Z400: HP Z400 front USB 2.0 port upgrading?

Similar Questions

• Can I replace front usb 2.0 ports with 3.0 - if so how?

  I have a HP p6653w 64-bit with Windows 7 which currently has 2 usb 2.0 ports at the front.  I want to replace it with usb 3.0 ports but I don't know if I can or the steps to do if I can?  HP support told me to use Buffalo USB 3.0 PCI Express Interface Card for the replacement of back, but I have a drive hard toshiba laptop which has a cord usb very short, so I prefer to Exchange just in front.  Thank you.

  Hello

  All standard pins on the USB ports are the same.

  Kind regards.

• USB 2.0 ports on the front of the Inspiron 660

  The two front USB (2.0) ports of computer object will accept only USB cables. Must use the rear ports. Not all ports accept the USB cable?

  oldshaw

  The two front USB (2.0) ports of computer object will accept only USB cables. Must use the rear ports. Not all ports should accept the USB cable?

  oldshaw

  Yes, the front USB ports must accept all the USB Type A connectors.

  http://pcsupport.about.com/od/termsu/a/USB-type-a.htm

  Bev.

• HP a6554f: Front USB Ports not working for a6554f

  Hi, I cleaned the dust from my computer yesterday for the first time because the computer kept crashing. I removed the motherboard, so I unplugged everything that was clinging to her and I also removed the hard drive then plugged everything once I had finished, (do not know if I just plugged in as it was, even if I took a video of it, but the wasen can't good quality so I had to guess a little). I also added thermal compound to the cpu.

  Anyway, everyhting seems to work except the 2 usb ports front of the case. It was working fine until I opened the case (this is why I do not open the computers, but the dust was just too). The audio ports and microphone located in the front work correctly. And the rear USB ports are working properly.

  What I've done so far is running pilot Booster and also I went to Device Manager > USB Bus controllers, then I turned off everything on the list, then allowed them again. And nothing has worked.

  I don't know much about computers so I don't want to go to the hassle of opening the case cause once again I was scared lol but could I maybe hooked up a cable in the port of fake?

  Also, is there a diagram to show where each cable goes to the a6554f model?

  As you pointed out the audio before and MIC ports are working, then it might be just the plug for the ports before USB is not properly or is in the wrong place.  Here is a page that relates to the motherboard. In the lower right corner of the image or the page layout scheme, there are two blocks header before normally taken into USB ports.  Says F_USB1 and F_USB2.  Either we must work to the front ports.  Check to make sure that the wiring box beam (which has the wires going to the front USB ports) is connected on one of them.

• HP Pavilion P7 - 1037c: my HP Pavilion desktop computer has been moved and I can't find the front USB ports. How can I find them?

  My computer has been moved to my new apartment and set up my movers for me.  I used to see some front USB ports at the bottom of the front panel, but now I can't.  Is there something I need to do?  I really need those!

  Slide the cover down. Look at this picture.

  

  Good day!

• I have a Photosmart 3210 - Can I use the front USB port instead of port back? (back is broken).

  Hello!  Trying to help a friend.  Rear USB port no longer his plug slips outside, no electrical connection.  Tearing in the unit for her brief submeter (out of warranty, nothing to lose).  Can I use an adapter with a standard USB plug on each end to connect to a PC for printing?  The user manual is too vague on this - looks like front USB is just for PictBridge stuff.  Any suggestions/ideas will be greatly appreciated.

  Thank you

  kott2ke

  Hello kott2ke,

  Front USB port: print photos directly from your camera or storage only.

  Rear USB port provides connectivity for printer and USB.

  Kind regards
  Jabzi

  Help the community by marking this post.
  Your question has been answered? Mark it as a accepted Solution!
  See a great post? Give it a Bravo!
  I work for HP

• HPE 500f broken Front USB Ports. Need hardware

  I broke all my front USB ports. Does anyone know where to find replacemnts? I can't find parts in the manual or on the website of HP.

  Thank you.

  HPPartSurfer lists the USB port double room like 517181-001. See here.  Used for sale

• front usb ports are unable to detect the large capacity external hard drive (250 GB)

  Hello
  I have 250 GB external hard drive, whenever I connect to my front usb ports it detected, but pen drives, are to detect flash drives, one of my friends said that you need to update my bios & I here is the motherboard.

  motherboard: Mercury 945gcm

  It is possible that the USB 1.1 and not 2.0 ports that can explain the problem.  In addition, sometimes USB ports out enough power to run an external device that is not powered separatelly.  I don't know if updating the BIOS will help, but if there is an update available for your system (and it MUST be for your system - big bad can occur if you install the wrong BIOS so get with the computer manufacturer, and speak to a representative to confirm that they are appropriate for your system AND your version of Vista) then by all means install it and see if that solves the problem.  You can also get the updated drivers for the motherboard manufacturer, at the same time and see if that helps as well.

  I hope this helps.

  Good luck!

  Lorien - MCSA/MCSE/network + / has + - if this post solves your problem, please click the 'Mark as answer' or 'Useful' button at the top of this message. Marking a post as answer, or relatively useful, you help others find the answer more quickly.

• p6610f front usb ports not working not

  I just noticed that my 2 front usb ports do not work. I had recently opened it to add RAM and swap the optical drive. Could I have hit a loose cable or something?

  TIA!

  Hey vkh3203,

  I'm sorry that you run on this issue with your USB ports.

  Check the connections on the ports indicated in the image below. It would be best to go and resettlement.

  

  Taken from this link

• What is the difference between the rear USB ports and front USB ports?

  Why some USB equipment only works with the USB on a computer BACK and not the FRONT USB port?

  USB ports on the rear panel carry more voltage (voltage not exceeding) the USB headers on the front...

• Front USB Ports suddenly inoperative

  I installed an SSD as drive 0 and moved the former player to Player 1. In doing so, I can have disconnected something because now my front USB ports are dead.

  Can someone tell me what controls the front USB ports or where I can get a diagram of the motherboard for the 8700-1262 XPS?

  Thank you.

  It is located in the owner's manual on the link below, download it and go to page 13 0f the PDF document

  www.Dell.com/.../manuals

• My two front USB on the front slots do not work. How to decide what could be the problem? Thank you

  My two front USB slots don't work. How to decide what could be the problem? The machine is a HP Pavilion p6516f-b. Thank you

  try to uninstall the drivers (usb root hub) from Device Manager, restart the pc if you see little red or yellow circles can mean the mistake with the equipment. see if the keyboard works in ports

• Q180 USB 3.0 Ports

  Hello

  I bought a Q180 IdeaCentre and have not been able to find out which connectors are USB3.0 ports.

  Thanks in advance.

  Caesar

  Hey cromero411,

  Welcome to the forums.

  from what I've read in the datasheet for the Q180: http://www.lenovo.com/shop/americas/content/pdf/system_data/q180_tech_specs.pdf

  the front two USB 3.0 ports are

• USB 3.0 port locations

  Continue to see "by moving your device to a USB 3.0 port, you can get faster speeds. Where they are on my desktop 500 - 205t? I have 4 ports on the back, two in the front and none are labeled.

  Hello

  If the port has a blue separator it is USB 3.0.  Rear ports can be found here.

  Strangely enough, HP has black separators in the two front USB ports yet they are labeled SS (super speed) which should be USB 3.0

• HPE-210F dead USB 2.0 port AV - where to plug them in?

  My newest HPE-210F has a USB 2.0 on the front, and he died. I opened the case, and of course, the connector it is not connected to the motherboard. I want to know where to plug the connector on the motherboard. I can attach a photo of the MB, if necessary, but I suspect it's an easy question. On a related note, there are three small openings in the metal cage where the USB port on the front is pressed. Are enough spots on the MB to plug in a few extra USB 2.0 ports? I wonder if HP sells ports ready to fit in the cage or if it is a standard of the industry and I could get them elsewhere?

  TIA!

  Pick up and empty the USB socket and plug the connector.  This motherbaord is used for different configurations of the firm.  Pocket USB and media drive bays would also use the empty USB Sockets.