Satellite 1135-S155 beeps + freezes and shuts down... Help, please!

I have a Satellite 1135-S155 beep constantly, nonstop beep, and beep about 30 seconds it stops.

Help, please.

Thank you

FS

Hi Fausto

It is not easy to say what he can be, but in my opinion, it's a hardware problem. Contact the Service partner and leave check your laptop.

Tags: Toshiba

Similar Questions

  • Satellite L350D-213 repeated overheating and shuts down

    Hello

    Recently had problems with my Toshiba laptop Satellite L350D-213 of the he repeated overheating and if off, any suggestions as to prevent overheating would be greatly appreciated

    Hello

    There is a lot of advice about the overheating problem.
    First the laptop stops automatically to avoid that the pieces of equipment from damage, the higher temperature may affect parts and this is the reason why the laptop stops.

    Why the temperature is too high?
    Well, maybe the cooling modules does not t run with the best performance because of the dust and debris inside the modules?
    It is mainly the reason why fans do not twist and cannot cool the laptop.

    I recommend to check this and remove dust and debris from cooling vents using a jet of compressed air.

    I do from time to time, and it helps to clean the fans

  • Windows does not shut down correctly, please choose an option (safe mode, safe mode with network, start windows normally

    Original title: battery

    When the battery dies on Windows 7 Home premium, what makes the look of the laptop screen as to everyone with the same computer? (IE black, dim and then black, dim and white and then black, Sun & blue, etc.)
    And you always get the "Windows did not shut down correctly, please choose an option (safe mode, safe mode with network, start windows normally)" Note?

    It could be a hardware problem, so it is best to contact DELL or a local technician if the problem persists.

    As a work around, I suggest to update the drivers of the computer display and check if it makes a difference.

    Download the drivers from http://www.dell.com/support/drivers/us/en/19/Product/latitude-e6410

  • I can't erase unnecessary files on my Mac Pro by pressing option, command, and then J.  Help, please.  Thank you

    I can't erase useless files more pressing option, command, and then J.  Help, please.  Thank you

    option, command, and then J is not listed as a shortcut KB

    here:

    Keyboard shortcuts in Mac - Apple Support

  • loads of YouTube but then when I click on a video it doesent play. It worked fine the other day and it does not work in the past and suddenly. Help, please!

    loads of YouTube but then when I click on a video it doesent play. It worked fine the other day and it does not work in the past and suddenly. Help, please!

    Clear the cache and cookies from sites that cause problems.

    "Clear the Cache":

    • Tools > Options > advanced > network > storage (Cache) offline: 'clear now '.

    'Delete Cookies' sites causing problems:

    • Tools > Options > privacy > Cookies: "show the Cookies".

    Start Firefox in Firefox to solve the issues in Safe Mode to check if one of the extensions or if hardware acceleration is the cause of the problem (switch to the DEFAULT theme: Firefox (Tools) > Add-ons > appearance/themes).

  • I have IE to Mozilla Firefox password and can not find that my internet registered the username and passwords. Help, please!

    I have IE to Mozilla Firefox password and can not find that my internet registered the username and passwords.  Help, please!

    Tools > options > Security > passwords saved...

  • Hi guys I need help for Pixel Bender, cansomeone send me a link, I have Photoshop CC and I googled and all I met seems to be corrupted. I also tried Adobe lab and nothing! Help, please!

    Hi guys I need some help getting Pixel Bender, can someone send me a link, I have Photoshop CC and I googled and all I met seems to be corrupted. I also tried Adobe lab and nothing! Help, please!

    Trevor says.

    Adobe Pixel Bender killed several years ago.

    John Nack on Adobe: Pixel Bender abandoned in PS, AE CS6

  • I am trying to download my trial version of photoshop. It says installation failed then downloads to 83%. When I click on start, it starts at 42% then fails again, again and again. Help, please

    I am trying to download my trial version of photoshop. It says installation failed then downloads to 83%. When I click on start, it starts at 42% then fails again, again and again. Help, please

    Hi Sherry,

    You can follow the thread: creative cloud hangs at 42% , where this issue is already discussed and resolved.

    You can also follow article: error "Unable to install" received when installing Adobe Creative Cloud desktop application that will help you get this fixed number.

    Let us know if it works or not.

    Thank you

    Yann Arora

  • Graphics Intel hd 5500 is sufficient to run Photoshop, dreamweaver, illustrator and coral? Help, please.

    Graphics Intel hd 5500 is sufficient to run Photoshop, dreamweaver, illustrator and coral? Help, please.

    Is this enough? Sure. It will be fun? Not always.

    Mylenium

  • Is it possible to buy 3 three software only? I am interested to buy photoshop, ae and creation. Help, please.

    Is it possible to buy 3 three software only? I am interested to buy photoshop, ae and creation. Help, please.

    tessaso wrote:

    Is it possible to buy 3 three software only?

    It is possible, but this isn't the best way to do it.

    Adobe cloud plans don't offer a mix and a game approach. There are 3 separate plans: Plan of photography. Only App plans and applications.

    You have two options:

    1. Plan of photography ($ 10 / month) + App unique After Effects ($ 20 / month) + one App Premiere Pro ($ 20 / month) = $50 / month
    2. All Apps Plan = $50 / month

    Clearly the plan of applications is the best deal if you want apps 3 or more.

  • Satellite Pro A200-PSAE4E - computer laptop shuts down randomly

    I've had my Satellite Pro A200-PSAE4E for about a year and a half now. He ran very well most of the time, but in recent months he has been stop itself randomly. There is no warning or "Windows is shutting down" he just me using my computer to a blank screen.

    After frustrated with her, I did a full format my HARD drive and started from scratch. This does not solve the problem, and since then, the taskbar freezes. When I click on it I get the error and the hourglass cursor message "Windows Explorer is not responding... "I then have to click"restart", which makes the taskbar disappear for a few seconds before returning (usually without my sound icon).

    The laptop turns off when it is connected to the electric network with & without the battery and when running only on battery, so I excluded all power problem.

    I have considered it heats up too, but I use a block of cooling with built-in fans and has not himself in a few minutes after being hit not 24 hours, so I'm not sure that's the problem.

    Someone at - it ideas?

    I am running WIndows Vista Home Premium 32-bit if that's any help.

    Thank you.

    > It worked fine most of the time, but in recent months he has been stop itself randomly.
    > There is no warning or "Windows is shutting down" he just me using my computer to a blank screen.

    I think that the problem of overheating.
    The fact is that the laptop would be down automatically stops in order to avoid that the pieces of equipment against damage.
    In most cases this problem can be solved very easily. Using a jet of compressed air, you can remove the dust from the cooling modules and fans.
    I clean my fans from time to time, because I noticed a higher temperature and the laptop was a little stronger.

    Check it out mate

  • Satellite A100-225 keeps freezing and crashing with the new HARD drive

    Hi all

    I have a Satellite A100-225 with a 100 GB SATA Hitachi drive I int it that recently started showing bad sectors. Then I bought a Hitachi 320 GB SATA II drive to replace it. I tried the drive and it was recognized right away, so I didn't need to change the SATA speed. I ran the restore a disk installed newest. The problem I have is that the computer keeps freezing and crashing with the new drive. It takes a lot of time to load up when turned on and there is a noticeable to untermittant delay when you drag the cards around solo.

    I tried to run the Hitachi drive test and it comes back fine. I also tried to turn the SATA speed of the drive down from 300 to 150 via the firmware, and although I saw a slight improvement, it is still not right.

    I talked to Hitachi and they say that he could not be 100% compatible, so the problems. Someone at - it else sucessfully set up a replacement for this notebook drive and if so what make and model. Has anyone else had simular problems?

    Thank you

    Years ago, I've updated yet more former Satellite M70 with SATA HDD (270 GB if I m remembering well) and everything was fine.
    In my view upgrade with SATA HDD normal shouldn't be a problem. Do not SATA II because it will not work faster.

    I can't say for sure, but there must be a compatibility problem.

    Let's see if someone else had better luck with the upgrade of the disk on the Satellite A100.

    Have you checked this forum with advanced search option? Maybe you can find some old NET on upgrade the HDD on A100.

  • Startup and shut down problems on Sony VGN-AR51SU laptop with Vista Ultimate

    I have a Sony VGN-AR51SU laptop which has Vista Ultimate preloaded when it was purchased. The windows product key is noted on the underside of the computer.

    The computer is configured to close, either by closing the lid or will the icon start then shut down. I don't remember which option I used to shut down the computer.
    However when I press the power button the computer immediately emits three short beeps. The hard disk icon flashes as if it is starting, but the LCD display remains black and never even a blue screen comes. Devices powered by the computer the light upward.
    Eventuallu the hard drive icon will stop blinking.
    When I put the cover towards the bottom of the computer behaves as if it ends and all devices close but the power of the computer remains on, regardless whether I am with the main power or battery.
    Obviously I can not use the starting/closing track that I have a black screen.
    I tried all the options to remove lead AC and battery close and all devices, then re-boot just on AC power or battery or any combination of these options, etc etc etc and nothing makes a little difference.
    I keep my system and software updated and this problem was one of sudden nature IE. OK one day then the problem the next time I turned on the computer.
    Make three short beeps on start uo and the fact that the screen remains black gives a clue as to the problem?

    Hi Taked,

    This seems to be a hardware problem. You must contact Sony support for assistance on the issue.

    Contact Sony technical support

    http://eSupport.Sony.com/us/Perl/select-System.pl?Director=contact&SR=NAV:support:Electronics:contact_support:ESUP

  • HP 2000 running win 7 32 bit freezes and slows down.taskmanager shows his works normally.

    my brand new hp 2000 crashes every time and slows down.the warranty does not cover my position as I bought abroad.

    He sometimes stops to up2 a hr and then she'll start working for alittle while only to freeze again.very frustrating.any helps apprecieted

    Hello

    I suggest always back up your personal files, etc. before you try the following procedure.

    Shut down the laptop.  Tap away at f10 you start Notepad to open the menu of the bios.  Under Advanced Options or diagnosis tab, you will find the possibility to run tests on the hard drive and memory.  Post back with the details of any error message.

    If the criteria above, try the following.

    In the Menu start, open the all programs, open accessories, right-click on command prompt and select "run as Administrator".  In at the prompt, type the following command and press ENTER.

    sfc/scannow                (Note that there is a space between sfc and /)

    Let the entire process, then the output type and press ENTER.

    Then, click on the Start Menu, click computer, left click Local disk C once to highlight, right-click Local disk C and select Properties.  Click the Tools tab and then click on the button "check the drive for errors.  In the next window make sure that both boxes are checked, then click Start.  Right plan the audit on the next reboot of the system, and then restart the laptop - this process can take several hours before the load in Windows.

    Kind regards

    DP - K

  • Satellite M70 164 - screen freezes and goes black, overheating

    Hello world! :)

    Recently my Satellite m70-164 started to freeze after only a few minutes of work. The picture on the screen freezes, and a few seconds later, it becomes completely black.
    The computer doesn't even have time to warm up, and it's not stop... It's just the screen that freezes and becomes so black. I have to reset the computer by pressing the power button. (I write from another computer).

    I noticed that working time reduced whenever I have reset the computer and after some time it freezes even though I am in the BIOS settings, so I don't think it's an OS problem.
    Even if the computer does not have time to warm up, this suggests it might be a heat problem.
    So I tried pointing a fan this is low (a big, like the ones we use in the summer), and it works without problem!

    With the fan facing these, I reinstalled Windows - so no Virus.
    Laptop fan * not * continue to operate as it is overheating.
    The fan runs and it is not clogged as I've cleaned.

    So if anyone has the same problem, or ideas, please respond!
    (And sorry for my English)
    Thanks in advance! : D

    Hey Buddy,

    I agree with you. In this case, even in the BIOS, that it has nothing to do with Windows or a Virus. In this case, it seems to be a hardware malfunction

    But before contacting an authorized service provider to diagnose what part is the cause, clean your laptop using a jet of compressed air. This should be done from time to time (every 4 months) and, therefore, it of not necessary to disassemble the laptop.

    Check this box!

Maybe you are looking for