Large capacity of Portege R100 defective battery - LED would not turn

Similar Questions

• iPhone off to 30% of battery and would not turn on until I plugged it?

  I have an iPhone with 16 GB of storage 6.  I never had this problem or a question similar to this one before.  I'm currently updating on iOS 9.2.1.

  I was walking home from school today and everything trying to remember my mother-in-law, my phone (which is around 35% at this point) cut himself off from any incentive and displays the image bit appears when the phone is too low and he wants that you plug in.  I went back home and as soon as the charger is plugged into the phone (like, literally, the split second he was completely) the phone showed the startup screen white and then fully charged, he had about 30% battery remaining.  This caused a huge problem because my family thought something had happened, and I was wondering if anyone had suggestions on how to avoid this problem and solving persistent problems that this could cause.

  Also, I didn't know where to post this, so I apologize if it was not in the right section.  Thank you!

  The first step to solve this problem is to calibrate your battery. Let your battery drain until your phone stops at 1%. If he dies before, then plug back in it for no more than a minute, unplug it, and then continue to use until you reach 1%. You may need to plug several times.

  If this does not work, or if the problem persists, see this article.

• Portege R100: RTC battery replacement

  Problem: On my computer laptop Portege R100 the RTC battery needs to be replaced (laptop loses date and time system start-up after having done automatically stop when the batteries were empty).

  Question: I am trying to figure if this RTC battery is easily replaceable, i.e. I can order it from my dealer and can their technician quickly/easily replace the battery or is this battery soldered to the motherboard and replacement has so to do by Toshiba technicians, which means that my laptop will be gone for a few weeks?

  Thanks a lot for any input.

  Hello

  As I know the RTC battery is not soldered on the card mother but only connected with the cable. To remove the CMOS battery, you have to disconnect the cable from battery RTC PJ8760 on the system board and remove the battery from the RTC to the RTC battery.

  All that s. But if you have no experience in these things you shouldn't t replace yourself. The safe option is to contact the Toshiba service partner to change the battery. Here, you can also order one compatible

• Portege R100 and Linux - function keys not working do not and the latest version of the BIOS?

  Hello world

  I have a Portege R100 (PPR10L-13G10P). I am trying to install Linux and when you try to access function keys (F6) the computer does not allow me to... no idea why?

  Also, what is the latest version of BIOS for this computer? And where it can be downloaded?

  Thanks in advance!

  Terrence

  Hello

  At first, I must say that Toshiba doesn't support Linux in general if you are alone with this problem.
  I hope that someone will be able to help you a bit.
  If you want to discover the latest version of the BIOS, just enter the BIOS settings and check it out.
  BIOS version latest won't help you at all, so my opinion is that you shouldn't change anything.

  Anyway, the bio download page is - http://www.toshiba.eu/innovation/download_bios.jsp

  The feature keys F is supported by special tool Windows and it only works on Windows.

• Battery led does not work by Satellite A100-926

  Hello

  I noticed a little problem in my notebook.
  Infact when the laptop is charging battery led is orange.
  So far it's all ok. But when the battery reaches 100% the led turn off, instead of turning into the color blu, as usual.

  Is anyone know about this problem?

  Thank you.

  Hello

  Hmm have you check the BIOS if you count all the parameters concerning the battery LED?
  Access the BIOS and check this!

  However if might be something wrong with the s light and consequently, it would be advisable to contact the ASP in your country for control!

  It s your decision and you have to decide whether contact ASP or not.
  I mean it doesn t look like a problem serious and the laptop runs fine except for the LED

• Portege R100 - defective headphone jack

  Headphone 3.5 mm on my R100 hole seems to be defective (I tried it with another helmet and with them the sound is distorted unless I managed to get the plug in the right position).

  I will provide Toshiba on this subject shortly, but I was just wondering if anyone could tell me if this component replacement is a simple procedure?

  Thank you very much.

  Hi Dan,.

  The headphone jack is a pretty basic device that can usually be bought quite cheaply from most electrical spare outlets. The real problem is to find a repairman that will repair to the component level. Nowadays, the trend is to replace a whole PCB rather than simply weld on a new component.

  According your description of the problem as it sounds as if we spring metal tags is either loose or bent and therefore does not sufficiently wityh contact the helmet when it is inserted.

  If your laptop is still under warranty, then it should be replaced at no charge.

  If your warranty has expired, it may be useful to check for repairers of local PC that quote ' component-level) repair services.

  Good luck

• :^/ Treo 755 p LED will not turn off.

  :^( My Palm Treo 755 p (Sprint) has a new evil.  The LED light on the front will not be shut down.  It's on all the time, and I don't know how to remedy this situation.  Any suggestions would be apreciated...

  ;^) The fixed.  A screw was too tight, but he's fine now...

• Pavilion DV7-3162nr: HP Pavilion DV7-3162nr does not turn on and the battery light flashes during charging

  I was upgrading my HP DV7-3162nr for windows 10 when all of a sudden the laptop stopped working and would not turn.

  The power adapter is plugged in and battery led was flashing. Now battery led does not at all depend on. When I press the Start button the laptop would try to start then turn off after about one second. However most of the time when when I press the button nothing happens.

  I took out the battery and tried to immediately start the alternating current, but the laptop is like there is no power. The led near the power connector is on the AC adapter is plugged in. I checked the tension between the adapter and it is correct to about 19 volts, I even loaded to 1.5 Amps and voltage remained close to 19 volts. I tried now on the button for more than one minute with applied power (no battery or AC) and no change when I tried to start with just AC.  The battery is old, but shouldn't the laptop run on just the AC adapter with the battery installed? I do not think that windows 10 has done this, but it's a weird coincidense that he died during the upgrade.

  I read about simular problems with flags of HP but nothing exactly like it.  The fact that I can not turn on the laptop with just the adapter seems to be a problem really bad.

  Anyone has any ideas I can try to let me know

  I was able to fix my laptop.

  I thought that it must be a hardware problem, because the laptop would not run just the adapter. And the adapter was good, as I said, he had the right voltage and can support the load.  So after looking at a lot of U tube videos on how to disassemble laptops and looking for schematics on the laptop which I couldn't find. I disassembled the laptop and a beep on the load circuit and it showing. What I found, it was a bad MosFet at the beginning of the charging circuit. The MosFet P/N P0603BDG has shorted door to the Source.  I was able to get the part of China via Ebay for less than $5.00 total and it took a week to arrive.

  Now, the laptop charging the new battery and works very well. I could have found the bad MosFet faster if I had diagrams. Does anyone know if it is possible to get the schematics for this HP laptop? I found a manual and it helped a bit to disassemble the laptop, but he had nothing on the main map.

  This problem is now solved hope it helps someone out there.

• LAN wireless status Led does not light not upward

  Hi all

  I recently bought a Lenovo S10 - 3 model 20039, and I noticed that the wireless lan indicator led is not turning on even though I'm connected to the internet. Is this a driver problem or a bad led light? I tried the update, install, and uninstall the wireless LAN driver but its stiil same. Its a minor issue really because I can always connect to the internet even if the led indicator is not turning on. It makes me just feel uncomfortable because it's a new machine... If there is anyone here who can help me solve this conflct, it will be very appreciated. Thank you very much in advance

  Hi the last BIOS 37 for S10-3 , but that did not help for a broken light bulb

  cordially KalvinKlein

• Extended battery for Portege R100 in the United Kingdom

  Hello

  I hope that the topic covers it pretty well things, but...

  I read that the R100 in America comes with a long battery life and I was wondering if it is possible to buy one in the United Kingdom. I can't find anything online.

  Also the Portege R100 boot from USB at all?

  Thank you very much

  This battery high capacity has PA3155U-1BRL part number. I don't have time to search for on Google but use this number in Google UK, and I hope you find an online store where you can order.

  On boot USB, I can not say much, but at the start of the laptop under the Toshiba start screen you should see small symbols with all bootable devices. Check if the USB is there.

  You want to use USB external CD-Rom?

• Portege R100 - XP shows constantly the battery icon at 0%

  Hello!

  I have a Portege R100 with just the standard battery. Having bought used, it has been reinstalled with Windows XP and all the drivers of the unit in question and public services. The BIOS has been improved to 1.60 and ACPI common Modules installed.

  The problem is that XP shows constantly 0% battery icon, even if the power supply is on. As far as hardware is concerned, the battery charge and works very well for about 1.75 hours. As far as XP is concerned, there is no battery.

  It's very weird and a bit frustrating! Can anyone maybe shed some light on this and, more specifically, if it is the battery or the charging circuit in the R100 itself? Obviously, one is a * much * more expensive than the other!

  Thanks in advance,

  Sophie.

  Hello

  Have you installed or did you use the Toshiba power saver?
  Usually if the Toshiba Power saver is installed on the Microsoft Windows option doesn t power unit control the battery or the power state.
  Try to reinstall the Toshiba power saver.

• Portege R100 freezes - CPU fan is defective?

  I ' v was Portege R100s for a long time, maybe 7 years old, I am at my last one.

  I'll be back from it after eating and the XP screen froze, no mouse movement, CntrlAltDel did nothing. Press and hold the power button it stopped.

  Now I can start, but it freezes again in a very short time, a few minutes. I'm guessing that the processor fan is stopped.
  Not tht sounds good to people, it's a realistic possibility to cannibalize the carcass of my previous and hang the fan of my current group?

  Thank you

  Of course, it could be linked to the question of the CPU.
  If the CPU wouldn't be cooled correctly then the system can stop to answer.

  Are you sure that the fan has stopped working?
  If yes then the cooling module must be checked and replaced by the compatible.
  You may not use the cooling modules. It should be compatible.

  But to be honest, I think that the RAM modules need to be checked also
  In most cases, a RAM problem is more realistic as a defective cooling module

  My old laptop has stopped working because one of the RAM slot is faulty
  I delete a module and the laptop worked using a single module of RAM
  However, I couldn't use it as I wanted and I bought the new notebook.

• VGPBPL9C large capacity battery and battery VGP-BPS9/B-Stock

  What are the differences between large capacity battery VGPBPL9C spec and battery VGP-BPS9/B of Stock

  The VGPBPL9C seems to be a battery 9 cells 6600mAh nominal. The common VGP-BPS9 battery is a rarted of 6-cell 4400 mAh battery. Basically, the improved battery has roughly 1.5 times more power than the stock battery. Find the real Sony brand seems to be quite hard to find among all third party replacements. Note, sometimes more large capacity batteries also have a small additional strap to accommodate additional cells while you might find a little battery that comes out of the laptop.

• Portege R100 and new hard drive

  I think to put in a larger capacity internal hard drive - 40G is now a little bit :(

  Does anyone do this? The traps? Any suggestions on compatible drives?

  TIA

  Hello

  As far as I know the old Portege R100 supported a HDD IDE controller.
  So you will definitely need an IDE HDD. I think that it s a 1.8 IDE HDD.

  I think the HDD IDE controller supports only the 28-bit LBA and it would mean that there would be larger than 120 GB hard drives not recognized.

  That's why I choose smaller hard drives.

• Optical USB mouse problem with Portege R100 on windows XP

  We have three laptops Toshiba Portege R100 currently giving problems with mouse optical usb from Toshiba.

  When starting the laptop, that the mouse is not recognized by windows. Before and after will be identified in the mouse will not respond while Burns led.

  The mouse will be recognized after re - plug in the USB port.

  We have updated versions of bios to the latest version. (1.4)

  Another mouse (USB optical) works OK without problem.

  We have removed the drivers and reinstalled by windows plug-and-play process, but it does not work.

  Is this a known issue?

  Thanks in advance

  Hello
  would it be possible that the USB mouse has high power consumption?

  As far as I know, there are a load of maximum intensity for each USB Port.

  Do you know how much power (intensity) needs to this mouse?

  Good bye