Latitude E6400 Inverter card

Similar Questions

• GMA x4500HD on a latitude E6400: how to change the amount of memory assigned to the graphic card

  Hello

  I have a latitude E6400 with the A03 BIOS and lastest drivers memory on Vista x 64.

  I don't see how to change the amount of RAM assigned to the integrated graphics cards.

  How can I change this setting?

  Concerning

  
  

• The latitude E6400 LCD is dim/dark

  I have a Latitude E6400 with Vista. When I boot, I see the bios and the running of State Bar. as soon as it starts at the window, the screen goes black/sun. I can still see, but it is very very light. It doesn't matter if it is on battery or AC is fine when I plug in an external display. I tried key fn and arrow making, but which was useless. could the backlit feature on the LCD is dead? any help would be greatly appreciated.

  I am facing exactly the same problem with my computer laptop studio 1555. My research on line up to tell me that this is very probably the inverter which is bad.

  The fact that it has very low picture indicates that the screen is probably ok.

  A possible culprit is the hinge switch that turn off the screen when folded down. If this does not work when you lower and open on the external screen, my guess is that the switch is probably ok.

  The third possibility is the backlight ccfl lamp. What I generally find people reporting is that the screen begins to turn red before the ccfl lamp turns off. If we do not face that then the lamp should probably be ok.

  I'll order a new card of the inverter and replace it and pray with my fingers crossed.

• Latitude e6400 network controller

  Hi, try to install the network and Broadcom USH controller for a latitude E6400 driver and can't seem to find the correct file to download.

  Running Vista 32

  Service Tag 1MDXZ1S

  Any help would be greatly appreciated!

  Thank you

  Normally this driver do not something other than what you have seen.

  However, if you are not signed in, then obviously it has failed.

  Now that I know you have the wireless card, then try the driver from the Dell support site for your model.

  http://www.Dell.com/support/drivers/us/en/19/DriverDetails/product/latitude-E6400?driverId=W9K9K&osCode=WLH&FILEID=2939894298&LanguageCode=en&CategoryID=NI

• Dell Latitude E6400 LCD / LED video screen has partial display of vertical lines

  Hello

  I have a Dell Latitude E6400 on which display LED screen / video shows the stable vertical lines in the right half of the screen (partial view on the left side is good, see photo). I have already tested the external VGA port - it is displayed correctly on an external LCD display. The vertical lines are constant and the same brightness, regardless of the position of the lid of the laptop. This could be a problem with the inverter or the water of the LED screen? Or something else? Thanks in advance for any comments.

  P. S. Please note that glow Golden on the top left of the screen is just a reflection of ambient light.

  

  It is not the inverter (assuming that the display has a);  who simply controls the backlight.  It may or may not be the cable - it's not likely.  It resembles a billboard damaged.

• Latitude E6400 taken helmet does not

  I have a Dell Latitude E6400 with Windows 7 Enterprise 32-bit Edition. I installed the chipset drivers, then the rest drivers until there is no bangs in Device Manager. When I plug in external speakers to the headphone jack, however, there is no sound. Test the speakers on another system, and they work.

  I worked on it for a few weeks and I'm out of ideas.

  faithmarian

  Dell service manual does not (or I couldn't find) information on how to fix an audio input jack broken.

  Hello. The plugs are on a track called ' I/o card' in the maintenance manual. You need to replace the circuit board, but it there are 2 different according to the graphics in the computer. See here.

• Dell Controlpoint (Latitude E6400) connection manager

  Dear community,

  I have a Dell Latitude E6400 laptop with Win 7 64 bit, 5530 Card HSDPA, Wifi, Bluetooth and I can't download the Dell\Downloads controlpoint Manager application (it is automatically as updates/download drivers and applications for my laptop Dell based on the tag). Can you help me please where I can download this application, it works on my laptop, or have I reinstall it (However, I do not see something like that)?

  Thank you very much!

  Kind regards

  MY

  Hi maland,.

  Please visit the following link to download and install the Dell Controlpoint Connection Manager Application: http://dell.to/132945B

  Let me know the results.

• Dell Latitude E6400 does not start pressing the power instead button, I have to remove the battery.

  Original title: problem starting Latitude E6400 lappie

  Hi all

  When I start my dell latitude6400 is not start pressing the power instead button I have to remove the battery to the rear and place it again, and then the lappie starts... someone can help to...
  Thank you

  Hello

  1. what happens when you start the laptop, you receive no error message?

  2 have you made any changes to the computer before the show?

  I suggest to remove the battery and connect the laptop to AC power and then try to start the computer to see if the problem is with the battery.

  I suggest you to contact Dell support on the issue, as this can be a hardware problem.

  http://support.Dell.com/support/topics/global.aspx/support/DellCare/contact_us?c=us&l=en&s=DHS&CS=19

• Latitude E6400, dell: HP officejet 4215 printer does not meet Dell computers

  Dell latitude E6400 window 7 (directly connected to the printer), window of inspiron Dell 8 3520 (wireless), they do not meet the printer. I HP4215 like a printer by default on both computers, but I can't print anything. Please advise! Thank you!

  Hello @azarita and welcome to the Forums of HP, I hope you enjoy your experience!

  I understand that you are having problems printing from your system.  I would like to help!

  I would recommend you to do a power reset the printer.  Unplug the power cord from the printer and the power outlet, then wait 60 seconds. After 60 seconds, plug back in the printer. Make sure that you connect the printer directly to a wall outlet. Make sure to bypass any surge protector or power bar.

  I suggest also download and run the HP print and Scan doctor.

  Good luck and please let me know the results of your troubleshooting operations. Thanks for posting on the HP Forums!

• More Compatible with Linux XFCE for Dell Latitude E6400

  What version of Linux with XFCE interface do you recommend for the Dell Latitude E6400?

  Xubuntu: http://xubuntu.org/

• (Redirected) New keyboard for Dell Latitude e6400 does not

  I recently purchased 2 computers laptops dell latitude e6400, but both have the same problem, the keyboard does not. I'm even not go into the BIOS (F2) settings using the keyboard of the laptop. using a wired USB keyboard works very well. any suggestions?

  As you have a laptop, better make this laptop in the computer Forum post here:

  http://en.community.Dell.com/support-forums/laptop/default.aspx

  Bev.

• Latitude E6400 built-in Microphone does not

  Hello. My machine is a Latitude E6400 running Windows 7 34 bit.

  I bought used recently and found that the microphone (which, according to specifications must be built in) does not work.

  I tried to check it is not cut, as well as turn the off/on it again. It is said it is active, but (in the recording devices), there is no upward movement/green line to show that is to record my voice. Setting up the microphone via the Control Panel does not work either.

  I tried to install the Audio drivers from Dell, but it comes up with the following message is displayed:

  "The hardware found is not supported by this package IDT.

  The installation will be interrupted. »

  I tried everything I can think of. Someone at - it other ideas on how to fix my microphone?

  AshHolland

  microphone (which should be built according to specifications)

  I might have missed, but the single microphone that I see in the documentation of this model is in the assembly of the webcam at the top of the frame of the screen. The webcam has been a purchase option on this model. The webcam itself work? Because if it's not then either it is not or does not, and in both cases, the microphone does not work. If you have a program named Dell Webcam Central in your list of programs, then use it to control the webcam.

  Even if the webcam works the microphone could become defective. You can get a replacement webcam people-parts.

  You can also check in the BIOS. I don't know about your model, but some laptops have a mic option in the BIOS.

  AshHolland

  I tried to check it is not cut, as well as turn the off/on it again. It is said it is active, but (in the recording devices), there is no upward movement/green line to show that is to record my voice. Setting up the microphone via the Control Panel does not work either.

  Ensure that levels are facing upward.

  

  AshHolland

  I tried to install the Audio drivers from Dell, but it comes up with the following message is displayed:

  "The hardware found is not supported by this package IDT.

  Go to this page and you can see all the drivers for Dell just introduced for the E6400.

  http://downloads.Dell.com/published/pages/latitude-E6400.html

  Try all the audio drivers Windows 7 IDT. If none work there is another problem with the laptop and I would suggest running a System Recovery if the seller has provided the recovery media, or if the recovery image is still on the hard drive. If you are able to perform a system restore and the microphone still does not work, then it is either missing or failed.

• (Dell Latitude E6400) Windows 7 64 bit Dell control point

  I installed Windows 7 64 bit on my Latitude E6400. I can't find any way to install the Dell Control Point. I got the Pack of drivers to install. I found a single download of the Security Manager who has worked, but I would like to than the power one Manager.

  I looked on this forum a few times and all the links I click redirect just me at the page downloads and drivers. I get an error saying that my service pack is not supported... I'm on Windows 7 Service Pack 1. I have also some 32-bit errors, but it's my fault to have downloaded the 32 bit version.

  Someone has a link to the full package of checkpoint Dell (Power Manager, Manager of connections, Security Manager) that works on Windows 7 64 bit?

  Thank you

  -Ryan

  parrotrpg1

  Here is a good article on reimage the Latitude E6400

  downloads.dell.com/.../Latitude%20E-Family%20%20Mobile%20Precision%20Re-Image%20How-To%20Guide%20-%20A03%20Rev%203%200.pdf

  Win 7 Control Point System Manager files are a little hard to find, but they can be downloaded from the following link.

  www.dell.com/.../DriverFileFormats

  This will help you if you have installed the drivers in the correct order.

  TB

• Dell Latitude E6400 running slow

  I have a Dell Latitude E6400 - it has 4 GB of RAM and a processor 2.53 Ghz running Windows 7 Enterprise 64-bit - how is it is slow? I ran all the troubleshooting I can think, made malware scans, virus scans, and it is still slower than my other laptop that has 1 GB of RAM and a processor 1.73 Ghz - ideas? Thank you!

  The problem is that the CPU is overheating and when it the fact that the processor at 800 mhz speed and stay there the CPU goes to 100% usage and the system dies.  I had this problem for 2 years before I understood what it was.  I took off the bottom of the computer (a screw in the middle).  Removed the heatsink to the CPU/GPU and cooling fan.  I have removable fan and removed the therma spent the CPU and the GPU thermal pad.  I have then divide a tube of thermal paste Arctic Silver 5 Radio Shack ($10) and replaced the heat sink and let it heal from one day to the next.  I also bought a block of cooling fan powered to the computer but never needed to use it.  The machine works like a monkey assed stipped running multiple video streams at the same time and cool enough to keep al running stayng.  I was ready to relegate this machine to a storage device, but now it it GREAT.  Good luck

• factory setting dell latitude e6400

  I have a Dell Latitude E6400, it came with Windows Vista 32-bit, there now Windows 7 64 bit. should I try to go back to Vista or just stay with Windows 7 64 bit?

  Hello

  Thank you for contacting Microsoft Community.

  You can continue with Windows 7 64 bit. It is safer and more stable than Windows Vista. You can get all the necessary drivers for the hardware of the Dell Web site, in order to work with Windows 7 will not be a problem.

  See you soon.