron TV turns off. The red light blinks 7 times

  I have A FD Trinitron WEGA. It works perfectly for the past year 8 and a half. Recently, he died while we watch. The red on the front of the TV blinks 7 times. I wonder if a repair is required, and how much it will cost, thank you for your help.

  Hi joehui,

  Check whether in the TV, clock/Timer is set. If so, disable the timed operation parameters.

  If the TV is connected to a power strip or surge protector, remove the power strip or surge protector and plug it directly into the wall outlet. If the problem is resolved, the problem is with the power strip or surge protector and not the TV.

  Follow the steps below to perform a power reset:

  • Turn off the TV.
  • Unplug the power cord of the TV from the power outlet.
  • Let the TV remain without power for 60 seconds.
  • Plug the power cord into the power outlet.
  • Turn on the TV.

  If the problem is still not resolved after following all the steps of troubleshooting, service may be required. Locate the centers of the closest authorized repair the link below.

  https://eService.Sony.com

  The exact cost of the repair can be determined only after a physical examination of the TV. You can contact the service centers to know exactly the cost of repair.

  If my post answered your question, please mark it as an "accepted Solution".

• Ex720 turns on and off the red light blinks 8 times continuously

  LED blinks 8 times continuously and turns on or off tv

  Follow the steps below to troubleshoot the TV.

• Tecra M9 - no power orange light error code sequence

  Hello

  I have a Tecra m9 laptop and when I try to turn it on, it blinks with a light orange in this sequence:

  6 short flashes, short 1 long blink, 1 blink, a ditch, and then it repeats.

  Does anyone know what is the problem?
  Any advice would be greatly appreciated.

  See you soon.

  What you see flashes code. The flashing provides an error code. Short means 0 and 1 long.

  The hexadecimal code can be read by the service partner. The blink code will be sent when the microcontroller detects a problem with the power supply. Unfortunately you can not do anything alone. Contact the closest partner in your country and ask for help.

  All you can try right now is to disconnect battery and start the laptop with AC power only.

• Sat Pro 6100: The orange light blinks

  GDay guys,.

  Thursday, it was the last day of school.
  In the last lesson of the day, I used the laptop to play games (Toshiba Satellite Pro 6100, 1, 6 GHz) when the Bell went. I tried to stop in time, however running in battery mode, she went up to 1 ghz and has been quite slow, closing the game so I immediately turned it off by holding the button for a few seconds.

  I put it in my new computer case belkin which offers a thick foam padding and went home by bus. When I finally got it, I plugged the laptop and tried to boot the system. The screen didn't work for some reason, so I tried the key light several times without success. Reset the computer several times, still nothing. I was wondering if it was the hard drive of the stopping is not correctly earlier this day here but I could always blindly log windows. It me intrigued as to why the screen wasn't on. I presume that a cable was loose so I removed the keyboard and checked the cables on the graphics card. They were fine. Put the keyboard back on and tried to start the laptop.

  The flashing yellow light has shone in its ugly glory. Something was wrong. I left the cell only and got the father, who is an electrical engineer to check on the laptop for all things obvious which could cause this problem. Dad couldn't see anything.

  Before, I read a post on the resettlement of the graphics card can work so I reinstalled the graphics card and tried to boot the system. Still nothing!

  What the hell is happening?

  I read these support forums and find a post on how you can charge the battery, start etc and try it and watnot, but it still fails. When I remove the battery and exit onto the adapter and replace the AC adapter in, a green light that shines above its power light shines. When I put the battery in again, a yellow light shines above the stack, however as soon as I press the power button, everything shuts off and the yellow led shines above the logo of ac power...

  Any ideas as to what may cause this problem and how can I solve this problem?

  -Well done guys!

  Hello

  Littco is right. You must contact the partner in your country. On this way is really not easy to say what can be the problem, but I guess Hat there is a problem with the electronic control gear and you will not be able to repair only. Check it please this page

  http://www.CSD.Toshiba.com/cgi-bin/TAIS/Su/su_gaspLocator.jsp?PF=true

  and there you can find a list of aspic in your country.

  Good bye

• Toshiba Satellite CDT4070 power on problem - orange led blinks 8 times...

  I have a problem with my laptop, it's a Toshiba Satellite CDT4070. When I press the button start power
  Tour LED from yellow to orange. Then the LED flashes 8 times. SLSSLLLS = 01001110. Peut
  can you tell me what this error code means?

  Another person wrote "I solved the problem" by connecting the 2 PCBS together. but what is PCB? I do not know.
  I will be grateful for your help.

  Post edited by: krystianic

  Hello

  I guess that the "0100101010" - code must be some kind of error code, but I'm not sure. But even if that's who you wouldn get information on this subject given that these technical information are kept for toshiba technicians, I guess. :)

  So, in this case, you can not do anything and just ask some laptop technician/service station for a checkup of material or a repair.

  Sorry mate, but that's all.

  Good bye

• My battery does not charge even when it is plugged and my orange light blinks when it is plugged.

  My cord broke first, then I got the exact cord to fit my computer. Them I got 75% battery charge, but even when it is plugged in the light to connect it to the computer itself has never been white once again, it flashes orange. Now, I'm down to 2% and I tried to load it. It will not be loaded. I tried to take the battery out and just have it is plugged in, but still it flashes orange. Not white as before. What could be wrong?

  The battery? Batteries will you know. Tried to contact the Office of support for your laptop brand?

• X 1-consumption of high power (> 20W), GPU 100% life time battery, short, fan-noise

  My new X 1 is ideal for grinding through data, but energy consumption seems high when idling or when I do simple tasks.

  I have the BIOS version 1.27 (released October 21, 2011) and Power Manager 3.62

  I have used Power Manager in order to use the value "low energy". However, the power used is always > 20W and usually around 25 - 27W. This translates into excessive heat (so the fan runs at 4500 RPM all the time) and the battery is lasting less than 1 hour if I give a Powerpoint presentation (not movies).

  In addition, the power watch GPU at 100% all the time - Manager is this normal or would it not be a cause of increased tension required?

  I tried all the solutions on fan noise in this thread:

  http://forums.Lenovo.com/T5/X-series-ThinkPad-Laptops/X1-fan-noise/TD-p/469001

  I tried to set all the power settings to maximize independence in Windows 7, and then also in the power manager, but not enjoy. Help, please! What are the normal electrical needs and the GPU % at idle?

  
  

• KDL-55HX750 red light blinks 3 times

  My TV no longer works, it feeds on. that it snaps and then the power light turns RED and flashes 3 times repeatedly. Please help me, cause I can't believe I have to pay so much to replace the main Board.

  TV works fine. I found that I had downloaded the version of firmware USA instead of the version of the MEA. Once I downloaded the correct software copied on the USB, the TV updated Firmware accordingly.

  Thank you

• Laptop does not - the power adapter light flashes three times? G62 b29SA

  I was replacing the fan in my friend's laptop computer. I had a problem with the trackpad works not once I put back it together and this problem is not yet solved, but I have another problem that prevents me from getting more. Now when I press the button, the light power adapter (next to the socket for external power) flashes three times and that's it. It flashes three times, whenever I press the power button. It does this even with a connected external power supply (I'm sure it's supposed to just stay on constantly when the charger is plugged in but the power source I have is a universal set of one to 19 V - he was fed up with this trendy before but I don't know if it was taken in charge of it). Any advice?

  I have the charger of my friend and now it starts very well. There seems to be a lot of sense for the three flashes based on my Internet research, but in this case, it seems that it is a way to indicate a low battery.

• HP Laserjet 1018: Printer light blinks 15 times but does not print

  I have 2 printers, my work horse HP laser jet and a Brother Multi printer/scanner/fax etc. Both printers work correctly when connected (usb to LJ1018 connection) or wireless (Brother MFC) to my notebook running windows 7 lite.

  My desktop HP compaq core 2 duo machine is connected to two printers with the help of a brother network cable and a usb cable for the LJ1018 but I decided to connect the brother wireless to my network, because it allowed me to use my netbook without having to plug in a usb or network cable. I also created my office to connect wireless to the brother and it works fine, but now I find that I can not use the LJ1018 that I think only has a usb cable connection. Although the computer says the printer is connected it is flashing the light several times - about 15 but does not print anything. I tried to reinstall the USB driver but this makes no difference. One thought I have is that Windows XP cannot deal with a wireless connection, but also a connection usb, if yes can I have go back to wired connections?

  Hi @petec48,

  Personally, if it is not broken, do not fix.