Satellite 4030cds beeps at startup (POSTAL codes)

Similar Questions

• Satellite A100 beep at startup

  My Satellite A100 still beeps at startup (or when he wakes up after hibernation) as if a key is pressed down, and it will not stop until I press one ' ~ ' key (just below "Esc"). In addition, it begins this character by typing in the field log-in on the start screen.

  Any ideas why this might happen?

  HI Maria,

  It seems to me that if the key is either stuck or is defective. It is possible that the keys are shorted or the rubber under the top key shared so that contacts of does not return to the open"" position.

  I suggest that you only contact authorized Service partner who can check the keyboard.

  Kind regards

• Satellite P20 - beeps at startup after cleaning the keyboard

  Hey!

  I have a Satellite P20, which is strange. I have cleaned the keyboard (deleted, took apart and cleaned all the keys) but when I boot up to now (I have connected the keyboard) it will * beep beep * beep beep beep beep * on me (sounds like one of those things in the hospital). If I wait for some time, it ends by starts XP but then some keys (5%) did not respond (S and arrow down to name a few).

  I tried to start with the keyboard disconnected and that works like a charm.

  Then it is the keyboard that is defective? (I'd rather not buy a new one just to have the same problem) or is it keyboard connector or hurt (I have unplug and connected the keyboard several times)

  I am very grateful for any help or advice I can get.

  Best regards

  / Martin

  It is strange, but maybe the keyboard is defective, as you say.
  Or you don t have the keyboard connected to mainboad correctly. Check again.

  Maybe a key is always pushed and get the beeps. Select this check box.

• Satellite A100 beeps at startup and goes straight to the mode without boot failure

  When I turn on my A100 there is a beep and I'll striaght on-screen 'safe start mode.
  I can then load normally in windows XP and everything is OK. Is something missing?

  The computer is less than two years.

  See you soon
  John

  Hello

  > 'safe start mode.
  Do you mean that your Windows operating system starts only in safe mode?

  If yes then it might be something wrong with the system files or the registry.
  How do you reinstall the operating system on your laptop? Is it 2 years ago?
  Eventually it s time for a new OS update?  :|

  If you the problem is only with the software, then a new recovery would solve the problem.

  Good luck my friend

• Satellite P300 - 13 M - beeps at startup

  Hello

  My laptop now and then beeps at startup and then I get a black screen (and can't do anything)
  The beepingsounds goes as follows: BEEEEEEEEEEEP BEEP BEEP (1 x long - 2 short)

  Anyone know what this could be?

  It is very annoying when I want to show my client project and all of a sudden the laptop no longer works...

  Thnx in advance

  Raey

  Hello!

  Beep codes mean that there is a faulty hardware component.
  It's not easy to tell what is the reason for this, but in your case I would try to exchange the RAM.

  If it doesn't work you should contact an ASP and ask for help. Technicians can check your laptop and exchanging all the necessary parts.
  On the Toshiba site, you can search the nearest ASP:
  http://EU.computers.Toshiba-Europe.com-online decision-making supported Downloads & => Download drivers

  Good bye

• Keyboard and beep on startup with Satellite A80 problem

  Satellite A80 continuous beep on startup after the keyboard does not work. He writes only

  Post edited by: habib00

  Hello h,.

  I suggest you to bring your machine to a local service partner, or at least by a technician who is familiar with toshiba laptops, because your question looks quite related to the material.
  Someone pour some liquids above? I had the same problem a few years ago that my sister pours coke on the keyboard of my satellite 2430. :(

  Would like to hear a response from you :)

  Welcome them

• continuous beep on startup and the black command screen

  I have problems with the boot on my computer laptop gateway. I bought it last year, and despite the update anti spyware and etc., he refuses to start after a black screen.it command refuses to go into hibernation mode is that drives me crazy. When I try to put it in this mode the red light that usually indicates the hibernation mode flashes 3 times faster and when I open the screen it displays the screen of welcome without a moments notice. is this just a virus? or is it something else. I don't have the keys sticky and I clean them every week and ran the antivirus program several times a week since I bought it.

  Hello

  Sound beeps are error codes that describe a problem with your machine. A continuous beep
  can mean keyboard (loose or bad cable), losing the card, power, a short circuit or other matter according to the
  System/BIOS manufacturer.

  Startup and select CONFIGURATION/SETTINGS (BIOS/CMOS) - usually F2 that you start - look to see BIOS
  Creator, then see here:

  Computer MESSAGE / beep codes
  http://www.computerhope.com/beep.htm

  If my computer beeps and won't start, what do the beeps mean?
  http://KB.IU.edu/data/afzy.html how to troubleshoot Beep Codes
  http://pcsupport.about.com/od/nonworkingcomponent/HT/beepcodestb.htm

  POSTAL Codes beep
  http://www.technick.NET/public/code/cp_dpage.php?aiocp_dp=guide_beep_codes

  Power on Beep Codes post
  http://www.pchell.com/hardware/beepcodes.shtml

  It can be so other check with the manufacturer of the system.

  ----------------------------------------------------------------------------

  Are there any error messages? May be material.

  Check with Support technique Gateway, their documentation and online drivers.

  Gateway drivers and downloads
  http://support.gateway.com/support/drivers/dlcenter.asp

  Technical support Gateway
  http://support.gateway.com/support/?cmpid=topNav

  Door Documents
  http://support.gateway.com/support/SUPINFO/index.asp?cmpid=topNav

  I hope this helps.

• Satego X 200-21 L - 3 beeps at startup

  Hello

  first of all, sorry, my English is not very good, but I can't find a German forum. I hope you understand what I want :-)

  Here, I have the laptop (subject) and when I try to start it, there is nothing on the screen. Black. Only 3 beeps.

  Am I just informed that 3 beeps are Code of a default to the graphics card? When this is true, what costs a new card (or 2, it is a sli system) for this book. Is there a hotline where I can get this information?

  Sorry for the bad English and thanks to all who wants to help me!

  Hello

  I m not very well that 3 beeps means but these beeps seem to be a POSTAL code.
  Simply said: Test of power (POST) checks the laptop of State initially and provide the different beep codes if an error has been detected.

  Here is a page on the BIOS beep codes:
  http://wiki.WinBoard.org/index.php/BIOS_Beep_Codes

  To my knowledge it s Phoenix BIOS but 3 beeps are not mentioned on the page for Phoenix BIOS.

  However, if the GPU (graphics card) is defective, then the whole motherboard must be replaced.
  But I recommend to check RAM first.
  This could be too affected.

• Equium A100-306 beeps at startup

  Hello

  I have an A100-306 which, at startup, beeps for about 30 seconds, then starts up fine and then works perfectly, if I look at the laptop all the ram is recognized and the CPU seems very well, there is no display problem, the only thing that doesn't work is the CD drive doesn t recognize disks but the drive shows on the laptop , but if I remove the CD drive still beeps on startup anyway.

  Any ideas anyone?

  Hello

  The beep code during POST (power on self-test) means that an error has been detected on the motherboard.
  But it of really difficult to say what could be the problem here, you said RAM is recognized correctly hmm try to remove a RAM module and start Notepad using RAM only one in each slot

  All devices are connected to the laptop? If so, unplug everything (all devices) and try again.

• Inspiron 3650 does emit any beeps at startup upward. Does?

  Seems to work well, less than a week old. I was expecting a beep at startup upward, but I hear nothing (unless it is very quiet) I should wait for a beep code. Unable to find anything in this regard in the manual. I have a S2316H monitor with built-in speakers attached via the HDMI.

  Any thoughts appreciated please. Thank you.

  With more recent versions of the UEFI BIOS, there is no beep at the STATION, unless there is a problem. Now, the POST beep means generally: card system: the BIOS ROM failure.

  A while back, Dell has a brand-new model giving the 'normal' beep at the STATION, but confused users with the motherboard beep fault code beep.

  This led to many mothers unnecessarily replaced under warranty. Dell has subsequently removed the 'normal' beep to the STATION in a revision of the BIOS and saved the lives of many mothers!

• Beeps at startup. also pages screen down in itself but cannot me up__window base page Vista / acer 5515

  Have tried the system restore, but no luck

  Beeps at startup are usually a warning that something is wrong in the BIOS. What is the problem depends on the order of beep. Visit this link for the relevant sound codes: http://www.pchell.com/hardware/beepcodes.shtml make sure you know the manufacturer of your BIOS - it is usually displayed when you start your PC and will be Phoenix or FRIEND. John Barnett MVP: Windows XP Expert associated with: Windows Desktop Experience: Web: http://www.winuser.co.uk; Web: http://xphelpandsupport.mvps.org; Web: http://vistasupport.mvps.org;

• T500 beep at startup

  Last week, my computer (Lenovo ThinkPad T500) has started to beep at startup (a long, two short) and will not allow the system to boot. I need to stop and restart a considerable amount of time before the display finally manifests. The strange thing is that he has informed me that this indicates a problem of video and still I ran diagnostics and others, and there is nothing wrong. In addition, my computer works perfectly, if not even better than before the beeps started.

  This problem starts to become annoying and I'm afraid I could irreversibly damage my computer if I keep trying to start when it beeps. How can I fix?

  Thanks for all your help!

  katrimc, welcome to the forum

  the hardware maintenance manual(pdf p. 52), the beep code means that you may be a problem either with your motherboard, display or memory. I suggest deleting and reinstalling your memory, (pdf p. 78 or look here), and if the problem continues to run memtest86 to check your memory. Let him at least 3 complete passes.

  If your memory goes and the symptoms persist, you must call support.

  Know how you get on the forum.

• How to change postal code using the prog.

  whenever I have access to one web site, that the answer for a postal code is other than mine.

  Firefox doesn't store information about your postal code. Sites Web assumes that this information by looking at the location that you have your router and the IP address. This postal code is only an approximation, and cannot be changed by Firefox.

• MacBook Air mid 2009 3 beeps at startup

  Hello world!

  I had a problem: after a few hours of videos online watch my book mac freezed with sound fixed.

  After that I pressed the power button and shut down the computer. After evil market see black screen and hear 3 beeps.

  Also: I have used all the key-combination to repair the situation, problem still there.

  P. S.

  ALT-CMD-P-R - give me long 3beeps - 3beeps short - long 3beeps

  And now I want to try a version:

  "Same for me here.

  My MacBook Air mid-2011 with 4 GB of RAM would be only 3 beeps on startup.

  "Put the logic card 8 minutes in the oven at 190 degrees celsius - was again very well then begin."

  of https://ru.ifixit.com/Answers/View/27783/3+beeps+on+start+up

  Dear Mac users, if you have and idea to fix my mac - please enter into this discussion.

  Good day!

  Problem with RAM.

  https://support.Apple.com/en-us/HT202768

  Please contact Apple.

• Pavilion dv7t-7000: Notebook keeps beep at startup

  I have a hp model pavilion dv7t-7000 with a (version F.29) Insyde bios that retains a beep on startup until the bios Setup menu appears.  This started in the last three months and went from occasional incidents to a constant.  Someone else has a similar problem, and if so, what can I do to fix this.

  Hi .in my experience the keyboard has a sticky key.
  And can be replaced.
  Is the pc still under warranty?