Satellite A350-122 - how to install the second HARD drive?

Similar Questions

• How to install the second hard drive in the Satellite A200-1 of body weight?

  I see my new Satellite A200-1 of body weight has two hard drive bays, the research in the second span, I don't see how a second drive can be mounted as the plug into the Jack seems to be missing.

  What parts do I have to mount to place a second drive that they are held in stock by out of the local computer and are quite cheap, can someone advise me on part numbers etc of the bits I need.
  Thank you
  Steve

  Hello

  I know that this empty place for second HARD drive is a bit confusing, but the same situation is with my A200-1CR. The fact is that some A200 models come with 2 hard drives and laptop case design this place must be prepared for this second HDD.

  But this does not mean that each A200 can be improved for the second HARD drive.

• How to install the second hard drive in the Dell XPS 8900

  My new Dell XPS 8900 only has a single HH and I would install a second HH.  Probably 3.5 SATA internal a 2 T.  I need a repair of XPS 8900 so that I know how to install the second disk.  I just need a few simple instructions so that I know how attached a data cable SATA and do the go by car.  Direction will be appreciated.

  You will need the drive AND a data cable.  The manual is here:

  www.Dell.com/.../manuals

• What do I need install the second hard drive HP PAVILION: p6633w

  What do I need install the second hard drive HP PAVILION: p6633w?

  donp815 wrote:
  

  What do I need install the second hard drive HP PAVILION: p6633w?

  Hello

  You need two cables, one is a sata cable:

  http://www.play.com/PC/PCs/4-/30305659/706331346/STARTech-com-6in-SATA-to-right-angle-SATA-serial-ATA-cable-female-SATA-female-SATA-6-inch-red/ListingDetails.html?_%24JA=TSID:13315% 7Ccat: 30305659% 7Cprd: 30305659 & kw = {keyword}

  This cable is only for data and connect the hard drive to the SATA connector on the motherboard.

  The other cable is energy:

  http://www.itpartsdirect.com/STARTech-15-24cm-4-pin-Molex-to-SATA-power-cable-adaptor.html

  It connects the hard drive to the PSU.

  You can also buy a combo like this cable:

  http://www.Amazon.co.UK/DP/B00064GBT4/?tag=hydra0b-21&hvadid=9550951989&ref=asc_df_B00064GBT4

  All you have to do is to connect the hard drive and that's it. Make sure that the main drive with the operating system is connected to the primary SATA connector (I think there are the numbers 1, 2, 3...)

• Satellite P70 - how to use the second HARD drive?

  I have recently bought a satellite P70 - A - 10 d.

  I see that there is no second location on hard disk, so I can install a second disk.
  You can see the second slot in this video http://www.youtube.com/watch?v=uW75IsuFeoY.

  But I can't understand how screed the disc.
  Do I need additional items for it or he'll be safe just plug the drive and leave it without screws?

  Hello

  If the second HARD drive bay contains the HARD drive connector, you can connect the HARD drive using the 2.5 HARD disk as [this | http://www.newmodeus.com/shop/images/TOS-X505%20sm.jpg] a

  Welcome them

• How to use the second HARD drive of Satellite A210 - BP1 for mirroring

  Satellite A210-BP1 came with 2 HDD (160 GB).
  Now, I want to use the second hard drive mirrored the first, one that has Vista installed.
  This should be done without supervision and in real time - as a RAID 1.

  How can I do this?
  I also have Vista professional available and I would be willing to use 3rd party software as well.

  Thanks in advance for your answers.

  Hi Jan

  I doubt that this is possible
  Why? The point is that you need to use two hard drives in mirroring, RAID striping, mode etc technology
  Satellite A210 can't RAID. It s only a SATA controller without RAID capacity!

  Therefore, the final answer is; NO, it is not possible to use mirroring

  Concerning

• Possible to install the second hard drive in the p6110f Pavilion

  Is it possible to install a second hard drive, 1 TB Seagate, in the expansion on my Pavillion p6110f slot?

  Hello

  Your PC has a hard drive cage which will host two disks.  This how-to - HP document from removing a hard drive will show you the process to remove the hard drive cage.

  If you want to continue using the Expansion Bay then you will need a 5.25 "to 3.5" adapter support. NewEgg.com would bring such a support.  You also need a SATA data cable.  This how-to - HP article will give you an idea on how to use Expansion with a 5.25 device Bay ".  Check by the optical drinve for a spare SATA power connector.  If it is not available, then you will need to use a SATA power splitter.

• CD player not recognized after installing the second hard drive

  My OptiPlex 755 Windows 7 with a ran fine until I installed a second hard drive.  Now only the hard drives are recognized.  I have cd players connected to SATA 2 and 3 a the SATA drives 0 and 1.

  The 755 a 0 and 1 and then 2-3 THEN esata.

  Other chipsets have 0 1 2 3 4 5 and raid 5 capacity.

  These options appear as
  SATA 3
  for the mini tower,.
  SATA
  0
  through
  SATA 2
  for the
  Desktop
  for

  The blue connector is drive 0

  The 2nd Black, this is the dvd's.

  There is no car setting just the port enabled or disabled.

  2nd HARD DRIVE GOES ON THE WHITE CONNECTOR

  The 2nd CD GOES ON THE CONNECTOR FOLLOWING

  DRIVE CABLE IS BLUE AND CD CABLES ARE ORANGE.

  

  

  

• Tecra W50 - cannot start when installing the second hard drive (caddy).

  Hi all
  I have a Tecra W50 PT640A 04103NN1.
  When a second hard drive is installed in the Bay of DVD player cell phone will try to boot from the drive bay, not the internal drive
  This second drive has no operating system installed and so the fails to start.

  If I hit F12 at startup and select HARD drive, while the machine starts correctly. That is starts on the main hard drive.
  Change the order of boot in the BIOS makes all the difference; He will always try to boot from the second drive bay drive first.

  All known A it works correctly?

  Thanks in advance!

  Hi Doppelfrog,
  I had the same problem with my W50, got my HDD caddy a few days ago.
  You have a bit of luck to fix this problem?
  I believe that the Bios for this laptop is not developed to serve both drives (like the computer I had that one drive Bay) and it is not possible to prioritize the witch THAT HDD should start first...

  Kind regards
  Marcin

• How to install a second HARD drive disrupted Qosmio G10

  Hi all

  I have a G10 and want to add a 2nd HARD drive, I know it's on the Bay, but I found I need an adapter plate, I tried just putting the new disk, but the system wouldn't boot! take out and presto back to the original state.

  1\ where can I get another set of training?
  2 How to recognize the second car and start correctly

  Thank you

  Bigkid2071

  Hello

  As far as I know you can build in a second HDD, but it must be defined as the slave HARD drive. If your has been defined as master he can be a problem, because in your case, there are two disks HARD masters.

  One of my friends already tried that, and it had success just at the moment where 2nd HARD drive has the same capacity as the first. Two of them were with a capacity of 80 GB.

  Configure the other as a slave, and then try again. If you have success, let me know.

  Good bye

• How to install the new hard drive on PowerMac G5

  How it installs a new hard drive on PowerMac G5?

  I have a number of readers of the previous Mac that can fit in this PowerMac G5, but I don't know what - if anything - is necessary to make them fit. Or guides, assistance would be appreciated.  Thank you!

  You need a 3.5-inch SATA drive. Concerning how to swap the drives you can use these instructions to fixit. You can skip step 4 that this plastic cover does not need to be removed. https://www.iFixit.com/Guide/Power+Mac+G5+hard+drive+replacement/1952

• Install the Second hard drive on the HP Pavilion DV7-4270us laptop

  Hello

  My laptop has a space for a second hard drive, but not of connectors. I use Windows 7 Pro 64 bit and I would like to add a second drive in this niche. My main drive is 1 TB and I'm running out of room. I am currently using a 1 to external but it is cumbersome when you travel. What should I do to use the second drive?

  TIA,

  Marty

  Hi Marty,

  An example of what you need to use the 2nd HARD drive Bay is at the link below.

  http://www.newmodeus.com/shop/index.php?Main_Page=product_info&products_id=345

  Kind regards

  DP - K

• Re: How to use the second hard drive in Satellite A300?

  I got a second hand Satellite A300 which was to be thrown out due to a defective DVD.
  I fixed the DVD and have a perfect system.

  On opening the box, I discovered that there 2 x 250 GB hard drives. I checked CMOS and show the 2 drives. However, Vista displays only the a drive.

  Excuse my ignorance, but how do I access to the second drive?

  I have Satellite A300 with two hard drives and each HARD drive has another operating system. Both hard drives are recognized correctly.
  I put t know what the problem is here, but the two hard disks should be recognized automatically.
  Try to set the BIOS to default settings and check again.
  Try to start the check and install Microsoft bootable disk if the two hard disks are displayed in Setup.

  I just hope that there is not a hardware problem.

• How to install the new hard drive and windows key?

  Hello

  I have a aspire v5-121-c72g32nkk.
  I have just updated to Windows 10, don't panic, but I want to upgrade my HD drive to a SSD drive.

  You can find the steps to do this?
  Windows was preinstalled, how I reinstall on another drive?
  I have no serial key or whatever it is.
  I'm a bit lost, you have an idea?

  Best,

  There are several ways to do this, anyone have product keys, since

  If you want to do a clean install:

  Windows 7-8 - 8.1 keys are embeeded on your BIOS

  Windows 10 use a generic key during the upgrade, so just skip the steps questions about a product key and the first time you connect on the web, it will authenticate to.

  You must decide:

  (1) do a clean install of your operating system to factory

  (2) make a disk - image of the system image and reload

  (3) to do a clean install of windows 10

  option 2 is the fastest at the end, as you create a copy of your HARD drive and reload it to your PC.

  you need a bootable windows 10 (USB or DVD) media and little space on external HARD drive.

• How to do the second hard drive as main hard drive and move the files to the first hard drive to the second.

  Original title: How to I can't remove my 1st hard drive program files?

  Basically, I got a new laptop for games with Windows 7 on it, and I know almost nothing about computers. So it all starts on my SSD (180 GB) and I want to move to my 2nd hard drive (750 GB) HHD. I want to keep windows and steam (platform game) on my SSD and move almost everything on my other hard drive.  When I move everything on it works, but when I try and do a right-click and delete the programs or program filex (x 86) it says I don't have permission. So I give myself permission and ownership of the program files, but it does not work. I tried to remove anything that did not come on the computer and what I just said try again, but it still does not work.  I have tried myself giving full ownership of readers, but it still does not work. He always tells me that I need permission from myself. Is any way for me to have my computer recognizes the HHD as the primary drive, and then I can move Windows and Steam my SSD? And all that would remove? (If yes let me know if I can put the drivers I have on a flash, so they are removed). Any help or advice would be great! Thanks for reading and you're time and effort!)

  P. S.
  Do not forget that I know little to nothing about computers, so just assume I know nothing and give me instructions step by step, if it is possible.
  May peace be with you,
  Alex

  Basically, you can not, you need to uninstall the programs, then custom Setup to the location/reader of your choice, even in this case a lot of files will always be located on your windows disk.

  When you install a program many entries are written to the registry, if you try to move a program, if you can, the registry entries will be incorrect then the program will stop working.