Update PIX515e to ASA55XX

Similar Questions

• Hash MD5 for PIX515 IOS does not match check

  I've recently updated our firewall PIX515 release 7.2.2 to 7.2.4 and I wanted to check the hash MD5 for the downloaded IOS. However the hash generated on the PIX using the verify command does not match the hash that is published on the website of download of cisco. Published f2f6b88ea1b4a0b33045b3b18d0fb852, generated hash hash is fdcd... I checked the MD5 7.2.2 on a firewall, I have not yet updated and does not correspond to either. Am I missing something?

  OK, so you've downloaded an intermediate version - 7.2.4 (30), instead of the main exit of 7.2.4.

  7.2.4 checksum (30) is correct and corresponds to which advised you earlier: fdcd3a9d884baf0ec0aad78048f0e441

  You can check it out here:

  http://www.Cisco.com/cgi-bin/software/tablebuild/doftp.pl?ftpfile=Cisco/internal/special/ciscosecure/PIX/pix724-30.bin&app=tablebuild&status=showC2A

  Hope that clarifies the confusion.

• Telnet and SSH on PIX515E does not

  I have two PIX515E (primary and Fail-over) and I can't access it via telnet or SSH.

  I can access only once they have restarted and then they react to me and close the connection.

  the version of the show from the primary is as below:

  Cisco PIX Security Appliance Software Version 8.0 (3)

  Version 6.1 Device Manager (1)

  Updated Wednesday 6 November 07 19:50 by manufacturers

  System image file is "flash: / pix803.bin.

  The configuration file to the startup was "startup-config '.

  Primary up to 3 days 19 hours

  up to 13 hours and 18 minutes failover cluster

  Material: PIX-515E, 128 MB RAM, Pentium II 433 MHz processor

  Flash E28F128J3 @ 0xfff00000, 16 MB

  BIOS Flash AM29F400B @ 0xfffd8000, 32 KB

  Hardware encryption device: VAC + (Crypto5823 revision 0 x 1)

  0: Ext: Ethernet0: the address is 0019.e762.f577, irq 10

  1: Ext: Ethernet1: the address is 0019.e762.f578, irq 11

  The devices allowed for this platform:

  The maximum physical Interfaces: 6

  VLAN maximum: 25

  Internal hosts: unlimited

  Failover: Active/active

  VPN - A: enabled

  VPN-3DES-AES: enabled

  Cut - through Proxy: enabled

  Guardians: enabled

  URL filtering: enabled

  Security contexts: 2

  GTP/GPRS: disabled

  VPN peers: unlimited

  This platform includes an unrestricted license (UR).

  Serial number: 810417710

  Activation key running: 0x7785a916 0x349cafef 0x49afea88 0x8bbd3f92

  Modified configuration of enable_15 to 12:49:25.499 EEDT Sunday, July 26, 2009

  can someone help me solve this problem please.

  I would upgrade to 8.2. I don't have the bug number, but you should be able to find it in the Bug Toolkit.

• Since update 10.0.2 at 6s "trash all ' in the Inbox.

  Since I did the update (10.0.2) I can no longer just "trash all ' mail inbox (Verizon).  Because I get emails 300 + a day, I need to be able to empty my Inbox easily without deleting all of them individually.  It is very irritating and time consuming.

  Anyway around this?  Thank you...

  sharikay wrote:

  Anyway around this?  Thank you...

  Not at the moment. Tell Apple you want to come back.

  http://www.Apple.com/feedback/iPhone.html

• Uninstall software update Apple says error in seller contact package package unstaller

  Try to get itunes working to make a backup of my faulty iphone before repair.

  First-itunes does not start says error. I'm trying to fix it, who said success but same error when you try to start it.

  Then uninstall completely worked. Then reinstall that seemed to be over except for a message "an older version of Apple software update already exists" then he went down and install itunes apparently had not been completed.

  Then I try to remove the update from the apple software and executed by an error in the installation program - it says there is an error in the installation and contact the supplier of the installation package. Same error if I run the uninstall command line program.

  Try to repair the Apple Software Update of programs & features Control Panel and then try to update iTunes again.

  For general advice, see troubleshooting problems with iTunes for Windows updates.

  The steps described in the second case are a guide to remove everything related to iTunes and then rebuild what is often a good starting point, unless the symptoms indicate a more specific approach.

  Review the other boxes and other support documents list to the bottom of the page, in case one of them applies.

  The more information box has direct links with the current and recent if you have problems to download, must revert to an older version or want to try the version of iTunes for Windows (64-bit - for older video cards) as a workaround for problems with installation or operation, or compatibility with third-party software.

  Backups of your library and device should be affected by these measures but there are links to backup and recovery advice there.

  TT2

• Since the update for Sierra, contacts do not appear in Messages - just phone numbers.

  Since the update for Sierra, Messages no longer displays Contact names - only phone numbers.  No instructions on how to remedy this.  Ideas?

  Hello

  Go into the Contacts application and ensure that it uses the same account synchronization like the iPhone and other devices you may be using.

  Also check the part of the accounts of the Contacts application preferences and make sure that it's only using one account.

  

  21:34 on Friday. 7 October 2016

   iMac 2.5 Ghz i5 2011 (El Capitan)
   G4/1GhzDual MDD (Leopard 10.5.8)
   MacBookPro (Snow Leopard 10.6.8) 2 GB
   Mac OS X (10.6.8).
   iPhone and iPad (2)

• Problem after update 10.0.2 iOS iPhone touchscreen

  After I have updated to iOS 10.0.2, I noticed a problem with the touch screen. Using the position of the image on the right side, near the corner, the toushscreen does not work.
  For example: when you use the keyboard, I can't type the letter 'P', have trouble typing BACKSPACE. Using the Contacts app, I can't scroll through using the alphabet bar.

  Do what idea of the problem?

  Kind regards!

  Hi fabriciorela,

  Thanks for the upgrade to iOS 10! I understand that the right of your screen is unresponsive to the touch. You can try the steps in this link to fix the problem. If the screen of your iPhone, iPad or iPod touch does not respond to touch

  If it does not help the problem, try to restore the device to factory settings. I would like to backup your important data first.

  The backup of your iPhone, iPad and iPod touch

  Use iTunes on your Mac or PC to restore your iPhone, iPad or iPod to factory settings

  Please use the Apple Support communities to post your question. Let us know how it turns out. Have a great day.

• USB disabled after the update of the Sierra (a short circuit and a work)

  Hi, when I bought my mbp 13 inches mid2012 (used, not new) I noticed that a USB port did not work. In the Yosemite sometimes I noticed that a USB port consumed too much energy and have been disabled. (I think because the usb port has been short-circuited. Year when it was time to update the mbp to El Capitan I had a few panic the kernel and the newspaper was shown as the last driver loaded the USB driver, so I kept the mbp with Yosemite. A few days ago, I updated for Sierra but only usb which used to work stopped working. It has enabled and turned on but Finder and disk utility does not see the drive. In an Apple dealer they said that could be established relationships with some oxide and next week will take it and see what the problem is.

  If there is someone with the same problems, please tell me what to do! I don't want to put in the trash my mac just for a flash drive... but I need!

  Hi Supermene,

  Thank you for using communities of Apple Support. Based on what you said, it appears as a USB device is not recognized in one of the USB ports. There are a few things that can cause this. I recommend you read these articles, which may be able to help solve the problem.
  

  macOS Sierra: If a USB device does not work

  Reset the management system (SCM) controller on your Mac.

  See you soon.

• I can't go to my bookmarks after update for Sierra

  I have a MacBook Pro. I just updated this week to Sierra with no problems, but now when I click on multiple points in the upper left corner to reveal my favorites and my playlist only, it displays the top sites page and does not open my favorites and reading list, as it used to.

  Can someone tell me how to access my bookmarks and playlist in the Sierra? I'm sure it's something in the settings or something escapes me. My Bookmark Bar is the top of the page, yet. I can't find my bookmarks and reading list.

  Thank you

  I thought about it, I had to go to Favorites on top and tell Safari to display in the Sidebar again.

• Calendar Apple App Bug frozen works only with iOS 10 update grrr

  Since I updated to iOS 10 (more more later than 10.2, etc.), everything was not too bad except THE APPLE CALENDAR app, its deiving me crazy when I click on the app it's like it freezes and past shift x 50 mode still something to do with the calendar app will cause either a frozen or a black screen or white and then crashed ack to main menu. Sometimes it will allow me to create but will be trolling with typing and finally crashed or not even save it... Please HELP I am sure what else to do, I tried to download google calendar and which seemed to have something of bug he loves too then something happens. And I tried to delete it and download it again, / force delivery, nothing has changed

  Hi there calsparks!

  Thank you for bringing your question on the calendar of freezing and trolling since the update to iOS 10 on your iPhone for Apple Support communities.  I rely on the calendar to keep my life organized, so I'm happy to help you resolve this issue today.

  Looks like you did a few good troubleshooting by force to leave the app, force to restart the iPhone and deleting and reinstalling the application calendar.  At this stage my next recommendation would be to backup your iPhone, then erase and restore your iPhone as a new device, then test calendar to see if it behaves correctly, and then restore your backup.
  

  The backup of your iPhone, iPad and iPod touch

  Use iTunes on your Mac or PC to restore your iPhone, iPad or iPod to factory settings

  Restore your iPhone, iPad or iPod touch from a backup

  Have a great day!

• new iPhone update

  I have an iPhone 5 and will probably get an iPhone 6s with a new SIM from nano.

  My photos will remain on my iPhone 5 until I save them?  I don't want to put my new sim card in the iPhone 6 and then the old sim become inactive and lose my photos if that makes sense?

  Thank you

  Hello

  IPhone 5 should run ios 10.2 if not go to settings - about us - software update

  Do update on your WiFi.

  Then go to settings - iCloud backup now.

  The new iPhone set up on your WiFi when you are asked if you want to use iCloud backup say Yes.

  Use the same identifier apple then you will get all the apps / photos on the new iPhone.

  See you soon

  Brian

• How to solve printing problems after update OS Sierra

  After the OS Sierra update, some of my files can not print from my printer. The message showed "internal error - an untrapped exception was raised. Choose 'continue' to continue execution in an inconsistent state. Choose 'Crash' to terminate the application and fill out a bug with Crash Reporter report. Choose 'Crash' will result in the loss of unsaved data. "Despite having chosen the above options, there is still nothing happen on the computer.

  Is there a way to fix this?

  Install a printer driver updated - check the site of the manufacturer for compatible drivers Sierra thew.

• My App Store did not work... When I try to update or install apps it does not work. Can you please fix this?

  Can you please fix the problem? Appstore cannot update or install apps... App Store not worked yesterday.

  We cannot solve a problem for you, but we can make suggestions of troubleshooting...

  Have you tried restarting your iPhone yet?

  1. Press and hold the sleep/wake button until the Red slider appears.
  2. Drag the slider to turn off your device completely off.
  3. Once the device turns off, press and hold the sleep/wake button again until you see the Apple logo.

• HI, Siri would not speak in Italian Luca voice after update for Sierra

  HI, why Siri not talk in Italian Luca voice after update to Sierra?

  Open  (Apple menu) > System Preferences > accessibility > speech.

  Next to the system voice menu, select Customize...

  Scroll down to Italian, and then select Luca, and then click OK.

  It will take a few moments to download the new voice.

• I tried to download macOS Sierra for the last hours on my Mac, but it is still holding still to download. Should I download the El Capitan instead? All sites tell me that I should update my Safari.

  I tried to download macOS Sierra on my macbook pro iOS 10 for a few hours and it still has several hours to go. Should I just download the Capitan instead? All sites tell me that I should update my Safari or I wouldn't even through this disorder.

  You must complete the download of Sierra. It is a very large file and will take some time, especially on a slow Internet connection.

  (145165)