Satellite C850D 11(f) does not illuminate
Hey there all,
I recently received a defective C850D Satellite of a friend hoping that I could work my magic, basically, the laptop fuel not on.
I tried 3 Chargers, I ve stripped to the bare bones unit and run a multimeter on the Board, there is power to everything apart from the exit of the fan, I am a little confused, it's just a bad connection or something more serious. I know it's not water damage and there is no visual damage to the Board or to the housing...
Any help would be appreciated.
Thank you very much
As I see that you have removed all laptop and make Visual and technical check.
On this virtual path, it is not easy to say with certainty what can be the problem.
Are there other symptoms?
I mean what happens when you connect to AC power for laptop?
Is DC led on? What is with battery LED?
There are some LED flashing?
What happens when you press the button walk / stop? Is there a reaction?
It is not easy to help, but if the phone is completely dead I assume electronic power supply may be faulty?
Tags: Toshiba
Similar Questions
-
Satellite Pro L50 - A does not illuminate
Hello
I took a few steps on this forum but no luck so far...
My L50 - A Satellite Pro was working fine up until yesterday, but today, only it just won't turn on. A small orange led light appears when I connect to the power cable...
That's what I've done so far-
1 power cable removed
2. using a needle, pressed force shutdown (stop) at the bottom for 10-12 seconds
3. then I pressed the start/power button on the front for 60 to 70 seconds
4. I have connected the feeder and then to new press button start / stop at the front for 60 to 70 secondsYet the laptop does not start!
any suggestions?
Thank you
Hmmmmmm... It is not easy to say what the problem is here.
Have you used your computer laptop usual ot, you might update something?
In general, there are steps that you did which could be responsible for your problem? -
Satellite Pro P300-156 does not illuminate
I've had this laptop for 2 years, it was working fine this morning and I pressed the power button to turn on the sleep mode. I went back to the laptop a few hours later to turn it back on and the power light lit for about 2-3 seconds, then came out and nothing happened. Whenever I press the power button, the same thing happens, the light appears for 2-3 seconds then turns off and the laptop does not start. This produces both with the power adapter connected and disconnected. When the power connector is plugged the adapter power light and battery light comes on.
Does anyone have any idea can be what the problem is or if it can be fixed?
Thank you
Disconnect the power and remove the battery. Leave it for a while and try to start the laptop with AC power only.
Please let us know what exactly happens when you try to turn on your laptop. -
Satellite C850D-107 - screen does not work
Hi, my first post here and need help please.
I have the laptop above and last week I had 3 dead crushed inside my screen bugs, so I searched google and found some info on how to clean them.
I took the screen and then carefully carried the front end, giving me access to the rear led? I cleaned the bugs and as I thought carefully back together, when I started the laptop backlight as does not I had thought broke I bought another exactly the same thing and put in, but its doing the same thing.The screen works but no light, so, any help would be great. I know there is no converter in these so what could the problem perhaps, cable the screen? I can't help LOL.
Thank you, Wayne.
> The screen works but no light
I guess the backlight module does not work. Now quite sure if you get a defective screen or perhaps display isn't compatible/certified for this unit but the fact is that the LED backlight are simply connected with a LED backlight cable and there is no other modules which would impact on the functionality.So I think that you should simply try another display unit
-
Satellite M100-164 display does not illuminate after hibernation
After the computer wakes up from hibernation by lifting the display panel (cover) and the LCD screen turns off due to power management settings, display shows the Toshiba logo and does not return after a key is pressed and the keyboard is not responding.
I turned - power & removed the battery without success-.
OPS: windows XP.
Help, please.Hello
You have removed the battery but wait you a bit?
If please plug the laptop and remove the battery.
Wait 15-20 min and then plug the AC adapter and put the battery in the laptop.Then try again!
-
Satellite Pro C660 does not illuminate
Satellite Pro C660 does not illuminate. no noise, no light just fill out the dead.
any suggestions?
Hello
On this virtual path, it is not possible to provide an accurate diagnosis. All you can do is to unplug the power plug, remove the battery and leave it for a while. Then press the power button and hold it for 15 or 20 seconds.
After doing this connect the power running and try to start again.What happens when you do this?
-
Satellite M30X-127 does not illuminate
Hello
Need help!
My satellite M30X 127 does not illuminate. When I push the power button, it is DIRECTED in turn. But nothing comes on the screen. There is no sound and the fan does not start. I took it to a repair center and they told me the motherboard is fried and it will cost me 400 pounds to fix.
The guy there offered my 100 pounds for to buy me.
Please a little help. What should I do?Hello
Otherwise you will search in ebay for the second hand with the good motherboard unit.
Sometimes people sell books with the failure to display or other parts of damage, but the motherboard is ok.
You can try to use second hand motherboard in your laptop. -
Satellite A300D does not illuminate
Toshiba Satellite A300D does not illuminate
The battery light is red when it is plugged in with the light of the white plug
When I press the power button it lights up two other fires, and one that looks like a sheet a4 fact paper.it a vibration when turning it on also.
Any help would be greatly appreciated
Disconnect the power adapter and remove the battery.
Leave the laptop unplugged and then hold down power button / stop along 30 sec.
Then reconnect the two parts and check how the unit works.In which case nothing would be visible on the screen, try replacing the RAM modules. Perhaps one of the modules is the troublemaker
Otherwise if the RAM modules are OK, the problem could be linked to the motherboard. -
Satellite M100 does not illuminate unless the AC adapter is pluged
I am also having the same problem with my Satellite M100. The computer does not illuminate unless the AC adapter is pluged and plugged into the power outlet.
Any ideas on how to solve this problem? The battery should be fine.
B.
Hello
Well, to me it sounds like a battery problem
Why you say that the battery must be good?
Have you checked it or because the technician?In most cases if the battery is faulty then the laptop would have no power until it would be connected to the power adapter.
So I think (but that's just my personal opinion) the battery must be enabled (by technician, ASP) and if necessary should be replaced.
See you soon
-
Satellite L500-1DT does not illuminate
My laptop does not illuminate unless the switch the off market cable is disconnected and the connections are bridge on the motherboard. Any suggestions please?
You start your mobile phone if the battery is removed and the laptop connected to the power supply current only?
-
LED light for Wi - Fi on Satellite L40 - 14F does not illuminate
Is he someone correct the problem with LED light for Wi - Fi on L40 - 14F?
What do you think average is by any fix for the WLan light
Are sure you that you have enabled the WLan switch on the side of the laptop?
Only this switch controls the WLan light!If the WLAN led does not illuminate after that you have activated the WLan switch there is something wrong with the hardware.
then if there is something wrong with the hardware of notebooks is needed the help of ASP.
-
13-inch early 2011 macbook pro. light green mag extremely shoddy security cordon, macbook pro stopped charging bought new magsafe. and the led does not illuminate or strings. SMC reset now mac does not recognize battery. disconnected the battery and security cordon mag, maintained hold button / stop for 5 seconds, nothing. Another SMC reset and it is the only way Mac powered on that she has no back light for the keyboard and the fan works on high all the time, please can someone HELP, thanks.
This is the Office Mac Pro forum. I asked that your post be moved to the MacBook Pro laptop forum.
-
iPhone 6 with iOS9.3.4.
WiFi button does not illuminate. I rebooted the phone. How can I make this button of the device?
You can always update your firmware with iTunes. But it seems you might have a larger, likely hardware problem with your phone.
Try to restore the firmware with iTunes. If this does not help, make an appointment with a genius at the Apple Store.
-
My MacBook Air does not illuminate
MY MacBook Air does not illuminate?
Nothing happens when you try?
Power light?
Tones? Startup chime?
If you connect to the charger, which is LED color on the card?
-
MY iMAC, which is several years old does not illuminate
Take the test/diagnosis. Nobody here can 'pull' hardware problems.
Barry
Maybe you are looking for
-
Hello I have a problem with my wifi. The button always orange and nothing happens when I press on it: no errors, no message, no reaction at all. This is why I can't use WiFi. The laptop is a little new: I use only 2 months. 1. number and product name
-
I don't have the orginial toolbar... just the interface toolbar for facebook
I added a few Add ons... and then deleted... I now have only the toolbar for the interface of Facebook with firefox. I deleted the orginal... downloaded again configuration. Whenever the unwanted page is as mentioned above. Can you please help... Enj
-
Series A satellite with Vista stopped sees any DVD/CD inserted
My Toshiba with Windows Vista laptop suddenly stopped see that no matter what DVD/CD inserted, and Device Manager all the time gives the message that the software may not be installed correctly due to the error in the configuration. I updated Windows
-
Add an album to the iBook/iMac iPhone
-
XP Home was activated by phone. Now, a dialog box appears saying THAT XP needs to be activated. When Yes is selected, an activation dialog box opens saying XP is already activated and brings back me to the login screen. Once I try to log in, the proc