When the battery drops below 50% the Satellite P200 turns off

The laptop turns off when the battery is less than 50%.
Do I have to get a new battery or what?

Hello

I guess you have preinstalled Vista.
Have you checked your vista power management configuration?

There you can assign some settings that would control the laptop turned off depending on the State of the battery.

I think you need to set it to a lower level for example 5%

Tags: Toshiba

Similar Questions

  • Satellite P30 seems to completely charge the battery only when the unit is turned off completely

    Hi, I have my Toshiba Satellite p30 and only works on battery. This unit operate on sector or only on the battery as after the period of time go down the warning, then closes. The orange light fades in and out, but seems that it will only fully charge when the unit is turned off completely.

    I only just received this unit so bit of a novice.

    MASH

    Hello

    normally, the battery should always charge until it is full when the power is connected.
    If you have an orange light flashes, it means that something is wrong. Maybe your battery is faulty or something else. This should be checked by a technician.

    Good bye

  • Tecra A5 - charges the battery only when the computer is turned off

    Hello

    For a few days, my Tecra A5 has started to beep and stop it (like when the battery is low) then that it was connected to the power supply adapter.

    I finally realized that when the computer is plugged in, the battery discharge and does not use the power supply to recharge.

    On the other hand, if I turn off the computer, the battery starts to charge.
    I replaced the battery a few months ago, so I think it's still OK.

    The charger would be defective? Seems strange since it can always recharge the battery when the computer is turned off.

    Thanks in advance for your contributions.

    > The charger is defective?

    Theoretically; Yes, but could also be electronic supply on the motherboard is affected, but on the first stage of the AC adapter should be verified and laptop needs to be tested with AC adapter new, good work.

  • My Ipad charger charge my iphone 5s only when the phone is turned off

    Hi guys. My Ipad charger charging my iphone 5s only when the phone is turned off. The phone does not recognize if it is on and I can't transfer files with it. Help, please?

    Hey Bigfootinyourface,

    I understand that you have a problem with your iPad charger or cable. Accessories and connectors uncertified can often result in the mentioned behavior. Article in the link below provides information that you may find useful.

    Identify the fakes or not certified lightning connector accessories
    https://support.Apple.com/en-us/HT204566

    See you soon!

  • My reading shows the HDMI as a default device, but the sound is yet to come of the computer laptop, even when the volume is turned off on it

    Original title: HDMI sound

    I know that many have had problems, but I did not mine specifically. My HDMI connection was working fine with my laptop HP and m HD tv. I didn't use it for a while, now it is just the video, no audio on the TV. My reading shows the HDMI as a default device, but the sound is yet to come of the computer laptop, even when the volume is turned off on it. Ive read all the reviews and updates of pilot who was old. I don't know what else to do!

    Hello

    System Restore does not have this long period of time.

    You may want to refer to the suggestions in the thread below link and check.

    No sound via HDMI output portable computer connecting to TV

    I hope this helps.

  • Microsoft ON essential to keep all the time automatically, when the PC is turned OFF? I don't know to do.

    Dear Sir/Mam...

    I installed Microsoft essential to protect my notebook of virus & spy ware. When I turn off my laptop sound off automatically. Please send me the details to keep essential Microsoft on all the time, even my laptop is OFF please. Icon for turn on essential Microsoft whenever I start my computer. I can't find the related parameters in the ICONS.

    Once a computer is turned off, it's... Well well, off the coast.  But not just asleep, off.  By the definition of 'off' it does nothing.  Microsoft Security Essentials is a program and only works when the computer is turned on, as all of your other programs.  You cannot run a program when the computer is turned off.  The good news is that a computer is turned off is completely protected against malware are malicious software programs and does not work either.  There is absolutely no need to have anything by protecting your computer when it is turned off.  That said, I think that your concern doesn't really MSE all the time, but that's automatically done already when you turn on your laptop.  Not to worry.

    You see the pop-up warning that MSE has not yet started Microsoft.  If you click on the Start button in the pop - up notification MSE should start (but not immediately).  It may take a minute or two.  If you wait just MSE must start with itself and the notice will go away without having to do anything.

    I see the same thing when I run one of my virtual machines that you see when you start your laptop.  I'm very familiar with it.  It goes away in a few minutes and only means that from MSE wasn't the first thing the computer did when I turned on.  Windows moves to finally start MSE, but you can the long hurry up if you want.

    To manually start Microsoft Security Essentials, find its icon on the lower right side of your taskbar (called the "notification area").  The icon looks like a Red House with an X on it.  Right-click on the icon and choose open on the pop up list.  The MSE window opens on the desktop.  Click on "Start it now" button in the window that appears.  The window fades.  It may take a little time to start the MSE.  When everything is OK, home in the notification area icon will turn green with a check mark.

    When I see the Red House, I usually just give the computer a few minutes to complete marketing and the problem goes away on its own.  On rare occasions I start MSE myself.

    Colin Barnhorst

  • The trash empties automatically when the computer is turned off. How can I fix it.

    The trash empties automatically when the computer is turned off.  How can I fix?

    The trash empties automatically when the computer is turned off.  How can I fix?

    Find what to do (something you installed and/or took the time and effort of installing) and undo - because it isn't Microsoft / default, or even something extremely simple (not something inadvertently, you can check, etc.) to (that happen.)

  • Satellite Pro U400-11V - charges only battery when the computer is turned off

    Following a reformatting my hard drive of the computer, my laptop recognizes only the AC/DC power adapter when it is turned off. When the computer is turned on, it does not recognize the AC adapter.

    Changed the power supply ac and it made no difference.

    Have also tried an update of the BIOS (3.0), I am running Windows Vista 32 bit.

    Hello

    I doubt it has something to do with the software or the operating system. In my opinion, that this looks like a hardware problem, because the battery will be always charged if AC/DC adapter is plugged in. That's why it of not necessary to enable this setting in the configuration of the software.

    If your BIOS is already updated, contact an authorized service provider. Technicians can check your laptop and maybe the motherboard needs to be replaced.

  • Want to fire green W701 fingerprint reader when the laptop is turned off

    I realize the amount of electricity it uses is trivial, but unfortunately the accusation that carries the battery isn't much else. For the most part it's just because I don't have a use for the fingerprint reader. I completely uninstalled the software from the control panel. I thought that would get the light, but the "light on" survived the uninstaller not so complete.

    I hope that there is a way to do it in the bios. If necessary I could re-download the software of fingerprint and do a from there, if possible.

    It is possible to do anyway, please let me know. It's a minor thing, but I'm pretty annoyed that I'd make a sort.

    When you turn on the computer (off-state), press F1 when you see the Lenovo logo (until the BONES start to load). "I think that you should find the fingerprints under security settings). It shouldn't be too hard to find.

    Edit: Looks like that I don't remember it correctly. In the BIOS, you have the option to completely disable the fingerprint reader, but you do not have the option to turn off the green light only without disabling the fingerprint reader. If you want to disable the fingerprint reader completely turn off the computer, then turn on and press F1 when you see the Thinkpad logo (prior to the OS). When you enter BIOS click protection on the menu, and then select access to the Port of IO. In this list, you should have the ability to disable the fingerprint reader that I am sure that will also disable the go-ahead since the sensor is no longer in use. Press F10 to save and exit from BIOS.

    To remove the green light only, or disable the option to turn on your computer by sliding the finger without completely disabling the fingerprint reader, in my view, you must reinstall the fingerprint reader software. Then, you must open the application after installation and type your password or by the finger scan enter enter parameters. Then click the settings button in the toolbar and you should have several tabs where you can turn off the green light or disable the use of fingerprint predesktop authentication.

    -gan

  • calendar-clock does not retain the exact time when the computer is turned off

    original title: calendar-clock

    Clock only works when the computer is turned on.  It does not update the time.

    date does not update also. It is a program in windows vista.

    The year stay as the exact year, or back to a previous year, after restarting the computer?

    If the above applies:

    You probably have a failed in your motherboard CMOS battery.

    It's a battery power supply NET, size piece that keeps your system settings when your computer is off.

    They cost about $5 to replace.

    http://www.computerhope.com/issues/ch000239.htm

    How to replace the CMOS battery in the above link info.

    See you soon.

    Mick Murphy - Microsoft partner

  • iBook randomly started playing when the phone is turned off

    Just noticed this with the upgrade to iOS9. The phone is off (i.e., black screen, but still able to receive phone calls or be activated with PW or digital), and iBooks starts reading my audio book. We then see the iBook controls in the lock screen. No one touched the iPhone 6.

    Does anyone else have this problem? Suggestions to prevent it from happening would be greatly appreciated. Thank you.

    Maybe it's not a specific question of iBook. My iPhone is not actively running - sometimes even just sitting on a table across the room to anyone - lights sometimes at random a random application without apparent reason. (This is especially awkward when he phones random random contacts!) Or, as you say, starts playing audio.)

    I don't know what causes it, and I didn't notice all the reasons for this behavior. I think if the phone was turned off in fact he wouldn't do this, but that sort of impact at the point of having a phone in the first place.

  • Task failed when the computer is turned off

    In the computer I use at the office, I need to create a task in Task Scheduler to run every month on the first Monday of each month. And everything works fine, except when that day's holiday. The computer is turned off during the weekend and holidays.
    If this occurs. How can I force this task runs next time I turn on the computer?

    In the computer I use at the office, I need to create a task in Task Scheduler to run every month on the first Monday of each month. And everything works fine, except when that day's holiday. The computer is turned off during the weekend and holidays.
    If this occurs.  How can I force this task runs next time I turn on the computer?

    You're overthinking this problem.  Simply configure tasks planned to inform you of missed tasks .  If the date of scheduled backup has been a weekend or a holiday with the computer off, the next time you turn on the computer you will get a notification that "some tasks did not run."  At this time, manually start the backup job.

  • Wireless router WRT160N cable on the desk, I loose internet when the laptop is turned off.

    I have wrt160n v2 router wireless, it does not work for me.

    If my wireless XP laptop is only powered ON the Vista desktop internet wired connection works, I'm not wired or wireless using laptop computer, not on the internet, only power.

    If the laptop is turned off, I have no internet on the desktop, always connected via the router.

    The laptop is used and I didn't know if the without built-in thread was pretty new, so I bought a card to go in wireless.

    When everything is on everything is to play on the internet times two computers, but if you turn off the laptop I have to connect internet directly on the Office to continue in the internet.

    I started working with a tech support yesterday and they are difficult to understand. I had put in the new firmware and the problems persist.

    Can someone help me, I don't really have time to be on the phone for hours figure this all out.

    Thank you

    Jackie

    go to http://audipages.com/router/ and follow the instructions

  • Nursery application. ScheduleApplication, when the phone is turned off.

    Hi all

    My question is,

    Application Manger.schedule Application (Desciptor, time, true), starts the application on time, but if the phone is turned off during this planning period, the application is not laucnh when I turn on the phone after a calendar time.

    is it possible that I can do this? I have a CLDC application.

    with midlet, I can use the registry to push but not in CLDC application

    Y at - it any other way to set the application to autolauch at a specified time.

    Any help will be appreciated.

    Thank you

    Anne Laure

    Hello

    AppManager.scheduleApplication (Descrptor, time, true);

    There is no other solution for this if the phone is turned off at the scheduled time, until and unless that it point to another entry.

    I will close this thread. mark resolved.

    Thank you

    Anne Laure

  • Battery will be charged only when the Satellite P10 is off

    Hello

    I have problems with my laptop. Although turned off, the battery charge. Switching on, the battery stops to load and the battery runs out after some time.

    where is the problem?

    Thank you

    Konstantin

    Hello

    To me, it looks like either a power supply electronic malfunction on the motherboard or battery failure.
    Both are possible, but I n t think you will be able to know the malfunction yourself without any extra help.
    Therefore, I recommend the Toshiba service partner in your country requesting an audit of the laptop.

    You know, guys are experts and know exactly what needs to be checked.

Maybe you are looking for

  • Want 7640: scan to email

    I have a new fancy 7640 all-in-one that I cannot receive emails of scans made from the electronic mailbox "button", or by opening a new e-mail message and adding the scan as an attachment.  Initially he used to take a few hours for the email to appea

  • PDF, COPY AND PASTE FILES

    A Treasurer, I send monthly reports and statements my Secretary into the monthly minutes. He told me that when sent in PDF format, although it can download and open it can then transfer the minutes ("you can't copy and paste the content of PDF files"

  • HP 2000: Hp 2000 - 2d10nr does not start

    Then I fell asleep with my computer on last night and it was not plugged in. I woke up this morning and he was dead. I have plugged and waited about an hour and tried to turn it on but it wouldn't turn. I then let him sit and for about 4 more hours a

  • Windows 2008 Server Installer is not detect RAID5

    Hey everybody, So I tried to install Windows Server 2008 (not R2) on a Dell PowerEdge 2650 spare part, but when you are prompted to choose an installation location that nothing shows, at the bottom of the window, it is said "no hard disk found. "Clic

  • DETECCIÓN tarjeta sd

    MI COMPAQ presario no mi tarjeta sd detecta. Gracias.