Support CPU VS CPU series

Similar Questions

• ERROR: No supported CPU installed, HP P6310F

  HP p6310F

  Windows 7 Home Edition

  ERROR: No supported CPU installed

  CPU replacement

  Hello!  I replace the CPU in my HP P6310F.  According to this literature, http://support.hp.com/us-en/document/c01949155 , I have an AMD Phenom II X 4 Quad-Core 9xx/9xxe/8xx (Deneb).  My understanding has always been that "9xx" means any phenom II in the class of the 900 series.

  I bought a retail Phenom II X 4 965 Black Edition, part HDZ965FBGMBOX number, installed and get the error message: CPU support is not installed message.  After searching and reading about the error message and other messages, it seems it might be due to the 'black edition' and/or because it is 125 watts.  It was the answer to a few others in the same situation as me.

  Can you please tell me why this CPU is not compatible and please help me with a list of compatible CPU?

  This is also in the 9xx series, but is it at 125W

  HDZ955FBK4DGM AMD Phenom II X processor 4 955 - Quad Core, 6 MB of Cache L3, 2 MB L2 Cache, 3.20 GHz, Socket AM3, 125W, fanless, OEM

  This lies in the 9xx series and is 95W

  AMD HDX945WFGIBOX Phenom II X 4 945 Quad Core Processor - 3.00 GHz, 6 MB of Cache, bus front to 2000 MHz (4000 MT/s), retail, Socket AM3, processor with fan

  The stock processor is an AMD Athlon II X 4 630, 95W

  I can provide any other information you may need, thank you very much!

  There is no AMD Black Edition CPU that are compatible with any PC HP desktop.

  That's what the problem is related to. Black Edition CPU are special processors who have discovered the multipliers for amateur quality motherboards. You could not access the multipliers to overclock the CPU with the motherboard you have installed it anyway.

  Even if you choose, buy and install one of the microprocessors in maintenance & service Guide there is no guarantee HP which will be exploited.

  You should also be aware that installing a different CPU than your office has been delivered with the warranty.

  Sorry to bear bad news.

  The good news is that the processors listed in the maintenance department & guide reputable reports of upgrade in discussions in the forum, to run.

  Best regards
  ERICO

• Why my Vista operating system will not support a lexmark Printer series s600?

  I spent the last two hours trying to set up my 'Wireless' Lexmark S605 so I can print from my laptop 32 bit Windows Vista. I followed the instructions given in the installation process and used the installation cd, but was still unable to print from my laptop. Then, I downloaded the software and complete drivers (which was the last updated February 2013) from the manufacturer's website. The first error message that I got was one of the pilots be found / had failed to install. The second error message I got was:

  "Your operating system cannot support a lexmark s600 series printer. Installation cannot continue. »

  What can I do to solve this problem, if anything? (in addition to buying a new laptop which doesn't have Vista)

  Hello

  Here are a few troubleshooting steps that you can try to solve this problem.

  
  We will try to set up the printer using the tool of Lexmark.
  All the drivers and software for Setup, configuration, and usage of your device with 32-bit Windows.

  http://support.Lexmark.com/index?docLocale=en_US&page=content&ID=DR15867&locale=en&UserLocale=en_CA

  How to reconfigure your inkjet printer to join Your Wireless Network by using the http://support.lexmark.com/index?page=content&id=HO3161&locale=EN&userlocale=EN_CA wireless configuration utility

  If the problem persists, I suggest you contact Lexmark support using this link

  http://support.Lexmark.com/share/index_ca_en.html

  Thank you

• Support CPU for Satellite Pro 4600 series

  I tried to find out if I can pass the CPU on my satellite 4600. It is running a PIII 800 MHz, but what is the maximum that can support the system board?

  Hello

  Like chris said there is no way to upgrade CPU. You can upgrade the RAM. The maximum memory for your laptop model is 512 MB.

• Support CPU Tecra M1

  Hi all fans of Toshiba and the users of the forum.

  I would like to get to know what are the processors supported for the Tecra M1 laptop computer product? Given that or what version of bios is required etc. It is a pity that the BIOS download page provides no further information on this subject.
  I would be happy to receive all responses,

  Sincerely yours

  Jens

  Basically, the upgrade of the processor is very limited. If you are installing a processor that does not recognize the BIOS, the CPU cannot operate at full speed or it does not start, or it may cause damage or overheating.
  Your best option would be to look at other Tecra M1 models and determine that we have the fastest CPU. That the exact CPU should work in your M1 with the latest version of the BIOS.

  In addition, I found this page on the Toshiba site, explaining the upgrades: http://aps2.toshiba-tro.de/kb0/FAQ7A01ZW0007R01.htm

• Presario CQ5320F: upgrade the processor 'not supported CPU.

  I was looking to upgrade the CPU on my Presario CQ5320F, for most popular processors in the list on the HP site for my computer. So I bought one, actually two, of the AMD Phenom II X 4 processors (Deneb). When I installed it, them, I get a message saying that the CPU is not supported. I don't know how I got it done, but it does not work. I bought two of the processors by mistake. The code on the processors that I bought is "HDZ955FBK4DGM", which seems to be the processor in the list of compatible processors on the HP website.

  -AMD Phenom II X 4 9xx/9xxe/8xx Quad-Core (Deneb)

  -AMD Phenom II X 3 Triple-Core (Heka) 7xx/7xxe

  -AMD Phenom II X 2 5xx (Callisto)

  -II AMD Athlon X 4 6xx/6xxe (undactylopodite)

  -AMD Athlon II X 3 4xx/4xxe (Rana)

  -AMD Athlon II X 2 2xx/2xxe (Regor)

  -AMD Sempron 1xx (Sargas)

  I'd appreciate any help.

  Thanks in advance,

  nashville_bill

  Thank you for giving me the answer. I guess it's time to look for a new motherboard now.

  No doubt, it would be nice if someone let HP know this, so people like me would not try to use this processor with the motherboard.

• Satellite A500-1GH - what this laptop supports CPU load

  Hello everyone.

  Does anyone know which processor is supported for this laptop?
  I mean the exact models because I know what Intel I5 installed.

  Or maybe if you know the best processor that can be installed in this laptop.
  Are there documents for this laptop because I can not find the drivers in the toshiba site?

  Thank you.

  Hello

  The laptop supports the * Intel (R) Core i5-430 M * processor
  All details can be found on the page of Intel:
  http://www.Intel.com/consumer/products/processors/Corei5-specs.htm

  > Or maybe if you know the best processor that can be installed in this laptop.
  > Here are all the documents for this laptop because I can not find the drivers in the toshiba site?

  Usually the CPU upgrade not is not supported by Toshiba... but if you use the CPU of the same family of CPU (i5 - 520 M, i5 - 540 M), then you should have a good chance that the laptop would be compatible with this CPU... but I would not recommend these updates.

  Why?
  (1) you will not see any performance gain
  (2) you will lose the warranty

  Welcome them

• Hyperic support CPU / hard drive temperature?

  Dear all,
  

  
  

  Is Hyperic supports followed by CPU / hard drive temperature?

  
  

  -

  Sree
  

  Hello

  Unfortunately hyperic is not supported for this metric.

• Support CPU LAHF/SAHF in Long Mode

  Hi guys,.

  I try to install esxi on a HP DL380 G4 5 (I know its probably not supported, but it's just for learning). When I run through the installation program, the message I get is:

  the system has found a problem on your machine and cannot continue. VMware ESXi cannot run this processor. VMware ESXi requires a 64-bit processor with support for LAHF/SAHF in long Mode.

  So I tried to install ESX 4 on this machine that I was sure there 64 Bit CPU. ESX 4 successfully installed which means the processor is capable of 64-bit.

  Any ideas how I can get this to work?

  Thank you

  DrYv

  DL380/DL360 G4 models have XEON 64-bit processors. However, these processors do not support Intel VT as well as other features of the new generations of processors. Also, I have some of these models in my lab and run ESXi 4.1 on them (with guests from 32-bit only). Looks like that ESXi 5 requirements that cannot be met by these XEON Processors however. BTW. the last supported version of ESX (i) for G4 models was ESX (i) 3.5

  André

• FT on the non supported CPU

  Is it possible to activate CVS on a host in a cluster has no a taken CPU supported by changing masks CPU? This is a laboratory, not a production system. All hosts are the exact same processor brand/model/no no, but CVS does not illuminate because it correctly detects the CPU. The custom mask CPU thing works for CVS?

  VCA is not related to FT.

  Both methods require certain characteristics of the processor, but they are different.

  VCA is only for VMotion 'friendly' on the model of different processor (but in the same family Intel or AMD).

  If your hardware does not support CVS, you can always do it manually using CPUID mask on each virtual machine (see VMware KB).

  FT is to have a virtual machine in waiting that is synchronized with a computer master virtual and ready to run if the ESX hosts the primary fails.

  André

• Satellite A110-293 taken supported CPU

  Hello

  If anyone can be good to enlighten me? I want to upgrade the CPU to a Satellite A110-293 of the current, [Intel Core Solo T1350 | http://ark.intel.com/Product.aspx?id=27243] to an Intel Core 2 Duo. This model has him [Compal HTW20 | http://www.pc920.com/upload/dede8953_20100103051533_13.pdf] motherboard. Is it possible or not?

  Thank you!

  Hello

  Check out this Toshiba document - http://aps2.toshiba-tro.de/kb0/TSB9401AX0001R01.htm

• Portege 7010CT: max capacity HARD disk support + CPU

  Hello
  Since I am a student I can't afford a new laptop (unfortunately) so I have to use my old 7010... That's why I think a small update... a bigger HARD drive (used)... But I cannot find anywhere the maximum size HARD drive for the 7010 - everyone knows, or experience with the largest drives that small 4.3?

  Also - is it possible to change the CPU with a faster mobile P2?

  Any help would be GREAT

  Hello

  I put really t exactly know the limit of the capacity of the HARD drive used on Portege 7010but, I'm sure you can use hard drives up to 10 or even 20 GB with no problems. Unfortunately only service partner or a buyer of HARD drive have precise information on this subject. They are specialized for the hardware upgrade and jut, they can give you a guarantee that the HARD drive is recognized properly by the BIOS.

  With CPU is the problem because most of them cannot be changed at all.

  Good bye

• Supported CPU upgrade BIOS

  Hello... we have an approx. 5 years dv6 - 1253cl laptop that I updated to 8 GB of memory, new SDS, new card USB 3.0. then what I would do is replace the stock Intel P7550 processor with the Intel T9xxx or a series of P9xxx Intel.  The repair, the Board of Directors of system/chipset will support until the T9900 @ TDP = 35W and P8800 @ TDP = 25W.  My question is: can I go beyond the P8xxx P9xxx (e.g., P9700) even if this series is not specifically referred in the manual?  Others have successfully swapped P7xxx for T9xxx processors on this particular model, but I tend to keep close to the TDP stock Plug and P-series.  Is this possible?  Thanks in advance for all advice.

  The motherboard used in the P7xxx (i.e. your motherboard) is the same as the motherboard used in these models with the T9900. I understand you want to keep the current absorbed as low as possible, but HP means generally what it says when it contains a list of compatible processors. I frankly never saw a case where someone shows the installation of a series of different processor rather than just a slightly faster processor in the same series. The T9900 is a beast and I am pretty sure that it will work for you. You lose a battery life but will gain some performance. Your Service Manual:

  Manual

• Taken T60 supported CPU, s

  has obtained a T60 earlier and you want to upgrade the processor. The problem is that I don't know what fits and what does not work

  never mind that I checked and the CPU, s it takes are not produced more

• Constant use of Adobe CEF to support cpu

  Hello

  I have CC Photoshop and Lightroom CC updated to the latest versions.

  
  I have a Macbook Air and this process constantly use 11.8% of my CPU. I've seen other threads with similar problems, but no answers. However, with the same software on my mac mini the same process a 0% usage.

  Why shouldn't it?

  Your if all goes well.

  John has.

  I've just updated creative cloud in Version 3.4.1.181 released on 26/11/2015, and this problem is now fixed. Don't know what you a bug but it worked for me.

  Kind regards

  John has