my computer hp laptop does not save in pdf, what can I do?

Similar Questions

• HP Pavilion G6 computer 1093SA laptop does not charge when I plug in the power adapter

  HP Pavilion G6 computer 1093SA laptop does not charge when I plug in the power adapter

  The battery is dead. When I try to turn on the laptop by plugging the AC adapter does not charge or led power LED does not turn on. But when I press the power button, the power, the indicator flashes and turns off (when power adapter connected).

  (1) I tried the press and holding the power button for 30 seconds after removing the battery & AC adapter / CC.

  (2) I tried to change the power adapter too.

  The problem is that it is.

  Your advice is very much appreciated.

  Thank you best regards &,.

  Zia

  Dear customer,

  Welcome and thanks for posting your question on the Forum of Support HP

  It seems that you are not able to turn on the laptop and tried to solve the problem

  Please perform steps listed to find out if it is a hardware or software problem below:

  1. remove all cables and devices, disconnect them and try to turn on the device

  2. check the LED light situation and ensure the action of the spring button / stop is normal

  3 Exchange with a well known power cord and the AC adapter

  4 Pack no adapters are available, check if the power adaptor is slightly warm

  Note: This will give us an indication that the power adapter could be good

  5. do you know if the laptop was in battery or power adapter when you used the last time

  Note: Make sure that there is no spill of liquid or cutting

  6. check if the Port of the AC adaptor is loose/broken

  Note: If the laptop is not on even with a power adapter well known, this confirms the hardware failure with the system board or power DC Circuit

  Hope this helps for other queries to answer the post and feel free to join us again

  * Click on the star of CONGRATULATIONS on the left to say thank you *.

  Make it easier for others to find solutions by checking a response "Accept as Solution" if it solves your problem.

  Thank you

  K N R K

  I work on behalf of HP

• Compaq CQ58 computer 301SA laptop does not connect to 50Ghz band on router

  My laptop does not connect to the band 50Ghz on my router dual-band. I know that my router Netgear dual band diffuse 24 and 50 Ghz, but the laptop only shows the 24 Ghz band depending on availability.

  I have a Compaq CQ58 301SA Notebook PC, Windows 8 (64 bit OS).  It has a Ralink RT5390R 802 11bgn network adapter and a Realtek ethernet network adapter. I use the laptop wireless, for example using the Ralink connection and it connects easily to the 24 GHz band, but I want to broadcast TV programs and movies smoothly, for which, I understand that the 50Ghz band is preferable. I pay my ISP (Virgin Media) for a connection to Super-fast broadband but my laptop seems to be limited to the 24 GHz band. Seems to be the case if I work with the adapter Ralink wireless or wired with Realtek ethernet connection.

  This problem can be corrected? If so, how? What I have done research on the web, the problem seems to be network adapters. Can they work on the 50Ghz band? Or do I need to download another adapter (if so, which?) Or use an adapter external network I plug into a USB port?

  Driving me crazy...

  Hello:

  The Ralink RT5390R 802 11bgn is a map of the only band (2.4 GHz) only.

  Whenever you see a labeled bgn wireless card, it is a single band card.

  Cards labeled dual band abgn or agn.

  The maintenance manual (Chapter 3, page 19) does not indicate that any internal dual band card is supported, so you would probably have to go with an external usb dual wireless adapter.

  http://h10032.www1.HP.com/CTG/manual/c03593268.PDF

• Lightroom crashed (and caused my computer down) and does not load now. What should I do?

  Recently I bought lightroom and a week ago, I used it to change lots of photos so not only crashed Lightroom, but it caused my computer down as well. I have a surface with load and 3 pro, I was able to restart it. However, whenever I try to open lightroom, it does not load and possibly the computer says it does not. I am desperate to change these images, but not sure what to do to get lightroom to restart. What would you recommend? I have version 6.0...

  Hello

  Please, go to the Windows, where Device Manager, expand display adapters.

  Turn off the graphics card and open Lightroom, go to Lightroom preferences, then the performance tab, and then uncheck the option "use graphics processor.

  Lightroom farm and go back to Device Manager and activate the graphic card.

  Open Lightroom and then work in Lightroom and check if it works very well.

  Kind regards

  Tanuj Sandal

• Pavilion 15 laptop: HP Pavilion 15 computer PC2170 laptop does not boot to Windows - 2 years

  Hi, my Hp Pavilion is only 2 years and 2 months (not very old at all) but suddenly it does not start in Windows, it hangs at the HP logo screen, it starts with an HP logo screen then goes to another screen of the HP logo, and then freezes. I can't get into safe mode.  I got in the Hp diagnostic screens and I conducted tests on all and everything.

  I did a hard reset, still frozen.

  I removed the cover, he went out and placed him in, still nothing.

  Whenever I have to try and reset it, he said administrative privileges is necessary, but there is no administrative privileges on this computer.

  There is no restore point.

  I ran chkdsk via the command prompt and had no error.

  I tried running sfc: scannow but I had which was something in the meantime and could not do.

  The laptop is: laptop HP Pavilion 15 2170

  A6-5200 APU AMD processor

  Can someone computer whizz out there enlighten us on this you problem, please.

  When you request support, please provide the model name and product number complete (p/n) of the HP computer in question. HP/Compaq made thousands of computer models. Without this information, it can be difficult, even impossible to help you solve your problem.

  The information requested above are on the bottom of your computer, inside the battery compartment or on the BIOS boot screen. Please see How can I find my model number or product number? for help more to find this information. DO NOT include your serial number.

  

  If you have any other questions, feel free to ask.

  Please click the 'Thumbs Up' white LAURELS to show your appreciation

• On Toshiba M505-S4940 computer microphone laptop does not work after upgrade Windows 7...

  I bought this laptop in July and it came with a free upgrade to Windows 7. Until I upgraded my cell phone, my microphone worked fine, but since I installed Windows 7, the computer does not recognize the microphone as a device. I looked for answers on the Web from Toshiba site, but nothing has worked. What is the problem with my microphone?

  Hi jillibeans34,

  Thanks for posting. Here is a link to the drivers of Toshiba. Download the sound and drivers of Toshiba Speech system. If you're still having problems, please contact Toshiba to see if they can provide you with the correct drivers.

  http://www.CSD.Toshiba.com/cgi-bin/TAIS/support/JSP/modelContent.jsp?CT=SB&OS=&category=&MOID=2346345&RPN=PSMG2U&modelFilter=M505-S4940&selCategory=3&selFamily=1073768663

  I hope this helps!
  Shawn - Support Engineer - MCP, MCDST
  Microsoft Answers Support Engineer
  Visit our Microsoft answers feedback Forum and let us know what you think

• Computer Toshiba laptop does not work after the lid slam... Help please!

  This problem with a Toshiba - windows vista laptop began after the cover was closed too hard. When he was conducting swiched, instead of going to the usual blue screen, the screen was grey and a message would come in saying ' it installed program cannot start. " Click ok to stop the computer", as I could not get into windows at all, I took the drastic step to insert the recovery disks that came with the laptop to launch new and see if it worked (a cell phone factory default is is better than nothing).

  In any case during the process, which took a very long time, I got messages such as not found HDD1 also say there not enough space to recover.  Then I got x:\windows\systems32 and nothing else it got stuck on that for centuries, because he just asked me to check the disk, but I couldn't because I couldn't get a windows session, I looked online and saw something similar to my prob and says type chkdsk c:/f I did after recovering past for much longer afterwards I had to stop at 80% , because there is no room in the end and now I don't even not the blue screen.

  As soon as the laptop is turned on, it says, could not start windows. A recent hardware or software change might be the cause to fix the prob insert your windows installation disc.  But it won't let me, I get just the same message and also it says File\Windows\system32\drivers\Wdf01000.sys and the State: Oc00000e9 and Info: Windows could not load a critical system driver is missing or damaged.

  Please help me if you can, my daughter really needs the laptop works again for homework, thanks a lot

  Thank you for taking the time to answer, I think that will be my next move, was hoping I wouldn't have to take to a repair shop, because you never know how it will end up costing, there may be more damage than all formatting, thanks once again :)

• computer Vista laptop does not accept password

  I have been using my HP vista laptop and today, it does not accept my password. I tried safe mode and tried to change password. NO RESULTS...

  Help, please...

  James

  Dunedin FL

  Hello

  It is available on you microsoft information help on problems with passwords

  http://support.Microsoft.com/kb/940765

  If you are unable to connect to Windows 7 or Windows Vista, you can use the Windows Vista System Restore feature, or the Windows 7 system restore feature.

  You may be unable to connect to Windows Vista or Windows 7 in the following scenarios:

  • Scenario 1: You recently set a new password for the protected administrator account. However, you don't remember the password.
  • Scenario 2: You type the correct password. However, Windows Vista or Windows 7 does not accept the password because the system is damaged.
  • Scenario 3: You delete a protected administrator account. Now, you cannot connect to another administrator account.
  • Scenario 4: You change an administrator account protected with a standard user account. Now, you cannot connect to another administrator account.

  ________________________________________________________

  except that we cannot help you

  read this microsoft's policy NOT to provide assistance to crack passwords when they are lost or forgotten:

  http://answers.Microsoft.com/en-us/Windows/Forum/windows_vista-security/keeping-passwords-secure-Microsoft-policy-on/a5839e41-b80e-48c9-9d46-414bc8a8d9d4

• Computer Dell laptop does not start

  Was an upgrade and lost power or connectivity during the upgrade
  now my laptop will not boot.

  Is there a way to return to a previous start-up and it stand up, so I'm able
  use and restore updates.

  ~ tom

  Looks like the partition is damaged. I fear that even a repair check does not work, the best that we can suggest is reinstalling new windows.

• Computer Dell laptop does not light

  I have a Dell inspiron 15, that does not illuminate. I tried to take out the battery and pressing the power for 30 seconds, did not help. Called customer service, they said maybe the motherboard, but they don't have any that match my laptop and the warranty is expired.

  Any other suggestions? Thank you

  Hi VICIOUSVIC,

  Please write to us.

  Please private message us the serial number of the system as well as your login email.

  (Note: Please do not mention the id of service tag or by e-mail on the public forum because it contains your personal information).

  Kind regards
  DELL-Loïc M
  Professional community and social media
  #IWork4Dell

• Why sound for computer hp laptop does not turn on

  HP G72 Sound does not illuminate. Started yesterday

  Windows 7 32 & 64

• Computer Toshiba laptop does not start

  Have had some problems malware. Thought I had deleted them, including Thinkpoint. Restarted. Got the original F2 and F12 screen then just empty. Will not go further.

  Can anyone help please.

  Hi jagman49,

  1. try to start the computer in safe mode and check if you are able to boot to the desktop.

  See the link below to start in safe mode: a description of the options to start in Windows XP Mode:http://support.microsoft.com/kb/315222

  2, if you are unable to boot into safe mode, then try the steps by Mike - support engineer Microsoft Support, moderator of the link below: http://social.answers.microsoft.com/Forums/en-US/xprepair/thread/901f9138-7a73-42f2-86ed-00c7fef3b77e

  With regard to:

  Samhrutha G S - Microsoft technical support.

  Visit our Microsoft answers feedback Forum and let us know what you think.

• Computer HP laptop, does not accept the recovery disks and don't accpet Windows Vista upgrade (HomeP to ultimate).

  Apparently the upgrade does not recognize that Windows is on the drive, but cannot restore the original software as HP blocked their recovery disk. The recovery partition is there, but he cannot get starter.  The recovery disks have the original spirit operating system Windows - how can I get the upgrade to recognize?

  Hello

  an upgrade must be done from vista, NOT operating system by booting from the disk to upgrade

  as you have problems using the maunfacturers recovery process, upgrade disc etc., read what you may have hardware problems.

  If you have problems with the process of recovery of manufacturers, contact the manufacturer

  It's their recovery process not microsofts

• My laptop does not recognize new Sandiscs - what am I missing

  I recently bought 3 new Sandisk SD Ultra 16GB 10 speed but the card reader in my computer hp laptop Windows XP, does not recognize them.

  They work fine in my camera.
  The original disks are 2 GB and they work fine in the camera and the computer.
  What Miss me?

  You don't mention what service pack you have, but if you have sp 3, the most likely reason is that the card reader in your laptop is too old to read new (> 2 GB) SDHC cards.  Connected by USB readers are fairly inexpensive, just be sure that the one you get includes the ability to read SDHC cards

  For example: http://www.amazon.com/s/ref=nb_sb_ss_i_4_5?url=search-alias%3Daps&field-keywords=sdhc+card+reader&sprefix=sdhc+%2Caps%2C213

• I have adobeXI stuck in limbo in my computer. I can't uninstall it or install any new version, and adobe does not work properly. What can I do?

  Adobe XI is stuck in limbo on my computer and I can't uninstall it or install update for adobe systems. What can I do to get rid of this one and install a update or at least a version I can use?

  Hi maggieg30085397,

  If you're on windows computer try uninstall using this cleaner tool Download Adobe Reader and Acrobat tool - Adobe Labs.

  Reboot your system and install the latest version using this link Adobe - Adobe Acrobat Reader DC Distribution.

  I would like to know if it works.

  Kind regards

  Nicos