Equium issue of power

Similar Questions

• Equium P300 - broken power supply

  Last summer, I bought the laptop above.
  He was in to be repaired twice for the same issue - broken power supply.
  Today the issue happened again so once more, end up with a useless laptop.

  I am so in anger that my computer is either defective or it is not be repaired correctly.

  Anyone know if this is a common problem?

  Broken power supply-> do you mean the power adapter or the power plug?

  However, I doubt that this is a common problem
  I think that it s simply no chance or maybe the technician has done something wrong, who knows.

  In your case it s highly recommended to contact the ASP guys again (which replaced this part in the past) and to clarify this issue

  Good luck

• Equium P300-190 power - free problem

  Hi all

  This is my first post here/first Toshiba number after owning my laptop for about 4 years!

  I have a big problem with my Equium p300-190, with a Li-ion battery.

  This morning, there seems to be a problem with my diet. The connection of the charger would change quickly load and then do not load per second or more.

  This continued all day until the computer turns off suddenly.
  Now even when the charger is connected, the lights on the front of the computer not able to save it as a laptop.

  Initially, I thought it was a charger problem, but the computer turns off when the power of 43%. I was wondering if someone can help me to determine if it is a battery problem or a problem of motherboard, as well as the suggested courses of action.

  Any help is really appreciated!

  > Now even when the charger is connected, the lights on the front of the computer not able to save it to the loading of the laptop.

  This means that the power LED and AC adapter LED don t light even if the AC adapter is plugged?

  In this case the new, good working AC adapter must be connected to verify if she s AC adapter or mobile phone related problem.

  Just FYI: I n t think that the problem is battery since the laptop should work fine with the AC adapter only. Even if the battery is removed and AC adapter connected, the laptop must turn on

  So either the AC adapter or portable s hardware problem.

• Equium A60 - defective power cable

  The power supply for my laptop began to divide and although I have wrapped in insulating the split tape, it still does more. Annoyingly, the separation is the wire that connects the computer (which is attached to the battery), so I think they're pretty difficult/expensive to purchase.

  Anyone know where I could get a new track that doesn't cost the Earth?

  Thank you very much!

  Hello

  they are not very expensive, this site-> http://www.pcupgrade.co.uk/productdetails.asp?ProductID=3146&categoryid=368 wants only 40 pounds for a such AC, so if you use "Google.com" and type 'Equium A60 Ac adapter', you will get many results on adapters CA / CC for Equium A60... :)

  Good luck

• Equium P300 - 16t power problems

  My laptop Equium P300-16 t has suddenly stopped working. When it is connected, the power icon is always on view, but the battery icon has disappeared, and the battery icon when you press the power button flashes red for a few seconds before disappearing... it means I need a new battery?

  I thought that the computer could work without the battery, if it was still not able to connect to a power supply via the power adapter? I just wanted to check before you buy a new battery, I don't want to spend £50 on something that is unnecessary, especially if I have to buy a new laptop.

  Any help would be appreciated.

  Hello

  I don t think you need a new battery because the laptop should work without the battery only on the AC adapter.
  I guess that this problem is related to the motherboard or components (RAM) on the motherboard.

  Guess what? Try this:
  Disconnect the power adapter and remove the battery.
  Now press the power button / 30 sec long. Connect the two parts, then try to turn on the unit.
  To be honest I m not sure if this would help you but it s worth a try

  If this does not help, delete one of the RAM modules and test the device using a module in each slot, but in the worst case it is a motherboard problem, and this should be verified by a Toshiba ASP

• Equium A60-692-power - laptop gets no power

  Hey

  My Equium A60 - 692 has ceased all powered by the AC adapter (though I measured it and its give a good 19v). I noticed the end of the adapter (the end that goes into the laptop) is different from the normal ones. Rather than having a hole in the center that integrates a pic on the laptop, it's just got a piece of flat metal. Wondering that was normal and the problem is inside your computer laptop or if the latter has somehow broken and is stuck in the adapter. It looks like its supposed to be that way, but it seems a little weird...

  see you soon

  HELLO Rodders,

  I fear bad news. The flat piece of metal that you describe is the rear part of the central axis that broke inside the power jack on your laptop. It is quite a common phenomenon (check some other posts on these forums).

  Unfortunately, the solution to this problem is for your authorized Service partner nearest replace the motherboard (expensive!) unless you can find someone ready to weld in a new socket.

  Sorry to be the bearer of bad news.

  Kind regards

• Docking station issues with power - power of the outdated USB hub

  We get an outdated 'USB hub power' error on my docking station with an E7440 anchored in it.  Worked fine, since I have received the device, but all of a sudden it-error when I try to access any flash drive.  Swapped out with a new one, number the same dock.  Also swapped power adapter, also with no effect.  Any ideas on the problem or resolution?

  Did you by chance install or upgrade of Citrix Receiver recently?  I did and my USB ports no longer works in the docking station.  This link has Details of why:

  blog.wisefaq.com/.../USB-Power-issues-with-Citrix-Receiver

• Equium A60 - 155 Power Supply Problem

  Hey guys,.

  I've had my laptop for several years now, but it was replaced a few times is not so old.
  I have problems with my battery to charge, I thought it was the power adapter that was the problem until I bought a new one and it would not load.

  When I used to plug in the charger it works if the lead was bent at an angle, now it won't work at all... So I think that there is a problem... as with the port it charges through internally.
  If anyone has any help with how to fix this or how it will be cost to fix the help would be appreciated so much!

  In addition, my warranty has run out so this is a no go.
  Thank you, Rebecca.

  Hello Rebecca

  Sorry, but I think that there is nothing that you can do it alone. The laptop needs to be tested with special tools and this should be done by technicians.
  To write something on the price isn't easy because I think that the prices are not the same for each authorized, service provider

  I don't know where you live, but I recommend you check out http://eu.computers.toshiba-europe.com/ > support & downloads > find an ASP. You will find the addresses and phone numbers. Connect with some of them in your country and ask for prices.

  Good luck!

• Equium L40-156 - power cord melted!

  My daughter just called me in a panic that his Toshiba laptop power cord started smoking and melted!
  The laptop is about 2 years old.

  Does anyone else have this problem that I wonder? do you think it is safe to use with just the battery? Don't know what to do about it - any advice would be welcomed!

  Thank you

  I would not use the laptop, the power failure may have damaged components of the laptop.

  You have to send the laptop adapter + cable to a service provider authorized to ensure its all working properly.

• cDAQ-9174 with modules 9225 and 9239 for issue of power measurements...

  Hello to one and all.

  I do turn a cDAQ-9174 with modules 9225 and 9239 to measure the voltage (120, 208-240, 277 VAC) and current (via the clamp amp i400, Fluke - 10mA/exit A) respectively.

  I have the set scale scale Differential No. (1:1 I guess) for 100: 1 for current and voltage.  With the acquisition mode set to "N samples", 10 samples to read, at the rate of 500 m.  This feeds into 'EPM_Power.vi' (polymorphic VI of the palette of EMP... can be downloaded here, http://sine.ni.com/nips/cds/view/p/lang/en/nid/209826)

  I try to check my numbers with an Analyzer of power quality of 435 Fluke and supporting that upward is a Fluke 179 True RMS DMM with clamp amp i200 (for current playback)

  Now, I'm running is my numbers I take data look like they're following a curve of fishing... the averages are on the right, but when my blood pressure is expected to be relatively stable, it's over the map... same story with my current readings.  I tried several different filters without success.  I would like to have relatively stable values for voltage and current so my other values are correct.  Is there a signal conditioner or filter that will help with this?

  As always, a point in the right direction would be greatly appreciated!

  Thank you!

  Chad

  Hi, Will,

  Your request for a screenshot actuall lead me to the solution.  Not enough samples!  I took little data too slowly and only seeing part of the wave of fishing AC each iteration.  .. that became glaring when I tried to this graph.  So I increased my sampling of 100 to 5 Hz and things seem to have settled things down a bit.  Thank you for the good question!

  SH?

  C

• HP Pavilion DV73020SA laptop computer Wont Boot, how can I trouble shoot issues of power?

  Hello...  First time posting here so I hope that it is in the relevant section.

  I have a HP Pavilion DV7 - 3020SA Entertainment Notebook PC

  s/n {removed privacy}

  p/n VL110EA #ABU

  64-bit version of Windows 7 Edition family

  Laptop [2 Yr Old] had only the normal HP and updates windows 7 and work perfectly before its last closure [2 days]. The problem is the following:

  If the power on button is pressed. All the lights flash once. Fan starts then dies of the machine.

  I tried to boot the laptop with or without the battery connected, but the result is the same. I am aware that these machines have overheating problems & have been careful to avoid this by making sure that the laptop are always well ventilated. I had no previous problem.

  It takes about 2 seconds for the closing process to complete, without ever getting the windows logo or offering a chance to access Bios. I think it's a hardware problem.

  I used a multimeter to determine if the power supply HP failed. It seems to work properly at 19.5 volt. I removed the hard drive and checked that its still viable. It seems to work very well. I am a fairly competent user and comfortable disassemble the machine if necessary. Any help would be appreciated. Thnx

  Power output may drop when under a load as load or when the notbook is started and running, or both.

• Equium issues 5-6 sec and then it shuts

  Hello

  I got my laptop for about a year and he began to spoil.
  When I turn it on all that I get it a continuous beep for about 5-6 seconds and then it turns off.

  Anyone know what is wrong with it and how I can fix this problem?

  Thank you

  Hehe... I would be a psychic if I want to know what's wrong with the laptop without checking it first ;)

  I think that no one would be able to tell what's wrong exactly, but most of us can provide suggestions and could assume what s wrong

  For me, this looks a bit like a RAM problem.
  I think that you should first check the modules RAM use only one Ram or if possible, try to start Notepad with new Rams who work for you

  Good luck

• Acer Aspire 7750 G power supply Issue

  Hello

  I have a recurring problem with my Apire 7750 G - while the laptop is turned on and the charger is connected, the battery charge for 5 minutes and then both the power light and seeing the flashing battery and load stops. If I disconnect the charger and plug it in again, the battery starts charging again but stops again in 30 seconds, with the same problem.

  I just want to know what is the cause of this problem, as its very frustrating indeed. The laptop will charge very well while turned off. I can use the laptop for about 1 hour on battery fully charged, so I don't think it's a problem with the battery. Can someone shed light on this please?

  Thank you.

  Hard to tell from a distance. Could be the loosening of a screw, a bracelet of ground or metal leaves touching a record of the Board of Directors, a misaligned or not completely seated connector, - any number of possibilities. If it was mine, I remove the back cover and closely check in the vicinity of the power plug, tighten the screw, re-seat all accessible connectors like the fan on the CPU - some systems detect fan connectivity issues and power down even if the temperature is not enough high to trigger active cooling. Use your good judgment and common sense in the search of inside things that aren't quite right.

  Jack E/NJ

• Tecra S2 - power and battery LED flashes - no start

  G ' Day at all.

  I have a TECRA S2 under XP SP3.
  Everything was fine until I went to a place of friends with her and plugged into the power supply and it lights up not at all and no LED.

  I removed the battery and then tried again and then happen to the power and battery LED flash together, but nothing else.

  Tried several times with the battery inside and out with the same results.
  I have stabilize power before removing or installing battery.

  Do not even have BIOS or a screen. I put the HARD drive in a caddy, and it's accessible.
  See you soon
  kb3500

  > Everything was going well until I went to a place of friends with her and plugged to the power
  Did you use the right adapter?

  To be honest, it looks like a malfunction of the power supply motherboard maybe electronic issue of power.
  the power indicator would start flashing amber if the AC adapter voltage is abnormal or failure of computer power supply.

• Compaq SFF 6300 Pro: upgrade my power supply

  Hey HP gurus, receive recommendations for a more powerful PS for my box? I am wanting to update my video card for some games, and I know that the processor will handle it, but I'm running in issues of power with all the cards in the correct performance.

  You can see that it's a totally weird owner PSU (point 2):

  

  I think it's old thread answers your question fully:

  http://h30499.www3.HP.com/T5/business-PCs-Compaq-Elite-Pro/video-card-for-HP-Compaq-Pro-6300-small-form-factor-PC/TD-p/6183611#.VK2G0ivF_OM

  If it's 'the Answer' please click on 'Accept as Solution' to help others find it.