Cisco NAC does support Wireless LAN?

Similar Questions

• Cisco NAC offers Support

  Hello

  I have some question about Cisco NAC and don't know if it is able to support:

  1. can you packets qos to NAC honor/confidence when it is configured for inband/off band?

  2. for the creation of the lobby admin on local accounts management comments (using the own access device); cisco nac appliance does support

  the lobby admin via acs/external db authentication? If this isn't the case, adding a comment server would reach it?

  3 - is not cisco NAC appliance support wireless controller and the mixture of cisco/non-cisco switches? If so, if the switch supports snmp mib mac-notification/link/link down; would this be enough?

  4 is Cisco NAC comes with a predefined set of rules AV to verify that all AV support is running for the posture check (example if NAC supports 100 produced different viruses; can he check all 100 different product that can be installed on a PC for control of posture). An example of this would be hotel / that there are people of different products installed antivirus trying to access the network and the antivirus must run and installed and updated to access network). I know that the pre-confgiured default rule can check for installation/setting however not sure on the status of service / application running.

  Thank you.

  Hello

  For VGW configurations, you must have in separate subnets. For RIP, they can be in the same subnet without problem.

  HTH,

  Faisal

  --

  If you find this article useful, please note so that others can easily find the answer

• does support wireless dual band (2.4 GHz and 5 GHz) in the hp probook 450 - g2

  Model: Hp Probook 450 - G2

  Please confirm the support of platinum rating book Wi - Fi the below mentioned criteria?

  • A Wi - Fi connection must support dual band (2.4 GHz and 5 GHz)
  • Support 802. 11A, 11b, 11 g, and 11n IEEE standard
  • It must have the ability to set roaming aggressiveness
  • It should support WMM (Wireless multimedia)
  • He must have a configurable protection as RTS/CTS mechanism

  Hello

  Yes and no, can't confirm because hp probook 450 - G2 may have many options. See the following list:

  http://h20195.www2.HP.com/v2/GetPDF.aspx/c04336794.PDF

  Kind regards.

• My 3000 N200 does support Wireless-N

  Dear all,

  First of all, my apologies if this question has been asked before, I have search the Forum but did not find what I needed. Please do not point to a previous post if you are aware of a response.

  My 300 of Lenovo N200 (0769) is very difficult to connect to my home network. In fact, whenever it comes to suspend I struggle to pick up on the network. I have updated the drivers for the card and verified that Windows XP is unable to fund the card to save energy, but I still struggle with it. So I was thinking to replace my router with a Wireless N one. I was wondering if the forum members were aware that my Lenovo would support a Wireless N card and if so, could anyone recommend a card please?

  Thank you for taking the time to read my post.

  Kind regards

  Johnny.

  
  

• iPhone 7, supports Wireless charging?

  I've been waiting for a true wireless phone, the iPhone version 7 does support wireless?

  There was no mention of wireless for iPhone charging in the Press Conference today and there is no mention in the tech specs, so I would say that the answer is no.

• Cisco NAC device filtering question

  Cisco NAC provides support for devices such as printers, IP phones, UPS failure, etc. by adding them to a list of filters.

  This allows these devices to bypass basically the NAC system and is only available on the network.

  My question is this. If exempt us these devices of the NAC evaluation, where is the security? What prevents a person to set the MAC address of the printer using a laptop?

  I can't imagine on this subject has not been raised before, but I can't seem to find an answer.

  Thanks in advance for your answer!

  Tom

  Well Yes, it was a big critical with the NAC device out of the box. There is no way to prevent the usurpation of MAC. Cisco has another device called parser SNAC, that solves this problem, but it costs extra.

  http://www.Cisco.com/en/us/prod/collateral/vpndevc/ps5707/ps8418/ps6128/product_data_sheet0900aecd806b7d4e.html

• Satellite A210-ST0 - wireless LAN driver does not work

  I recently reformatted my laptop with windows XP, and I have all the drivers working except the wireless Lan driver.
  I got the driver from the toshiba page and this is the XP driver. I install it, but the computer still does not recognize that the map has a pilot (appears as a question mark in the Device Manager) does anyone else have this problem? is there another place to get the driver?

  PS: I'm pretty good with computers, I just need the driver file and can installed with on an EXE file

  Hmm

  What page of the driver Toshiba did you use for the download of the driver?

  As I m not wrong not the * Satellite A210 - ST0 PSAFGC * is a Canadian series and therefore, it would be desirable to use the Canadian page for the download of the driver!

  Check this box:
  http://support.Toshiba.ca/support/download/ln_byModel.asp

  The WLan card chip could come from Realtek or Atheros.

  Last but not least, you should check your BIOS version. If the latest version is available on the Canadian page and then try to update!

  Good luck

• aco27TX: Wireless LAN Driver does not work

  Hello

  I tried to install wireless LAN Driv er for winodws 8. Cant able to install and use the LAN driver wireless for windows 8

  Hi @nagaxking,

  Thank you for visiting the HP Forums! A place where you can find solutions for your problems, with the help of the community!
  
  I stumbled upon your post on the laptop and wanted to help you! I looked into your problem on your computer laptop 15-ac027tx HP and your wireless adapter does not.  Here is a link to fix the wireless.

  Here is a link to the HP Support Assistant, if you need it. Simply download and run the application and it will help with the software and drivers on your system that may need updating. It has a built-in right troubleshooting wireless network.

  Please let me know how it goes.
  
  Thank you.

• HP support assistant - update card Ralink 802.11n Wireless LAN April 23, 2014

  My HP computer:

  Product name: p6 - 2220t

  Product number: B3F79AV #ABA

  My Ralink 802.11n Wireless LAN card:

  oem230.INF:RALink.NTAMD64.6.1:NDIS61_RT3900E_C1. NDI:5.0.9.0ci\ven_1814 & dev_5390 & subsys_f0511814

  My OS:

  Windows 7 64-bit sp1

  The current version of the driver on my wireless LAN card Ralink is 5.0.9.0.  HPSA now tells me that there is a version 5.0.33.1Ap1 update.

  Last AS HPSA said that there is an update, it was bad and created problems. See http://h30434.www3.hp.com/t5/Desktop-Operating-Systems-Software-Recovery/HP-Support-Asistant-Ralink-...

  Does anyone know if HPSA sends the correct update this time?  I would like to learn more about this until I followed the recommendation to download and install it.  Must what problems/bugs or security issues correct?

  Thank you for your time and your help.

  Hi mpw101,

  I understand that you get an automatic update that indicates that you must install the software driver for your Ralink Wireless LAN card, and I would be happy to help you!

  For your computer, the most up-to-date Ralink Wireless Network Controller Driver is labeled sp58084.exe. I spoke with Dunidar on this subject, and he referred me to a previous post that you created on your network card. That being said, if you update is always at the SP62055.exe, please ignore this update as it is a business unit.

  I hope this helps!

  Concerning

• Cisco NAC appliance - after a success does not change users to connect to the vlan propper

  Hello

  I am new to cisco NAC BURNERS and I have to troubleshoot an implementation. It is a real OOB IP gateway configuration. Users can connect to the Pentecost the CCA, but after the connection of this success, they remain on the role not authenticated, as well as on this vlan. I checked the SNMP protocol and seems to work very well. Also, I checked the logs on nac_manager.log and there is nothing surprising, in fact I see nothing about this user or IP address that connects.

  Also the user does not appear on the list of users online on cam.

  Can someone help me figure out how can I fix? version 4.8, I'll post any information requested

  Thank you

  We recently had the problem with Windows AD SSO and Windows 7 clients.

  Would authenticate the XP clients very well, however, Windows 7 clients would not authenticate and will remain just on the authenticated vlan.

  Our question was looking for CASE SSO account, we installed on AD. It only support the encryption, WHICH has no Windows 7 64. We turned off "Use OF THE encryption" on the account authentication UNIQUE AD and re-tested.

  What are the parameters of the port-profile to which is applied the switchport?

  What is the map settings vlan ports trunk not approved or confidence?

• 8 or 16 wireless LANs supported

  OK, I've looked everywhere and I can't seem to find the answer.  I know that the WLCs supports up to 16 wireless LANs, but I could have sworn that I see only 8 could be active at the same time.  We had a combination of WISN WLC 4400 and WLC 2100 s in our environment.  The only places wer you're going to need more than 8 is in our stores WISN and WLC 4400.

  Any help is appreciated (accompanied by supporting documents if you have one).

  Thank you all!

  Ryan

  I don't have the docs in front of me, but I know that the 6.0 code supports more than 8 (I think 16), given that we currently have 10 local wireless networks deployed during our migration. -John

  Edit: Found this in the WLC 6.0 configuration guide:

  All controllers to publish up to 16 local to each connected access point wireless networks, but

  You can create up to 512 wireless LANs and then selectively publish these wireless LANs (using access point groups)

  at various points of access in order to better manage your wireless network.

  And this from the 4.2 guide:

  The Solution of UWN Cisco can control up to 16 for light access points wireless LANs. At each WLAN

  an ID separated from WLAN (1 to 16), a separate WLAN SSID (WLAN name) and can be assigned unique

  security policies.

  Post edited by: [email protected] / * /

• Are Cisco 1130ag APs compatible with Cisco Wireless LAN Controller virtual?

  Are Cisco 1130ag APs compatible with Cisco Wireless LAN Controller virtual?

  It's... AP compatibility depends on the code that runs on the WLC. This is a matrix that is a good reference.

  http://www.Cisco.com/en/us/docs/wireless/controller/5500/tech_notes/wire...

  Sent by Cisco Support technique iPhone App

• HP J6450 really does support WPA Wireless encryption?

  I just bought a new J6450 yesterday, and when I tried to install it as a wireless network my SSID does not appear (even if the PC just next to the printer is connected to my network).  Even when you enter the SSID manually the installation process does not recognize it. There are other SSID in the region that appear during the installation.  I confirmed that my router is broadcasting and the printer was 4 feet from the router, so I know that is not due to the intensity of the signal.

  Details of router - NetGear WPN824v3, configured for either 802. 11B or 802.11 g (auto mode), WPA encryption

  The only thing I noticed during my research it tonight is the SSID that was listed when installing 2 are encrypted and most of the HP support info and documentation related to the wireless configuration seems to refer essentially to WEP.  If the HP J6450 really does support the WPA encryption, and if so, does anyone have ideas for troubleshooting why it does not recognize my router?

  Thank you.

  Connection to the router under the admin user, then "Wireless settings" page is a Mode setting and the default value is "Auto 108 Mbps.  Using the arrow in the drop-down menu, change to "b and g" then set the channel to 'Auto' and save the configuration changes.

• Satellite U500 - 11G - wireless LAN does not work

  Please could some help me because I have a problem with the Realtek RTL8191SE Wireless LAN 802.11n PCI-E NIC

  Whenever I turn on my laptop in the seem to do not to work. You put the laptop restarting and it works I tried to talk to the pc world, where I had the laptop but I seem to be hitting a brick wall with them.

  I had some other Toshiba laptops and never had this problem. I also will not download the date is

  Sometimes every reboot of the router can help. ;)

  Can you detect some other router in your area?
  Do not forget that the same protocol is enabled on the router and laptop.
  Often the small error in the WLAN settings is responsible for connecting Wireless does not.

• Cisco Wireless Lan Controller 2504

  Hello:

  Hello; I lost the password to my wireless LAN controller. Everything was fine until a few days ago and now can not identify.
  Is it possible to recover. The model of controller is AIR-CAP2602E-A-K9, the software version is 7.4.110.0.

  Please, anyone, help me.

  Kind regards.

  Fernando.

  Check this box:

  http://www.my80211.com/Cisco-WLC-CLI-commands/2009/12/27/recover-your-WL...

  Concerning

  Remember messages useful rates