corners of screen fading white

Similar Questions

• (Redirected) Latitude E5540 flickering screen turns white of greysih and turns off

  I have a Latitiude E5540 refurbished which are recently out of warranty. While using it last night, my screen started flashing, the colors changed, the text seemed blurry and multicolored (almost like double vision) and the screen faded to white greyish and is now white. I turned it off, tried to reconnect, but the screen was still a grayish-white.  It was the first timme anything like this has happened.

  To operate normally once again I had to unplug the power supply, remove the battery and press the power button to discharge the laptop. When I installed the battery and plugged to the power source, I could connect normally and use it without incident for a while but the same problem happened again and I have to go through the same process to make it work again.

  Since yesterday, whenever I use it, the same problem occurs.

  Can someone help or give me help with this question

  Hi Lijepu,

  Please repost this in the Hardware Forum general computer laptop for help.

  http://en.community.Dell.com/support-forums/laptop/f/3518

• P2412H - displayed briefly and then the screen turns white.

  Hello

  I got a pair of monitors of P2412H little more 3 years, bought from a dealer - I don't have tags and monitors say manufactured in September 2011 (so I think that, apart from any warranty).

  This morning one of them has failed - it displays briefly, then the screen turns white.

  Manual test:

  1 unplugged every wire and power button which is held for 15 seconds.

  2 reconnect the power cord.

  -Switch will blue

  -L' initial Dell boot screen is displayed on the screen for less than a second.

  -L the screen turns white.

  -Stays blue power button

  3. press one of the control buttons

  -Nothing happens

  4. disconnect the monitor

  5. connect the monitor to on PC with Windows connected using DVI.

  6. connect the power cord

  -Switch will blue

  -L' initial Dell boot screen is displayed on the screen for less than a second.

  -L the screen turns white.

  -Stays blue power button

  I also tried to reset the monitor according to the instructions of the manual by pressing keys 1 and 4, but as the monitor does not appear, I couldn't see anything.

  The monitor did briefly revived properly after one of my attempts back manually, but the after turning on and the new to check if the problem itself had set the monitor returned to the not displaying no not again.

  Can anyone help or point me in the right direction on how to fix it?

  Thank you

  * UPDATE *.

  Disassembled the monitor I've used this as a guide to youtube to open the monitor the safely:

  cs_setInnerHtml ('video_aebd897a-01ed-42eb-a8c5-b3b6ecee6556', ");

  Inspect the circuits printed for all the obvious problems such as cracked soldering or fried capacitors.

  Could not see the obvious problems... you realign a couple of back vertical capacitors where some of them were in sharp corners appeared to be very close together as a result.

  Back together carefully.

  Backwards and now it works very well for 48 hours.

• MacBook Pro screen turned white rose areas

  I use a Macbook 2009 end Pro 15 ", 4 GB of ram, 2.8 GHz Intel Core 2 Duo. Everything is fully updated. Yesterday, I started getting intermittent flashes of rose on the white areas of the screen. Affected programs were Pages (old and new versions), Safari, Mail, numbers and Quickverse. I have tried a reboot and everything seemed fine, but he reappeared briefly to the waking from sleep.

  Today the same programmes on each screen, including white ares of my desktop image. I can read the material, but it's distracting. The best way I can describe the pink areas are thin vertical lines as fabric. The area directly below the words is mainly white.

  I searched the forums and tried to reset the Pram and go through all the steps for the MSC. I started using the safe, but the rose remained. I ran the disc with no found error utilities. I tried to run the apple hardware test, but nothing happened. [The instructions said close then turn on by holding down the button D. I tried 3 times, but the icon never appeared].

  I also tried 8 Tech tool for video and nothing was found.

  The Apple store nearest is 3 hours away if I'd rather solve this problem without going there.

  The Apple store nearest is 3 hours away if I'd rather solve this problem without going there.

  You did all the good troubleshooting-

  You have a hardware problem.

  GPU, cable, cable connection, LCD or LED

  In or out of warranty you can get for free a 'Apple Service Diagnostics' OTC test and ask specifically for the VST (video systems Test)

  Genius of booking http://www.apple.com/retail/geniusbar/

  Online https://getsupport.apple.com/GetproductgroupList.action

  check the warranty https://selfsolve.apple.com/agreementWarrantyDynamic.do

• Why screen going white for an update

  During the two or three updates to ElCaptain once the Mac has rebooted the screen turns white for a while and then the apple logo appears and the update happens fairly well after that. However, during the white screen, it is unclear whether the computer has crashed, hung or what. I think it would be nice to have a message as the download, installation, or whatever place right there, so we don't have to panic something went wrong!

  It is part of the start-up procedure and the installation process, it may be for a number of different reasons, but in almost all cases it is the normal operation of the computer.

  You can suggest Apple using this link, they provide clarification on the screen during the boot process.

  Apple.com/Feedback

• Re: NB200 - making noise and the screen turns white

  Hello

  My laptop makes the high pitched noise and the screen turns white. Please help with this question.

  Thank you

  Hello

  It is especially as this problem with the inverter. She is, die, and made a noise of pitch. Try to connect the external monitor and check if it is displayed.

  Welcome them

• HP Jet 7: Black screen with white lines on the HP 7 stream

  I bought my HP 7 stream about 2 years ago and I'm now a black screen with white lines whenever I turn on the tablet.

  Can you kindly help.

  If that's what you see immediately when you turn on, the graphics have not to the Board of Directors.

  These tablets were dropped after the first year of release, and it would not be worth the cost if it could be repaired.

  I'm sorry.

• Satellite L300 PSLBGE screen turns white after a while.

  I * model Toshiba Satellite L300 PSLBGE * and I have never seen this problem before.
  I use my laptop since last year in fact my laptop screen turns white after spending some time on it, usually after 10-15 minutes...

  sound also stop here and the only solution is to reboot, after that reboot it still works well, but after a while once again its screen turns white.

  Please help for this problem

  Post edited by: bharatjaiswal5

  Hmm have you tried to reinstall / recover the laptop to see if it helps to solve this problem?
  In my opinion you should try it because it could be a problem in the system.

  Otherwise if new system installation / restore does not help you, it could be a malfunction of the equipment.

• Why the Satellite L300 laptop screen stays white?

  Why the Satellite L300 laptop screen stays white?

  Hello, I have a Toshiba Satellite L300-29U over purchase, turn when he was first an hour about it looks a whole without problems, then the screen was blank. Feed again in a couple of times more hours after rest and passes him still takes some time to operate.

  What is your recommendation?

  Thank you for your response.

  Post edited by: Sams

  Hello

  Why?
  Who knows what have you that your screen is white?
  My screen is not white it shows everything correctly.

  The same white screen will appear on the external monitor?
  If so, then this problem may be related to faulty graphics card, if no, your laptop computer s display can be defective

• When I turn on my emachine and try to check my e-mail, I get my homepage to google for about 1 second and then the screen turns white with bee.pl.

  HELP me get my E mail.

  When I turn on my emachine and try to check my e-mail, I get my homepage to google for about 1 second and then the screen turns white with bee.pl.

  http://INFOTEP.bee.pl/info.php?avted=;     I'm not that day on computers, and many of their functions and a few times I get a little lost in there so if anyone can help me I really appreciate it.    Thank you!!!

  Hello

  1. what operating system do you use?

  2. What mail client do you use?

  3. you have made any changes to your

  4. what site you're talking about?

  5. How do you access the webpage?

  6. you use Internet explorer or another browser to access the site?

  The link give http://infotep.bee.pl/info.php?avted takes me to a blank Web page

  Are you referring to http://www.bee.pl/index

  Refer to the following, who says that the sites host malware

  http://www.Google.com/SafeBrowsing/diagnostic?site=monidopo.bee.pl/

• 11 - e010nr after the signature on the photo and a few icons appear and then the screen turns white and reappears

  Laptop TouchSmart 11, e010nr 11, windows 8, no error message. I can Ctrl/alt/del and obtain the lock... the Task Manager screen. This screen works but nothing else

  Hi danny61,

  Just to clarify , when your screen turns white and reappears, the icons reappear also? and do you not see that set the desktop background or the taskbar? that it could be as simple as restarting the Explorer process in the Task Manager.

  If you can update me if I can see how I can help

• After you download incredimail, my screen goes white, says done, and I have to hit Ctrl-alt-delete.

  My laptop screen become white

  After you download incredimail, my screen goes white, says done, and I have to hit Ctrl-alt-delete. I removed incredimail and it still happens. It seems to be deteriorating

  Hi karlenechapman,

  ·         What version of the operating system is installed on the computer?

  Follow these methods.

  Method 1: Follow these steps:

  Step 1: Start the computer in safe mode and check if the problem persists.

  Start your computer in safe mode

  http://Windows.Microsoft.com/en-us/Windows7/start-your-computer-in-safe-mode

  Step 2: If the problem does not persist in safe mode, perform a clean boot to see if there is a software conflict as the clean boot helps eliminate software conflicts.

  Note: After completing the steps in the clean boot troubleshooting, follow the link step 7 to return the computer to a Normal startupmode.

  Method 2: Update the graphics/display drivers.

  Updated a hardware driver that is not working properly

  http://Windows.Microsoft.com/en-us/Windows7/update-a-driver-for-hardware-that-isn ' t-work correctly

• Why desktop screen display upwards on the left side of the monitor screen and white is on the right; Properties show nomal.

  Why desktop screen display upwards on the left side of the monitor screen and white is on the right?  When I do my office they show nomal properties.  Everything seems to be normal.  Thank you

  Hi Sdaugherty3,

  Follow the methods below:

  Method 1: Try to change the resolution of the screen and check the results.

   

  To change your screen resolution

  http://www.Microsoft.com/resources/documentation/Windows/XP/all/proddocs/en-us/display_change_screen_resolution.mspx?mfr=true

  Method 2: If the method above is not enough, you can see the article in the Microsoft Knowledge Base and check.

   

  Resources for troubleshooting problems in Windows XP

  http://support.Microsoft.com/kb/307960

  I hope this helps.

• My laptop computer screen flashes a few times (very rarely) and after some time screen goes white

  I use compaq V6000 computer laptop with windows xp. My laptop computer screen flashes a few times (very rarely) and after some time screen goes white, I hear only audio. After the reboot, it works normally for hours. I used to know the reason for this and the solution.

  Hello

  1 how long have you been faced with this problem?
  2. don't you make changes on the computer before this problem?

  Read the following article that may help you resolve this problem.

  Resources for troubleshooting problems in Windows XP
  http://support.Microsoft.com/kb/307960
  Glitter wallpaper
  http://support.Microsoft.com/kb/555373

• When trying to view videos full screen, the screen turns white!

  When I try to watch videos, I love to watch full-screen, but when I press the icon full screen the screen turns white. I have to press the ESC key to return to normal. What will fix this?

  i right click on video > select settings > remove the check mark from material

  Acceleration.
   
  II] download and install: -.
  Adobe flash player: -.
  http://www.Adobe.com/products/flashplayer/
   
  III] update your graphics card driver on the website of the manufacturer of the graphics card.