IOPORT. SYS driver

Similar Questions

• Need help on IOPort.sys driver

  I need to open a program for the school, which requires a driver of IOPort.sys, and the error message indicates that it has not been copied in the system32 folder. I can't find one of these things on my computer. I want to know how to download the driver. I tried searching on google and I can't find anything. I could use all the help I can get.

  Hello

  Contact the program manufacturer support for further assistance on the issue, since the problem is specific to the program.

  Thank you and best regards.

• Cannot boot safe mode or any mode - hangs on the mup.sys driver

  Can someone help me. I did some research on the internet and see that it is a familiar problem. I have been using a usb and someone removed without doing safely - storage key my laptop then froze and the only thing I could do was turn it off at the power button.

  Now I can't do anything - it just goes to several times on the same page saying that there was a problem to choose a way to start - I chose alone and nothing - it loads until the mup.sys driver and then just goes to the same page again. I'm out of ideas.

  Can anyone help?
  I'm trying to avoid the recovery disk that I really want to lose my job yet, but realize that might have to happen, you mind I read reports that it even still hangs when you try this option.

  Thanks Rachel

  Hello

  AFAIK the mup.sys is placed in the folder C:\Windows\System32\drivers and it s responsible for the control and the start-up of the operation of the system at the lower level (control of the printer or the graphics card, etc.).

  If your computer loads all the way up to mup.sys then your HARD drive should work. If he died it would not even charge anything at all. It would not even try to load this file.
  It is likely that this file is corrupted just.

  If you re not able to run the Win operating system and use the System Restore tool, so I put t see any other possibility to use the Toshiba Recovery CD.
  To save important files, you can remove the laptop HARD drive and connect the HARD drive to another computer via the USB interface.

• Help! Windows Vista does not start because of 'ACBRUVI. SYS driver"is bad, can't find my restore points...

  "I tried to post a question on my PC not allowing not windows update to install the latest definitions of security and I don't know there's a virus or a trojan, but before I could get an answer on the forums my computer crashed lastnight and and when I tried to restart, he said that the ' ACBRUVI. SYS' driver was corrupted and contained also the registry as corrupt. So I installed Vista on another partition and I can access the other system files and registry but I tried to restore the registry with a backup I had made using CCleaner, it did not help. I went to the location of the driver (windows/system32/drivers/acbruvi.sys) and it is there, but ranked 0kb. I don't know what this driver is, nor do I have another copy of it on my system. In addition, I lost all my system restore points and do not know how I contracted this problem/virus/worm/trojan horse regardless, but it seems impossible to repair using available like AVG free resources, advanced care and Windows Defender system (Windows defender will not update or another) how can I fix files and the registry without having to reinstall vista on the infected version? I'm at a loss to know what to do? Please let me know what I'm dealing with here?

  Hello

   

   

  This file is not a windows file and I could not find any information on this file.

   

  Method 1.

  To connect from the new Windows Vista partition and run the scan on all drives online.
  I highly recommend to run a Virus Scan online. Sometimes the security program installed might not be fair enough. I also recommend you update your security software regularly.
  a. follow the link below to start the free online scan:
  http://OneCare.live.com/site/en-us/default.htm
   
  b. run the malware removal tool from Microsoft.
  Microsoft Malicious - 32-bit removal tool
  http://www.Microsoft.com/downloads/details.aspx?FamilyId=AD724AE0-E72D-4F54-9AB3-75B8EB148356&displaylang=en
   
  Microsoft Malicious removal tool - 64 bit
  http://www.Microsoft.com/downloads/details.aspx?FamilyId=585D2BDE-367F-495e-94E7-6349F4EFFC74&displaylang=en

  Method 2.

  If the problem persists, you may need to run the upgrade on site to repair the operating system. Use the upgrade option when you start with the Windows 7 installation disc to run the.

  Reference:

  Installation and reinstallation of Windows 7
  http://Windows.Microsoft.com/en-us/Windows7/installing-and-reinstalling-Windows-7

  I hope this helps.

  Thank you, and in what concerns:
  Shekhar S - Microsoft technical support.

  Visit our Microsoft answers feedback Forum and let us know what you think.
  If this post can help solve your problem, please click the 'Mark as answer' or 'Useful' at the top of this message. Marking a post as answer, or relatively useful, you help others find the answer more quickly.

• Problems caused by the nviddmkm.sys driver

  My computer turns off because of the file nviddmkm.sys (this according to my performance report). The nviddmkm.sys driver has been recently updated, and the problem with my computer began at this time.  I am running Windows 7 64 bit on my computer and don't know how to solve this problem.  How can I uninstall the driver and install one that will work properly?

  Assuming that it is the graphics drivers-
  It seems that the updates of Windows was allowed to update your graphics drivers.
  (the machine does not stop is rare however).
  It is better to setup Windows updates so it does not automatically install from the
  "optional" updates without your approval.
  Never use updates to Windows for graphics drivers in particular and also avoid a recent
  'optional' Update - KB 2670838 - as this will stop some (mostly older) games to launch
  If you are not connected to the internet.

  Download Nvidia drivers from the link below - use only the WHQL.  I suggest using
  the 310,90 vs the newer version, at least for now.
  If your computer is a DELL, HP, etc., it is sometimes better to get the drivers on their website
  for your model of PC.

  NVIDIA Driver Downloads - advanced search

  -In before to install the new drivers uninstall all components of the graphics Nividia
  drivers, including - PhysX, audio HD, 3D and updater - via programs and features.
  -Restart the computer before installing the new drivers.
  -If you continue to have problems doing the same thing again, but after restarting execution pilot Fusion to
  clean leftovers Nvidia graphics driver files.
  -Reboot again before installing the new driver.

  Treexy external page

  .

• Satellite Pro L770 damaged TVALZ_0.sys driver - where to find?

  Satellite Pro L770 does not start after flashing the BIOS to version 1.3 and install the latest version of Toshiba Service station.

  According to the repair of the Windows system, the c:\windows\system32\drivers\tvalz_o.sys is damaged.
  Where can I find a new driver for tvalz_o.sys intact?

  I tried to repair using repair windows system, but failed.

  The autoinstall tool would provide a solution for my problem?

  I think that the TVALZ.sys file is part of the Toshiba value added package.
  This package is released for Win 7 as well regarding the old Win Vista.

  I think you should try to reinstall this package

  You will find this software on the Toshiba UE driver page.

• Tecra S1: Cannot install Windows Vista - ACPI.sys driver problem

  Get the blue screen when you try to install Vista Ultimate edition on my Tecra S1--> STOP... ACPI.sys incompatibility.

  Someone knows how to fix this problem and where can I find an update for this driver?
  I already have the latest version of the BIOS (2.50) and don't see any driver update on the Toshiba site...

  Someone at - it already correctly installed Vista on this type of laptop?

  Hello, Johnny

  Robin is quite right. Tecra S1 is a portable older and certainly not Vista supported. As you know just for laptop with Vista capable sticker are supported Vista and Toshiba offer a BIOS update to make it Vista ready.

  I recommend you to use Windows XP Home as before. Optimize Windows XP Home edition preinstalled and you will have very good performance on this laptop more old.

  Bye and good luck!

• Satellite Pro A60: Windows XP cannot start isapnp.sys driver missing or corrupt

  I had a Satellite Pro A60 for about 3 years without problems.

  Last week Toshiba touchscreen developed vertical lines of the bleeding and I got error message "Windows XP cannot start because of the missing or damaged driver isapnp.sys. I tried using the recovery disk, but it loads OK, but it fails to make a difference. Hard drive seems to work OK as slave to another computer.

  No matter what wil suggestions appreciated!

  Thank you

  Found this Microsoft Knowledge base article:
  You receive a "Windows didn't start because the following file is missing or corrupt: Isapnp.sys" error message at startup

  http://support.Microsoft.com/kb/315311/en-us/

  Can it help

• Pavilion DM1: Stay before moving on to Windows 10 kl1.sys driver search

  Fault of kept my upgrade to Windows 10 and I found this driver kl1.sys had been let go a previous uninstallation.  He was not related to any process underway and once deleted my upgrade went smoothly.

  It may solve upgrades at a standstill, look out for what he

• Rrchcm.sys driver corrupt. Where to download?

  I get an error during startup indicating that C:\windows\system32\drivers\rrchcm.sys is missing or damaged.  I can get to a command prompt and verify that the file is there.  I tried to find the driver online but can't find where to download the specific driver.  There is not a restore to return point.

  Posts like this are often a symptom of a virus partially blocked or partially deleted.

  Download and run the free version of Malwarebytes Anti-Malware http://malwarebytes.org/

  If the message persists, run Autoruns of http://technet.microsoft.com/en-us/sysinternals/bb963902 . You can search for entries referring to the rrchcm.sys and disable them.

• Nvldd.sys driver failure BSOD HELP!

  Problems persisted since 9/14 (the last Patch Tuesday). Initially, I thought it was MSUpdate (which I still think is).

  BSOD: error 0 x 0000016, nvldd... failed pilot sys.

  Windows will be BSOD randomly (and whenever I have to use a graphic intense program like WoW).  Now my computer can't even stay idle at the office without going to the blue screen later.  Last week I got bad to get same Windows to start.  I can enter the mode safe mode with disabled graphics driver.  Is that what I can do to save my computer (still usable?) or do I just get my data back and buy a new laptop?

  I tried to replace, versions of old and new of uninstalling/reinstalling the drivers.

  I opened my laptop cover and dusted everything on.  I tried to find solutions to this problem and everyone pretty much returned saying "just buy a new computer.

  After a week to try to help out myself, I am at my wits end. School semester has just started, and I really need my laptop to be in good shape, not the BSOD'ing when I load: MSWord or Facebook!  This platform used to run WoW on almost full settings, two weeks ago and now he can't handle of Bejeweled Blitz, a Facebook application running.

  HP dv9000 Laptop

  Windows Vista-32 SP2

  NVIDIA GeForce Go 7600

  Bug Check 0 x 116: VIDEO_TDR_ERROR - Which indicates that an attempt to reset display driver and recover a timeout failed.

  Please update the graphics driver.

  "A programmer is just a tool that converts the caffeine in code" Deputy CLIP - http://www.winvistaside.de/

• BSOD and vwifimp.sys driver

  As he tried to watch the video (a mobile phone accessory) the screen went black and then blue screen of death. I made a Safe Mode boot and verified that all drivers are up-to-date. I disabled the Virtual Wifi Miniport Adapter at this time. After that several reboot failures I made a Safe Mode with logging enabled. This saves the driver loading process and ends the last driver loaded before the failure.  This driver is \system32\DRIVERS\vwifimp.sys. The computer is a stable if not Windows 7 64 bit with 8 GB. Appreciate your thoughts.

  Bud

  This phenomenon was related to the device driver wireless Extensible athrx.sys of Atheros Communications, Inc.  Yours is 5 years and more.  I remove the current driver and install the latest driver available.

• Could not start - missing/corrupted msisadrv.sys driver Windows XP

  After trying to repair existing Windows XP installation disc. New facility running chkdsk, deletes and copies the files and gets to the extent of the first reboot. Restart translates a msg "Windows cannot start because of lack or corrupt system32\drivers\msisadrv.sys" which is also the result by simply trying start from C:

  Hello

  Exactly how did you transfer files?

  Try to restore the system from the windows XP Recovery console. Follow the steps in the article.

  How do I recover from a corrupted registry that prevents Windows XP startup
  http://support.Microsoft.com/kb/307545

• Cdr4_2k.sys driver blocked by loading

  After starting I get said flag automation server can't create object in the list of system drivers is driver cdr4 blocked also loading how can I clear/ok it?

  Caused by Roxio, see here: http://support.microsoft.com/kb/315345

  John

• When I typed my name on my new doctor hard it doesn't have to enter the [s] in my last. How can I fix it name cela in all the app, on my sys drive.and. ?

  http://answers.Microsoft.com/en-us/search/search?Searchwhen I typed my name on my
  new drive hard o.sit, impossible to copy everything that the letters of my last. How do I fix this?

  Hello

  Try the steps suggested in the link below: http://answers.microsoft.com/en-us/windows/forum/windows_xp-desktop/changed-account-name-but-cant-change-logon-name/e90f81a9-0e5e-4511-b2f9-e286e05589e4