Sansa Clip + crashes

Similar Questions

• Work doean can't Sansa Clip after crash

  Hi guys!

  My Sansa clip 2 GB drive has dropped by 30 cm (12 in.) and now it only works when connected to the computer.

  You have any ideas how to fix it?

  Thank you!

  Looks like probably tore the battery cable loose. This seems to be a common problem with the Clip. I hope is not as vulnerable to this problem than the clip Rev1 rev2 Clip. If your clip is set to connect in MTP mode, then on your pc you can check tharge on the battery. This could help you confilm it's battery cable that fell off. If you have your receipt when you bought it, and it's less than a year, you could RMA return to Sandisk for repair under warranty. Otherwise, you could open yourself and solder the wire on. Depending on where you are, it might cost $30 or more for an electronics store to fix it. In this case, either it is logical to set, or buy a new player.

• Sansa Clip + short circuit

  My sansa clip + stops or crashes whenever the slightest Pressure is applied to the front. I'm relatively sure that there is a short circuit somewhere in the unit. This makes using it almost impossible and incredibly infuriating that it accepts several tries to get to what I want to hear without freezing. Whenever it freezes and if off, it resets to where it was when I turned it on, which is also irritating. I tried to restart it and I'm relatively sure that it is not a software problem. I had the player for about two years, although I him have not used exclusively as I had a phone that played music (I lost this phone last week). This problem has been present for several months and I'm not very eager to buy a new player, as the clip has been very useful and well done before this problem.

  Looks like it's a Goner. Fortunately, they are relatively expensive. It's not as if you replace a Cowon for $250 - $ 300.

• Sansa clip-drag & drop shockwave object corrupts - the error of the operating system "refreshing database".

  If by mistake, you drag and drop an object flash shockwave from your local directory from the PC to the sansa clip, corrupt you the operating system of the sansa clip. When re - start the sansa clip, clip progresses by up to 70% with error message "refreshing database", but fails to start successfully. If the press-'hold' button on sansa clip, the appliance does not start. It crashes with the error message "refreshing database' but doesn't load is not the operating system.»

  It was a user error to drag - move all the MP3 files in the directory of the PC, one of whom was of type shockwave flash object file.

  Help!

  André

  Try the clip board.  This is the map of the e200 series.

• Transfer from Windows Media Player to Zip Sansa Clip

  In the end, I am creating playlists on my Sansa Clip Zip. So I think THAT I have to create a playlist in Windows Media Player and then sync my Sansa Clip Zip. For some reason any I am only able to see 5 playlists, but I know that I have created several of them. In fact, if I try to create a new play list using a name I know, I created, it is said that there are already. How can I see ALL my playlists?

  Also, if I click on playlists for the Sansa Clip Zip it shows I have 9 playlists, but I can't see what they contain!

  Hi Nymickey,

  I suggest you to contact the Sansa Clip Zip support for better support associated with Sansa Clip Zip and check if it helps.

  http://KB.SanDisk.com/app/ask/session/L2F2LzEvdGltZS8xMzM4MDA4NzQ5L3NpZC90QmxJQjJaaw%3D%3D

• When I connect my SanDisk Sansa Clip MP3 player Zip I get Code 10 device cannot start

  Original title: Code 10

  When I try to plug in my SanDisk Sansa Clip Zip MP3 player I get the device Code 10 cannot start.  I have XP.  The MP3 came with a 2.0 USB.  I don't know what the USB on my computer.

  Hello

  First of all, thanks a lot for taking the time to help me.

  After having tried everything you have suggested and have no chance and then by searching the Microsoft sites, Dell and SanDisk, I finally found a very simple solution that worked.

  Thought I would pass it for any future reference.

  The SanDisk site said to try this:

  Activation or forcing MSC mode on the Sansa player

  How to connect my Sansa in Mode "MSC" player or forcing MSC mode on my Sansa player?
   

  The steps below will force your readers Sansa Connect mode MSC on your PC.

  Sansa Clip Zip
  1. turn off the device.
  2 hold down the central button while connecting the device to the computer.

  Thanks again.

• My Sansa Clip does not work

  I use my Sansa Clip when I work at the YMCA. I used it last night and it worked fine then. This morning when I went to the O, it didn't work at all. Once I got home, I plugged into my computer. It still does not work. Why it does not work and I can fix it?

  How about a magic Sansa?

  Slide the switch to position IT and hold it there for 10-15 seconds.  If you have sensitive headphones, you can hear a "click" soft as the device resets.  It is the function of soft reset .  Your Clip should restart normally after the reset.  Try to turn it on as usual.

  µsansa

• Sansa Clip and Slacker Radio?

  Does anyone know if the Sansa Clip will work with Slacker Radio?

  Any info is appreciated!

  As Slacker internet radio, and the Clip (or indeed any Sansa player) is not, I don't see how.

• Power outage Sansa Clip

  Hello

  I have a 2 GB Sansa Clip I bought about 4-5 years ago and have been very happy with it.

  He runs the version of the 01.01.30A software.

  However, recently and for no apparent reason suffering from power cuts.

  It would just turn off, no matter how much battery there left, how long it has been running or what he does. And when we turn on (which is sometimes hard to do) he can't remember the last thing he was playing.

  After further tests it seems to turn off when put under different angles, almost as if there is a piece on the inside that is open/close the connection. When shaking a slight ratteling inside there, but I can't be certain that's not making noise power switch.

  Of course, this looks like a hardware problem.

  So, how can I open it and fix it? Is there a diagram somewhere I can look at?

  Thank you

  Max

  Well, I opened it and looked around in there.

  True, the battery had detached from its adhesive strips and pulled the loose battery negative cable.

  Gently, I took out the battery and was able to resolder the wire and test that it works before you all shut up.

  My double-sided adhesive foam Strip seemed to be too thick, so I used a drop of silicone glue to prevent the battery from moving around.

  All together again once, case snapped back and forth between them well.

  A little notation around the seam is a small price to pay for a media player that fully operational once again.

  Thanks for all your suggestions!

• Sansa Clip + question

  Hello, I am really considering buying the Sansa Clip + for the race, and I just want to know one thing.

  When in Shuffle mode and you accidentally skip a song, are you able to return to the song you just jump by pressing the back button?

  I only ask this because my Archos can not, she keeps just still dragging on the back button.

  Thanks in advance!

  Best regards, Daniel.

  Yes.

• Sansa Clip does not

  My sansa clip is on but can not receive music or bring up the menu. What's wrong?

  Is this new? You take off the sticker of the shield? Say the screen if there is no menu? We cannot read your mind; you have to tell us more about this if you want any help.

• How WE / OFF sansa clip jam

  I bought the sansa clip jam, and I can't ON / OFF.
  I need to wait a few hours and sansa clip jam is off and connect him to the load to the sansa clip jam
  Where is the ON / OFF?

  Click and hold the Center button for three seconds. Same on/off button.

• Headphone Jack does not fit into my new Sansa Clip +.

  Hello

  I just bought a new Sansa Clip + so I could listen to my songs while he's on vacation, but when I put in my profile 3.5 headphone jack into the hole on the side of the mp3 player, it will not thoroughly and grave if I don't hold him properly. That is how a Sansa Clip + is? because I found it very boring.

  I hope someone can answer quickly because I'll be on vacation in a week about. And sorry for my English because it is not my mother tongue.

  When the player is again taking is very tight and it takes a little force to get the plug completely.

• Can not record songs on a Sansa Clip +.

  I recently bought the Sansa Clip + and it has firmware version V01.01.05F and the song rate feature doesn't seem to work. I choose 1-5 stars and select the choice, but the note is not saved. Another poster asked a similar question and its solution involved affecting USB MTP mode, but this has not worked for me. Any suggestions?

  Thank you

  OK I thought about it, the new firmware fixed this problem for me.

• Sansa clip + does not see the audio books I have loaded

  I got my Sansa Clip MP3 player + for two years and it works very well, so far.  I only use it for audio books.  Recently, I reformatted the player and loaded new books in.  When I went to read, the audio books folder was empty.  I have connected the player to the computer again, and the books were in the audio books folder, where I had loaded.

  I've updated the firmware to the V01.02.16A Version, and there was no change.  I tried to reset by pressing the start button. No change.

  Memory has 3750 MB with 3135 free, indicating that there are books in memory, but the player does not see the.  What is going on?

  That's all!  I checked the format of audio files.  It is the AAFC, with suffix .m4a.

  The Sansa manual says:

  "The Sansa® MP3 Player will support MP3, WAV, WMA, secure WMA, FLAC, Ogg Vorbis and audiobook formats.  I guess that AAC is not one of the formats that they support.  So I have to convert .m4a to .mp3.  I guess there are a lot of tools to do it.  Any suggestions about which one is the best?

  Thanks a lot for this revelation.